Ford Excursion :: Install Snaps On 2nd Row Back Seat?


Aug 24, 2012

How to install snaps on the 2nd row back seat fold down board? My just wont stay up anymore with the velcro.

View 14 Replies

Advertisement

Ford Excursion :: Power Seat Won't Move Back

I've had an intermittent problem with the driver side power seat not moving back. Can't figure out if its a switch or drive gear.

View 14 Replies

Ford Excursion :: Reading / Map Light Burnt Out In The Back Seat

I have been looking on the internet but can't really find anything on this, how do I replace the 2 bulbs that are in the back dome light? It seems like the plastic piece comes off but I don't know how and I don't want to break it

View 2 Replies

Ford 6.0L Power Stroke Diesel :: No Back-up Sensors After Remote Start Install

I have read countless threads and have done research and can't figure out my issue. Had remote start installed in the truck a month ago. The day it was installed sensors were working. I left the shop and went to back in and noticed they didn't work and the light popped when in reverse and sometime it will the random beeping. I did the check and found the inner right sensor was not buzzing. So ordered four from eBay and it still doesn't work. I even switched one of the others out thinking it was the eBay special issue. It didnt work so it's just that sensor. Now what? I have checked the wiring under the truck and it all looks good. What's my next step? Could the remote start have taken just one sensor out?

View 2 Replies

Santa Fe (CM - 2007-12) :: Headrest Of Back Seat Won't Go To Up Position After Fold Down Seat

The headrest of back seat will bend over when fold down the seat. But one of the headrests can't go back to original up position. The dealer has adjusted the cable but this just temporarily fixed the problem. The problem is back again. I will go back to dealer but can they really fix it? Should I ask for a replacement of the whole seat?

View 1 Replies

Ford F-150 (2004-2008) :: Plug Connector On Coil 3 No Longer Snaps On

I changed out my plugs. The plug connector on the #3 coil no longer snaps on. My only option is to use a small ziptie to hold it in place. Can cut it off and wired a new plug end on..

View 3 Replies

Ford Excursion :: Amplifier Install Complete Diagram?

I've got 2 amps/ subs I'm trying to install. I've got a couple of questions. How have you ran your power cable? Is there an opening or access that is pre-existing or did you have to drill an area in the firewall? With the factory head unit, which wire do I need to tap for the turn on wire? Also, just a side note. The second row headrests have been replaced with monitors which I plan on removing. I'm assuming they have some type of power cables already ran for them? Would they have the turn on wire as well? I haven't had time to see how they're wired up yet. If the wires are large enough I may just add a fuse in-line and call it a day. I guess it depends on how they are wired in. But if I can use the pre-existing wires there for either the power or the turn on wire it would make the install a lot easier.

View 14 Replies

Ford Excursion :: Separating Mirrors For Recon Lens Install?

Ok, so I picked up some Recon clear lenses because both my amber lenses had cracks in them, and because I think they really cool.

I can't get these damned mirrors apart. According to the directions you shove a screwdriver in the three tabs behind the mirrors and push down and presumably out to separate the skin from the mirror. Problem is, I push down and out and nothing happens. Is there an order to this or what the heck am I doing wrong.

View 9 Replies

Lexus LS 2007+ :: 2008 - How To Install Front Seat Cooling Filter

I notice that I am not getting much if any cool air out of the front seats when I have that feature on. I assume that the filter needs to be changed in my '08 LS. The Lexus bible says to see a Lexus dealer to have that done. I want to know where that filter is and if I can buy it and install it myself.

View 4 Replies

Ford Excursion :: 2000 - Starter Motor Fuse Keep Blowing After Radio Install

So i bought an excursion 3 or 4 days ago and yesterday I went to install a double din dvd receiver. As I was installing something shorted out and I blew the radio fuse. No big deal or so I thought. Got the radio in and replaced the fuse but then the X wouldn't start. Went through everything and found a 5 amp fuse and a 15 amp fuse blown as well. Turns out the 15 amp fuse is for starter motor or something. Well I replaced the fuses and they kept blowing. Unhooked the radio completely and still keep blowing and the X is still obviously not starting. Pulled every relay I could in hopes something would reset and nothing. Any clue what it could be at this point?

View 14 Replies

Lexus RX 2004-09 :: How To Remove Front Seat Rear Panel To Install Headrests

I am getting ready to install DVD headrest players in my RX400h. I am stumped on how to remove the read shield of the seat if that makes sence? I believe the are held in by clamps from middle to top but not sure what needs done at the bottome. And I can also feel two straps at the bottom.

How to remove the back so I can run the wires down the seat from the headrests? Pictures? Diagrams?

View 5 Replies

Golf VI R :: Rattle Noise Coming From CAI After Turbo-back Install

Is it normal to have this rattle noise that is coming from the CAI which i never noticed before? This only happened after installing a turbo back and car runs fine. It just sounded like marble got sucked in the intake or 2 thick plates banging. I am pretty sure its not the heat shield for the filter also because i tried holding that and looked at that part. Went under the car too but i cant pinpoint where its coming from but maybe inside the engine?

[URL] ....

I also got a pronounce rattling at 2000 rpm when I let go of the gas that's located maybe at the bottom passenger side. I am thinking fuel lines?

