I towed my friends car hauler yesterday for a short distance for him. I had no turn signals or 4 way flasher while towing. After dropping off the trailer still no signals or 4way flasher. I parked and checked fuses all were good and signals started to work. But still no 4ways. Any thoughts on what to look for. Never had this before. I have blown a fuse before and always been able to find and fix.
View 13 RepliesTurn signal flasher doesn't work in the heat. What gives?
All lights work. Turn signal stalk works fine. It just flashes a couple of times, then stays on. Everything works fine in cool weather, but it rarely works at all when the temperature outside is above 90 degrees. Very annoyed.
My 2000 Excursion 7.3 Limited started something all new this week. No brake lights, signal lights or flashers. The signal flasher relay is only a couple months old, but I don't think that's the issue. If I sit for just a moment with door open or park lights on, the truck is too week to start. Batteries seem fine and ALT is 14 volt charging when running (ALT replaced with used ALT about a month ago). Further, it has started having long starts like the glow plugs are not cycling. Any clue as to what might be going on?
View 1 RepliesMy 97 F150 4X4 's turn signal flasher buzzes all the time except when brake is depressed or turn signals or hazard signals are active. The flasher is a 5 prong one. What to check?
View 9 RepliesI'd like to put in a louder turn signal flasher on my 2007 F150 - where is it located and where I can get a louder one ?
View 1 RepliesExactly where that part is, pictures would be useful. Pretty much just had my whole dash apart with no luck. Switched to leds, and can't stand hyper flash like I thought I could. Trying to pull it to make sure I order the right part to correct it.
View 11 RepliesI have a '97 AWD and my brake light, turn signals and emergency flasher have stopped working. I've checked all the bulbs, checked all the fuses (under the dash) replaced the flasher just in front of the fuse box...nothing. All the running lights work, and the 3rd brake light above the rear door window works.
View 3 Replies2015 prius package 5 w tech package and HUD display, I found a flasher mounted up between the fuse box/ module assembly mounted on a clip! I have a led replacement flasher, but clip mounts and pin locations don't line up? I watch the video but I have nothing in area! Or I just need to install the resistors? Or it could be a combination circuit assembly where multiple function module all in one ?
View 1 RepliesI'm having an electrical issue that is driving me nuts. I have an '01 F-250 Super Duty that I just put a new battery in today. The truck normally runs great, I drive it to work everyday with no issues. Today, there is a noise coming from under the dash that sounds like the turn signal flasher, and the clock on my radio flashes in time with the noise from under the dash. All my lights are working ok, and all the idiot lights come on as usual when I put the key in the ignition and turn it to the on position. However, my truck won't start. It won't even turn over. I get nothing but a dead switch when I turn it to the start position. The starter solenoid doesn't even click. Like I said, yesterday everything was just fine. I knew my battery was going bad (6 years old), so I changed it.
View 4 RepliesI want to install some LED turn signal bulbs and lights but the flasher will flash twice as quick because of the burnt-bulb detector.
I have taken the flasher apart and tried all the tricks on the book to isolate each pin on the IC and changed the timing resistor without avail. I do not want to put in load resistor on the bulb end to fool the detection circuit.
I want to modify/cut off the detection circuit?
I have an '07 Azera and the turn signal sound is intermittent. The signals flash normally, but sometime I hear the flasher sound inside the car and sometime it is dead silent. Cannot seem to correlate it to temperature or other factors. Any way, I assume as the lights flash with no sound that either the flash or the sound is electronically generated, but cannot be like an old school mechanical flasher. What makes the flasher sound in the Azera and where is it located?
View 1 RepliesSo with 172,000 miles my truck has started a new trick. When I turn on the turn signals theyll flash or interrupt normally for a few times then stop. After I turn the signal lever off and back on again they start to flash again only to stop after several times. This happens to both the left and right hand sides. The emergency flashers seem to work alright. Is this a function of the indicator flasher SF631? If so, were exactly is it located?
View 5 RepliesWhere is the signal flasher relay located. I can hear it but can't track it down.
View 5 RepliesI'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 RepliesMy driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 RepliesPut a new bulb in the right front turn signal, still doesn't work (parking light works though).
View 10 RepliesI installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
I've got a problem with the turn signal on my '01 V10 4x4. 3 out of 4 times I hit my turn signal, it immediately resets because my wheel may not be perfectly straight. If my wheel is not straight or turned significantly (>180 degrees) the turn signal will not reliably latch. Its a minor annoyance that could turn into a safety concern.
Is there anyway to adjust the latch mechanism?
My wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
I got my headlights swapped but the turn signal sockets can't go into the housings. The old bulb socket thing is a 90 degree twist in and it would twist in if there was room for the socket to twist. The back of the housing has a blocky lumpy thing in the way and I need a straight in socket I guess.
View 14 Replies