Ford Excursion :: How To Remove Hub Locking Cap
Nov 27, 2014
I have seen pictures of other hub lock cups that have Allen bolts to remove - mine do not have any fasteners - how can they be removed - do the just pry off?
View 14 Replies
Nov 27, 2014
Advertisement
Ford Super Duty (1999-2016) :: 2000 F350 - Cannot Remove Auto Locking Hub
In my attempt to remove the auto locking hub on my 2000 F-350 4x4, I found that it would not slide out. I removed the retaing clip and the hub should of be able to come out with a couple wiggles, it seems to have seized inside the hub. I tapped it with a rubber mallet on all sides. Any thoughts as to other alternative methods of removing the hub locker ?
View 14 RepliesFord Excursion :: Trac-lock Not Locking Up?
I instead rebuilt the factory trac-lock...well I need more lock....
In the slow crawling I do to get in and out of the camping/hunting/fishing spot with the wife and kids the trac lock just does not lock up well enough.
It I get on it and get it spinning then it will lock up enough but then I fear parts will break, I prefer to slow crawl.
I had my Bronco locked up with Detroit's but I cant do that here it is my DD
So I am back looking at lockable diffs.
I have used ARB and they work well but I came across this Eaton E-Locker. I only saw it for the rear though.
Ford Excursion :: Auto Locking Hubs Won't Engage?
And the vacuum pump was replaced.
View 7 RepliesFord Excursion :: 2000 - Hubs Locking Warning
The 2000 X I have has Warn locking hubs on them. Just to be clear, I'd need to switch them to 'lock' then choose either 4-Hi or 4-Low on the dash in order to engage the transfer case, correct?
View 8 RepliesFord Excursion :: 2002 - Door Locks Continuously Locking
Had the two batteries disconnected on the 2002 Excursion (7.3). Once reconnected, the door actuators all repeatedly lock. They all click every 5 - 10 seconds. Sometimes they click every second for about 5 seconds.
I can't actuate ANY of the door locks on the truck, the switches seem dead. Also, the "door open" LED in the dash is lit. The "THEFT" light is blinking fast as well.
I've disconnected the batteries again several times to see if I can reset whatever is going on. I am keeping a spare key in my pocket because I will get locked out otherwise.
Ford Excursion :: How To Remove The AC Lines
I've got the front of the excursion done with my spring swap finally and now it's onto the rear. How do I move these ac lines along the passenger side to get them out of the way from that shackle bolt? I see the brackets holding them but since they are all hard lines how many do I have to remove?
View 3 RepliesFord Excursion :: 2003 - Manual Locking Hubs Won't Turn / Stuck?
On my new to me '03 Excursion (I've owned it for 1.5 weeks now), I'm starting to get through the 1st level of issues (Wandering - fixed, Speedo/ABS issue - still working on that, changing the rear diff fluid this week, hopefully).
Now, I want to look into why the manually locking hubs won't turn. When I brought it up to the Previous Owner, who was about as mechanically inclined as my Golden Retreiver, he said "these are auto locking hubs. I never turned those things before".
They are frozen in the non-locked position, so I have to pray that I never need to actually manually lock them.
Any lucky experience at un-freezing stuck hubs? I've started the liberal application of PB Blaster process.
Ford Excursion :: Burnt Clutch Smell - Rear Calipers Locking Up
Driving home today I started smelling a burnt clutch smell!
Well since I have an automatic, I wasn't to worried until my 6 yr old gets out when we get home and says "DAD something stinks really bad out here!"
Get out and wow!! I have never had a caliper lock up on any vehicle I have ever owned! It stunk like I burnt a clutch out of a standard tranny!
So I start poking around and the left rear caliper is locked up, rotor is blue and you can hear it popping like a valve spring cooling down.
So my question is is there anything to look for other than the normal? I will be getting the brake system power bleed after I replace the caliper. I already checked the brake lines and there are no obvious issues. It is possible the rubber inner lining is toast.
Ford Excursion :: 2000 - Pulling And Unlocking The Auto Locking Hubs?
I just recently purchased a 2000 Excursion and had some questions up in another thread. After doing some diagnosing....I have a couple of questions about the auto locking hubs. The problem I have is that even with the vacuum line disconnected from the knuckle and no vacuum...the hubs won't unlock in auto/2wd. I confirmed that the knuckle and the hubs will hold vacuum when I hooked my vacuum pump up to it and it held vacuum (the fitting should be clear as I heard the hub making some sounds). I'm getting ready to pull the hubs to clean and re-grease them. My question is that being they are still locked....will it be any harder to pull them off the spindle and after disassembling them/cleaning them.....when I re-install them....will they be unlocked by default after putting them back on the spline as they have been pulled apart and reassembled?
