Ford Excursion :: SES Never Go Out / Cranks Over But No Start
Dec 19, 2014
My 6.8L is experiencing an issue. Truck hasn't been ran in a few months...it ran fine when it was parked and has sat longer than this with no issue before. Battery voltage fine...
I get in, insert the key, turn it over and it cranks but doesn't fire.., why is that, I wonder? I notice the SES never goes out before I crank the truck over.
I unplug the battery, tried to clear any fault codes with my handheld tuner (which there was nothing showing up) and turned the ignition on. I left the key in the on position but didn't try to start it. The SES lights never turns off.
I am assuming that if the SES light stays on, the ecu will not allow the truck to start...is that true? What components have an effect on the SES light when you first turn on the key?
View 9 Replies
Advertisement
Had the Excursion out today. Made a stop coming back and used the remote start. I entered the truck and by mistake pressed the brake pedal which shuts off the engine. When I tried to start the truck with the key...it cranks fine but does not start. It'll try to run, sputter...but will not run.
I cannot hear the pump running when the key is turned. It was towed home and it in the driveway. I assume it's the fuel pump....but wondered if the remote start/alarm could be killing the power to the pump? The cut-off switch in the passenger footwell is pressed in. Where do I start:?
View 14 Replies
I have researched a little and believe i have a leak in the high pressure oil system. My 2004 Excursion 6.0 will start when it is cold but after warming up will not start it just cranks over. So here is my question; the two wires leading from the Turbo had melted and shorted and in fixing that i loosened what i believe to be an oil line feeding the Turbo. Could this be the problem? Also is there an O-Ring that seats the line into the block that may need replaced?
View 2 Replies
My 2004 6.0 will not start. It cranks fine. History This happened once before about a year ago towed it into the shop and it stated fine.
The batteries were low yesterday and the truck would not start because the voltage was too low to run the starter. I charged them. Went to try again and I cranked it for close to 30 seconds with no results.
Only cods so far are #6 glow plug and EGR valve open. Whats next, check the FICA?
View 8 Replies
Been having an odd problem with getting my truck to start. Pass couple of days I've gotten out from work and gone to start the truck. It cranks just fine but wont start, acts like there is no gas. Let it for a minute or two and try again and it will start right up and keep running with no other problems. Go to leave for the work the next day and the same issue. Weird thing is the problem only seems to happen when its cold out 30F so or below. I was thinking fuel pump but I'm not sure. What to check?
Edit Its a 2002 Excursion XLT with the gas 5.4
View 8 Replies
2001 Ex V-10 4x4. Ran like a top yesterday. Turns over fine but not even a sputter today. Plenty of fuel & battery. Has spark. Tried starting fluid, but nothing. No codes. Checked fuses and relays in dash & under hood. Fast forward an hour...
Went out and tried it again - fired up like nothing ever happened. Plowed snow for the better part of an hour, - ran like a champ again, smooth, no missing or stutters - parked it and shut it off. Tried to start it again within a minute or so and it would start, run rough & die. Tried a few more times with same results. Now it cranks fine but no start, no sputter. Gonna try a fuel filter tomorrow.
If it were the fuel pump, wouldn't it throw a code?
View 7 Replies
I have an 05 diesel. I have noticed the last 3 days I needed to crank it slightly longer to start it and it takes a second before ideling normally. It usually fires right up and jumps to life. Today i drive about 45 minutes. Stoped for about 30 minutes and shortly after I started it back up the check engine light came on. Will the Ex flash you the codes or do you have to have a reader? Thought I would try Autozone tomorrow but not sure if they read deisel codes or not. I was suspecting maybe glow plugs but who knows at this point. It seems to be running fine and I checked all fluids.
View 13 Replies
I just changed the alternator this morning. Hook battery back up now cranks wont start no security light flashing no security light blinking at all. When turn ignition over gauges do not swipe don't remember if they normally did or not but now they do not swipe as in speedometer and RPMs. I've also been having trouble with the no windows no radio. Just driving down the road and radio cuts out and power windows hear a click under the dash radio coming back on Windows work again research and see if it's in the battery save circuit inside the dash cluster wondering if this is causing no start now.
View 14 Replies
2000 7.3 Excursion. Truck ran fine on a 5 hour trip for family vacation. Pulled and to where we were going turn the truck off then what I had to do I came outside try to restart the truck for the next three days it would take 2 to 3 cranks before it was would start. Then on day number three tried six times and didn't start went to bed woke up the next morning and it took three cranks to start. drove it down to mechanic shop near me they have been troubleshooting and think it's an electrical issue the code is P1280; he said there were a couple other codes too and he would tell me what they were later but he never has. I took him a new CPS a new ICM and a new PCM, none of that fixed it. I am at my wits end here and really have to have my truck for work every day.
View 12 Replies
I also tried jump starting - get same same result. Engine cranks, turns, and then sounds like it is just about to start up normally but it just dies completely. It seems to want to start but just can accelerate the engine high enough to keep it running. Almost like it's flooded on a carb motor.. 2000 V10..
View 7 Replies
I don't drive the truck much anymore but over time my MPG has gone to total crap...about 10mpg around town...and that's baby-ing it.
Now it suddenly takes many cranks to finally start on a first start. (cold or warm days)....
