Leaking from the top, right center. I taped over the brake light, still leaking. Not the gasket, any water sources others have found? I guess it wasn't a problem its first 8 years of life in the Arizona desert, but I bought it and brought to the wet northwest!
View 6 RepliesRear lift gate refuses to stay up in cooler weather, cylinders must have leaked down.
View 14 RepliesMy mother-in-law has a 2003 Escape with a V-6. For the last week the rear lift gate and window will not open. Tried the door key and the driver's side door unlocked. Turned the key again within three seconds (according to the operator's manual). The two lights flashed, the remaining doors opened except for the rear gate. I pressed my ear to the gate and it sounds like it is trying to release the locking mechanism. Any recommendations?
View 7 RepliesHow to remove inside plastic of the rear lift gate? Want to remove a few dents.
View 6 RepliesI have a 2009 Saturn Outlook. The rear lift gate does not work anymore, as a matter of fact it tries to slam itself shut whenever it is lifted. I am not extremely mechanically inclined but I can do minor repairs so I also need to know if I can fix this problem or need to take it to a mechanic.
View 3 RepliesMy 2010 RX350 (~30k miles) recently has been making a squeaking noise when I close my rear lift gate. Sounds like the squeaking is coming from the left side "Rear Door Hatch Support" ..i believe that is what it is called. Is this something I can WD-40 and lube? Car is under warranty..
View 3 RepliesI took my wife's 2010 tig for a drive after washing it this morning and noticed water on the rear window so I turned on the rear wiper. Well, to my dismay, the wiper didn't clean the water off because it was on the inside. I noticed water streaks on the inside part of the rear window a few weeks ago but I figured it was from condensation. It wasn't one or 2 drops, it was leaking down across the whole back window. I assume it is a seal but wanted to see if this is an identified issue.
View 2 RepliesI took the 88 out yesterday (3.0 with rebuilt transmission).. it looks like there is transmission fluid on the back (spots all over it).. I can only assume it's transmission fluid... I tried to wipe it off... but it was kind of a mist.. I assume the modulator should be checked? I'm not sure where it is or what it looks like though...
View 14 RepliesI'm going to be installing an 8" lift on my excursion and I would like to add a rear sway bar.
I cannot find any info on the hellwig if it works with lifted excursions or if I need extended links, which I also cannot find for an 8" lift
I found front sway bar end links for 8" lift but the rear is really frustrating me
I know 4" is still good, as that is what my 05 had. Just curious about my 00. Locally a guy is selling a pair of fab tech 5.5" front leaf springs. Just curious if I went that high if the stock drivelines would survive? We do not have a driveline shop on the island, so I would like to go as high as I can, without modding the drivelines. If 4" is all, that's fine. Just curious!
View 14 RepliesMy lift gate handle has come loose for a second time. First time epoxy was used and that worked really well since the contact was plastic and it Broke. This time it's more loose and afraid if I use epoxy again in same exact spot it won't. Adhere the Same?
View 5 RepliesI have a new RX 450h with 3500 miles on it and the lift gate is not working. before I drive 100+ miles to the dealership?
View 5 RepliesMy power liftgate recently stopped working. The motor seems to be working but the motor will only move the gate a ltittle bit, then beep and stop. It does this regardless of which buttons I push or manually move the gate. I have no issues with the lock function. I can't seem to find out where the sensors are as I want to try fixing those first.
View 2 RepliesWe're coming up on 36k miles and it will be a real hassle to get it into the dealer before it reaches the end of warranty. The lift gate is rattling horribly (my 8 year old diesel truck is tight compared to this car). Is it worth trying to get it into the dealership for this or would I be wasting my time because they can't do anything about it anyway? Or, is there a fix I can do relatively easily myself?
View 2 RepliesI just replaced the battery, and since then the electronic latch for the lift gate will no work. The only way I can get it opened is from the inside using the access hole and a screw driver. I have checked the fuse and it is good.
View 1 RepliesI forgot I had my lift gate open and backed out of the garage...crunch! Broke off the plastic air spoiler thing. It was attached with some kind of adhesive covering 5 bolt heads and a snap on grommet at each end.
I drilled out the old adhesive on the plastic panel and chipped it off the bolts. I hope I can get two new plastic fasteners at Toyota or a body shop. Question...should I just use a two part epoxy (or what else is recommended) on the bolt heads to mount it again?
One of the interior handles for the liftgate broke off. I removed it. From what I can tell, this handle is molded to the interior trim part.
I'd like to glue this piece back on, rather than having to purchase the complete lower trim piece.
What is the best type of glue for this plastic?
I bought a used 2001 Excursion. Neither of the middle row 60/40 bench seats will lift up.
The 60% (wider) bench seat lifted fine a week ago. Then I installed two car seats above them, drove it for a week, and when I took them out and tried to lift that bench seat, it seems stuck. I pull up on the lever, but the seat won't lift.
The previous owner re-upholstered the seats before I bought it, and there is no opening in the new upholstery for it even to latch into the base. So I'm very confused how it could be locked.
Similar story for the other 40% (smaller) seat. We actually just lifted this seat up and cut out holes in the new upholstery so that it could lock into the base. And when we finally pushed it down and heard it lock, after that we could not get it to lift. We pull the latch up and hear it unlock, and we can feel underneath that it is unlocked. Yet the seat will not lift.
I'm pulling with all my strength, but the seats are stuck.
I have a 2003 Excursion 4x4 Diesel 6.0. I want to do a lift of 2 inches with 18 inch wheels and 33 inch rubber. What is the best and most affordable way to get that done? The lift kits are at least a grand and that seems crazy for a 2 inch lift. I want to continue to park the scurge in the garage. So 4 inch is probably pushing it for garage access. My garage is 81.5 inches tall.
View 14 RepliesSo I have the option to get a bds 4" lift for about 325 brand new from a friend.
Hard to pass up that deal but I really need like a 6 to 7" lift.
Is there anything i can add to get a few extra inches? Shackles?
I do NOT go off road its just for street use, and I only drive it maybe 4k a year if that.
I have a 2003 excursion 4X4 on factory 16" wheels. I want to keep my same wheels. Want to install 7" lift. How big of tire can I go? I was looking at the 345/75R16 and 365/75R16 BFG Mud Terrains. Not many manufacturers are making big tires for 16s. I want to go as big as I can without cutting or spacers. Will NOT put any type of Super Swamper. This truck will never see mud.
View 5 Replies