View 14 RepliesFord Excursion :: Barn Door Lock Stopped Locking And Unlocking With The Key
Renee said her barn door lock stopped locking and unlocking with the key, so I checked the connecting rod from the cylinder to the actuator and found it had broke off the cylinder. I also found a small metal clip of some sort laying loose in the area beneath the actuator.
I checked the 'net and couldn't find any good, close up pics of each end of the rod to see how it's attached. I did find a YouTube vid of the actuator area, but when the goombah in the vid started talking, I thought to myself, that voice sounds familiar! So I scrolled down the page and what do I see? Apocs pic and name, showing it was uploaded by Jon, LOL.
Anyway, can someone remove that back plastic panel on the rear hatch and take a few pictures of the connecting rod and how it connects to the actuator? I know I have to replace the plastic/metal tab that connects the rod to the cylinder, but that opposite end, the actuator end, has me a bit perplexed.
Ford Excursion :: How To Remove The Rear Bumper
I have a newbie question on how to remove the rear bumper? Do I disconnect the sensors first or remove the bumper and disconnect the sensors.
I read this thread : [URL] .....
But was not sure which bolt to remove? Is it all 4 on each side or 2 toward the rear of the bumper?
Ford Excursion :: How To Remove The Cup-holder Cover
I need to send my cup-holder cover and trash hook to Clay so he can color match my F650 dash and I can't figure out how to get the damn side clips on the cup-holder to let go!
I got the top clips and the bottom clip to let go but the side clips will not slip through the slots... I've been near the point of breaking them trying to slide them through...
Ford Excursion :: How To Remove Rear Bench Seat
ok normally im very good at this stuff, but i just dont want to break anything (already broke 3 of those little "push" pin things that hold the plastic cover/trim pieces over the front bolts)
how do i get those out without breaking them, and the bolts towards the back of the bench seat, i dont even see where they are! i know there are 12 total. trying to remove to replace my carpet
Ford Excursion :: Without Dropping Tank Remove Hitch?
My hitch receiver is looking pretty strange lately and I want to take it down, grind it and repaint it. While crawling underneath the truck today, I noticed that it appears the bolts holding the hitch are kind of covered by the Tank Skid Plate.
I did some searching, and from what I've gathered, it appears that To drop the skid plate means to also drop the tank as they are one unit.
Is this true? Is there any way for me to get the hitch receiver out without messing around with the gas tank?
Ford Excursion :: How To Remove Dash Bezel To Access Radio
Installed an aftermarket stereo but having problems with the steering wheel controls adapter I purchased and need to remove the radio to access the settings on the adapter. The kit I used to install the radio states that once the radio is snapped in place with the kit, the dash bezel must be removed to access the radio. I googled and I cannot find instructions on how this piece come off.
View 11 RepliesFord Excursion :: Remove Plastic Cover In Front Of Radiator?
I took the plastic cover in front of the radiator off to clean the radiator and condenser. It directs air through the condenser before it gets to the radiator and I was wondering if it would cool the engine without it (if you don't need real cold ac air) . Without it the air can go over the top of the condenser and it is still blocked by the flap that stops airflow above the radiator. Also, I am wondering if the fact that the condenser has nothing in it affects the radiator cooling, and is it bad for the AC system to be empty. (My AC doesn't work)
View 7 RepliesFord Excursion :: Installing Speaker - Remove Rear Trim?
I'm trying to upgrade my speakers. I got the ones in the front and rear doors installed. I hoping there is a way I can access the speakers without having to completely remove all of the rear panels.
View 8 RepliesFord Excursion :: Changing Rotor - Can't Remove Broken Bolt?
I was in the process of changing out rotor and pads and my caliper bracket bolts while loosening them. The weird part is the bolt was turning in the process. The passenger side was easy as pie. The drivers side has me stuck. I have tried to drill out the broken bolt but noting is working. I don't know where to go from here. I have already purchased a new caliper and the bracket that goes with it. I just need to get this old one off so I can move on.
View 14 RepliesFord Excursion :: Easiest Way To Remove Center Caps From Factory Wheels?
There has got to be an easier way then the homemade method I'm using?
View 14 RepliesFord Excursion :: How To Remove Overhead Console And Cover For Rear Seat DVD
I need to pull my front overhead console to make some changes, gonna try to mount my sirius cradle up there to get it out of the way. Can't figure out how it is fastened up there. Also, I need to pull the cover off the rear seat DVD player as I want to solder in some RCA's onto the aux in. Can't figure this one out either, and I'm afraid to break the cover.
View 4 Replies