Ford Excursion :: Door Lock Rod Clip Broke?
Apr 29, 2012
So was replacing the actuator on a few of the doors today. I broke the clip on the passenger side rear door that attaches the exterior door handle to the locking mechanism. It's the clip that sandwiches the rod threads in place. I discovered the front and the rear doors are different in these clips.
What is the part # or diagram with description to find this part? I've found the replacement for the front door, but it doesn't fit the rear. Here is a pic of the front door one.
Dorman Products - 703-240
The difference in the part that connects the the locking mechanism. On the front its a round plug with tabs on it. For the rear it is rectangular and slides in and then rotate 90 degrees to lock in place. Cant for the life of me locate a replacement. Been researching for hours without success.
View 1 Replies
Advertisement
Trying to replace a right rear door handle on my 01 7.3. Attached is a photo of the new handle with the unlock rod. Also is attached is photos of the door without handle. I pointed to the part that moves the lack to unlock.
Looking for the clip part number or photo that is missing. I thought a hose clamp would work maybe with a nut on the rod?
View 6 Replies
2002 7.3l Diesel 4x4 Excursion with 200K+ miles. Best truck I have ever owned and want to keep it forever!!!
One of the latches on the jack access door broke off years ago. I want to replace or repair it. I have been looking for a jack access door for years, and then saw this forum and decided to give it a try.
Needless to say I have contacted the local Ford dealerships multiple times and they say they can not get them. I have looked on craigslist without success. I have a silver (they call it Birch or something) truck with similar leather and carpet and door panels. When I can get another door or repair the latch on the ?
View 14 Replies
On my 04 150 auto, the clip that holds the shift cable to the trans selector shaft broke, Ford says i need to buy the whole cable and what did you do?
View 2 Replies
So I was installing my Hid's and the clip broke off, clip still in tact but the part that it's held in where the screw is at is gone. What can be done about this?
View 6 Replies
All of my door locks work fine with the key fob or from the master driver side controls. One door lock, the front passenger, will unlock with the rocker switch on that door but will not lock with that switch.
I replaced the rocker switch on that door and I still have the same problem. To me this seems to indicate a problem with the lock wire from the rocker switch to the door actuator since otherwise the actuator works. I believe that is a black/pink wire.
View 1 Replies
I've searched the forums a bit but haven't found a definitive answer on my problem.
My back hatch door on my Ex won't lock.
Sadly anyone could climb through the back after I 'lock' it via remote. I have the standard ford sec systm which is just locking and need auth key to start.
Any solid leads I can get for my 2001
View 12 Replies
I spent write a bit of time and this process is living proof i can't do it.
View 5 Replies
This afternoon the Passenger door lock would not unlock, with switch, key fob or door pad,you can hear it and the lock rod moves a little but will not unlock. Now it won't lock or unlock, you can hear the actuator and see the lock rod move a little but it just won't get there. Should I get a part in hand before I tear into it or could it be a easy fix with no parts. 2002 Ex XLT 4X4
View 3 Replies
I just bought a 2000 ford excursion 7.3. None of the power door locks currently work but the one I am really consented about is the back window that folds up and down. I need to find out how to fix this back window because I can't lock it with the key like the others.
View 14 Replies
My Excursion recently had all of the door lock actuators replaced, but locking still wouldn't function correctly...everything works fine with both the fob and the door keypad, but when using the door switches it would only lock, not unlock.
I searched for three days trying to find where the door relays were because I knew my actuators were all good....I happened upon a thread on here where a user had my same issue and was asking about relays. Like me he was trying to find out where the relays were, but users kept wanting to tell him to do the foil quick fix on his actuators. Even after he specifically said he was sure it was NOT the actuators, posters kept telling him to focus on the actuators, that there were no relays other than internal to the VSM I think...he finally took it to the stealership and they told him they had replaced one of the power lock relays under the dashboard.
I searched the internet for a couple more days trying to find where those elusive relays were, and all I could find was a generic "under the dash" if even that much--most people kept wanting to point users to the actuators. So for any future readers who want to know where the door lock relays on a 2000 Excursion are located, there are three of them--one for "all doors lock", one for "all doors unlock", and one for "driver's door lock". They are buried in the dashboard, mounted to the firewall upside down behind the radio. The easiest access to them is from the floorboard to the right of the accelerator pedal.
