Ford Excursion :: 2003 V10 - Gauges Stopped Working
May 4, 2008
2003 Excursion 4x4 Limited v-10 gasoline engine powered
gauges stopped working
gauges dead
gauges not working
gauges
Coming home tonight, I lost all the instrument cluster gauges. Speedometer, tachometer, fuel, oil, temperature and transmission temperature.
So the logical thing to do was check both instrument cluster fuses, fuse 35 and fuse 41. They were both OK.
Kept looking and found fuse #45 blown, it's the "Ignition switch Run/ Start feed" fuse. It was blown.
Popped in a new one and gauges came back to life. I don't know why fuse #45 controls power to the instrument cluster gauges. Strange.
View 13 Replies
Advertisement
2004 Excursion 4x4 6.0. I just had the fuel injectors & wiring harness replaced and it runs great, but after 30 minutes of driving the complete dash lights/gauges stopped working. I found that the #45 10amp fuse had blown so replaced it and after 20 minutes the same thing happened. While it was working all of the lights & gauges seemed to be working okay. This doesn't effect anything else, still starts & runs okay, turn signals work, head lights work, but the head light auto on/off doesn't.
View 4 Replies
I am working on my son's 1997 F-150, 2 wheel drive, 4/6L truck. He was driving it when the gauges and the tach stopped working. I replaced the cluster and it still blows the fuses. The five amp fuse that is specifically for the cluster doesn't blow. It is a twenty five amp fuse that also power the overdrive circuit, etc.
After replacing the gauge cluster I installed a new fuse and the overdrive button on the shifter started smoking. Where I could get a wiring diagram of this circuit so I can see how it is wired.
View 2 Replies
2003 X limited, 2wd 6.0L
Last week wife's right rear turn signal/brake light stopped working. The left one flashes normally. The right tail light works fine which is a different bulb. I tried changing bulbs (didn't work).....tried a new socket with new and old bulb (didn't work). Could it be a relay? Or not relay as they would be both out (left and right)?
I looked at my trailering wiring plug down by bumper and the white wire with green stripe looks split a little towards the end. Could it be a bad ground or short in that wire? Would the trailering wiring have anything to do with it? I was going to try to replace the relay if I could find it, what is the part number for it.
View 3 Replies
We have a 1999 F-350 V10 super duty. The alt was over charging and the gauges stopped working. Replacing the alt, the guages still don't work, and the new thing is the charge light and selt belt light comes on. The fuses 29 (5amp)and 30(30Amp) which are supposed to be key on hot only are hot at the same time. With these on, it causes a drain killing the battery. Also if the truck is started, the lights go out, but when you try to turn the vehicle off, it stays running, one with the battery disconnected. The only way to shut it down is pull the fuse box power fuse, 50(amp)Some one had been in the dash before we got this vehicle and busted, burned out or removed the check engine light. I can read codes and their vehicle runs fair and does operate. Could this be a dash board? Also this problem appears when the truck is sitting, and the key removed nothing on. No fuses are blown either.
View 3 Replies
My father in-law gave us a 1996 explorer AWD with a 5.0 for my son who is 16. A couple of weeks later he's out learning with my wife and a very strong electrical smell took over the cabin. They came right home and when I got in I found all of the gauges not working. The instrument lights work, blinkers work, but all gauges do nothing. Pulled cluster and wires look O.K. behind it from what I can see. They saw no smoke, just smell, fuses look O.K.. What could cook on this vehicle that would wipe out just the gauges?
View 5 Replies
I have a 2000 F350 4x4 with 7.3L diesel and a manual transmission. While driving home yesterday my gauges (fuel, temp, volts, oil pres) stopped working. Within a couple min the speedometer and the tach also stopped working, but the truck was still running fine. Within a couple miles the engine stopped running, just like I had turned the engine off.
After having it towed home I checked all the fuses, none are blown, but there is no power to fuse #16 (15A, instrument cluster, high beam head lamp). Also in the fuse box under the hood, again, no fuses are blown, but fuse #9 (left head lamp low beam) and #11 (right head lamp low beam) have no power to them.
View 3 Replies
The other day I bought an sct tuner for my excursion and its been a little glitchy, likes to freeze up and lock out my ecu.
I was driving yesterday and today I try to turn it on and my engine knocks badly revs erratically and all gauges weren't working so i shut it off. I tried to start up again and it flashes the theft light and abs light. Won't crank won't do anything my whole engine is locked out.
So i tried reverting the ecu back to stock. I did this several times once it simply lost power and shut off at the end another time it said wrong vehicle and the final time it said completed.
