I need to pull my front overhead console to make some changes, gonna try to mount my sirius cradle up there to get it out of the way. Can't figure out how it is fastened up there. Also, I need to pull the cover off the rear seat DVD player as I want to solder in some RCA's onto the aux in. Can't figure this one out either, and I'm afraid to break the cover.
View 4 RepliesWife just told me tonight that the overhead console and rear heater are not working in the excursion. Of course, we have a 3 hour drive tomorrow and it is cold outside.. The posts seem to center on either the readout not working or the heater not working, but not both. Trying to minimize time troubleshooting outside in the cold.
View 4 Repliesok normally im very good at this stuff, but i just dont want to break anything (already broke 3 of those little "push" pin things that hold the plastic cover/trim pieces over the front bolts)
how do i get those out without breaking them, and the bolts towards the back of the bench seat, i dont even see where they are! i know there are 12 total. trying to remove to replace my carpet
How to remove over head console in 2013 Lexus ES350? I know that I should probably just pull it down from the front or back, but I want to be sure ..
View 10 RepliesThe little screen that shows the MPG and outside temp went out a few months back. Getting close to winter so i'm getting more interested in fixing it if it's a simple thing. Where I should start? AFAIK, everything else works fine. This is on a 2000 Limited.
View 14 RepliesHow to remove the overhead console in my Excursion? I just want to make sure I dont break it.
View 6 RepliesI was taking off my console and I noticed this connection not being used. What's it for?
View 11 RepliesMy overhead with temp, compass and mpg stopped working.
View 11 RepliesCEL - code escaping me but it said #7 glow plug (ordered a scantool yesterday).
Shifting - its at lowest been in the 30's and the truck has issues shifting until its warm. Its wierd, its like the water temp gauge stays at cold, then snaps up and shifting is fine from then on. Takes what I think is a long time to get there, not a gradual temp change, just like click and the gauge is on.
Lots of electrical looking issues, maybe all tied together?
- Shut doors sometimes flashers blink
- Overhead console no longer lights up
- Door ajar and overhead lights on when doors are tight
- more oddities but I can't think of them now
As far as I can tell, Expeditions, Excursions and Navigators all had this same part in them but for whatever reason it seems like it's next to impossible to find on its own - I don't want to buy a whole overhead console for one part.
Here is what I'm talking about:
I want to replace the lens and buttons, not just the missing button (which is somewhere inside my truck)
Is it Part #5 on this? [URL] ....
I can't find an individual part # - Is it because the overhead console was sold as a whole?
The read out light on my overhead console (the read out that tells the awesome fuel mileage Im getting) isnt working, and hasnt been since I got my excursion a month ago. Thats the only thing on it that doesnt work and was wondering if it could be a bulb, or is this a common problem and if so whats the fix?
View 10 RepliesOn my 2000 Ex my overhead console screen does not work. I have searched and found a few F series ones but nothing about the removal of the huge console. Is it pretty much the same process?
View 4 RepliesDo the Ford Expedition overhead console is identical to the Excursion? I have an '04 XLT and the overhead console is damaged. I found a replacement unit for the '04 Expedition in the same color and the seller has no idea if the units are interchangeable.
View 2 Replies'05 Ex overhead console temp is showing -40 deg... Had the board out looking for loose diodes, didn't see any. Have any of you ran into this before?
View 14 RepliesLooking for a replacement part for the Copper Ring that bulb screws into? Attached is a picture I copied from a previous post. Notice the copper ring. On mine 2000 Excursion one of these rings is broken.
View 14 RepliesI'm trying to remove the middle console vent cover to install a kuda mount. It says to pry a bit with plastic tools right to the right of the vent between the plastic and the leather/pleather. Getting nervous and don't want to crack the cover or damage anything.
View 1 RepliesI need to send my cup-holder cover and trash hook to Clay so he can color match my F650 dash and I can't figure out how to get the damn side clips on the cup-holder to let go!
I got the top clips and the bottom clip to let go but the side clips will not slip through the slots... I've been near the point of breaking them trying to slide them through...
I want to replace the cover on the center console cigarette lighter. I know how to access it from the inside of the console, but I don't know how to remove it. I don't want to break it.
View 3 RepliesExactly how do you remove the cover (facia) below the front of the front seat so the battery can be removed. To my knowledge no one has spelled this out on this board.
View 7 RepliesI took the plastic cover in front of the radiator off to clean the radiator and condenser. It directs air through the condenser before it gets to the radiator and I was wondering if it would cool the engine without it (if you don't need real cold ac air) . Without it the air can go over the top of the condenser and it is still blocked by the flap that stops airflow above the radiator. Also, I am wondering if the fact that the condenser has nothing in it affects the radiator cooling, and is it bad for the AC system to be empty. (My AC doesn't work)
View 7 RepliesCompletely stock, no swap. No motor noise when I click the buttons on forward, back, up or down. Nothing. Everything looks connected under the seat but not entirely sure. Fuse 1 and 44 are good on the side of the dash. This is for a 2003 Wagon with GLX interior and most upgrades from the factory. I need to move the seat in order to remove the center console/radio cage as it's blocking the armrest nut.
View 1 Replies