Ford Excursion :: Coolant Leaking Right Behind The Front Passenger Fender Well
Nov 21, 2014
Alright, yesterday while I am at work, wife calls me up and tells me the Ex is leaking coolant. I got home a little before dark and looked at it. Right behind the front passenger fender well, it appears that either a bolt came out of a bracket, or someone took it off for something and was too lazy to put it on, allowing the metal elbows to swing over and rub on a bracket. So now I have a hole in that elbow, and I need to the excursion for our trip over Christmas leave. Where I might get an elbow to replace that one? Also, need to know the bolt size for that heater hose bracket to keep it from happening again? If I can't find one pretty soon, I will have to JBWeld or something it temporarily to hold us through until after Christmas.
View 6 Replies
Advertisement
On my 2003 Excursion 7.3L, I notticed I'm leaking what I think is coolant from the passenger side rear hard line by the front spring hanger. I haven't pealed the plastic loom away yet, but I did see the loom is chaffed near the spring hanger. What lines are the ones that carry coolant, and can I just cut the hard lines and replace with a section of rubber hose?
View 3 Replies
I'm 650 miles from home in WV and the truck overheated and I saw coolant leaking from the area above the passenger side rear tire.
View 9 Replies
Its been awhile since I have been on. Everything has been running great for me until I found my passenger side front axle leaking fluid. I'm sure something has been posted on here but I have limited access to internet right now and need to know what I am getting into to change the seals. From what I have found there is an inner seal in the pumpkin and then an outer seal and dust cover. Are both of these easy to change? Are there any special tools needed? Do I need to remove the gears in the pumpkin? If so, is this difficult and any special tools required for this?
Mine is a 2001 V10-6.8, 4x4 no mods at this point.
View 14 Replies
So this morning is just getting better and better. Was coming back in from getting the mail and noticed a small puddle under the passenger side tire/wheel area.
I never ever have a puddle of any sort in my drive way so...I start crawling around the truck and this is what I find. I can free spin the dust seal, but its all the fluid that has be worried. With less then 4 days till I have to haul everyone to the airport this is not what I need.
IF (man I feel stupid for asking) IF I leave it in 2 wheel drive how big of an issue would it be to drive it?
None of the parts will be in before I have to drive everyone out to the airport, this is the only reason I'm even considering this..
Plus would this explain a sudden lost of MPG?
View 12 Replies
Just as the title states. The thing I'm wondering is how this happened; I haven't hit any hard bumps nor has the right front had any sort of collision. My guess is it started to leak out about 5 days ago which triggered the low washer fluid light and when I went to put more washer fluid in it tonight it just starts dripping (about half second intervals) out of the valence.
View 1 Replies
This guy started as a slow leak. Now leaks down entire coolant res whether engine is running.or not. Appears the connection to the rest leg isn't sealed. Not sure if available from factory, or if I should cut it out and replace with barbed tee and hose clamps. That's my inclination. Not a ton of room to work with. I think it's an excursion specific thing, from pics I don't think super duty has a t there. Guessing it's where rear coolant line tees off?
View 7 Replies
Today while I was working I walked back to my truck after finishing the job and saw a red fluid leaking from behind the front bumper, I crawled underneath and saw that it was leaking from somewhere between the plastic cover for the fan and the radiator but I couldn't find exactly where it was coming from, I drove 30 miles before I got to the job site with my ac on, and my ac was making a noise that seemed like a whirling noise but I kinda brushed it off as the condenser going bad or whatever. After I found my truck leaking I decided to drive 20 miles to the next job site but this time I left the ac off and nothing happened the temperature gauge didn't even go up, I checked underneath when I finished driving and there was no more coolant leaking from the radiator. I drove it an additional 50 miles before I got home and still no leaks. Could the bad ac system cause coolant to leak? I have a 2000 excursion 5.4L V8
View 14 Replies
My truck has a 6 o powerstroke. I noticed some coolant loss, which I've been monitoring since I had the truck studded 2 years ago. Today I was looking around trying to find a cause of the coolant loss and I noticed some crusty orange residue on a hose that runs under the coolant reservoir. The hose seems to go behind the valve covers along the firewall to the passenger side through a steel line, and then go in a loop back to itself?
I'm guessing it's for the heater core, but I didn't see where it actually goes into the heater core, or anything else for that matter. It is a molded hose that has one of those crimped transitions into the steel line, so I'm not sure if patching it is an option or if I should look at replacing the whole piece. I'm guessing it's going to be expensive. From the fact that it never failed before, I'm thinking it wasn't originally routed with it touching the valve cover and was just something that happened after having the body off during the stud install.
View 7 Replies
I've just finished a marathon replacing the y-pipe, and doing the IPR screen. I had many seized/stripped bolts to contend with. 2 I had to cut off in the most awkward places.. Anyways, it all came together and completed the project late tonight...
Befoer even starting the truck I noticed coolant dripping from passenger side manifold/block heater area.. I obviously must have damaged something in my reefing on turbo to get it lined up with exhaust pipes, etc...
I cannot see the source of the leak, but it seems wet above the block heater, but pools there then drips.. I'm curious where to look. Could I have damaged the EGR cooler and its coming from there? At the manifold joint closest to the back, is there coolant flowing there? I am pretty frustrated, because after going through a day like to day, ripping my arms to shreds, straining for 12 hours straight, then having yet another issue to figure out...
Also this is as best as I could get the y-pipe to meet the turbo... slight gap at bottom.
View 9 Replies
2005 4wd excursion. I have a leaking rear seal on passenger side.
