Ford Excursion :: LED Marker Light On Mirrors Quit
Apr 30, 2012
I have a set of Tow mirrors off a Laredo on my EX (they are the rounded ones and not square). They have the built in LED Turn Signals and (5 LED) marker lights in them.
The Driver's side marker light has quit working but I still have power to everything in the mirror. It was working but only on 2 of the 5 LED's. Now they are all not working.
Successfully "remove" the LED housing that holds the Turn Signal and Marker lights from the mirrors to repair or replace them? If they are removable, how do they come out? It looks like they just "snap" in place but I'm afraid to pry on them for fear of breaking the plastic leans....
View 11 Replies
Advertisement
I was going up a little grade a couple days ago and the engine suddenly quit, the temperature and oil light came on, the heat gauge buried on hot, and it threw a code. I pulled over and it was still idling so I made a U-turn but it was in limp mode and would only go about 10 MPH, so I made it home and put water in it so it's good now but it still says service engine soon. What is the code going to say and am going to have to pay to get rid of it. (the light). I have a new cap coming.
View 14 Replies
08 F-350 Lariat. Folded mirrors in twice today. Second time they would not come back out. After four hours the fold function has not returned. As I read Owner's Manual, if it's a fuse it should take out power to driver's seat . . . correct? All other mirror functions including telescope seem to work normally. So if I've identified the fuse correctly what else could it be? Fold relay? Switch? Where is the fold relay located and how can one test it? What pins on the switch are the fold pins? I just looked at power distribution box schematic. Power fold mirror relay fuse is there. Apparently the only function it has. Better go check it out.
View 5 Replies
I have a 2005 Santa Fe, and both power mirrors quit working at the same time. I plugged in a different switch, and still nothing. I checked the 10 amp fuse under the dash and that was good (is there a different one). The locks still work though.
View 3 Replies
All at once my power locks and windows on all doors and the power mirrors quit working. The Driver Info center also says "Unknown Driver" when I start the car. After that happened the check engine ligth came on and when I went to get that checked there was no power to the ODB port (not sure if it is related or separate). Also, the brake, ABS, and traction control lights are on...they have been so I'm sure that is a separate issue.
View 1 Replies
I just swapped out my heated, lighted flag mirrors for OEM take off heated, lighted tow mirrors. I used the Ford adapter pigtail so it was a plug and play installation. The mirrors adjust but the turn signals don't work. The flag mirrors worked fine. I can't tell if the defrost works or not with either mirror.
View 14 Replies
My driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 Replies
I have searched many threads and seem to be confused. I have a 2000 excursion and unsure of exact plugs. I currently have the paddle mirrors that are heated and powered, and want to get the tow mirrors with heat and power. They don't need to have signals or power telescoping or folding. As long as they can manually fold. What is a good reliable mirror that will fit what I need?
View 14 Replies
I recently bought an 02 Excursion. The front seats have been swapped to Lariat seats. (I'm assuming to get the 40/20/40 seats which I love considering I have 7 kids and need to haul 9 people.) When I bought it I noticed right away that the power mirrors don't work. Noticed a few days later that the rear speakers weren't working either. Under the driver seat (its power and heated seat) I found the connector that went to the rear audio controls on the previous console.
I spliced the wires for the rear speakers and they are working now I tried replacing the switch for the power mirrors and still nothing. Could this problem be related to the seat swap or is this a total separate issue? I've got to get a new test light to check for power to the switch...the bulb is blown in mine. Assuming that I check the power wire (orange w/ light green, right?) and it is fine, what's next?
View 3 Replies
Ok, so I picked up some Recon clear lenses because both my amber lenses had cracks in them, and because I think they really cool.
I can't get these damned mirrors apart. According to the directions you shove a screwdriver in the three tabs behind the mirrors and push down and presumably out to separate the skin from the mirror. Problem is, I push down and out and nothing happens. Is there an order to this or what the heck am I doing wrong.
View 9 Replies
I added signal paddle mirrors on my 2000 Ex. I found the left and right turn signal wires under the dash. The mirror led signal arrows light up but they do not blink. Do I need a separate relay or am I just missing something here? I did a search about adding mirrors and extra wires but nothing is mentioned anywhere about the blink/no blink remedy.
