Ford Excursion :: Front Dust Shield On Driver Side Is Falling Apart And Scraping Against Rotor
Jan 9, 2017
My front dust shield on the driver's side is falling apart and scraping against my rotor. On the passenger side the dust shield is long gone.
My question is do I need the dust shields? Is there any issues without having them?
In a perfect world I'd like to replace them, but I have a feeling that this is going to be one of those dealer only items that's severely overpriced.
Seeing as I have the passenger side shield missing, and I never noticed anything before hand I'm thinking this is an item that might not be necessary.
View 6 Replies
Advertisement
I am going to have to replace the rear dust shields and emergency brakes soon. I was wondering if we have this documented somewhere. The main question is do we need to remove the axle to replace the shield.
View 9 Replies
I noticed that the driver side front wheel makes a metallic scraping noise while the car is turning right. It sounds like something scraping the rotor or shield behind the rotor ( a rotational/moving kind of scraping noise)
This only happens on a relatively sharp turn (wheel is turned 70~80% to the right). I don't suspect the power steering as there is no noise if the car is not moving even when wheel is turned to extremes. The scraping noise happens at any speed, as long as the car is moving. does not happen when car is turning left.
Note that I am 90% certain it is from the front... my ears may be playing a trick on me (kind of hard to listen precisely while driving). Where to start looking?
View 9 Replies
Here's what I am running into. I have factory setup and it doesn't feel adequate. I get vibrations, lots of brake dust on front wheels, and just don't feel I have the stopping power if needed in emergency or towing. Especially with how heavy my 6.0 is already.
View 12 Replies
How should the front rotors look for a 2000 2WD Excursion:
Photo #1 - With Studs:
OR
Photo #2 - Without Studs:
When I do searches online for parts, I get both kind.
Also, if with studs, do you have to remove the hub and cotter pin to remove the rotor?
View 6 Replies
Picture if you will...Removed tire, caliper and rotor. Removed hub, and knuckle containing the stub shaft/spindle with it's yoke for the U joint. You are now looking at the end of the axle tube, with the axle shaft in it, one end connected to the differential carrier, the other end has the yoke for the U joint on it. Just inboard of the yoke, is a seal. Apparently it's called a "dust seal" is there a bearing behind this, or is the first bearing all the way in at the differential? When I was doing my brakes, I noticed the passenger side u-joint is shot, and the axle wiggles around in the dust seal. Figured I'd replace the seal while I was doing the U joint. Also, how do I get the axle shaft out? Just pull, or do I have to remove a C clip from the inboard end? What is the right National part number for the seal? I have a 6/2000 Excursion.
View 2 Replies
I have a rattle in my drivers side front hub. I primarily hear it when I hit small bumps. With the hubs locked and in 2wd, the rattle is gone. Could this be just the hubs where replacing them with warn manuals would fix it or is it likely more involved?
View 6 Replies
Recently purchased a CPO 2009 F250SD 6.4L. Happy with the truck overall but this AM I noticed a slight burning plastic smell so I opened the hood and looked around closely. Didn't really find the culprit(I don't think) but noticed that the engine compartment heat shield/barrier appears to be falling down above and behind the turbos (pictures linked below). How big a deal is this? Would it be covered under the CPO warranty? It almost seems like a safety issue. I also wonder if the insulation material, now exposed without the metal reflector material, is what is causing the smell....
View 14 Replies
I noticed my rear brake smoking on the truck really just the rear driver side. I had replaced the pads and caliper and rotor a very long time ago. What I think happened is the parking brake got hung up somehow. The wheel was extremely warm and the reason I noticed it was not only the smoke but I felt some sort of wobble or almost out of alignment issue.
When I got home I noticed the smoke and extreme heat. I removed the caliper and the pads look still "new" and evenly worn. I did bleed the caliper just to make sure no air, I even put a spacer in the caliper and my wife applied the brake and they closed appropriately. Then I was trying to get the rotor off and no success. I did adjust the parking brake but I am not sure if you move it up or down to loosen it up?
I have used PB Blaster to try and loosen it up, rubber mallet while I turn it (although it does not turn easily at all), I sprayed it inside where the adjuster is hoping it would seep down between the shoes and the hub. I heated the hub up with a little torch - no success. I was thinking of using a wood piece as a butter and hammer from the inside out on the rotor but fear that will warm the rotor itself.
View 14 Replies
Went and got new tires on the supercrew. Went going through parking lots or simply driving i hear a loud squeal like brake pad squeal. I put brand new wagner ceramics on the truck. Also if i turn to the left the driver side rear sounds like brakes are dragging against the rotor. Whats goin on with this. The squeal will happen between 10 mph to 20 mph and the grinding noise will happen if I am cruising or turning to the left. It goes away when i apply the brakes.
