Ford Excursion :: 2003 V10 - Cruise Control Not Working
Apr 20, 2014
I have a issue with my cruise control not working. The Ford dealer in my home town has had my truck for 3 days now and cannot figure out what the problem is. I finally went by the dealer and wanted to know what the deal is and how can this take so long to figure out when they have to of seen issue like this in the past. The tech that is working on my truck said he has traced wires,etc and think it has something to do with the after market JVC touch screen DVD/backup camera. My question is would this affect the cruise? I cannot find anything on the net that may point in that direction. The steering wheel controls work for the fan and temp controls but not the radio as its aftermarket. Radio adapter for the controls?
View 14 Replies
Advertisement
2003 X limited 2wd 6.0L ... My cruise control was working intermittently. Could it be the buttons on the steering wheel itself? there is a cluster that I see. Does it pop off to expose the connectors/switches? Can these go bad? Can I buy new switches for the steering wheel?
View 2 Replies
Have this problem?
View 2 Replies
I had had intermittent issues with the cruise control not working in my excursion. most of the time it was fine though. after a recent 150 mile trip it stopped working half way through. i didnt worry about it too much..got back into town and checked under the hood. i found brake fluid running down the inner fender well! all over everything under the master cylinder. finally tracked it down to the cruise control switch on the master cylinder leaking. I pulled the plug apart and it was full of brake fluid.
Meanwhile the master cylinder was about half full, so i replaced it with the same switch out of a '96 parts explorer which is the same part luckily. also yes i have had the cruise control recall done. So if you have lost CC and you have a leak replace the switch! seems it can leak..and at a pretty good rate..alittle scary! glad i figured it out before my 800+ mile trip later this week/weekend.
View 5 Replies
Looking for any pointers on fixing my cruise control Have looked around under hood but what it looks like. I've got the air working again,put Warn hubs on and have ordered the Hellwig rear sway bar,adjusted steering box i/2 turn....
View 14 Replies
The cruise control in my recently purchased '01 Excursion isn't working. I've done a lot of searches and discovered there was a recall for a wiring harness: 2001 FORD EXCURSION Recalls
I called my local dealer and they stated there aren't any open recalls for this vehicle, so the previous owner must have taken care of it.
Is there any way I can verify that the warranty work was done? Can I visually inspect the harness? What else I can check to fix the cruise control? The lights on the steering wheel are illuminated.
View 14 Replies
I have a cruise control issue. I tried the self diagnostics test, and the "cruise" light would not come on. (Also read that 2001 did not have a self test, so maybe that's why it didn't work? Also, when I first start it, all the other lights turn on except for cruise.) I checked the brake master cylinder and it has the double fuse wiring with 2 good fuses. Not quite sure what else to test. I just bought the X knowing it had this problem, but didn't know how much I would miss cruise control until driving without for a week.
View 12 Replies
My fuel gauge is not working, nor is the cruise control, Had the truck looked at, was told the cruise was not working due to the fuel gauge not working?
Also when he hooked it up was told the dash gauge worked fine and the computer showed 60% which would have been about right based on mileage on the tank. My guess is that I need a sending unit?
View 2 Replies
I have a question on my '00 7.3. Cruise control just quit working. From reading the threads/forums I have gotten some ideas, but how about no dash light when turning the key to on? Nothing with the self test also. How can I troubleshoot the switch in the steering wheel? I could also have a bulb out in the cluster, but either way- no cruise function.
View 4 Replies
One day it work and the next day it didn't. I checked the 15a fuse and it was good. What else should I be looking at?
View 12 Replies
The ruck is a 2002 Ex limited v10 4x4. The cruise worked fine till my wife drove the truck! the green cruise light blinked a few times, now, there is nothing.I'm no good at electrical issues.
View 3 Replies
Many of you said it was the "ClockSpring" that needed to be replaced. But I already did that. A brand new clockspring on it. The horn only blows when the engine is off and when the engine is on the horn and Curse Control don't work. I have a 2001 Excursion. So What could the problem be? It works with the keyless remote. But just when you driving down the street and some bone head cut you off you can't just it.