View 5 Replies

Prius C :: Removing Rear Bumper To Install Back Up Sensors

How to remove the rear bumper, I have to drill some holes to install some back up sensors. I rather not but I don't know if anything is behind there.​

View 1 Replies

Golf IV R32 :: CV Boot Popped Out During Coilover Install - Slide It Back On?

I was installing my fk streetlines yesterday and when I was taking the strut out I must of let the knuckle sag to close to the ground. This caused the outer cv boot to stretch and pop out. Do I need an entire new cv boot? Or can I just slide it back on?

View 4 Replies

Golf/GTI VI :: 2010 - Unable To Remove Rear Side Headrest In Order To Install Child Seat

I have a 2010 4 door GTI. I'd like to install my daughter's front facing Britax child seat either in the rear right or rear central position. However, in either case, I'm finding that most of the rear weight ends up on the headrest and I would like to simply remove the headrest from that seating position.

I read in the user manual that to remove the headrest,I pull it to it's highest position and then push the button on the right side of the plastic entrance of the head rest into the seat, and 'simply' pull the headrest vertical out of the seat.

This is similar to how this was done in other cars I've owned. However it is not working for me with the GTI. Once I pull the headrest to the highest possible position I can get to, I press the button but the headrest simply refuses to come out. I've tried this on the other rear seat and same problem. With the middle rear seat I can't seem to pull the headrest out beyond its lowest position.

View 4 Replies

Prius (2010-12) :: Can't Install Back Sun Visor And Hatch Retainer Clip

I took them off and can not install them back in since I put some sound insulator on the proof. I also lost 1 metal clip somewhere on the ceiling, where can buy new one, and what is the part number for it?

When I push the sun visor, only the clip stay on the ceiling, the sun visor will fall down. It drives me crazy whole day How the white plastic part (electric connect to sun visor) suppose to be attach to the ceiling.

View 3 Replies

Touareg :: Back Seat Won't Go Back Up

I collapsed the rear seats this morning, loaded the Treg up with stuff (nothing too heavy) and drove 200 miles. Got home, unloaded stuff and then tried to put the seats back up. The center seat belt is integrated into the passenger side 60% folding seat. But for some reason it's now "locked" as the belts do when the car is in an accident.

Since the belt is tight as it is in the lowered position, it will not allow me to lift up the back portion of the seat. After looking at it in the somewhat narrow view I have from between the floor and the lowered back rest, I can see that when I try to lift the back rest, the belt needs to slack some to allow the seat back to go all the way up. But since it catches, it only allow the seat back to raise about 6" before it's too tight to raise the seat back anymore.

I looked at the mounting bolts for the bottom portion of the belt in the space I can see and I see a 12 point star pattern bolt (not sure of proper name). With my Passat, I was able to find a suitable allen wrench that fits in the 12 point star pattern bolt that controls the back door catch for adjustment purposes. But with this one, I tried both metric and SAE and neither has a close enough match.

The belt locking mechanism allows for about 1" of belt travel before it locks. I've jiggled with the belt trying to get the mechanism to unlock so I don't have to remove the belt anchor point on the floor of the car (which I don't have the right wrench for). Anything I can do with the belt? Or do I just go after getting the right wrench and undoing the anchor to allow more belt slack to reset the belt?

View 5 Replies

Camry :: 2004 SEV6 Hesitates / Hangs And Then Snaps Into Gear Mostly At Lower Speeds

Purchased a loaded SEV6 with 60k a couple months ago. It's a pretty car, but I'm a little concerned about the transmission's behavior. I previously owned a 2000 Camry LE 4 banger and even at 140k it shifted effortlessly. So it comes as a surprise that my new car hesitates, hangs, and then snaps into gear. This happens mostly at lower speeds, between 20 and 40 I'd say. It's actually given me a noticeable jolt a couple of times. This seems out of character for a Camry, no? I couldn't find any info on TSB's for this. What could be going wrong?

View 9 Replies

Ford - Explorer :: Back Seat Window Motor Regulators Going Out

My daughter has a 94 explorer xlt 4 dr. The window motor regulators are going out. I replaced one of the front ones and decided I'd just make the parts needed next time. All that was really wrong with the front was the little plastic slugs were crushed. They are easy enough to make.

Tonight I tried to remove one of the rear motors, so I could open it up and get the measurements I needed. I found 2 screws that secure the motor, but that's not all that holds it. It seems to be mounted with a spot welded stud as well. There is a small dimple in the door panel in the approximate area.

Before I start drilling things that might not need drilled, I thought maybe I better check here first. How is this supposed to be removed ? The Haynes manual for it tells nothing as to the removal and replacement of any of the window motors. Is the reg inside the gear head anything like the front door motors ?

View 4 Replies

Ford F-150 (2009-2014) :: Rattles Coming From Back Seat

I have a 2010 Ford Raptor and lately I have been hearing some rattles coming from the back seat. I am about 99% sure it's from the rear window... Not positive, but when I listen for the sound that's where it comes from. It's very faint on normal road and rattles after every bump or pothole I hit. I am still under warranty but I don't want to take it to ford unless I have to. I have spent hours on end looking for solutions online but I can't find anything that's my exact problem.

View 4 Replies

Ford F-150 - 1997-2003 :: Seat Belt Won't Retract Back Up

Driver side seatbelt wont retract back up i have to push it in and sometimes it will suck it up but most of the time it wont is there a way to take it apart and clean it maybe?

View 9 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved