Ford Excursion :: Front Passenger Shock Top Nut Removal
Dec 1, 2015
Any trick that they have used before for removing the Front Passenger Shock Top Nut without removing the A/C Accumulator? The Nut I need to remove is right underneath the A/C Accumulator and I can't get a 15mm Deep Socket on the nut so that I can use an air tool to take off the nut like I did on the Driver side. Is my only option to use a 15mm ratcheting box end wrench or remove the accumulator? On AllData, they show the pics of the Driver Side which is easy to access with just a swivel and a couple of extensions.
View 1 Replies
Advertisement
Looking to install rear sway bar on 2001 Ex. and noticed a skid plate looking thing in front of passenger side rear shock. Two questions:
1. What is that, and
2. Do I need to remove it to put on sway Bar?
View 14 Replies
Is there any particular front stabilizer shock I should purchase for a replacement for my 2003 X 6.0L diesel? Anything I should stay away from?
View 7 Replies
Well the old ball ball joints are out, new ones are in and now I'm working on removing gear assembly so I can change the inner axle seals. I've been trying to get it out. It haven't had much luck. I've loosened the cap bolts, prayed, pulled, hit, and still no luck. The only thing I've been successful at is screwing up the first few threads of the bolt holes for the passenger side cap. Tomorrow I'll be getting a tap and chasing the threads to clean them up. Hope I haven't screwed it up too bad. How to get the gear assembly out?
View 8 Replies
How should the front rotors look for a 2000 2WD Excursion:
Photo #1 - With Studs:
OR
Photo #2 - Without Studs:
When I do searches online for parts, I get both kind.
Also, if with studs, do you have to remove the hub and cotter pin to remove the rotor?
View 6 Replies
I am looking at using a 2009 F150 XLT to rig up a soil sampling truck. I was hoping to remove the front-passenger and front-centre seat to make room for a probe that will go through the floor into the soil. As I was looking through articles to see if this was possible I read that some newer models dont make this easy, as there are air bag sensors and seat belt sensors that screw up the process. Before going out to look at the truck and make an offer, I was wondering - if there are any tips for removing these seats.
View 3 Replies
I need to replace the front passenger side wheel hub unit on my 2012 F250 4x4 120,000 mile reg cab truck. Its been a while but I did one on my 2000 F250 without any problems. There should be a few clips inside the hub that hold the looking hub and shaft together, right? Do I need any special tools for this job? What do the bolts need to be torqued to?
View 2 Replies
So I'm pulling the front control arms on my car and was wondering how to pull the front bolt out of the passenger side control arm and if it is doable without dropping the sub-frame. The bolt has like no clearance between the oil pan and the front edge of the sub-frame.
View 3 Replies
Today I noticed I broke my steering stabilizer shock. It it broke at the connection on the piston arm where it connects to the steering linkage and the piston shaft is bent. Guess it happened when I hit a rock Thursday. I am thinking of purchasing the Rancho 9000 adjustable shock as a replacement. I do not do much off road driving and what I do is very moderate. This is for a 04 Excursion, 4x4, 6.0PSD, with 285 all terrain tires, no lift.
View 7 Replies
Couldn't get the bolts out of the bushings so just bought new mounts. Was wondering to have the torque value for the u-bolts...
View 2 Replies
Since my daughter was born a couple of days before I want to deactivate the passenger front airbag, for using a maxicosi-baby seat, where the baby is faced back.
I used the search function, but it showed no thread, so, hopefully
View 12 Replies
I've noticed quite a few threads looking for the shock bolts lately. I've replaced one of mine and just had another break. Today I ordered replacements for all 4 nuts and bolts.
The Bolt part number is - N605906-S2
The Nut Part Number is - N803714-S426
View 10 Replies
Alright, yesterday while I am at work, wife calls me up and tells me the Ex is leaking coolant. I got home a little before dark and looked at it. Right behind the front passenger fender well, it appears that either a bolt came out of a bracket, or someone took it off for something and was too lazy to put it on, allowing the metal elbows to swing over and rub on a bracket. So now I have a hole in that elbow, and I need to the excursion for our trip over Christmas leave. Where I might get an elbow to replace that one? Also, need to know the bolt size for that heater hose bracket to keep it from happening again? If I can't find one pretty soon, I will have to JBWeld or something it temporarily to hold us through until after Christmas.
