Ford Excursion :: Installing Seat Heaters?
Dec 7, 2013
Installing seat heaters? Looking to see if any problems were encountered along the way during the install. Seems straight forward enough and there's a you tube video.
Automotive Carbon Fiber Seat Heating #ISSH
View 14 Replies
Advertisement
Truck is 08 f350 lariat with minor issues. Both seat heaters don't get hot. Click is heard under driver seat. Both dash lights come on. No heat. Steering wheel fan control won't turn fan up. Turns it down fine.
PO put aftermarket HID with ballasts and bulbs and factory light housings. Factory housings scatter light and they are waaayyy bright. Can't drive anywhere with out blinding someone. What aftermarket projectors will work with HID set up I already have?
View 4 Replies
I had my car in the shop to have the seat-back recline motor replaced several weeks ago and just noticed that the seat no longer reclines (again) and now neither of the seat heaters work anymore. The seat did recline when I left the dealer but I didn't check the seat heaters. Is it possible a fuse for the seating heat unit blew? Unfortunately I can't find my owner's manual to look up the fuse schematics.
View 5 Replies
Now that the cold weather is here I wanted to fire up the seat heater, and no heat was to be had. The buttons on the dash light up. Both seats are out. Car is a 2011 TDI with 39000 miles and the cold weather pkg.
View 10 Replies
This morning my daughter was burned by the rider's side heater in the seat. It was only set on "3". She got a burn on her hand when she put her hand down to shift on the seat.
View 8 Replies
Test drove the v yesterday. Heat from the Seat heaters was near nonexistent. They are important to me for therapeutic reasons. Any experience with seat heaters, have an issue with them or find them luke warm heaters?
View 19 Replies
Musty odor TSB. I noticed today that when my car is parked and idling my interior lights and MFD "surge" when the seat heater is on, is there a TSB for this?
View 6 Replies
I tried to pull out my sun visor one day to get more sun protection and ended up yanking it out. I put the sun visor back on and my seat heaters, interior mirror/compass, cigarette lighter, exterior mirrors, and mirror heaters don't work. I guess What do I do about these small annoying issues??
View 1 Replies
Both front seat heaters are not working on my 2009 Avalon XLS. The center console lights do not illuminate. I presume it's not the fuse because according to the owners manual the 7.5A fuse also controls dash light, power outlet and flashers and they all work. Could it be another fuse, or something else? I can use a voltmeter
View 3 Replies
I am installing a two channel amplifier and a dc to ac power inverter and was wanting some suggestions on the location. I was thinking of maybe the center console but was concerned about papers and what not I keep in there from preventing the items from staying cool.
View 14 Replies
I just got my Bosch fuel pump from Riff Faff and will be installing it this weekend.
I want to add a Pre and Post filters to the pump and had a couple of questions
1) the threaded end that's under pressure what is that connection.. I would like it hard connected to a filter and then the stock line connected to the out put of the filter.
2) for Pre Filter its a push Lock connection... Should I keep it or look for something that works better under Vacuum?
View 9 Replies
I am in the process of installing this gauge and I am having a heck of a time finding the right power points at the fuse box. The gauge requires both a switched 12v power supply and a constant 12v power supply. I am going to use one of the power outlets as the switched supply but cannot determine a constant supply without running wire all the way to the battery. Wiring and electrical stuff is just not my forte!
View 5 Replies
I just had a heck of a day. I was using my weed whacker to clean up my front yard before the city got on my case- we got a bunch of rain so the desert is oddly very green. Anyway, I was working on the other side of my yard when I hear a sickening, loud pop sound. I turn off the trimmer and go to look at the Ex, thinking a rock somehow hit the door panel pretty hard. No damage. Weird, I think.
As I'm turning around, my eyes glance up to see... my driver's side rear door window in a million pieces being held together by the tint. Holy. Dang. My trimmer kicked up a rock which flew a good 25-30 feet and shattered my door glass.
So, I am planning on ordering a replacement glass online. I's it a very difficult job? I have done window glass before, but just in old trucks and cars- 1960 Falcon, 1969 F100, 1970 F500, 1976 Jaguar XJ-12. Never did a new truck.
View 13 Replies
I came out of work to see a fair amount of fluid on the ground under my excursion (2000 limited 7.3l 4x4). So I checked my fluids and found the coolant low and all the other fluids were good,. I had some in the excursion (not sure why I had it but it was there ). Filled it as much as I could started the truck and there it was a pretty big leak from my water pump. I was able to get one (new one lifetime warranty from an auto parts place, Ford was closed) so now on my day off instead of relaxing I will be installing a water pump. I guess it was about time. I figured since I was there I might as well flush the system. How many gallons of coolant this will take to refill the whole system?
View 7 Replies
I have done a good bit of reading but am still not completely sure I understand what all is needed when installing a chip on an Ex. Looking at the edge tuner or bully dog. My question is are both of those chips integrated in the tuner? I cant seem to find the answer to this.
View 6 Replies
I'm trying to upgrade my speakers. I got the ones in the front and rear doors installed. I hoping there is a way I can access the speakers without having to completely remove all of the rear panels.
View 8 Replies
I am going to install an aftermarket gauge on my Excursion. Just would like to know the best place to install the probe. Hopefully it isn't that hard.
View 14 Replies
Im installing a set of 04 lariat seats into a 00 truck. I need to know how to hook up the heat. The power part is no problem. What I thought was right which was a separate constant 12v and a switched 12v for the module and ground apparently isnt right. If somebody could ohm out their harness on a 01 truck that would be great. As I have it right now the light on the switch comes on but almost instantly turns off.
View 14 Replies
Folded 3rd row seat down last year, need to fold up to use for passengers.
Don't remember how to fold up.
View 4 Replies
I have a 2002 ford taurus. It has the 3.0 ohv engine. The heater has quit working. I recently flushed the coolant system as well as the heater core and replaced the thermostat with no change in the heat situation. It will blow warm air for about 30 to 45 seconds then turns cool .
View 10 Replies
What the use for the flat plate behind the second row bench seat? The velco pieces are not holding this thing up anymore, is there a way to fix this or can I take it off and thow in the trash...
View 1 Replies