View 2 Replies
Ive got a 2004 excursion Eddie bauer and I've got the non-towing paddle mirrors with power adjustment, heated, and turn signals. I want to put the 2008 style towing mirrors on that have power adjustment, heated, turn signals, and have the marker lights but not power fold or power telescope.
How I can wire these new mirrors to my factory wires? I understand that the marker light may have to be separately wired in, but all of the other functions I want to wire in to my existing wires.
View 7 Replies
I have the small single heated mirrors on my '00 Ex. This is what I would like. To do the mirror conversion with the newer square signal/heated mirrors as easily as possible as I am NOT a mechanical genius by any means. They do NOT have to power fold OR power telescopic as my garage is large enough for my '11 F350 King Ranch to fit without folding them in. But I would like to find a direct easy plug n play type conversion for the signal and the power and heat to work. The EX just looks so dumb with those small mirrors and I want to see what's going on behind me.
View 3 Replies
Bought some power tow mirrows, aftermarket, any special on installing?
2011 F150 Echoboost, 4 x 4
View 4 Replies
I'm replacing tow mirrors on my 2004 F250 with 2008 mirrors. Both are factory Ford mirrors. Need wiring diagram since connectors and wires are different. They both have power mirrors, turn signals, heated mirrors, but are not power retract or fold.
View 1 Replies
Just got my 2008 F250 SD and am thinking about removing the FX4 decal and the tinted pieces that go over the tops of the windows on the doors. Also want to remove the marker lights on top of the cab or maybe switch them from yellow to red (truck is red) so they blend in a little better. No "hate" to the folks running these options just not my style.
View 8 Replies
My Excursion is stuck in 2wd. It worked one morning, then it didn't that same afternoon.
I've checked all fuses that resemble a related fuse in the fuse box.
I've replaced the dash switch, Transfer case shift motor and ESOF/GEM module behind the glove box. I've swapped around the relays under the hood on the drivers side fender well.
I ran a hot & ground to the 2-wire plug on the x-fer case shift motor to have it move the ex back into 2wd (replacing the shift motor required me to manually put it in 4hi with a wrench).
At this point, I'm thinking it's a wiring issue? Where to go next?
View 3 Replies
2002 Excursion 7.3 4x4 160,000 miles trans rebuilt @100,000.
Yesterday while driving on the freeway our Ex all of the sudden felt like it was in neutral. Coasted to the side of the freeway, it would not move in any gear including reverse. There were no bad noises/sounds or anything like that.
The Ex ran great before this, with no signs of the trans going out. My question is what could cause the trans to go out all at once, sure doesn't seem like something was wearing out.
View 12 Replies
My 05 has always had good air conditioning front and back but around three weeks ago it quit blowing cold. I found all the 134 had leaked out through a pin hole in the aluminum line that runs down the back of the engine to the rear ac unit. I removed the line and brazed the pin hole. So I reinstalled the line, put a vacume on the system for 20 mins then let it sit for another 20 to make sure I had no leaks. All seemed good so I re charged the system. Now my front blows nice and cold but the rear is warm?
My pressures at idle are around 40psi low side and 200ish on the high side when the engine is warmed up and the ambeint temp is around 74 f. If I turn it to the warmest setting for the rear it gets noticeably hotter so I'm thinking the blend door is working properly?? I've read that the thermal expansion valves can give some trouble so I pulled the jack and cubby out to gain access to it. I tried tapping on it with no gains. Also the top left line seems to be pretty cold coming out of it too the evaporator but the line coming out of the evap is room temp. I was very careful not to let any junk get into the lines when they were apart for the line repair but I'm thinking maybe some junk has plugged up the TXV?
View 8 Replies
I have checked the fuse number 38 and it's fine, and I've also checked the bulbs and they look good. Where else do I look to check for problems with my reverse lights not working? I just had my transmission rebuilt, and wondering if a sensor or something went bad?
View 1 Replies
More electrical gremlins. The car is a 2000 1.8t, it has had some running issues since I got it a few weeks ago. I replaced the ECM (had water damage), fuel pump relay and battery and it was running fine all week, my wife went to start it after work and it died when she took the e-brake off. I went to her work to get her and noticed the rear marker light was on when the car was running. Got the car home and now it wont run for more than about a minute and the light comes in when the fuel pump is running, turn the key but don't start the car and the pump and light come on for a second and go out. Start the car and the light stays in until the car dies.
Is there anywhere in the system these two circuits are connected? Do they share a load relay anywhere?
View 13 Replies
