Our headlights work fine in regular mode. when we turn on the brights only the left side is working. I thought it was the bulb, but replaced them this morning. Still having the same problem. Thoughts?
View 3 RepliesYesterday my 2003 VW Golf TDI turn signals stopped working. The hazard/emergency lights do work. Also, when I push the signal lever forward the brights don't engage. Does this sound like a bad relay or blown fuse?
View 6 RepliesI'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 RepliesMy trailer left turn signal and brake light stopped working. The running lights work on the trailer. The lights all work on the truck. I am hooked up to a 2007 F150 and it all worked 'yesterday.' not sure where to start.
View 6 RepliesI realized my horn is not working. I also realized that the left side turn indicator (blinker) light is not working and when I popped it out I saw the wires were chewed up, I am not sure what happened. Do you think I need to remove the wheel well liner to try to access that area? What to do?
View 14 RepliesI have a 99 Camry and have two issues:
The brights don't work. After doing some research, I reached the conclusion that it is the dimmer relay, however I noticed that upon unplugging the relay, the regular headlights don't work until I plug it back in. Does this mean the relay is good, or is it just that the car is set up in such a way that if the relay isn't there, working or not, the lights won't come on? I know you can test it with a voltmeter, but I don't have one and the relay doesn't have a wiring diagram on it, so I'm not sure which two of the four plugs you'd use to test it. Worst case, I'll buy one off ebay and just send it back of it doesn't work, I just wanted to ask before I did that.
The front, right turn signal does not work. I tried a new bulb, that didn't work. The rear right signal works fine. I was told to try using tweezers to pull out the tabs in the socket in case one was stuck somehow and not making contact, but that didn't work. Did some research, but this is apparently a fairly rare issue. Someone suggested I get a metal file and file off the tabs to remove corrosion, so I wanted to get a second opinion on that, plus I'm not sure how to go about doing that. There is no easy way to pull the socket out, far as I can tell (unlike the headlights), though I suppose I could try without undoing anything if I really had to.
Well now I have to replace the multi function switch due to moving my steering wheel and the headlights sometimes working and turning signals not working. I saw a great video on youtube about changing a Multi Function Switch and it shows where the air bag needs to be removed. I was hoping that since my truck is an older 1997 F250 LD I wouldn't have to remove the airbag. Is there a way to do this w/out messing with the airbag on the 1997?
View 1 RepliesI have a 2003 Ford Excursion Eddie Bauer 6.0L that I bought and noticed the headlights are not working.
The brights come on when I pull back on the signal lever. However when I push the lever forward the headlights do not stay on. In order to get home last night I wedged a dime in the lever space to keep the brights on so I had light while driving.
Brights work with lever pulled back. Headlamps do not work on auto, or manually turning on. FOG lights do work correctly.
Reverse, Turn signals, Hazards, Break lights, and amber front signals all work as they should. The low beams do not work at all.
I'm looking to replace the headlights and turn signals on my 2002 Excursion - I've seen loads on Ebay, but don't really know how to tell what ones are ok? I like the chrome style, and like the led lights too - but mainly I just want the front of the truck to look more modern (I am buying the 05 style grill too)...
View 10 RepliesI got my headlights swapped but the turn signal sockets can't go into the housings. The old bulb socket thing is a 90 degree twist in and it would twist in if there was room for the socket to twist. The back of the housing has a blocky lumpy thing in the way and I need a straight in socket I guess.
View 14 RepliesI have searched the Owners Manual, forum and internet about this, but I can't come up with a solution. Perhaps I am not using the correct terminology. I also have an ALLDATA DIY subscription on this vehicle, but I could not find any instance of this occurring to be able to troubleshoot. I though that there might have been a light out somewhere.
View 2 RepliesI have a 2000 Excursion lifted 6 inches with 35" tires on 20" Fuel wheels and i notice when I make a left or right hand turn between 10-20 mph i get a single pop or clunk from the front end.
Also one more really annoying thing while i am turning there is creaking, sounds like body flex? maybe body mounts? Any issues with ball joints?
This label is on the left side of the radiator support of my 04 Excursion, 6.0 PSD. What this means?
[URL] .....
Had a grinding noise in my front end, left side. Found the hub was bad so got it replaced. Now I still have a grinding noise that comes and goes. If I hit a bump, it starts the grinding noise but nothing constant. Had the front end checked and nothing was obvious. Was trying different things and when I put it in 4WD, with the switch on the dash, the noise goes away. What to try next?
View 2 Replies My truck is a 2004 F150 XLT, 4.6L 2 wheel drive extended cab
The truck starts fine. With no lights on, heater/ac blower turned off... my turn signals and hazards work as they should.
If I turn on my headlights, I have no turn signals and the indicators on the dash are slightly lit up along with my highbeam indicators. The actual dash lights do not come on.
The blower does not work at all regardless of whether the lights are on or off. Turning the blower on immediately creates the same issue as the lights. (no turn signals, slightly lit up indicators, etc). The blower does not work on any speed. I can hear the duct work changing direction behind the dash as I move the blower selector from dash to windshield to floor, etc. I can also hear the compressor kicking on for the AC.
What I have done: I have checked all the fuses. I have attempted to remove every one of them while running to see if anything shutting off would let the blower kick on. I have unplugged the blower entirely wondering if there was a dead short. I have removed and unplugged the resistor to see if that might be an issue. I have also removed the right side kick panel and checked the ground wire there that runs to the dash. Everything so far seems to be in good order.
I'm having problems with my front marker lights. The turn signals work but when I turn on the parking lights or headlights they don't work. They only work with the turn signals. And I can't get the front side marker lights to come on. I've tried everything...
View 2 RepliesI have a 97 Buick Regal with turn signal issues. The left side will not flash but stays lit and the right side flashes fast. I have the problem isolated to the Daytime Running Light Module. (replaced turn signal stalk, flasher and bulbs). I ran a jumper wire bypassing the module and everything works as it should. Do I need to replace this module, or can I simply bypass it without it messing anything else up. I don't want my horn going off when I change the station on the radio.
View 1 Replies2003 Ex rwd 6.0l 125,000 miles. The complete rear left side door is stuck shut and has been for about 6 months. This is not a side door, but the very back where the lift gate is. I sprayed wd40 in there, nothing. It won't budge. If its a broken cable inside, how to I take off the interior door panel to get to the access holes and actuator on that door or both doors on the tailgate?
View 11 RepliesAlright i have one here to stump everyone.... My uncle called me and his 05 f150 STX left speakers both front and back aren't working. I took a look at it the other day, i switched his radio with my radio from my 06 f150 stx, then I switched my front speaker out. Didn't work. I looked at his back speaker and the magnet on the speaker was stuck in the door. I checked fuses and don't see any blown.
View 1 RepliesI have a 2006 F150 and the left rear turn signal and brake light has quit working. Also the license plate lights do not work. The cruise will disconnect when signalling a left turn. I have checked fuses and bulbs and the wiring/connector at the multifunction switch with no luck.
View 2 RepliesI started my car yesterday and noticed the headlights, A/C, defroster, turn signals were all not working. I checked the fuses and they're all fine. Checked other posts and it looks like the common denominator is the ignition switch. (Looking for pics) how to change out the ignition switch? And what is the level of difficulty?
View 1 Replies