I've been using the 'special' plastic ring tool to try and separate the lines from the filter, but with no joy. I can feel the tool compress the spring(?) on both fittings, but no matter how hard I am able to pull the lines won't come off.
View 10 RepliesProblem started when the fuel supply was low, she had to floorboard it to get on the interstate, keep getting cel, misfire #4.....I replaced fuel filter, had a little water causing the plug to arc....had a mechanic replace the plug.....at startup cold, cel is off and it doesn't miss, after it warms up, light comes back on and starts to miss. I have ran every type of fuel cleaner in it, even used a three step cleaner for throttle body, vacuum system, and tank. I just poured sea foam into the tank and trying that, I noticed a gurgling noise when I removed the gas cap. I'm thinking #4 injector is stopped up.. I recently replaced all the coil boots.....kept getting condensation in the boot (she has been washing the underside at the car wash).....the truck has the 4.6 and has 85,000 miles, it is an 07 sport trac.....
View 2 RepliesDo you change when you change your oil, or at what interval? How often to change fuel filter?
View 14 Replies2002 7.3 liter. I tried to change my fuel filter, but the cap is stuck. I completely striped the socket on top of it. How to remove it? I tried Chanel locks.... It won't budge.
View 6 RepliesI am getting ready to change the fuel filter on my 2000 and I was wondering how to get the filter out of the medieval looking cage that holds it to the frame once the lines are disconnected. I figured I'd seek some knowledge before messing with it and breaking something.
View 8 RepliesI could smell fuel so I popped the hood to look for a leak. On top of the filter housing cover fuel was puddled in the little nooks and crannies of the black cover and some had leaked over the side into the valley between the heads. Is this a common leak? How in the world did fuel get on top of the cover but not on the hood insulator cover?
Also, just bought this not too long ago and the po said he had just done the fuel filter service on it. The gasket seemed pretty flimsy and weak and didn't really fit the gasket surface. Although I'm used to my cummins powered trucks and they use a o-ring to seal the housing cover. 2001 excursion 7.3
Have had my Excursion for a few weeks now. Took it to the dealer for some maintenance on the brakes. Had them do oil and fuel filters while it was there. Dealer calls to tell me that the water drain valve had broken off when they tried to drain water and the needed to replace the housing. Picked it up today and this is what they found when they pulled off that assembly...
View 11 RepliesAfter replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesDumb question but how do I remove the air filter intake from the turbo Its a little oily there from a fuel or oil leak but I dont see a clamp holding it on the turbo?
Also what is the e clip? Is it the little thing holding the wastegate rod on the exhaust turbine? Can I just pull the rod up off the clip?
I am trying to remove the lower half of the air filter. How do I do that. I removed the upper half , the air filter and the snow screen. The lower half moves in its place but does not come out. Is there a special procedure to remove it ?
View 1 RepliesI have removed this filter before but last oil change I took it to a garage as it was too cold for my liking to change oil. The cap is now stuck on very tight. This one has a plastic 27 mm lug on top with an arrow clearly pointing clockwise. I am assuming that means to turn clockwise (or reverse thread) to remove it. It simply won't budge.
I read the post where someone broke the plastic top on the housing and I do not want to have that happen. How to confirm that the oil filter top is reverse thread?
I have a 95 F150 4x4 reg cab long box with a 302 V8 and dual tanks... I was driving around yesterday when my truck started to lung and then the motor stalled... when I stopped moving I tried starting the truck and it started with no problem, so as i kept on my way, about 5 minutes later the same thing happened and it stalled again, (I have an automatic by the way). but this time before it stopped moving i pump the gas a few times and it fired back up and then stalled again... i switched from my front take to by back maybe thinking it could me my fuel pump in the tank but it did the same thing again about same time later... Would it be my fuel filter on the frame (like in line fuel filter) or why is it doing that? its EFI by the way.
View 14 Replies2002 E-250 with the 4.6 V-6. Pulled the 30 amp fuse, replaced the fuel filter, replaced the fuse, now the truck wont start. Checked the fuse and the kill switch under the passenger kick cover, all ok. Cranks and cranks but wont fire. No problem prior to changing the filter. Even swithed out the relay with another, no luck.
View 4 RepliesIs it fair to assume that my filter is clogged when I turn over the engine and fuel does NOT come out of the filter with the uphill line disconnected. I was able to disconnect the rear line from filter and fuel DID pump out of line when I cranked it over. Been dealing with a crank no start, I'm in the process of trying to test my CPS properly but not sure if I'm testing it right.
2000 f 150 4.2 v6 232,000 miles....
I'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister, there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one. It's a 2007 Ford 4x4 6.0 diesel.
View 2 RepliesI have a 94 F250 5.8 liter with 96K miles. Can I remove the fuel rail and clean or replace the filter that is placed at the top of the fuel injector?
View 10 RepliesChanged fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 RepliesI have a 77 f-250 with a 460 engine and a 4bbl Motorcraft carb and its leaking a substantial amount of fuel out of the newly replaced filter that is attached to the carburetor. The fitting is tight and I even tried buying some small gaskets to seat it, but that didn't work either.
View 1 RepliesI have a 2010 5.3 silverado, extended cab 2WD with 100K Miles on it. It's time to change the transmission fluid and Filter. It looks like there is an exaust pipe that runs about 3-4 inches under the transmission pan. Can I drop the pan without removing the exhaust pipe so i can change the filter?
View 2 RepliesI have a very slow fuel drip off the housing for the fuel filter on the engine. Can't see where it's coming from. It started sometime after I changed the filter a couple of months ago.
View 5 RepliesI had my fuel filters changed at the dealership today on my '15, and then I bought fuel and headed home (70 miles). About half way home I got a "Low Fuel Pressure" message and a little while after that "Reduced Engine Power" along with the check engine light.
I pulled over to see if they did something like leave the drain open, thinking it might be sucking air. Of course it was dark and I could not see anything. However I did hear a buzzing sound and could feel a vibration when I touched the fuel line going into the top of engine filter.
While it is possible I got bad fuel, I suspect they did something wrong installing the filters. Even after cycling the fuel pump multiple times they had a hard time getting it started afterwards; I think they finally disconnected the top fuel line to bleed the air out.
I continued home and made it, but not sure what to do now; its 70 miles back to the dealer.
What is the most likely problem? Improper fuel filter installation or bad fuel?
Should I pull the filters in the morning see if there is something obvious like an out-of-place gasket? If so, top or bottom filter?
Is this a tow truck affair or should I drive 70 miles back to the dealer?
What the heck is the buzzing sound?