Ford Excursion :: Brakes Smell Emanates From Right Rear Wheel / ABS Light Comes On
Feb 28, 2012
2002 Excursion Limited V10, 96k miles...
History - 3 of 4 calipers have been replaced, to include the caliper on the suspect wheel, along with new brake lines. On occasion, while driving, i can smell the brakes. It emanates from the right rear wheel. I'm reluctant to think it's the caliper. At this point I'm thinking the him needs replaced. Any reason for this too is, on occasion the ABS light will flicker on.
I'm uncertain as to the cause of this because of it's intermittent nature - both the brake smell and the ABS light. When the ABS light comes on, it only flickers on, but when it goes out, the speedometer will drop to zero and come right back up. The truck has an electrical ghost, I know. For that matter, the door ajar light is always on, and the codes say it's all four door sensors - it's not the sensors, and it's not the GEM.
More importantly, though, I need to figure out the issue in the right rear wheel.
View 6 Replies
Advertisement
After smelling burning for a few days randomly, I've narrowed it down to the rear driver side wheel. After about on the highway, I stopped, and it is HOT! I pulled the wheel but the hub spins easily 1/16th of a turn or so, as it's in park, so the brakes are not dragging. What else this could be? Or are they dragging at random? The rotor is perfect, no rust and no groves, so hte pads are doing their job. 1/16th of a turn is way exaderation, but it can move. Also there's no sounds at all.
View 13 Replies
Before I get started... My truck is a 2006 F-250 Super Duty XLT 6-speed 4x4 with a Limited Slip.
I just got finished with a big job on my truck. New pads all the way around, turned rotors, new emergency brake shoes, hardware, and backing plate as well as replaced the rear wheel bearings both inner and outer as well as the axle o-ring and inner seal. Also, took off the rear pumpkin cover painted it and put fresh fluid in, went with Mobil 1 75W140 LS.
Took it for a drive and the brakes work great. Followed the directions for breaking in the emergency brake which worked fine.
Now the problem is I'm getting rattling from possibly all of the wheels. Definitely from the front driver and at least one of the rear wheels. It was so dark I didn't get a chance to look at it I just pulled it back in driveway.
I'll start looking at things tomorrow but, any common mistakes or things I should check first?
View 1 Replies
I was fueling up my 06 F-250 yesterday and smelled hot brakes. I checked and found the right rear was really hot. After it cooled down I was able to drive on home and it was not too hot when I got here. I was towing a trailer with my tractor on it so I had a pretty good load. It was over 6 miles to my house with stop and go traffic and no hang up. What should I do to keep this from happening again? I don't drive this truck much but when I need it, I need it to be dependable. It has 99k on the clock and is a gas job.
View 1 Replies
Here's what I am running into. I have factory setup and it doesn't feel adequate. I get vibrations, lots of brake dust on front wheels, and just don't feel I have the stopping power if needed in emergency or towing. Especially with how heavy my 6.0 is already.
View 12 Replies
I am getting a burning smell from the drivers side rear wheel. It does not seem to occur all of the time but when it does, when I get out of the truck I can smell it. We found its location just by smelling around the truck.
The brakes are not noticeably grinding and I don't recall ever getting a smell like this from brakes.
View 14 Replies
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
View 7 Replies
Driving home today I started smelling a burnt clutch smell!
Well since I have an automatic, I wasn't to worried until my 6 yr old gets out when we get home and says "DAD something stinks really bad out here!"
Get out and wow!! I have never had a caliper lock up on any vehicle I have ever owned! It stunk like I burnt a clutch out of a standard tranny!
So I start poking around and the left rear caliper is locked up, rotor is blue and you can hear it popping like a valve spring cooling down.
So my question is is there anything to look for other than the normal? I will be getting the brake system power bleed after I replace the caliper. I already checked the brake lines and there are no obvious issues. It is possible the rubber inner lining is toast.
View 14 Replies
The pads were replaced 5000 miles ago. Today the truck is acting hard to go, brakes are squealing, and I noticed a hot brake smell. I got home, grabbed a remote thermometer gun and the front rotors are 130 degrees, the back ones are 650 and 700 degrees! Super hot. I'm going to NAPA for new calipers and pads. I hope that fixes it.
View 3 Replies
I have had the truck just under a year. It has 104k on it i only drive it on weekends. Last weekend going to Home Depot about 15 miles got out and could smell brakes burning. Felt the wheels and the right rear was very hot. Got back home no smell but still hot not as hot as earlier. Pulled the wheel off it looks as if the pads and calipers are fairly new paint is still on them caliper is a TRW. The pads were stuck in the carrier even the stainless clip ends look rusted.
Cleaned it all up both sides lubed the pad carrier with pin lube. Pushed the calipers back in some both sides went in easy. The right rotor has definitley been hot. Put it all back together and went for a test drive. Came back no problems checked the temperature with a laser type heat thermometer all wheels were around 140 f. Went out yesterday morning stopped and could smell the brakes again. Drove it back home and the right rear was 300 f. others 150 to 160 f.
Jacked it up put it in neutral and the you can spin the wheels by hand. Started the truck had the wife get in put it in drive wheels turning applied the brakes they stopped let go they turn freely again tried the parking brake it works fine also. So do I buy new calipers and brakes or maybe is the wheel bearing going bad causing the brakes to heat up?ied.
