I got my headlights swapped but the turn signal sockets can't go into the housings. The old bulb socket thing is a 90 degree twist in and it would twist in if there was room for the socket to twist. The back of the housing has a blocky lumpy thing in the way and I need a straight in socket I guess.
View 14 RepliesJust wondering if its possible to have 2015 Sonata SE Headlights to turn Off when turn signal on and turn On when turn signal is Off...
View 6 RepliesLooking for a replacement part for the Copper Ring that bulb screws into? Attached is a picture I copied from a previous post. Notice the copper ring. On mine 2000 Excursion one of these rings is broken.
View 14 RepliesI just got a 2003 1.8T Passat about a week ago. I have already installed a new HU and put some subs in it. I haven't really had the chance to test the headlights while driving because I haven't driven after dark since I got the car. When I used the headlights today some strange things were happening.
When the headlights are turned on the right signal comes on and stays on until the headlights are turned off and doesn't pulse. If I try to use the right signal while it is stuck on it makes the indicator clicking noise once then the noise stops but the light stays solid the whole time.
If the headlights are off and I try use the right signal the signal works fine but the instrument lighting pulses with the signal and I assume I haven't noticed this because driven only in the light I probably just never noticed.
The left signal behaves completely as it should as far as I know in all conditions. The hazard lights are also behaving oddly but I'm thinking it's because of the problem with the right signal.
2004 Santa Fe 2.7L
When the headlights are on the left turn signal stays on(but does not blink). The right turn signal functions ok. With the headlights off both signals function normally. The headlights work correctly.
This issue happened once a year ago but just started reoccurring two days ago.
I seem to have a problem with my jetta. It's the 1.8t. When I turn the turn signal on, I can see the dash and headlights dim. Also when I tried putting both windows up at the same time, the car seemed to short out and almost shut off. It reset the time and trip mileage when it did so.
View 1 RepliesI towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 RepliesI'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 RepliesMy driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 RepliesI am having an electrical problem with my front right turn signal I have not been able to chase down.
The symptoms are when the headlights are on, either manually or automatically from the daylight sensor, the front right turn signal will not flash, and I get the double speed clicking as if there were a burned out bulb. However, when it is daylight out and the headlights are in daytime running light mode, the turn signal works fine, 95% of the time. Occasionally when the headlights are off the turn signal will not work either.
I have replaced the headlights casing and bulbs, and tried rebuilding the pig tail harness as well.
I have a 2012 limited last night while driving when I would turn my turn signal on the headlights would flash off and back on. I tried it a few more times and it did this quite a bit. I do have HID lights which I have had for about a year now but never had an issue before.
View 8 RepliesPut a new bulb in the right front turn signal, still doesn't work (parking light works though).
View 10 RepliesI installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
I've got a problem with the turn signal on my '01 V10 4x4. 3 out of 4 times I hit my turn signal, it immediately resets because my wheel may not be perfectly straight. If my wheel is not straight or turned significantly (>180 degrees) the turn signal will not reliably latch. Its a minor annoyance that could turn into a safety concern.
Is there anyway to adjust the latch mechanism?
I have searched the Owners Manual, forum and internet about this, but I can't come up with a solution. Perhaps I am not using the correct terminology. I also have an ALLDATA DIY subscription on this vehicle, but I could not find any instance of this occurring to be able to troubleshoot. I though that there might have been a light out somewhere.
View 2 RepliesMy wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
Turn signal flasher doesn't work in the heat. What gives?
All lights work. Turn signal stalk works fine. It just flashes a couple of times, then stays on. Everything works fine in cool weather, but it rarely works at all when the temperature outside is above 90 degrees. Very annoyed.
Just got a 2014 Prius Three. All my precious cars (non-Prius) had an automatic on headlight system, noticed the Prius doesn't. Can I just replace the turn signal lever with one that has the 'auto' feature? Could it possibly be that simple?
View 2 RepliesI'm looking to replace the headlights and turn signals on my 2002 Excursion - I've seen loads on Ebay, but don't really know how to tell what ones are ok? I like the chrome style, and like the led lights too - but mainly I just want the front of the truck to look more modern (I am buying the 05 style grill too)...
View 10 Replies2003 X limited, 2wd 6.0L
Last week wife's right rear turn signal/brake light stopped working. The left one flashes normally. The right tail light works fine which is a different bulb. I tried changing bulbs (didn't work).....tried a new socket with new and old bulb (didn't work). Could it be a relay? Or not relay as they would be both out (left and right)?
I looked at my trailering wiring plug down by bumper and the white wire with green stripe looks split a little towards the end. Could it be a bad ground or short in that wire? Would the trailering wiring have anything to do with it? I was going to try to replace the relay if I could find it, what is the part number for it.