I have a 2003 excursion with the V10. at the hunting camp I drove it into some water without knowing my neighbor had gotten stuck and left a BIG hole. It took an hour to pull it out with a tractor. The water was up to the floor boards. afterward the transmission would not shift past second. The OD light blinks. I left it for two days to dry out. Still no good. What I need to do to get it back going?
View 9 RepliesI am considering buying a 98 Passat, it has 140k kms (80,000 miles) on it. It is in mint condition, but the transmission, will not shift past 2nd gear, whether in Auto mode, or manual shifting? (5 speed tiptronic).
The current owner took it to a mechanic, he tested it, replace a sensor in the tranny, but the problem is still there, and the engine light is still on. Is it possible that the computer just needs to be reset with a proper Vag-com?
Girlfriend has a '92 automatic. Transmission's been acting up for several months, periodically not wanting to shift into higher gears. Now, it will not shift at all after the first one, about 20 mph. Engine whines, but has power up to about 50 mph. Odometer states 64,xxx miles but don't know if accurate.
Need info on possible causes, other than total rebuild. Been reading about speed sensors, shift solenoids, control modules, as well as replacing fluid/filter and adding a treatment.
My 4r70w is having some issues. It drives/shifts fine in reverse, 1st and 2nd but wont shift past 2nd gear. Doesn't even act like it tries. No CEL. I dropped the pan yesterday and there wasn't any metal chunks or any other debris in the pan and only the normal fuzzes on the magnet and there wasn't even an abundant amount on the magnet. This is a junkyard trans that was put in before I purchased the truck (2001 F150 supercrew 2wd).
I've ohm'd the shift solenoids and they seem to be within spec (below 30 ohms) so i want to rule them out, but still thinking of replacing all 3 solenoids just to be safe. Also, the filter just fell out with the pan so I'm assuming that might be part of the problem. My next thing to check is the 2-3 accumulator and spring to see if its stuck or broken.
I have a 2000 Excursion w/ V10 and I have an issue with the transmission form time to time. some times it does not want to shift out of first. if I pull over and turn it off for a few minutes it will be fine for a while and it doesn't do this all the time. A few nights ago it did this so I pulled over and turned it off and it still did it but then it started shifting on its own just fine till we got on the high way which is started shifting in and out of over drive going around 60-65 MPH. didn't want to go too fast not knowing what it could or would do. it did this for a few miles then it started working fine. next day it did the same thing not wanting to shift out of first then started working fine. drove it around last night and it all worked perfectly. The CEL is on but I get a no communication text from the scanner so that is another thing I need to look in to. I'm guessing it is an electrical issue being when it works it shifts fine and it does not slip at all.
View 14 RepliesFix a Loose Column Shifter on Ford Vehicles - YouTube
The first pic shows the torx screws that come loose, allowing the handle to get sloppy.
The second pic shows the black plastic adjuster wheel that centers the gear shift selector needle on the proper designated gear displayed in the indicator window.
As it turns out, my shift cable wasn't bad. The transmission lever coming out of the transmission doesn't want to move very easily. When in gear, it shifts fine as it should, so I'm thinking something is bad with the lever. Problem is, I don't know what could possibly be causing it.
View 8 RepliesI recently bought my first EX and I finally had enough of looking at this
The transmission shift lever indicator not being in the proper position needed to be fixed!
After some searching, I realized what the issue was and was quite surprised that the "fix" is replacing the entire shift lever indicator assembly. Seems overkill but right on par of with the way the world works nowadays.
The other solution I found was by a company called Dorman. They make a Shift Indicator Cable Bracket, which is the only part that was damaged in my case as you can see here. The white part pointed at by the arrow is supposed to be attached to the rest of the white plastic.
I looked around the garage thinking I need some glue. And something to reinforce the freshly glued parts. That should have been much more difficult as I don't regularly fix tiny plastic parts BUT I quickly came across this old external hard drive cover.
Broke some tabs off, trimmed them to size and poured glue all over the place.
This is what I ended up with.
Now my OCD can focus on something else
2003 Excursion won't shift into 1st or 2nd; P,R,N,D all work fine though. I checked the fluid and the level seems fine. (probly needs to be replaced though...) The truck runs brilliantly, but I just noticed this last weekend that she won't shift down into 2nd or 1st manually. We drove up to the top of a lava dome and I was gonna shift down for the drive down and it wouldn't go.
140k on it if I remember right.
My 03 Jetta is having transmission trouble. It will shift from 1st to 2nd but wont shift to 3rd. It is an automatic 2.0.
View 10 RepliesIt is a 2003 Excursion with V10, 4WD. When I start up and shift to reverse, the gear selector shows it moving, but the truck will not move. It just sits there and revs up. I have to shift back to park and then to reverse again, then you can feel the transmission dropping into reverse. It doesn't do this all the time. There is no pattern to it, just whenever the transmission feels like messing with me.
View 1 RepliesOk so I went mudding this past week, and I put my 997 7.3 truck in 4x4 had fun then took it out of 4 wheel now it won't shift past 2nd gear top speed 35 mph.... It still has all the power revs up Rpms fine but it won't go faster then that.
View 8 Replies1994 E350 Club Wagon 351w, E4OD Transmission. New MLPS, New VSS, New TPS, New Fluid, New Filter, 5 year old Torque Converter.