View 5 Replies
I am going to have to replace the rear dust shields and emergency brakes soon. I was wondering if we have this documented somewhere. The main question is do we need to remove the axle to replace the shield.
View 9 Replies
The right rear wheel is getting hot on my 2001 ltd 4x4 7.3. It also has some smell of brakes. That wheel had a new caliper, and pads as well as a new line about 2 years or 15K ago. What should I look at first? Could the emergency brake be sticking?
View 2 Replies
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 Replies
Rear steel brake line ruptured the other day (was pretty rusty). Despite being an idiot in regards to automotive repair (among many other things), I decided to give it a shot. I was able to get the damaged section off, went to Autozone with the broken piece, they matched it up, were nice enough to cut it and put on one larger fitting (because the two were different sizes) and flare it for me.
I was able to get the one side (at the T fitting) on OK. That was the "new" side, the one they flared at Autozone. Looks good. No leaks.
The stock side, at the passenger side caliper, leaks like crazy. Not out the threads, but out the hole through which the line passes. Know what I mean?
I'm having a hard time figuring out what's happening, because I'm not sure how this thing works. Does the line fit flush to something inside the connection at the caliper? Is it a bad flare?
It did not go in easy, but the new one was just as much trouble as the fitting that came out (stock?), so it must be right.
View 9 Replies
Got home from work last night, passengers side rear wheel was smoking, and damn hot to the touch. Drivers side rear was hot, but not as bad as passenger's side.
My first thought was worst case sceneries - wheel bearings. After getting it in the air, in neutral, I can turn the wheels, but, it takes a lot of effort. There's no grinding noises, but, it sounds like a brake is in constant contact.
I'm in the process of taking both wheels off, but, I'm leaning towards either the brakes/calipers or the ebrake dragging. It definitely smells like hot brakes, and not diff fluid.
View 14 Replies
I have a 2000 7.3 with about 114,000 miles. I just had my water pump, thermostat and belt replaced about a week ago. I've been driving the truck since and everything feels normal. This morning I drove the truck to work and parked it for about 10 hours. Got in it after work and everything started up fine. I noticed the brake light on the dash was lit up which I thought was odd because I never use the E brake. E brake wasn't on and I stepped on the brake pedal and it felt like I had no brakes. I turned the truck off and didn't try driving it, I didn't want to risk anything if I didn't have brakes.
View 2 Replies
My 97 f150 had been sitting for a while and after a few miles I could smell brakes and the left front rotor was hot. So I removed the caliper to see if I could free it up. When i push 1 piston in with a C clamp the other one comes out and visa-verse but I cannot push both in with 2 C clamps. When I push the brake pedal they both come out. Its like there is a check valve in the line. How should I go about trouble shooting this?
View 1 Replies
Today I noticed a strong burning rubber or plastic smell coming out of the right rear wheel well. All other wheel wells did not have this odour.
We had a bout of freezing temp's here recently and some snow, I'm wondering if the brake on that wheel may have seized slightly through the all wheel drives tourque vectoring or through parking brake use.
I'm going to drive it to the dealership tomorrow without making an appointment in hopes they will look at it right away as making an appointment this time of year is probably going to take forever.
Something I might be missing or can do?
View 55 Replies
A few months ago I bought a used 2008 Mazda3s sedan, and ever since I get an intermittent burning rubber smell from my rear left wheel. I recently got new tires, brake pads, and had the rotors turned, with no change.
The smell does not always happen, it will be there maybe one out of 3 or 4 times, and it is more likely to happen after long drives (e.g., one hour highway driving).
The wheel well also feels very hot. The obvious answer would be that the brake caliper is sticking, causing friction, heat, and the burning smell. However, if I touch the rotor it feels the same lukewarm temperature as the other three.
One additional thought is that this is caused by the exhaust, which is right next to this wheel well. I have noticed that the area of the floor of the trunk right above the exhaust gets very hot, which I had not seen in any other car I owned.
Could it be that the exhaust is causing the rubber of the tire (or something else) to overheat and smell bad? Visually, it does not look like the tire has a different wear or different appearance, compared to any other one.
This may or may not be related: my handbrake seems to be useless If I leave it on I can easily drive with little to no noticeable slowdown... I guess the previous owner did not read the part of the manual where it says you have to release the handbrake before you drive.
View 1 Replies
I have a 1997 F150, 4X4. My mechanic says its time for new brakes and was curious if it would be worth possibly converting from drum brakes to disc brakes??
My mechanic has quoted me $300 to do the rear brakes, would it be worth the extra money to convert??? I really don't care for drum brakes. I have done a search on the internet and every time it brings up the issue with the parking brake.
View 1 Replies
I just got a 2009 Corolla S back in October. Everything is great so far. Until last weekend when I was driving uphill on the streets of San Francisco where I noticed there's a distinct burnt rubber smell coming from the right rear wheel.
Have this issue after driving on a steep climb? My first oil change is coming up soon and I'll mention this for sure with my dealership. I checked the web and the forums here and nobody have seem to mention it yet. I have an auto transmission by the way.
View 14 Replies