View 5 Replies
I have a 2005 Excursion 6.0 ... .. A few months back the horn started sounding on its' own in the night, so I pulled the fuse... .. Then the Cruise Control stopped working. I have googled references to clockspring failure and these problems... ..
View 3 Replies
My speedometer stopped working yesterday after i replaced the 2 cruise control buttons on the steering wheel. When i connected the the battery the horn started blasting and I went over tap the horn then it stopped. Then i noticed that the horn did not work anymore. I put back the original cruise control buttons and still did not work .So know instead of fixing the cruise control buttons, I broke the horn and the speedometer while the cruise control is still broken. I checked the fuses and they all are good. What can it be ?
View 6 Replies
A few years ago I had the clutch changed on my 1997 F150. Afterwards the cruise control wasn't working. When I brought the truck back to the repair shop I heard the manager tell the mechanic to "attach the clip by the pedal" and that fixed it.
I just had some work done, had to replace the oil pan, and the mechanic had to remove the transmission. Now the cruise control doesn't work. I changed the Pressure switch but it didn't fix the cruise control. What that clip might be that fixed the cruise control last time?
View 3 Replies
I have an '02 F150 Lariat CC 5.4L. The truck is new to me and neither the cruise control nor the horn works. i have checked all (known) fuses and relays. I have tried the cc diagnostic, and the dash light DOES NOT illuminate. Should I assume that the dash light is not burned out? Is there a way to test the clock spring connections for continuity? and how do I access the connection
i checked the cc brake pressure switch and have continuity there.
View 2 Replies
I did the diagnosis,on my non working cruise control on my 2000 f250. The cruise light came on when, I, depressed the off switch and turned key on. I depressed on switch,cruise light came on.
I then depressed the resume, coast, and set switch, as described in the diagnostic procedure,suggested,and no light came on. Do the switches for the cruise control are bad.
I have checked the fuses at the power distribution box under the hood and checked the fuses under dash,all are fine. I just replaced the switch at master cylinder, as it was leaking and it had the recall switch replacement, too.
View 8 Replies
Just bought the 03 listed in my signature line, and I just found out that the cruise control isn't working, so started trying to troubleshoot anything obvious.
When I switch it on, I get no cluster light that the manual shows to be to the right of the brake light. When I turn the key to run, it never lights up, so am guessing the bulb is bad.
Can't see how a bad bulb would keep the system from activating, so am thinking I have bigger issues. I pulled the fuse panel, but the manual does not have a listing for speed control. Which fuse it is combined into?
Also need the skinny on how to change the bulb. Can I reach my hand behind there? does the cluster have to come out?
Last question. What is the most likely culprit for non functioning cruise? A module? Perhaps the switch in the steering wheel?
View 14 Replies
Cruise just stopped working. The fuses all check out ok. What would be the next simplest thing that I could check before turning the problem over to a mechanic?
View 14 Replies
I am having trouble with all sorts of functions on my 2002 F150 4x4, 4wd not working, cluster module illumination not working, horn not working, reving up and down at idle and sometimes dyin, cruise control quit working. I have been reading it is the GEM module that causes these issues. My question is I ordered a new one from Ford, when it arrives I was told I can just install it and It should be pre programmed. but one ford house tells me that they have to install it and program it. Which it right? I have seen several sites on u tube where people replace the module and then start their truck right up without any issue.
View 2 Replies
I have a 2003 F250 Super Duty 5.4 crew cab. Cruise light comes on when engaged but does not work. I did some research on why its not working checked wiring at the throttle body it seemed ok, Fuse is ok. Also did the self test and everything passed with just one flash but cruise still does not work. I read about many problems with the brake pressure switch but would it pass the self test if that pressure switch was bad? Also what should a switch cost. Local dealer wanted $125.00 for a new one and I have read where they cost around $15.00 - $20.00.
View 12 Replies