I have the hub assembly off. I'm down to the spindle. My old seal came out in pieces. There's either a piece of the old seal or another seal on the back of the spindle.
Are there two seals? This what looks like a seal still on the spindle against the plate on the back...
View 1 Replies
So broke down today and have no tools, in a city I don't live in. Huge coolant leak behind the block on the passenger side. Luckily we broke down right at a mechanics shop. They need to take off the manifold to get to the rusted out metal piping in back.
I am new to the V10. Looking for information on what could be leaking back there? I know I could do this myself but I need to know what parts I might be dealing with first. And its tight quarters back there.
View 12 Replies
Noticed some spotting in front of the house, and saw some leaking coming from the driver side near the axle. I'm guessing it's the axle seal leaking. I recently switched in to 4x4 about a week ago, shortly after that I noticed the leak. I have a trip to San Antonio coming up in the middle of Feb, about a 650 mile round trip. Can I continue with the plans and get it fixed afterwards?
View 2 Replies
I have a 2012 with 41k miles on it. I noticed it was leaking oil from the front of the motor. So...I checked the oil and found it to be over full. Assuming I overfilled when I changed the oil (2000 miles ago) I changed the oil again and made certain it was filled properly, 13 qts right in the middle of the dip stick. The oil leak stops. 1000 miles later the oil leak starts again. Too much oil again and the coolant is mysteriously low!!! The dealer can get me in two weeks from now.
Time to get the 7.3 back on the road, I knew I kept the old girl for a reason. 262k of miles no truck should endure and still going strong. I was 21 when I bought the 7.3 (16 years ago) and beat the crap out of it. This truck has been pampered compared to my past trucks. I was hoping to get 14 years out of this truck too.
Is the motor OK after having coolant sloshing around in there? I just hope ford stands behind this one. I have a feeling it's not an easy fix. I am sure glad I left everything stock.
View 3 Replies
So I had a stuck caliper on the driver rear side. I pushed the piston back and checked everything to make sure all was in working order. After some though and reading about the calipers getting stuck which old brake lines, I decided to upgrade the line with the Russell stainless steal lines.
I got all the lines put in but I seem to have fluid leaking on the passenger side fitting which I can't seem to get to stop. I put the old line back in but it is still leaking. I am not sure what I need to do or check to get it to stop. It seems to be leaking from the thread area. I checked the fittings and they don't look cross threaded so I don't understand why it may be happening.
View 3 Replies
I've had my early 99 f350 7.3L for a lil while now. Starting to see few problems surfacing. while doing my weekly fluid levels found oil in coolant and after looking around found oil covering bottom of driver side engine. As far as i can see it looks like oil cooler leaking from front side.. Should i just replace oil cooler or rebuild?
View 4 Replies
I recently did the water pump and hoses due to seeping around the water pump gasket. While there, I decided to replace the overflow reservoir as well - old and slightly discolored. I'm now on my 3rd overflow reservoir - they are all leaking at the front seam. I don't think I have a blown headgasket or injector issues - no signs of white smoke ever, and there isn't any oil or fuel in the coolant. I've also tried a new cap, but it's starting to leak before I build any noticeable pressure - I can back off on the cap and don't get much pressure released. So - just bad luck on parts from Ford? All were OEM from different Ford dealers.
Pics - hard to see on here but go to Imgur to zoom in. [URL] ...
1999 F350 7.3 CCLB Dually. Stock except for DP Tuner and Gauges.
View 7 Replies
Girlfriend's Escape is leaking from the front passenger side. I can see where the fluid is coming from, and hear a hiss when the brake is applied.
I think she just needs the one line replaced- what's a ball park cost?
View 18 Replies
My front carrier is leaking at the bottom of the Ring and Pinion Cover. I am going to pull the cover and replace the gasket. I am also a believer in Amsoil full synthetics, should I use the Severe Gear 75W-90, Severe Gear 75W-110 or the Severe Gear 75W-140. How many ounces does it take. I presume to fill until the bottom of the fill hole? What are the torque specifications for the bolts?
View 14 Replies
I have a 2001 expedition 5.4 ltr that has developed a coolant leak. Leak appears to be on top of the engine, in front on passenger side. The area around the front fuel injector (on passenger side) is wet and water is running down and sitting on top of engine (under intake manifold). My first thought was that the heater hose extending vertically from the block hose fitting. I have found no evidence of a leak in the hose but it appears fitting on block may be the source. It has three bolts holding it onto the block. One from the top and two coming up from the bottom. Two of the three area accessible. How to get to the upside down bolt nestled between hose fitting, block and valve cover. It's been a slow leak so far but I know that's not going to last. Runs fine but steams from water on block at stops and when parked.
View 2 Replies
Two weeks ago I was driving home from work and my heat stopped working. I pulled over and saw coolant dripping badly out of the bottom of my truck. I popped the hood and sure enough, coolant was bubbling out of the front passenger side of the intake. I took it to a shop to do the work (quoted at 500-550 out the door with a dorman intake). A week goes by and I get a call from the shop, "After two Dorman Intakes, the truck is not running right", what it could be.
The truck has 367k on it (not sure if original motor). Yesterday I get a call from the owner, " we put the original intake back on and fixed the leak with jb weld. The truck still runs bad. They claim they didnt do anything wrong and will not take any blame for ruining my engine. (Keep in mind the truck ran PERFECT when I took it in there). The truck doesnt throw any codes and they are at a loss of what could have happened. They put in 8 new plugs and 2 coils that they broke while in the process of removing the intake. F150 5.4 ...
View 3 Replies
