So lately this has been getting worst. You have to step on the brake before you can shift out of park. Well lately I have to step on the brake a few times before the safety will let you get into gear.
View 7 RepliesMy cousin has a 2007 Ford Taurus with the pushrod 3.0L. It has the console shifter and it is hard to move the shift lever into Park from Reverse. The shifer moves out of park and to every other gear with normal effort. The gear indicator correctly displays the shifter position. It drives/shifts perfectly fine. The only problem is that it is hard to move the shifter from Reverse into Park. It feels like there is a rubbery, or somewhat mushy threshold/resistance that needs to be overcome with a moderate amount of effort to get the shifter into park. Once the shifter is in Park it feels normal meaning you don't have to hold or force the shifter to stay in park.
It is frustrating because it seems most other people have a problem with the shfiter being hard to move from Park to Reverse or Neutral, but she is having the opposite issue. Will it hurt the car to keep shoving the shifter into park when necessary without getting it fixed?
While traveling I made a fuel stop. Restarted engine fine, stepped on brake, but could not move the shifter out of Park. Towed to Ford dealer, after extensive trouble shooting replaced shifter cable and transmission position sensor. A week later same problem but glad I learned about the interlock override lever on the steering column so can continue to drive. It locks up several time a day. Here's what I know and observe.
. brake light switch appears to be normal
. engine starts normally
. brake lights operate normally
. fuse on interlock function is ok
. when the lockup happens the shift indicator is missing the box over the P
. this may not relate but backup/reverse lights operate very weird - in reverse they only light when the engine in rev'd and go out when the gas pedal is released
There appears to be a gremlin in this Escape that eludes Ford and me. I read some reference to a computer control involved in the interlock function. I'm at a loss.
Experienced problem with the Automatic locks on the doors? The doors on my camry lock as soon as I move the shifter out of park. The owners manual indicates that I can get the doors to lock automatically at 20 km/hr. I have tried following the instructions in the manual to make this happen but without any success.
View 14 Replies2000 VR6 automatic. Yesterday my car was stuck in park couldn't move the shifter . Figured it was the brake sensor switch when the brake is engaged food pedal lights do not go out, I replaced it this morning but still won't work I've been driving it around in limp mode?
View 4 RepliesThis morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
I have a 09' 4cyl automatic engine with 54k.
About 30min ago when when I parked the shifter would not move past neutral into reverse and go into park. I can go from D into neutral or the next slot over for manual shifting. Naturally this causes a problem as you can't take the key out of the ignition if its not in park.
I took a screw driver and popped open the cap for the shift release button and used that to move it into park. Turned car off, back on, etc etc seemed fine. So when I tried moving it into reverse and it wouldn't budge. It instead would make a electronic click or snap coming form the steering column but more back toward the engine. Like more into the dash area but back in it. It would make this noise every time I attempted to move it but it wasn't a continuous sound. Just once with each jerk to the side to move it out of park.
So the car works fine except for this. I used it with the screw driver/shift release to unlock it and it drives fine. Goes into reverse and back in park but if I move it into neutral or drive it will not go back into reverse or park.
What this may be. 2004 Accent Automatic. We just purchased recently for my daughters fist car. Today when leaving the house the car stays in first gear, you can move the shifter through the gears but it wont shift up. Reverse is fine. Checked the oil level in Neutral when hot and it was ok. Hooked up my code reader and there are no Codes. Car only has 85,000 KM on it.
View 5 RepliesMy 2000 ford excursion gauges fuse keeps popping. It started earlier this year and I couldn't pin point when it would pop. Now I'm sure after 30.00 worth of fuses that it happens when I change the gear shifter from park or rev to drive.
View 5 RepliesSo my friends 2002 camry has a problem where she shifts the shifter into drive, but the gear position indicator in the cluster still shows her in park, and the car will still be in park with parking pawl engaged. is this a sensor that went out, or a deeper transmission problem to be dealt with?
View 1 RepliesMy son who is away at college, has a 04 F150 that has a center console and he can't get the truck to shift out of the 'Park' position. I told him to try and rock the truck back and forth and then try again...no luck.
View 1 RepliesI drive a 2008 Chevrolet Impala. The car has had some electrical problems going back about a year and a few months that I have neglected to fix. The first problem was with the shifter not being able to move out of park without hitting the button inside the center console to do a shift lock override, which started last August.
The second problem was with the ignition not being able to release the key without hitting a switch inside the ignition, which started back in the Spring. I have just been rolling along promising to eventually address those, but yesterday the car radio stopped functioning. Then this morning the car would not start.