View 8 Replies
My eXcursion is showing the typical signs of a failing fuel pump. It cranks and fires on a few cylinders, then quits. I released the schrader valve on the fuel rail but very little pressure is released. From these indications, and after checking for a blown fuse, it appears the fuel pump is going. I say going because it did start after this happened, but would you trust it?
I ordered a new fuel pump, it's due in tomorrow. I remember seeing instructions on how to drop the tank but can't locate them with the search function. I'm also concerned with how to remove the pump from inside the tank. I know you have to spin off the big plastic ring, how do you get the pump off the bottom of the tank?
View 14 Replies
This problem was sporadic. First time cranked it till battery died when I charged it it started. Second time I replaced the battery and it started. Now it did it again so I bought a distributor package I'm putting it in tomorrow and will update the results. Checked for spark and didn't see one.
View 6 Replies
it's been parked for about 2 months in my driveway, which slants upwards. I cranked it for a solid 30 minutes (jumped the battery so it wouldn't die). I don't smell gas so I think gas isn't making to the motor.
View 1 Replies
My 2001 Ranger is used for work to move furniture multiple times in a day. 7 weeks ago, I had moved a dryer w/ it, drove across town for a meeting, got back in & it refused to start & run. The same thing happened 3 days ago on a longer, fuller route w/ a trailer attached. Both times, the truck started & drove home ok AFTER sitting off waiting for my emergency ride. While I waited, I looked up the issue in the owners manual which told me to depress the gas pedal 1/3 to 1/2 & then turn the key in ignition. The first attempt did not work, so I repeated the steps, which started the truck & I was able to drive back. Both times, the truck started no problem the next workday. Does this sound like a problem worth fixing (for the age of the truck vs. cost of repair)? It has pull some weight, including on trailer, in between the two occasions.
View 1 Replies
Ok so... have an 04 that has more issues than Playboy magazine... any DIY tips or tricks...
I dont have an original key but the key I have has worked before. Motor cranks but wont turn over. Have tried the battery unhook thing, didnt work.
View 4 Replies
I just purchased a 2004 Explorer from a police auction. It had driver side damage but nothing major. When I try to start it it cranks but nothing else. I purchased a new battery, fuel filter, coil packs, spark plugs and installed all. But same thing it tries to fire up but stops short. A few times we sprayed starter fluid in it and it would start for about a second and a half and shut off..... I also listened for the fuel pump and I hear it coming on when I turn the key and checked the inertia switch...
View 9 Replies
Parked in driveway and 2 hours later it cranks but will not start. Pushed on fuel rail Schrader valve and it squirts out. Turn key and the fuel pump runs for 2-3 seconds then off...... Thought I had fuel... assume electrical. Read posts last night and thought crank positioner pickup was a good place to look. Took spark plug leads off #1 and #4 at coil and set a 1/4 steel dowel in each so they were 1/2 inch apart. Crank motor and I get spark out of coils so I assume the plugs are getting fire... Took off intake hose and shot ether in the tube while cranking... no fire or pop at all.
Where to now ? Seems like I have fire to the plugs, and fuel available but will not start. I have only one code and that's PO1116 coolant temp out of range..I don't have a cam sensor code or a crank sensor code...I thought they might effect the timing ? With spark at the plug wires, you would think I would get a "POP" now and then, especially with the ether ?
View 8 Replies
I'm trying to diagnose a no start issue on my son's 1997 F150 4.6L W code motor. It quit on him while driving and we haven't been able to get it re-started since. We immediately assumed the fuel pump was bad as we were not getting any fuel pressure and we cannot hear the pump running at key on. So we pulled the pump and bench tested it, and the pump itself seems fine.
We then checked for spark, we have spark in all cylinders. After that we started checking fuses and #30 under the dash was blown. We replaced that and it blew again at Key on. We ended up going through about a 1/2 dozen of them while poking and prodding at misc. wire harnesses trying to figure out why it keeps blowing. Today we put a new one in and have tried restarting and that one is not blowing anymore, but we still cannot get fuel pressure. We've checked all fuses and swapped relays around. We noticed that under the dash #20 and #21 do not have power, but the fuses are ok. Are we finally on to something here?
View 9 Replies
My explorer starts fine some days and others it just wont. No codes, have replaced fuel pump. Rail and starter.
View 11 Replies
Truck has been running perfect and is my daily driver. Went grocery shopping with the wife and made two stops and drove it home. Parked in the driveway. No hint of any issues but when I went out a couple of hours later we went to head out to dinner and it cranks and doesnt start. Nothing out of the ordinary anywhere. No check engines lights, no theft lights flashing, nothing to indicate an issue. Engine sounds perfectly normal cranking, I can hear the fuel pump when I turn the key. I cleaned the battery terminals today because they had some corrosion and I checked all of the fuses that have anything to do with fuel or fire and nothing was blown.
I also went and bought a Fuel Pump Drive Module and installed it and still nothing so I took it back.This is a pretty pampered truck, not a torn up beater. What else I should check? Will probably town it to a shop tomorrow if I dont have anything else to try but I am at a loss at this point. I tried to listen with a stethoscope and I dont hear the injectors firing or the COP's. Oh I also shot it with starting fluid and nothing happened so I dont believe its fuel related. I think something is keeping it from firing the COP's or the injectors arent firing. But what could it be? Nothing happened to the truck last time I drove it. Oh I did check the fuel pump cutoff button as well. Nothing there either.
View 11 Replies
