I have a 00 Ford Excursion and only heat blows out of the front vents, the temp control doesn't work at all! The back has it's own controls and will come out cold (not a/c just the outside air) when the front is on (blasting heat). What this could be?
View 10 RepliesJust picked up an 87 150 and have found the following few problems. (Chilton no longer has a "troubleshooting" section...taking that POS back). Anyway here we go... No heat. AC blows cold, but there's no heat. Possible problems and fixes?
View 9 RepliesI'm having with my truck. During a drive cross country my heat started to go from hot to mildly warm to cold in probably 5 hours. After stopping I checked my coolant level and it was empty. I do have a leaky head gasket and have driven about 18 hours so I'm guessing that's where it went. I could not find a leak anywhere. I filled it back up and left the cap off the reservoir to let any air work it's way out. My heat still blows cold as ice but if I shut off the heat completely and wait ten seconds then turn it back on it will blow warm air for maybe two seconds. What this could be?
View 3 RepliesThere used to be a audible pop in my stereo speaker when my heat would kick on. Now there is not. My heat did this last winter around the same time. I checked Fuses. The blower blows, but it just blows cold air. It could be a thermostat, or a clogged heater core. 1997 Ford Ranger 2.3L ...
View 2 RepliesMy brother-in-law has a 97 F-150 with 4.6L that has no heat in the cab (blows cold air no matter what setting at HVAC controller). Heater core was replaced one year ago and T-stat was replaced last night. Coolant level is full and the heater hoses are BOTH hot so I believe warm coolant is flowing through the heater core. I am thinking that the HVAC controller may be at fault or maybe the mixing door in the HVAC plenum is malfunctioning. I have 97 rangers that had a broken hinge pin for the mixing door inside the plenum (a common problem with these trucks), maybe this is the same issue (I don't know). I am taking the whole dash out to see what the trouble is.
View 9 RepliesOn occasion the heat on my mk6 golf will start to blow cold when turned to the max click. Turning it back one click will cause it to start to blow hot again.
Friend at the dealer said he thought there was a software update for the hvac controls ....
My daughter has complained about periods of no heat- fan blows but cold air. Next time the heater works fine. She is keeping coolant level up but does need to add a bit (pint or so) say every other month. Last week during the Chicago snow storm she called and told me the heater (which had been working) blew a bunch of "smoke" into the car and onto the windshield and windows which then froze solid. I assume the smoke meant steam and she did say it had a sweet smell when I asked her.
Car was towed to a SAAB dealer who ran the car for a couple hours and found no issue and then drove the car for a period with no issue. I had my local mechanic also check it in the past for no heat and it also worked fine then. Only thing I can think of is that there might be a small/intermittent leak in the head gasket with an exhaust bubble forced into the cooling system? That does not explain the steam in the passenger compartment though. Could it?
I have no heat in the LS at no settings. The AC runs good but does not seem to be regulated as it blows cold at any temp setting. The fan responds to settings but i still get no heat even with the AC turned off. I would like to find a diagram that shows the locations of the bleed valves to start a coolant air bleed.
View 13 RepliesHeat blows warm at best and A/C isn't all that cold. I want to believe its a blend door issue and dive into it this weekend and fix it but there isn't a single piece of foam coming out of any of the vents. Of all the systems on the car, HVAC isn't my cup of tea I don't know anything about it. What else could be the problem? I can live without A/C but the heat things must be fixed.
View 4 RepliesAt 145k my radiator seems to be leaking. Eventually I'll be at the point where heat blows ice cold. Where should I get a radiator?
View 4 RepliesMy g/f's 98 Passat 1.8T has been pretty bad on being able to blow hot air inside, and now that its colder out its even worse.
Ever since she got the car, the coolant temp gauge is always at it's coldest, so I'm thinking its time for a greentop sensor. Her coolant right now is a lil low so, in the meantime, I'll be headed to the dealer to get both a new CTS and some G12.
Her fan does blow air, but could there be anything else wrong that would keep it from blowing hot air?
The heat up front blows nice and hot but no matter how I adjust the rear ceiling mounted controls it blows cold in the back. Is this a blend door issue or something with the rear controls? Also, on a side note, one of my rear power vent windows just stopped working too. I guess it's either the overhead switch or the motor back there.
View 8 RepliesBought new oct.2012. Fiirst time used heat blows cold from one side hot from other. not consistent, will vary from left cold, then hot from right or the opposite. been fighting with chrysler from then till now. engineers know problem exists and are working on a fix. haven't found it yet. contacted chrysler numerous times, just get passed from one to another.
View 2 RepliesI have a 2002 Dodge Durango and the rear passenger air blows cold only - was fine last winter. Neither the passenger or the driver controls will get warm air to the rear via the overhead vents. Warm air comes out under the front seats to the rear only.
View 1 RepliesThe front a/c blows cold air but the 2nd row and back blows warm. Yes the temp dial is on cold on both dials. Is there a separate a/c clutch that I dont know about to ck the air gap? Is there a separate port to put freon in besides the front. I need to get this fixed because with my bulldogs in the back the heat will kill them.
View 14 RepliesMy 2009 silverado ltz is haveing heating issues. when you first start truck all work fine. After a couple min the drivers side vents loose heat and blows cold air. the heat on the pass side works fine. then the vent will change to defrost even though the display still shows its on vent. the only way to get it back is to mess with the vent control. then it will last about a min then back to defrost. at this point i just turn it off. I have already replaced the control panel to no avail ...
View 1 RepliesI just bought an 03 Ex that hadn't been driven but 600 miles the past three years. Needless to say, there's probably some sludge causing issues somewhere. I have a Scangauge installed, which has been very useful thus far.
I've flushed the coolant, currently with distilled water, changed the oil and filter, atf and filter, and installed my 2nd set of fuel filters after getting stranded after I ran my first tank of fuel through it. After changing the fuel filters the second time, I was still having cold starting problems, requiring 3-4 long cranks before firing. Once warm, runs fine. I just installed a FICM from Diesel Tech Ron, but I still have to try 3-4 times to get it to cold start, then it runs and starts ok. Not sure why the hard cold starts...
Also, the heat doesn't work. A/C is fine, blower is working. I installed a new thermostat, and like I said, I have flushed the coolant with tap water and now distilled water, but didn't want to pour in fresh coolant just yet, in case I have to drain it again with this heat issue. That vc7b is not cheap. Tonight I drove the truck about 20 miles and my highest temps for EOT was around 215 and ECT was 205. Fluctuated between the the mid 190s to low 200s most of the time, this was over some hilly roads with no load or anything. Anything else I can monitor or check on in the mean time?
2003 f150 lariat FX4 5.4L ... The heater only blows on defrost, Which vacuum line controls this? is it the black one that runs through the fire wall? What else can I check to narrow the problem down? this truck has the push button/digital controls.
View 7 RepliesI have an 06 F-150, there is lots of heat but it only blows on defrost. Is this the blend door motor or is it something else?
View 6 RepliesI have a 2002 Ford Ranger 3.0L truck that, all of a sudden, has a problem with the HVAC system that blows air only thru the defrost vents even when selecting any other vent levels (defrost, face/middle or floor levels).
I did find a thread on another forum regarding this problem, only it was for the 95-01 Ranger model years, yet they say that the 2002 Ranger is not the same as those earlier models.
Either running A/C or heat.. air only blows on the '2' and '4' setting.. so I have middle of the road or WOT when it comes to the amount of air. On the '1' setting nothing comes out and '3' setting is the exact same at the '2' setting. What is going on with this.
View 3 Replies