Ford Excursion :: 2004 6.0 Just Cranks Over But Won't Start After Warming Up
Nov 9, 2014
I have researched a little and believe i have a leak in the high pressure oil system. My 2004 Excursion 6.0 will start when it is cold but after warming up will not start it just cranks over. So here is my question; the two wires leading from the Turbo had melted and shorted and in fixing that i loosened what i believe to be an oil line feeding the Turbo. Could this be the problem? Also is there an O-Ring that seats the line into the block that may need replaced?
View 2 Replies
Advertisement
My 2004 6.0 will not start. It cranks fine. History This happened once before about a year ago towed it into the shop and it stated fine.
The batteries were low yesterday and the truck would not start because the voltage was too low to run the starter. I charged them. Went to try again and I cranked it for close to 30 seconds with no results.
Only cods so far are #6 glow plug and EGR valve open. Whats next, check the FICA?
View 8 Replies
My 6.8L is experiencing an issue. Truck hasn't been ran in a few months...it ran fine when it was parked and has sat longer than this with no issue before. Battery voltage fine...
I get in, insert the key, turn it over and it cranks but doesn't fire.., why is that, I wonder? I notice the SES never goes out before I crank the truck over.
I unplug the battery, tried to clear any fault codes with my handheld tuner (which there was nothing showing up) and turned the ignition on. I left the key in the on position but didn't try to start it. The SES lights never turns off.
I am assuming that if the SES light stays on, the ecu will not allow the truck to start...is that true? What components have an effect on the SES light when you first turn on the key?
View 9 Replies
Had the Excursion out today. Made a stop coming back and used the remote start. I entered the truck and by mistake pressed the brake pedal which shuts off the engine. When I tried to start the truck with the key...it cranks fine but does not start. It'll try to run, sputter...but will not run.
I cannot hear the pump running when the key is turned. It was towed home and it in the driveway. I assume it's the fuel pump....but wondered if the remote start/alarm could be killing the power to the pump? The cut-off switch in the passenger footwell is pressed in. Where do I start:?
View 14 Replies
Been having an odd problem with getting my truck to start. Pass couple of days I've gotten out from work and gone to start the truck. It cranks just fine but wont start, acts like there is no gas. Let it for a minute or two and try again and it will start right up and keep running with no other problems. Go to leave for the work the next day and the same issue. Weird thing is the problem only seems to happen when its cold out 30F so or below. I was thinking fuel pump but I'm not sure. What to check?
Edit Its a 2002 Excursion XLT with the gas 5.4
View 8 Replies
2001 Ex V-10 4x4. Ran like a top yesterday. Turns over fine but not even a sputter today. Plenty of fuel & battery. Has spark. Tried starting fluid, but nothing. No codes. Checked fuses and relays in dash & under hood. Fast forward an hour...
Went out and tried it again - fired up like nothing ever happened. Plowed snow for the better part of an hour, - ran like a champ again, smooth, no missing or stutters - parked it and shut it off. Tried to start it again within a minute or so and it would start, run rough & die. Tried a few more times with same results. Now it cranks fine but no start, no sputter. Gonna try a fuel filter tomorrow.
If it were the fuel pump, wouldn't it throw a code?
View 7 Replies
I have an 05 diesel. I have noticed the last 3 days I needed to crank it slightly longer to start it and it takes a second before ideling normally. It usually fires right up and jumps to life. Today i drive about 45 minutes. Stoped for about 30 minutes and shortly after I started it back up the check engine light came on. Will the Ex flash you the codes or do you have to have a reader? Thought I would try Autozone tomorrow but not sure if they read deisel codes or not. I was suspecting maybe glow plugs but who knows at this point. It seems to be running fine and I checked all fluids.
View 13 Replies
I just changed the alternator this morning. Hook battery back up now cranks wont start no security light flashing no security light blinking at all. When turn ignition over gauges do not swipe don't remember if they normally did or not but now they do not swipe as in speedometer and RPMs. I've also been having trouble with the no windows no radio. Just driving down the road and radio cuts out and power windows hear a click under the dash radio coming back on Windows work again research and see if it's in the battery save circuit inside the dash cluster wondering if this is causing no start now.
