I have checked the fuse number 38 and it's fine, and I've also checked the bulbs and they look good. Where else do I look to check for problems with my reverse lights not working? I just had my transmission rebuilt, and wondering if a sensor or something went bad?
View 1 RepliesI have a 2001 Excursion, 6.8 V10, with the factory fog lights.
The fog lights worked fine, until a few days ago until they suddenly stopped working when just the parking lights are on.
I can still pull out the switch, the indicator light does not come on but the parking lights still work. When I turn it to the headlight position with the switch pulled out everything comes on and works like it should.
I tried checking the fuses but I didn't see one labeled in the manual for the fog lights so I don't know for sure which one to check. Could I possibly have a bad switch?
Does the Ford emblem/camera just pop off the tailgate with a screw driver? Pry from top or bottom? I'm trying not to break anything here. I removed the tailgate panel inside and can't get any access there.
Both the camera and reverse sensors have quit working. I'm troubleshooting both but I'm not sure they are related. The camera died first but worked sometimes after slamming the tailgate. Sensors quit sometime after. Don't really care about the sensors but the camera is essential for hooking up the trailers.
I was hoping the wiring from the tailgate to the plug would be cut but that doesn't appear to be the case. I'd like to check the camera itself next. Ohm it out or something, I don't know.
Turn signals quit working on my 2006 E-150. Swapped out the relay under the dash and it did nothing. Also noticed the brake lights aren't working. The headlights and taillight a are working. I pulled the fuses under dash for the lights and they tested ok. I did notice the flasher relay was making clicking sounds intermittently even when not touching anything.
View 3 RepliesMy Excursion is stuck in 2wd. It worked one morning, then it didn't that same afternoon.
I've checked all fuses that resemble a related fuse in the fuse box.
I've replaced the dash switch, Transfer case shift motor and ESOF/GEM module behind the glove box. I've swapped around the relays under the hood on the drivers side fender well.
I ran a hot & ground to the 2-wire plug on the x-fer case shift motor to have it move the ex back into 2wd (replacing the shift motor required me to manually put it in 4hi with a wrench).
At this point, I'm thinking it's a wiring issue? Where to go next?
On occasion I'll have the reverse sensors quit working. I'll drop the shifter in reverse and the 'OFF' light on the button will illuminate. I took the sensors out and blew them clean with compressed air, dielectric geased the connectors and reinstalled the plugs. Let's see if that does the trick.
As mentioned, it's occasional and nothing in particular will trigger the fault....it's very random. Something tells I haven't seen the end of this problem, but tracking an intermittent fault is tough.
Tonight my wife and I drove ex to store and out to eat . We got back home and the wife opened the glove box and the radio quit working. And when she closed the box the radio came back on.
View 11 RepliesI have a 2002 excursion xlt 4x4 v10
The door locks quit working. The previous owner did the tin foil repair... I replaced the four door actuators today. Now all of the doors lock and unlock on the manual buttons. The fob doesn't work on any door.. when i try and use the door code pad, the locks go into a cycle.. the keep trying to operate by themselves. I had to disconnect the battery to get it to stop. I can't find the door lock relays. I have most of the dash out. Where these are?
I have a question on my '00 7.3. Cruise control just quit working. From reading the threads/forums I have gotten some ideas, but how about no dash light when turning the key to on? Nothing with the self test also. How can I troubleshoot the switch in the steering wheel? I could also have a bulb out in the cluster, but either way- no cruise function.
View 4 RepliesThe ruck is a 2002 Ex limited v10 4x4. The cruise worked fine till my wife drove the truck! the green cruise light blinked a few times, now, there is nothing.I'm no good at electrical issues.
View 3 RepliesI'm working on a 2003 that the front wiper and sprayer quit working on. The rear wiper and sprayer still work fine. We replaced the multifunction switch and no change. I would like to test the motor before we keep throwing parts at it.
View 5 RepliesNissan Pathfinder SE-V6 4x4 My blinkers quit working, but flashers still come on. All 3 brake lights also went out but tail lights still work. when the car is cranked and blinker is on there is a buzzing (alert) sound and the oil temp light comes up on the dash, there is no sound when the key is in the on position, only when it is cranked. Occasionally there is a crackle through the speakers that usually goes away when I turn it off. I don't know if the last part is relevant but I figured I would put it in anyway. Is this an easy fix or are there serious electrical problems?