The electrical system comes on just fine (save the radio), but when I go to start it the car just clicks over. I did not leave any lights or switches on, so I am assuming it must be some sort of problem with the electrical system.
My 2009 Ford Escape shift lever is stuck, not allowing me to shift out of park without using the manual override. However, when I slam my foot to the brake (rather than simply stepping on the brake), the brake switch relay, etc. all engage and I am able to shift out of park. Is this a brake switch relay problem, or is it possible that it has to do with the age of my brakes, etc?
View 3 RepliesMy wife's 2004 GX 470 was not going into low gear from 2nd, so of course I used some pressure and i heard something break inside the gear shifter (sounded plastic), now the shifter won't stay in 4th from drive and will shift out of park even when the car is off. Could this be the shift lock control? I know the linkage was probably the fault initially when not going into L from 2nd gear, but now I have this issue to deal with.
View 1 RepliesMy mom has a 2016 Sonata that recently has started experiencing some issues with the gear shift. A few weeks back my stepdad was not able to get the gear shift to move out of park. Finally, my step brother did get it to go into drive, but then could not get back into park (he could only get into neutral), so my mom took it to have it looked at. While at the dealer someone there was able to get the gear shift to work and we thought everything was okay. That was until today when my stepdad could not get it out of park again. I noticed today that button on the shift knob was fully depressed while in park. I did attempt to use the shift lock release per the instructions in the manual with no luck.
My mom is going to call Hyundai in the morning to see what they can do for her, as the car is parked at minimart right now.
I have spilt some coke into my shifter and it dried. Now when I shift to Drive or back to Park it makes this crackling sound and sometimes gets stuck. How to take the P-R-N-D-S cover off so I can clean?
View 1 RepliesI have a 2004 RX with 82,000 miles, well maintained. Lately the engine will start but the warning lights won't go off and the gear shift won't move out of park. I have to keep turning the vehicle on and off until the gear shift will go in reverse.
It doesn't happen every day but off and on over the past month.I've had numerous brake light switches replaced which could maybe be the lights, would that affect the transmission too?
What causes this? I have to mess with the brake pedal for a while for it to finally register that i have my foot on the brake and let me shift out of park.
View 5 RepliesAs it's progressively grown colder (which may or may not be related), my truck has grown all but impossible to shift from park into reverse neutral or drive with the engine running when the truck is cold. I often have to shut the engine off, and once I do it immediately is very easy to shift out of park into neutral, and then I can restart the engine. Once the truck has been driven some, it's not hard to get out of park, but if it's shut off for some time (an hour maybe) it will be difficult to shift out of park again. I don't know how to begin troubleshooting this.
View 8 RepliesI have a 2008 Nissan Rogue that is experiencing a shifter problem. The problem is that periodically the shifter will not go from the "park" position to the "drive" position after the car is started and your foot is on the brake. I have been able to drive the car by inserting a small screwdriver into the slot on the gear shift assembly to depress the switch that allows you to override the mechanism but as you can imagine that is tedious and what do you do if suddenly the screwdriver is lost - you go nowhere and you can't even get to store to buy another one because the car won't move!
I have had the car into the dealer twice now and they have been unable to correctly diagnose the shifter problem. They have said that it could be a failed solenoid that senses the brake pedal being depressed but so far that has checked out fine. They also thought that it may be a brake sensor and they asked me to keep an eye on the brake lights to see if they come on when the brake pedal is depressed and the lights do come on so they believe that is not an issue. They "repositioned" the shift assembly in the car center console thinking that it may be an improper position and they tightened it down into place but that has not corrected the problem either. They now tell me that the entire shift assembly needs to be replaced at a cost of $670.00 and I find that hard to believe let alone pay for!
The car has about 70,000 mile on it and it was recently in an accident that did deploy some side airbags and I am wondering too if the accident may have damaged the assembly in some way that caused the malfunction where the repairs may be covered by my insurance company. This has only started after the accident repairs were made and we never had a problem like this prior to that event.
Last night I jumped into my Treg to move it into my garage. When I pushed the brake pedal to move the gear selector out of park, I heard a whooshing sound. Like the sound of a bellows-type foot pump I use to inflate my dinghy. I could also feel a slight amount of movement in the transmission lock button on the top left side of the shifter when doing this.
Now I'm noticing this noise whenever I apply the brakes. It doesn't appear to affect braking performance, but does have me wondering. I'll have the dealer check this out when I take the Treg in for the recent recall (got my notice yesterday).