View 14 Replies
2000 7.3 Excursion. Truck ran fine on a 5 hour trip for family vacation. Pulled and to where we were going turn the truck off then what I had to do I came outside try to restart the truck for the next three days it would take 2 to 3 cranks before it was would start. Then on day number three tried six times and didn't start went to bed woke up the next morning and it took three cranks to start. drove it down to mechanic shop near me they have been troubleshooting and think it's an electrical issue the code is P1280; he said there were a couple other codes too and he would tell me what they were later but he never has. I took him a new CPS a new ICM and a new PCM, none of that fixed it. I am at my wits end here and really have to have my truck for work every day.
View 12 Replies
Ok so... have an 04 that has more issues than Playboy magazine... any DIY tips or tricks...
I dont have an original key but the key I have has worked before. Motor cranks but wont turn over. Have tried the battery unhook thing, didnt work.
View 4 Replies
I just purchased a 2004 Explorer from a police auction. It had driver side damage but nothing major. When I try to start it it cranks but nothing else. I purchased a new battery, fuel filter, coil packs, spark plugs and installed all. But same thing it tries to fire up but stops short. A few times we sprayed starter fluid in it and it would start for about a second and a half and shut off..... I also listened for the fuel pump and I hear it coming on when I turn the key and checked the inertia switch...
View 9 Replies
Truck has been running perfect and is my daily driver. Went grocery shopping with the wife and made two stops and drove it home. Parked in the driveway. No hint of any issues but when I went out a couple of hours later we went to head out to dinner and it cranks and doesnt start. Nothing out of the ordinary anywhere. No check engines lights, no theft lights flashing, nothing to indicate an issue. Engine sounds perfectly normal cranking, I can hear the fuel pump when I turn the key. I cleaned the battery terminals today because they had some corrosion and I checked all of the fuses that have anything to do with fuel or fire and nothing was blown.
I also went and bought a Fuel Pump Drive Module and installed it and still nothing so I took it back.This is a pretty pampered truck, not a torn up beater. What else I should check? Will probably town it to a shop tomorrow if I dont have anything else to try but I am at a loss at this point. I tried to listen with a stethoscope and I dont hear the injectors firing or the COP's. Oh I also shot it with starting fluid and nothing happened so I dont believe its fuel related. I think something is keeping it from firing the COP's or the injectors arent firing. But what could it be? Nothing happened to the truck last time I drove it. Oh I did check the fuel pump cutoff button as well. Nothing there either.
View 11 Replies
My 2005 cranks but will not start. I spray starter fluid in throttle body and it will start but won't stay running. I've replaced the fuel pump and the fuel sender unit which is located under the spare tire. After I replaced the fuel sender unit It started and ran for about 30 seconds. It quit when the fuel line popped off the fuel pump and pushed gas all over the ground. I secured the gas line back on and now it won't start again unless I use starting fluid.
View 3 Replies
2004 3.0L Ranger Edge, 88,000 miles on it, I am the original owner. It won't start. It cranks strongly. Usually when this happens, I have to reset the fuel pump inertia switch. This time, resetting the switch does not work. I disconnected the switch and jumped the two wires going to it, but still no start. The switch seems to work ok, in that I can reset it (a ball, spring, and magnet mechanism, I think), then shake it and the ball will come loose.
The fuel pump 20A fuse in the engine compartment is good. The fuel pump relay in the engine compartment is good (I switched it out with an identical relay that runs the fog lights without problem). I am getting spark. I don't have a fuel pressure gauge but pressing in the Schraeder valve on the fuel rail produces gas.
Usually, when the inertia switch is tripped I can get the engine to briefly start by using starter fluid in the air intake. But not this time. I do not hear the fuel pump kicking in when I turn the ignition key to the "On" position, and that would lead me to think that the pump is bad. Except, I don't get a brief start using starter fluid. The fuel filter has never been changed, but again, since I get no start with starter fluid, I don't see how that could be the problem. OBDII scan shows no codes.
