Ford Excursion :: Key Fobs Stopped Working
May 28, 2009
My Mom used my Ex to take the kids to the park today. When I went to unlock it with the fob.... NOTHING! I thought maybe a bad battery, but when I got home and tried the other one it didn't work either. Is there a fuse or something that would have gone bad? Everything else in the truck is working fine except for the remotes.
View 13 Replies
Advertisement
I've got a UK 2003 Phaeton (78Kmiles). Picked it up 6 months ago and have put 8K miles on it with no issues at all until...
The key fobs just stopped working. Car was supplied with two fobs and both stopped working. Replaced the batteries to no avail. Press any of the buttons = light on the key works but the car ignores it totally. (even right next to it)
I can use the key for entry / lock /,alarming, but it's really not cricket for such a fine automocar.
View 12 Replies
A few months ago I'm key fobs stopes working the I switched out the batteries and still no progress. What it could be?
View 3 Replies
My overhead with temp, compass and mpg stopped working.
View 11 Replies
I have a 2000 ex with the 05 front end. My headlight on the right side stopped working I have the high just no low. I replaced it and still no go. I suck at wiring so what to look for..
View 3 Replies
My A/C has just stopped working and I am looking for some pointers on how to diagnose the problem. The vent and blower still works, just no cold air coming out? Where do I start?
View 10 Replies
2003 Excursion 4x4 Limited v-10 gasoline engine powered
gauges stopped working
gauges dead
gauges not working
gauges
Coming home tonight, I lost all the instrument cluster gauges. Speedometer, tachometer, fuel, oil, temperature and transmission temperature.
So the logical thing to do was check both instrument cluster fuses, fuse 35 and fuse 41. They were both OK.
Kept looking and found fuse #45 blown, it's the "Ignition switch Run/ Start feed" fuse. It was blown.
Popped in a new one and gauges came back to life. I don't know why fuse #45 controls power to the instrument cluster gauges. Strange.
View 13 Replies
this thing stopped working on me today, can i fix it? or how can i get another one?
04 Ex
View 14 Replies
All five clearance lights on my cab stopped working, and I can't figure out why. I've read all the threads, but few show the wiring, and are more useful for installing than troubleshooting. I think I have the Ford SKU'd ones, not the Recons, but I can't say for sure. Here's what one of them looks like:
My questions:
1) How do you remove the bulb from the rubber mount? Just pulling it out didn't work.
2) Is there a fuse somewhere (in the harness, perhaps?) that protects these things? All my overhead console functions and lighting work fine.
3) Is their only connection to the vehicle wiring at the harness connector behind the passenger kick panel? I checked it, and it is well connected.
4) Is there a connection on the headlight switch? I've not checked there.
I bought this vehicle 14 years ago and they were already installed, and have worked perfectly since then. I hate stuff that doesn't work...
View 6 Replies
Having this issue and what could be the solution?
View 8 Replies
The water level is up, the heater hose is hot on both sides of the heater hose bypass valve, the MtrCrft thermo is pretty new, but it blows cool air out the vents even after a half hour of driving. It was working great last week and then nothing. I guess you can see the blend door moving if you pop the glove box out?..........haven't tried that.
View 14 Replies
My keyless keypad has stopped working on my 04 Excursion, what could be wrong.
View 7 Replies
One day it work and the next day it didn't. I checked the 15a fuse and it was good. What else should I be looking at?
View 12 Replies
I have a 2000 Ex V10 with 170,000 miles and the passenger side headlight stopped working. I changed out the bulb and when that didn't fix it, I changed out the harness.
The driver side headlight works fine as well as all of the other lights. What to look at next.
View 5 Replies
I replaced the batteries in my key fob yesterday, and now it doesn't work. My car has no accessible exterior key holes, due to the trunk lock being seized as long as I've owned it, as well as the drivers door lock having the exterior plastic cap(is there a lock still hiding under there?) So instead, I hopped in through the sunroof since I had left it open, and once I opened the door the alarm went off. I disconnected the battery, and when I reconnect it, the immobiliser resets. I assume that my fobs have reset, so with there being no exterior locks and no fobs programmed, what should I do? The car is not driveable at all right now, and I can't even close the sunroof in case it rains.
Some additional details:
2000 Golf 2.0 VIN WVWBA21J0YW745218
Fobs are HLO 1JO 959 753 F
View 4 Replies
I have a 2005 Excursion 6.0 ... .. A few months back the horn started sounding on its' own in the night, so I pulled the fuse... .. Then the Cruise Control stopped working. I have googled references to clockspring failure and these problems... ..
View 3 Replies
My speedometer stopped working yesterday after i replaced the 2 cruise control buttons on the steering wheel. When i connected the the battery the horn started blasting and I went over tap the horn then it stopped. Then i noticed that the horn did not work anymore. I put back the original cruise control buttons and still did not work .So know instead of fixing the cruise control buttons, I broke the horn and the speedometer while the cruise control is still broken. I checked the fuses and they all are good. What can it be ?
View 6 Replies
I have a problem with my 2007 Prius. The low beam and both FOBS for the car quit working at the same time. It worked the previous day as always, then the next morning, the car would not automatically unlock and had to use the FOB mechanical key for entry. Then I noticed that the headlights (LOW)would not turn on, but the high beams worked fine. Just an FYI I have changed the headlights on this car at least 3 times in the past 4 years.
View 7 Replies
2003 X limited, 2wd 6.0L
Last week wife's right rear turn signal/brake light stopped working. The left one flashes normally. The right tail light works fine which is a different bulb. I tried changing bulbs (didn't work).....tried a new socket with new and old bulb (didn't work). Could it be a relay? Or not relay as they would be both out (left and right)?
I looked at my trailering wiring plug down by bumper and the white wire with green stripe looks split a little towards the end. Could it be a bad ground or short in that wire? Would the trailering wiring have anything to do with it? I was going to try to replace the relay if I could find it, what is the part number for it.
View 3 Replies
2004 Excursion 4x4 6.0. I just had the fuel injectors & wiring harness replaced and it runs great, but after 30 minutes of driving the complete dash lights/gauges stopped working. I found that the #45 10amp fuse had blown so replaced it and after 20 minutes the same thing happened. While it was working all of the lights & gauges seemed to be working okay. This doesn't effect anything else, still starts & runs okay, turn signals work, head lights work, but the head light auto on/off doesn't.
View 4 Replies
Tonight the wife when she got home set the car's alarm off and after she turned it off none of our remote starter fobs will function (lock, unlock, alarm..)
The factory fobs still work fine.
Am I stuck going back to Hyundai to get the remote starter fobs fixed ?
View 7 Replies