View 6 Replies
Well, I had a friend put together my front brake rotor, now no more pulsating when coming to a stop, very smooth stop, new front brakes, had it aligned as well.. Also replaced the front shocks, however the passenger side came loose and rattles when going over bumps, speed bumps. I popped the hood, bounced my truck and could see it moving from left to right when bouncing front end of truck.
Question is, can i tighten it up myself, I dont have a jack, limited tools, I know, I know but i dont at the moment. My friend that worked on my truck lives a good drive and i hate to waste gas just for tightening something that should have been done but i have too, I will..
View 3 Replies
Its been awhile since I have been on. Everything has been running great for me until I found my passenger side front axle leaking fluid. I'm sure something has been posted on here but I have limited access to internet right now and need to know what I am getting into to change the seals. From what I have found there is an inner seal in the pumpkin and then an outer seal and dust cover. Are both of these easy to change? Are there any special tools needed? Do I need to remove the gears in the pumpkin? If so, is this difficult and any special tools required for this?
Mine is a 2001 V10-6.8, 4x4 no mods at this point.
View 14 Replies
2003 Limited 6.0 130K. Just took a 1000 mile trip for spring break. While away, I noticed a small leak near the front passenger side of the truck. It is red so I assumed it was transmission fluid. It is leaking from, the best I can describe, a small housing that looks like it might be a filter near the tire (it looks like the old style canister oil filter housings). All the hoses are clean and where the hoses go into the radiator are clean. Is this an easy fix? I am a bit worried about trying to get the thing off without damaging the hoses.
View 3 Replies
My father in law has an 04 EX with the 5.4. It has a weird sound coming from the front passenger side. He listened to the jiffy lube kid who told him it was the brakes. I pulled one side completely apart tonight and the brakes are fine. We took it for a drive so I could hear the noise. It is coming from the passenger side up front. It is intermittent.
Doesn't matter if we hit a bump or pot hole. It sounds like a cat being run over. It will either last for a few seconds or just really quick. I crawled underneath and could not find anything loose. The first time I heard it I thought it was a shock. But the second time it was way too long to be a shock. And they are only a year old.
Secondly, it has a cat, and two mufflers..... Is this normal?
View 6 Replies
How to stop a squeaking front shock. It's my drivers side front shock only. The shocks are fine as far as wear and ride, it's just this squeaking (very noticeable in parking lots) that's about to drive me crazy!!
View 14 Replies
I replaced all my shock and the last one front passenger side gave me fits. The lower mounting bolt stripped and I am unable to secure the shock. My question is..is it safe to drive around without the front shock to get over to the parts house? I plan to use back roads and low speeds. 20 mile round trip.
View 6 Replies
So this morning is just getting better and better. Was coming back in from getting the mail and noticed a small puddle under the passenger side tire/wheel area.
I never ever have a puddle of any sort in my drive way so...I start crawling around the truck and this is what I find. I can free spin the dust seal, but its all the fluid that has be worried. With less then 4 days till I have to haul everyone to the airport this is not what I need.
IF (man I feel stupid for asking) IF I leave it in 2 wheel drive how big of an issue would it be to drive it?
None of the parts will be in before I have to drive everyone out to the airport, this is the only reason I'm even considering this..
Plus would this explain a sudden lost of MPG?
View 12 Replies
On my 2003 Excursion 7.3L, I notticed I'm leaking what I think is coolant from the passenger side rear hard line by the front spring hanger. I haven't pealed the plastic loom away yet, but I did see the loom is chaffed near the spring hanger. What lines are the ones that carry coolant, and can I just cut the hard lines and replace with a section of rubber hose?
View 3 Replies