View 7 Replies
I just went out to move my truck to take out garbage and it cranks but doesn't start. It is 4.6L 4WD. I sprayed ether in intake no change. Checked all fuses all good. It has been raining pretty hard the last 3 days and it has been sitting in rain all 3 days. I checked for codes with a simple code scanner no codes. But the code scanner I used is not able to do KOEO or KOER tests. I know it needs new plugs but it has never sputtered or died on me. Has slight misfire but not engine stopping. I havnt had any check engine lights or problems before.
View 3 Replies
Brought a 2006 f350 6.0 from the action and knowing it was damaged from the frame, i went ahead and brought a another f350 6.0 2005 from someone around town, the last owner is calming the truck was stole, and most of the engine was stole, and the windows where damage. ( I just wanted to buy the truck for the body so i can transfer the engine to this one! ) but instead of switching the engine, me and my dad went ahead and only put the missing parts back onto the engine....
I can tell the last owner wasn't telling the truth, and me and my dad where thinking the last owner made up his own story about the truck being stole !! I did a vin check and noting came up about having a bad history!!!!!!!!! I'm thinking something went bad in the truck, and the last owner did his own fault story... Anyways!!!
we finally put everything back in place, and the truck cranks, but does NOT start!! and also has no spark. sometimes it sounds like it does wanna start!! we check the fuel, and wires, oil, fuel filer! everything good, but the truck has no spark, and where not sure if thats the problem. and also switch out the Crank sensor. Still no luck!!
And also there is smoke when we crank. battery are good too, and even left the truck 28 hours on the wire to head up the engine!!
View 3 Replies
Bought a truck from a guy the other day. Long story, but he was a con artist. Told me the battery was dead from cranking it, he couldn't hear the fuel pump so he thinks it needs a new one. Got it home, checked fpdm, it was unplugged. Plugged it in fp running now. Charged battery. Cranks slowly won't start. Appears the engine has been changed. Have codes P0201-208, all injector codes. Cranking it over reminds me of an older distributor type engine that if off its timing. But also of cranking with a low battery. There's a new starter on it already. I'm going to pull the converter bolts on the weekend to see if they may have bound the torque when they installed the engine. Injector codes?
View 4 Replies
My 04 f150 has been sitting upwards in my drive way for a month now won't start cranks great with full power..
View 1 Replies
I have a hard starting condition after warm up. It starts up fine when it is cold.After running diagnostics and coming up with no error codes, I noticed that I smell raw fuel after the car was warmed up and sitting for about 15 minutes. I believe this is the cause of the hard starting condition after warm up.
How do I test the fuel injector for leaking? I think it may be leaking fuel into the throttle body after sitting for a few minutes, causing a rich or flooded condition which makes it difficult to start after it has been warmed up.
View 1 Replies
While the owner of 2 Ford Trucks, I also have a 2004 Ford Taurus with 28K on it. For a while now the vehicle is hard starting, cranks but acts like it is not getting fuel, however, I can hear the pump come on. Other times it starts right up, but a clicking sound can be heard coming from the firewall area. At times the gauges will not immediately respond when the Vehicle is started and then all at once they will begin to work. Now, my check engine light is on, but my hand held obd will not read it. All the terminal pins look great, obd tester works on my other two vehicles, cigar lighter working, the fuses i checked are good. Vehicle runs great. Can this all be related to a bad module?
View 1 Replies
My truck's been having an occasional hard start, meaning the engine cranks strong but it fails to catch and then sputters. The 2nd start attempt usually fires up with no issues and then runs perfectly otherwise.
MPG's haven't changed, fuel filter was changed 15K ago. Air filter is clean. Plugs were changed about 10K ago. I always use Shell/Chevron gas. MAF sensor looked clean when I took it out so I didn't do anything to it.
This is starting to happen more frequently, maybe once every few weeks and I get a feeling it's the start of something. I've found myself waiting a few seconds for the fuel pressure gauge to come up before turning the key to start reliably. In the past, I could simply flick the key and it fires up the first time.
I see posts talking about the fuel pump module above the spare tire. What are symptoms of that going bad? Any pending codes that might be stored?
I'm about to get myself a scanner since I need one sooner or later. Which specific PID's to check while debugging this?
View 6 Replies