You'll need to remove the knee panel under the steering wheel that covers the fuse box; then remove the rubbery lower wiring cover below it that's held in place by 3 or 4 pf the phillips head push-pins; then in the lower right of the opening where you removed the knee panel (look just above the accelerator pedal), find and remove the single gold 7mm screw that holds the driver's footwell air diverter in place, and remove the air diverter. Then lay on your back in the drivers floorboard and look up to where would be directly behind and just below the radio--you'll see a small (2"x6") rectangular black cover facing down that hides the relays, held on with a clip at each end. Pop the cover off, and you'll see the three relays. I'm not sure what order they are in. In my case, I was intending to make sure the relay was my problem by having what was functioning change when I swapped relays....apparently my problem was a poor connection on one of the relays because everything started working perfectly and has worked fine since.
View 14 Replies
I searched but can't find anything I know how to fix it once it's out, but until I get it out I got nothing.
View 4 Replies
Renee said her barn door lock stopped locking and unlocking with the key, so I checked the connecting rod from the cylinder to the actuator and found it had broke off the cylinder. I also found a small metal clip of some sort laying loose in the area beneath the actuator.
I checked the 'net and couldn't find any good, close up pics of each end of the rod to see how it's attached. I did find a YouTube vid of the actuator area, but when the goombah in the vid started talking, I thought to myself, that voice sounds familiar! So I scrolled down the page and what do I see? Apocs pic and name, showing it was uploaded by Jon, LOL.
Anyway, can someone remove that back plastic panel on the rear hatch and take a few pictures of the connecting rod and how it connects to the actuator? I know I have to replace the plastic/metal tab that connects the rod to the cylinder, but that opposite end, the actuator end, has me a bit perplexed.
View 14 Replies
I have a 03 Excursion. The door lock buttons work perfectly to lock the doors but nothing happens when I try to unlock with the buttons on the doors. However the key fob and keypad entry work flawlessly. I was sure it was the drivers side master switch but replaced it with a brand new one today still doesn't do anything, no sound from actuators or any relay click nothing but the mechanical click of the contacts in the switch.
View 2 Replies
I've been thinking about doing a 2015 conversion on my Ex for some time. Well today I rear ended a little old lady and it seems like this is as good a time as any to get it done. I have only seen 04 and earlier models getting it done. My first question is can an 05 be converted? Second, is there a comprehensive parts list of everything i'm gonna need.
View 9 Replies
I am getting ready to tackle a few projects on the new X. First I would like to fix the door locks. passenger side front, it makes a noise when i hit the lock/unlock button, but doesn't move. Hoping it is the actuator but wanted to make sure first. Is the actuator the first culprit to fix? I guess, How do i know it is the actuator? Wanna order them from rockauto soon. I've researched on here door actuators, looks pretty simple.
View 2 Replies
My power door lock switch in the drivers door stopped working (not the actuator problem, but the actual switch would unlock, but not lock the doors)
I started to research if it could just be simple corrosion and decided to spray the contacts with CRC electronics cleaner. It completely fixed it.
Next, my parking brake light sensor stopped working so I did the same and it fixed it.
I began to research cleaning contacts and found a number of people in the automotive forums who basically spray contact cleaner on every electrical connection they ever touch.
I will do this in the future. The only part I wonder about is if there is something better to spray on them to prevent further corrosion in the future. I used dielectric grease but it would be nice to just spray the thing down. However, CRC does say their electronic cleaner prevent future corrosion.
View 2 Replies
My driver side door molding is missing a clip. This is the bottom half of the mold and one of the clips snapped off. I've checked junk yards and they never have any GX's. Just to elaborate the clip I'm missing is on the exterior side of the door, down by the bottom edge.
View 2 Replies
The tail pipe broke right in front of the muffler.
Y pipe Mod is installed. Headers are not in my immediate future as much as I would like to.
Thinking about having it straight piped, concerned about noise.
View 8 Replies
About a year ago I put in a new lock motor and it worked fine for a while but has stopped working. Is it the lock motor or something else? It unlocks but won't lock. There is not latch indicator on the upper hatch so it stayed unlocked without me knowing it.
View 12 Replies
Looks like if it was broken off but they tried to jb weld it in place and now I cannot get it out.
View 13 Replies