View 1 Replies
We've noticed an audible knocking that sounds to be coming from the front drivers side. It only happens at speed (over 30) and doesn't seem to be engine related. I can feel it under my resting foot while driving. I know this is vague but I think it may be enough to get started on figuring this out.
View 14 Replies
I'm new to the forum and Excursion ownership but was hoping someone could save me some time and aggravation chasing a rattle in my 2004 2wd 6.0 PS. It seems to be coming from the front driver's side since I can feel it through the steering wheel. As of now, it's nothing major since it doesn't seem to affect tracking but I'm afraid it's getting worse.
I'm thinking it's a worn bushing but as I'm less familiar with the vehicle as y'all are, maybe you can point out the weak points that may be causing my issue. I plan on jacking up the front end tomorrow and inspecting for play. I'll let you know what (if anything) I find. Are there any known issues I should be aware of?
View 11 Replies
Took the truck out the other night, got to town felt the slight drag but nothing alarming, got out of the truck and could smell it, rear drivers side rotor glowing red, pass side not glowing, pressed park brake then released, driver side freed on its own, pass side sticking, replaced pass side rotor and pads, found nothing out of the ordinary... Ford F250 4x4, 2005 ....
View 14 Replies
Started hearing a squeak from drivers front wheel area when turning right, thought maybe pads might need replacing but they were fine as were the pins. So I checked for play with tire off ground and there was def some play pulling from top to bottom, so that lead me to the front hub, I read some posts about pulling the abs sensor and getting some grease in the the hub bearing so I did that but when I replaced the sensor and spun the hub it was scrubbing on the bearing.?
So I shimmed the sensor with a washer but now the abs light comes on but there doesn't seem to be a squeak when turning right anymore. Any example of doing this and had the sensor scrub? And with the play I would assume I need to plan to replace the hub assembly fairly soon...
2000 X 4x4 V10 with 147k
View 14 Replies
My Ex did this to me a few months ago 2 days in a row and then didn't do it again until now...
Battery is almost new and alternator charges fine but every once in a while when it sits it drains the battery. I can hear an audible click and rumble coming from the front end behind the drivers side headlight under the air intake.
I've got a boost coming but I'd like to be able to start her up again to go to work later.
View 1 Replies
I replaced my front axle pads but the driver's side brakes seem to be dragging on the rotor making a very loud squealing noise when im driving. When I parked it in my driveway it was really hot and smoking. It doesn't happen to the passenger side. I pushed back the Pistons easily to get the brake pads in there so that wasn't a problem. But I must admit I changed them when my brakes were grinding.
View 13 Replies
I've only had the Ex for a few months so I'm still learning... After a trip to Orlando this weekend, I noticed a very faint odor of differential fluid from the driver's side front and rear wheels.
Nothing on the passenger's side. I've inspected the pinions and axles and found no wet areas at all, so I'm a little perplexed. The wheels and axle housings were pretty cool considering a 5 hour round trip.
I was also wondering if what I am smelling is due to the axle vent hoses?
View 5 Replies
I just had a new downpipe installed and now I am getting a horrible scrapping noise when coming off a dead stop. I got under the car and looks like the downpipe is touching subframe heat shield. My question is should i take it back and have them make some clearance or is there a quicker solution. New downpipe and subframe heat shield.
View 2 Replies
So... Took my car into a tire shop (tire pros) to get a screw pulled out of my front left tire... And after they finish the job - the guy comes up to me and says "your front brakes don't have much life left." I said, "I know I'm planning to change them in the next couple of weeks"...
He then said, "well I think your sensor just went off, when I pulled the car around.." I said "okay", got in the car and drove off - no brake light what so ever.
Anyways, A few hours later when pulling my car around the corner on the way home - I noticed that I am all of the sudden getting a random scraping sound from the front-right rotor anytime I turn the well all the way to the left at slow speeds...
I'm not too worried about it - just want to make sure these guys aren't trying to sabotage my car! The only thing that kills me, is that I didn't have the sound before and no all of the sudden I do? I'm assuming they somehow slightly moved the pad, causing it to somehow squeal - I'm just not exactly sure what they did...
View 13 Replies
The other day I replace the front brake pads and rotors on my daughter's '03 Accent. On the test drive I noticed a scraping noise coming from the driver's side. Got it home and didn't see anything obvious, but for fun I removed the pads and swapped the shims around. It was better, and afterwards I put the new brakes through a few heat cycles. The scraping noise became less noticeable so I figured she should just drive it for a few days. Well today I'm informed that the noise is "really bad".
View 1 Replies
Replaced my rotors today. When I was done, I spun each wheel to see if there was interference. Passenger wheel spins freely. Driver's wheel makes a scraping sound (brake pads?) and stops pretty quickly.Which one is wrong or bad?
[URL] ....
View 5 Replies