View 1 RepliesThe fuel gauge sender quit the other day so Im replacing the pump assembly. I believe in replacing fuel and ignition related parts with factory equipment. So I was going to get a Ford Motorcraft pump, but my wife checked for one through her work(local parts store). The counter guy found one that said original equipment, called them and was told "It is the same pump that gets installed on the assembly line". Well it came in today and its a Delphi. I was expecting a Ford pump. I associate Delphi with GM and I know GM pumps go out all the time. I know Ford pumps go out too, but I know several people with GMs that have replaced pumps multiple times within 100000 miles. Is Delphi worth taking a chance on?
View 6 RepliesI have a 2000 F-150 and my lights to my gauges and heater controls quit working. I checked all the fuses inside and under the hood. All good. I swapped a few relays around and no luck. I tried replacing the headlight switch and that did not work. I checked power to the gauges from the headlight switch and there is no power, I then ran a hot wire to the wire that powers the gauge lamps and they do light up, so it is not a bulb issue. I assume I am not getting power, but do not know where else to look?
View 14 RepliesDriving home my radio quit working. I looked at the gauges and they all dropped to the left. The it looked like my lights quit working and then the truck just quit. All of this happened within 5 miles and 10 minutes. I jumped it and quit before I could even get going, it did start momentarily. Could not even get the gear shift into neutral; had to jump it to get that to happen.
It is 2006 F150 4x4, 5.4L engine and about 95,000 miles.
Well today the tach was not working at all and the check gauge, check engine and glow plug lights are staying on. Truck runs and starts great, everything else seems to work except the trans temp gauge. Did a search for the GEM and could not find anything that indicates the GEM controls the tach and warning lights.
View 14 Replies2002 excursion with 7.3 diesel. A while ago i had problems with it not starting, and a buddy of mine worked on neutral safety switch. It was the issue, and it then worked. shortly thereafter, i noticed the backup sensors were not working, and figured it was just my luck. what i also didn't notice was the rear lights were not going on when i put it in reverse.
Just so happened one day when I put it in reverse i was a little off in the shifting and the backup sensor worked. I played around and discovered that when i lightly shifted into R (so that it was much more towards Park) things worked. so we ended up trying to adjust it some more. As of now, still doesn't engage backup sensors or reverse lights, and I have to hold the shifter up hard into park to start it. if i don't it wont start. How do I get it to adjust correctly?
My truck is a 2007 F-350 DRW. I'm not sure when,because I don't use it much in Texas, but My Four Wheel Indicator lights on the dash quit working. I don't see them in the dash at startup either. I'm not sure if the four wheel drive is coming on at all. There is probably a way to check that without driving off into a mud bog, right? Anyway I have looked for blown fuses etc, no luck yet. (15amp#33 under dash and 30amp#3 under hood). These are according to my manual.
View 2 RepliesMy 2007 F150's turn signals and hazard lights quit working. I checked the fuse and it was blown. Once I pulled the old fuse out the truck wouldn't start at all. What happened?
View 3 RepliesI have a 91 Honda civic hatchback base model 1.5L and I am having serious electrical problems. My wife took the car to town and when she got back all the lights quit working and it just sits there and clicks if I don't remove the main relay. But the main relay also controls the fuel pump. Have already replaced main relay?
View 2 RepliesIhave a 2004 F350 4x4 Dually diesel. While in my hay field I hit a small rut and the truck bounced. About two seconds later all gauges and lights/windows quit working and the truck ran rough. I have a Banks system and it registered a code 33. Maybe 32 error. Book says it is an airbag deployment. They did not deploy. So I drove out of the field and turned it off to see if that would reset the gauges. No, not only that but the gauges all swept the faces from off to full to off and the truck would not start, just chatter.
I disconnected both batteries and waited. Reconnected and it started, but the gauges quit after 10 seconds..... Everything flatlined even the banks IQ. But the truck kept on running. Got back to the ranch and the batteries went flat overnight... Charged them up, starts fine gauges work but alternator puts out 11.5.