The Transmission dribbled a little bit from the front pump seal a couple weeks ago, I checked the level, it was a bit low. Topped it off with Lucas, the dribble stopped. I drove it successfully for another week. I took it on a 10 mile trip, and 5 miles in, it started slipping above, 35mph, I let off the accelerator, and the transmission "Caught up" and I drove 35mph the rest of the trip. I let it sit over night.
The next morning it acted as if nothing were wrong. I drove it some more, and the same thing happened. I parked it, and revved the engine up a bit, and it tried to MOVE in park, I put it in neutral and revved the engine, and it lurched as if it were still in 1rst gear.
This time I let it sit for 24 hours, and after work I successfully put 20 miles on it without missing a beat. It was shifting right, good solid connection between the gas pedal and the road, and I thought the problem was fixed, as the temperature the day before was -20, and it warmed up outside to 30 degrees above.
I parked it for a couple hours and went to go do the errands, and it wouldn't make it above 15mph. It even struggled to do that much. I put it in reverse, and it held great, no slipping at all.
Let it sit until the next morning, and it was better. I pulled the Codes, and it gives me a 63(7) TOT High, and a 62(9) Torque Converter Clutch. It may or may not be relative, but Cruise hasn't worked in about 6 months either. What am I missing here? What could possibly causing this trouble? Fluid is up and new.
I have a 1999 ford f150 v6 no 4x4 has wont shift from 2nd to 3rd, shifts fine from 1st to 2nd, after that tho there's nothing. What to do or what it could b?
View 1 Replies98 Gmc Jimmy 4.3L engine 4X4, they told me when the Abs light would come on will driving the tranny would not shift past 2nd gear, so after a month of not driving it, I took it for a drive Abs light was out vehicle drove fine shifted good even took it on the highway still ran good, two weeks later problem is back Abs light comes on after driving for a few minutes and the tranny goes into limp mode can't shift past 2nd gear plus the speedometer was not working, could it be speed sensor on the tranny causing the Abs light and the tranny from working wright.
View 1 RepliesI have a 2000 Accent that wont shift past third gear until the car is warm. The car has 140k miles. When I turn on the car and pull onto the high way it sticks in 3rd. I then have to slow down and drive through a small town. When I get on the other side of the small town and get back up to speed it will shift. Over drive is on.
View 4 RepliesI have the above referenced car with about 65k miles on it. Today I took it for a drive, switched it to tip-tronic manual and found that the car would not shift past 3rd gear. When I switched to automatic, the transmission stayed on tip-tronic (the display indicated I was on 3rd gear). I had to fully stop the car, place it on park and only then did the transmission switch to automatic.
View 1 RepliesI Have A 2001 F 150 And I Have Just Noticed That On Cold Morning When The Temperature Is Below 35 That My Transmission Takes A While To Shift Into High. Sometime I Am Two To Three Miles Down The Road Before It Will Shift Into The Last High Gear. Is This Normal Or Should I Have This Checked Out? I Have 53,000 Miles On This Truck And Do I Need To Have The Fluil Changed An Serviced.
View 10 RepliesThe truck: 03 Ranger, 2wd, 2.3L, 5spd, 160k mi
I bought the truck two years ago and it's always been difficult to shift (especially into 1st, 2nd, 3rd). I don't drive it often and only put 5k mi on it since I bought it.
The problem: Someone more mechanically inclined than I once told me that the hard shifting is probably due to the clutch not fully releasing due to low hydraulic pressure brought about by a failing slave cylinder.
I just noticed today that there is a high-pitched squeaking coming from somewhere on the truck. At first, I thought it was the rear end, but now, after pulling it into the driveway, I noticed that the squeaking noise vanishes when I push in the clutch pedal and returns after I release the clutch pedal and drive in 1st gear.
The transmission oil level is good, but I've never changed it and I'm not sure if the previous owner ever did either. I'm hoping I haven't damaged the transmission.
After reading a few threads, it seems the problem might be the input shaft bearing. To replace it, I'd need to drop the transmission and borrow a couple of tools I don't have (feeler gauge and bearing puller). If the ISB is the problem, it seems like it would be a good idea to change it now before it seizes and leaves me stranded somewhere.
My VSC and check engine light have come on. In addition now the auto trans will not shift past 4 gear with in auto or with me doing it manually. My local shop who has worked on this car before and is very good put the computer reader on it and got a P0500 for vehicle speed sensor "A". Today they put it on the real monitor and it reads a different code that says check engine code but does not reveal the code to read.
I really don't want to go to my dealer and get it hard. The car has 175,000 and until now has run great. I tried the gas cap fix to no avail. The shop did a reset when i first got there and it last 75 yards.
My automatic 2007 Nissan Altima has developed an intermittent problem when I go to shift it into park it won't shift down past neutral. I can't physically move the gear shift past neutral and can't take my key out of the car. If I wait awhile or drive off somewhere else it will later allow me to shift normally again and won't happen for awhile. It has happened maybe 8-9 times but I worry it will get worse or break the transmission. I've taken it to a mechanic and they looked at the transmission and didn't see a problem but sense they couldn't recreate the issue they couldn't fix it.
View 1 Replies