Now when i try to start up it does the same thing and will not do anything but flash lights at me... When I downloaded the file it said select vehicle: 6.0 superduty. That was the only choice, and the guy at the store said that the truck tuner will work in my excursion I specifically asked if this works in the ex.
I really need my truck otherwise I will he paying hundreds in taxi fare. I tried calling the store and sct but both are closed on weekends.
View 14 Replies
I have a 2010 Sonata. The fuel and temp gauges stopped working. Tank is full and engine temp is good. Both dont move when you turn the key on. Tried to find a fuse that they may be on but couldn't find it.
View 2 Replies
My father-in-law has a 2008 f-250 with the 5.4. as he was driving a while back all the gauges of the dash quit. The engine still kept running without any noticeable difference but when he shut the engine off and tried to restart, it wouldn't even crank but the security light was flashing. He tried starting it again a few hours later and it started just like normal and ran fine.
He has had this problem occur several times in the last few months, but the other day it repeated the problem again and would not restart for about 5 days. He has tried charging the batteries, changing relays, checking all fuses and finding none blown, scanned it with his code reader, and checked the steering column for bare or rubbed wires.
View 10 Replies
A few days ago my speedometer stopped working. Then yesterday all of my gauges stopped working, as well as my turn signals. If this is a fuse issue then which fuse it is?
View 9 Replies
My '04 Passat 4Motion (station wagon) engine coolant temperature gauge, fuel gauge, and outside temperature display all stopped working in the same time. Interestingly enough, car has 32K miles and just ran out of manufacturer warranty 2 months ago.
What could be happening? Should I be checking fuse box or this may be related to some more serious failure?
View 1 Replies
I have a 98 F150 with a 5.4 auto 4X4. All four of the guages are on the left side of the instrument cluster. Neither one of the 4 work. The gas gauge, the amp meter, the oil pressure, and temp gauge work. the all four just stay all the way down. I've checked all the fuses and the sending units. ONly fuse position number 6 and 30 pertain to the cluster. I took the cluster out too make sure it was plugged in and it was. I know there is gas in it and I know the oil pump is working.
View 4 Replies
I have a 2000 F-150 and my lights to my gauges and heater controls quit working. I checked all the fuses inside and under the hood. All good. I swapped a few relays around and no luck. I tried replacing the headlight switch and that did not work. I checked power to the gauges from the headlight switch and there is no power, I then ran a hot wire to the wire that powers the gauge lamps and they do light up, so it is not a bulb issue. I assume I am not getting power, but do not know where else to look?
View 14 Replies
My Mom used my Ex to take the kids to the park today. When I went to unlock it with the fob.... NOTHING! I thought maybe a bad battery, but when I got home and tried the other one it didn't work either. Is there a fuse or something that would have gone bad? Everything else in the truck is working fine except for the remotes.
View 13 Replies
I have an 02 F350 7.3 ... I just installed my glowshift tripple gauge pillar set. I have an EGT, Boost and fuel pressure gauge ... I followed all the constructions on installing them. The boost is working just fine and the EGT was too, but after a while the needle started going back and forth and the red warning light what blinking and then it just sat at 0 with the warning light on and stay that way. My fuel pressure gauge is connected to a sensore i put in my fuel filter housing, my fuel pressure gayge right from the start stayed at 30 psi with the red warning light on and just stays there .... Also the buttons to change the color and set the peak on the EGT gauge are sticking for some reason and staying down and aren't letting me change the color ...
View 12 Replies
My overhead with temp, compass and mpg stopped working.
View 11 Replies
I have a 2000 ex with the 05 front end. My headlight on the right side stopped working I have the high just no low. I replaced it and still no go. I suck at wiring so what to look for..
View 3 Replies
My A/C has just stopped working and I am looking for some pointers on how to diagnose the problem. The vent and blower still works, just no cold air coming out? Where do I start?
View 10 Replies
this thing stopped working on me today, can i fix it? or how can i get another one?
04 Ex
View 14 Replies
All five clearance lights on my cab stopped working, and I can't figure out why. I've read all the threads, but few show the wiring, and are more useful for installing than troubleshooting. I think I have the Ford SKU'd ones, not the Recons, but I can't say for sure. Here's what one of them looks like:
My questions:
1) How do you remove the bulb from the rubber mount? Just pulling it out didn't work.
2) Is there a fuse somewhere (in the harness, perhaps?) that protects these things? All my overhead console functions and lighting work fine.
3) Is their only connection to the vehicle wiring at the harness connector behind the passenger kick panel? I checked it, and it is well connected.
4) Is there a connection on the headlight switch? I've not checked there.
I bought this vehicle 14 years ago and they were already installed, and have worked perfectly since then. I hate stuff that doesn't work...
View 6 Replies
