Ford Excursion :: After Standard Brake Line Replacement Fluid Leaking On Passenger Side Fitting?
Mar 27, 2017
So I had a stuck caliper on the driver rear side. I pushed the piston back and checked everything to make sure all was in working order. After some though and reading about the calipers getting stuck which old brake lines, I decided to upgrade the line with the Russell stainless steal lines.
I got all the lines put in but I seem to have fluid leaking on the passenger side fitting which I can't seem to get to stop. I put the old line back in but it is still leaking. I am not sure what I need to do or check to get it to stop. It seems to be leaking from the thread area. I checked the fittings and they don't look cross threaded so I don't understand why it may be happening.
View 3 Replies
Advertisement
Its been awhile since I have been on. Everything has been running great for me until I found my passenger side front axle leaking fluid. I'm sure something has been posted on here but I have limited access to internet right now and need to know what I am getting into to change the seals. From what I have found there is an inner seal in the pumpkin and then an outer seal and dust cover. Are both of these easy to change? Are there any special tools needed? Do I need to remove the gears in the pumpkin? If so, is this difficult and any special tools required for this?
Mine is a 2001 V10-6.8, 4x4 no mods at this point.
View 14 Replies
On my 2003 Excursion 7.3L, I notticed I'm leaking what I think is coolant from the passenger side rear hard line by the front spring hanger. I haven't pealed the plastic loom away yet, but I did see the loom is chaffed near the spring hanger. What lines are the ones that carry coolant, and can I just cut the hard lines and replace with a section of rubber hose?
View 3 Replies
This line is rusted out on my V10 and leaking fluid.
How hard/expensive is this to fix?
I'm in the middle of doing my exhaust manifolds right now, so I'm hoping it's a simple bolt-on fix.
View 8 Replies
I have a 2005 F350 XL Heavy Duty 6.0L truck that has 68,XXX miles. I recently changed the rear brake pads and about a week later the rear passenger side is leaking brake fluid. The fluid is slowly dripping from the bottom caliper bolt but i am not sure if there are seals in this area. the driver side is fine and the fluid is only leaking from the bottom caliper bolt not the top.
View 2 Replies
Well the time has come where I don't like the way my brake lines look running to the back of the truck. Question is, What size are the fittings on the ends of the lines? I know I will have to special order the line that goes from the frame rail down to the rear axle tube, but is the line that goes from there to mid way frame rail a standard size? I don't want to have to order that if I don't have too.
View 1 Replies
Did ball joints this weekend and now have little axle fluid leaking out passenger side. was going to change axle fluid when i saw this so continued and when pulled the fill plug i would say 8oz or more came draining out. Did I mess up the seal inside the tube?
View 5 Replies
I would like to replace the brake line to the rear brakes, and I noticed that the brake line-to-ABS unit fittings have different threads. I already replaced the line to the Left-Rear brake, and it had a fitting with a thread M10-1.0. I tried to replace the line to the Right-Rear brake using a similar fitting M10-1.0, but it did not work. I just damaged the thread on the brake line fitting itself. Then I noticed that the thread on the current Right-Rear fitting is different. what that thread size should be (the fitting to the Right-Rear brake line)?
It is 98 Regal LS 3800 engine.
View 3 Replies
My front driver side brake line broke. It had a typical double flare fitting at the caliper but at the distribution block on the other end it had a flared fitting that would be used on a industrial hydraulic unit. I took it to the NAPA store and they told me to cut the nut off the old line and put it new line and double flare it. I did and it leaks. Do I need a special fitting on the end that goes the distribution block?
View 2 Replies
It seems that the install of my Doug Thorley headers didn't go as well as I thought. Turns out the passenger side header melted the bracket holding the heater lines and then punctured one of the lines when it rubbed against the header. Right now I'm not sure what to do. I noticed the melted bracket and pulled the fender well, but that's when I noticed the leak. I guess some of the melted plastic was keeping it from leaking everywhere until I removed it. I live in AZ so the rear heater isn't really necessary so if a stop gap measure is to bypass it then I'm game but I can't find any info on how to do it. If the only real solution is to get the entire line replaced then I'm a bit hosed I guess. 2001 V-10 4x4 BTW.
View 6 Replies
The brake line on the passengers side went bad. Called ford for replacement and they said ford is not supplying that line any more. Where I can get a replacement? Its hard line and connects to the rubber line.
View 2 Replies
I have a 2006 with 15,000 miles and I have noticed under the front of the car on the passenger side there is some type of oil or fluid leaking. Its not leaking on the ground leaving a puddle its some type of build up. What could it be from? When in service for oil changes service never noticed anything. I am due for 15,000 oil change and want to have it checked.
View 1 Replies
2003 Limited 6.0 130K. Just took a 1000 mile trip for spring break. While away, I noticed a small leak near the front passenger side of the truck. It is red so I assumed it was transmission fluid. It is leaking from, the best I can describe, a small housing that looks like it might be a filter near the tire (it looks like the old style canister oil filter housings). All the hoses are clean and where the hoses go into the radiator are clean. Is this an easy fix? I am a bit worried about trying to get the thing off without damaging the hoses.
View 3 Replies
2005 4wd excursion. I have a leaking rear seal on passenger side.
I have the hub assembly off. I'm down to the spindle. My old seal came out in pieces. There's either a piece of the old seal or another seal on the back of the spindle.
Are there two seals? This what looks like a seal still on the spindle against the plate on the back...
View 1 Replies
So this morning is just getting better and better. Was coming back in from getting the mail and noticed a small puddle under the passenger side tire/wheel area.
I never ever have a puddle of any sort in my drive way so...I start crawling around the truck and this is what I find. I can free spin the dust seal, but its all the fluid that has be worried. With less then 4 days till I have to haul everyone to the airport this is not what I need.
IF (man I feel stupid for asking) IF I leave it in 2 wheel drive how big of an issue would it be to drive it?
None of the parts will be in before I have to drive everyone out to the airport, this is the only reason I'm even considering this..
Plus would this explain a sudden lost of MPG?
View 12 Replies
Recently I took my 2006 Subaru Outback wagon on a trip in the mountains. I parked my car in the driveway overnight and noticed oily fluid on all of the tiresand on the ground in the morning. The fluid spill was worse on the driver's side front and rear tires, but was noticeable on the passenger side as well. I did not notice an odor to it. I used the brakes alot on the way back down from the mountains..... I have taken this car places where I have used the brakes a whole lot but have not noticed this before. How bad is this? Is it possibly "normal?
View 5 Replies
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
View 7 Replies
So my 2000 f350 is leaking transmission fluid from the cooler line. It goes to the rear of the transmission, but where does it go to from there?
View 5 Replies
I think the top AC line that runs from the back of the compressor is leaking on my '01. It looks straightforward to replace, but I don't have any way to evacuate or recover the R134a refrigerant. Is this something that an AC place has to fix, or is there a way to do this on my own?
View 1 Replies
I have a leak in my rear wiper fluid line on my GTI. When I use the rear washer, I get a pool of fluid in the driver side taillight and under the rear seats. I'm getting some fluid in the rear driver side headliner as well so the break must be there. First step is to pull the headliner.
View 4 Replies
I have a 2003 Ford Excursion with the high pressure line leaking. My guess is that the original line had a rubber hose and was replaced with a 3/8" ID high pressure hose. My problem is that I can not get the 3/8" ID replacement hose over the second larger bulge on the line going to the radiator cooler. What am I doing wrong?
View 3 Replies
