Ford Excursion :: 2002 7.3L - Wiring Harness For Brake Controller
Jul 13, 2013
I am going to be pulling a trailer next week. I bought a raybestos voyager XP controller. I expected it to be plug and play but what I got was four wires. I have heard that there is a plug ready under the dash to plug a controller into directly. I found a gray pigtail with male ends. Is this it? Should I take controller back and get one with the correct plug or is there a harness one can buy or is a stop to my local ford dealer in the future.
View 5 Replies
Advertisement
My 2003 Dodge Caravan is shutting off while I am driving, starts up ok but goes a little and then shuts off, has to cool down all day and night to go about three miles, got a diagnostics done and it says I need an engine wiring harness and controller. My question is, is there a curtain part of the harness or wiring that could be bad that causes it to shut off, and what part would that be, can it be repaired instead of replacing the whole harness and wires?
View 11 Replies
We bought a 2012 f550 chassis and had a utility bed outfited. As far as I know the truck does not have a tow package (major F-up). They did install a receiver and electric in the rear. The 7 way pin in the rear does have the appropriate wires (including blue). I can not find the harness in the cab under the dash. I have looked near the radio where I have found the harness on our other trucks. I specifically looked for the red white and blue wire under there. Where is this harness? Is the harness still in the cab even without the tow package? This will be for the old school plug in controller, not the ford intergrated contoller.
View 4 Replies
I removed the rear radio controller from the back of the console and installed a power inverter in its place. It fit great and everything went smoothly. I should have known it was too easy... I now have no sound coming out of the rear speakers. I assume there is a way to jump the wires to allow the speakers to work, but I'd need a wiring diagram. Right now I have the controller hooked up and buried in the console, which I guess is fine. It's just annoying.
View 10 Replies
Early 2000 vs 2001? Looking for info on replacing wiring harness under the dashboard?
Is there enough clearance to pull the harness without removing the dashboard?
View 9 Replies
My truck had power to the Brake Controller until a recent road trip and now there is no power to the controller. All fuses are good. Which circuit the power comes from?
View 4 Replies
I just bought a 2000 Excursion limited v10 4x4. I'm going camping this weekend so trying to install my brake controller. I found the plug but noticed these wires dangling. I can't see the back of the harness. I'm afraid the PO may have cut them to install a universal harness. How to recognize them? I don't want to buy a ford specific harness if the wiring has been cut.
View 3 Replies
This is on my 05. I assume its for fog lights. Is that correct? If so, where is the fog light switch? I don't have one near my headlight switch. Is this one of those things where everyone gets the harness, but the option is only on the switch if equipped?
Here is the harness....
View 7 Replies
First, need a wiring diagram for the outputs on the back of the brake controller module? I want to check and see if there is a problem with the connection to the rheostat. I can activate the trailer brakes with the slider bar but not with the brakes.
Second, where I can get a new OEM controller that will replace my old one if I can't "Cypher it out"?
View 2 Replies
Well I have my new 8.5x20 trailer on order that has electric brakes and I'm looking to install a brake controller. I don't like how cheesy all the aftermarket ones look and love fords factory controller and upfitter switches. Looking for info on swapping these in the excursions and had it working? I've looked on the net for this mod and came up with nothing.
View 14 Replies
When I went to pick up my new travel trailer yesterday , the brake controller wouldn't work. Trying to diagnose this in the pouring rain is the pits. This was after closing time at the dealer so the shop guys were gone already. The sales manager drove to an auto parts store to get a fuse to try it. Worked!
I've got an assortment of blade fuses on hand, but I clearly need these too, and possibly others. I need a name for this type of fuse.
View 2 Replies
Where does the 3rd brake light wiring harness plug into on a 2000 GP ? It's just hanging down and I don't see where it plugs into. I'm talking I'm the trunk area.
View 1 Replies
I just bought a hard to start 1990 F250. Per the board, just replaced all 8 glow plugs with Motorcraft. Still wouldn't start (it turns over but will only start if you use either). I attempted to install a new BWD brand (Borg Warner I believe) glow plug connector relay today...I removed the old no problem, but am unsure what wires to plug where....the only connection that I'm sure about is the blue wire that works the WTS feature...it plugs in easily but I don't know if there are other connections that need to be made or not? All the wires run from the posts and into the bottom of the unit.
View 2 Replies
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
View 8 Replies
I have a Derale 16749 electric fan controller set up had a fan die, went back to a old set up using a fan shroud I made and sable fans being the controller isn't set up to handle the load from these fans I want to just add relays in. Way the derale is set up to the fan is 12v. constant but the ground is also a 12v. until the switch reaches temp. then becomes a ground. I am not concerned with wiring the low side up on these fans just high side.
View 1 Replies
Sometimes the headlights won't come on unless you move the steering wheel up & down.
View 1 Replies
I discovered today that I have no brake lights on my '02 Excursion. The center brake light works fine, but the two in the taillights don't come on. Stopped and bought new bulbs on the way home and replaced both, but the ones I pulled out were not blown. Checked the fuse - OK. Taillights and turn signals both work fine.
View 3 Replies
Need to know the Ford part number for cab light wiring harness? I am wanting to install some LED cab lights but I do not currently have any so I will need the wiring harness.
View 3 Replies
Looking for wiring diagrams for a 97 gran marq. Specifically I want to hotwire, the climate control , to give me heat and defrost for more then 2 minutes an hour. I've got the climate control unit out of the dash, and the relays click just before the heat comes on for a few minutes. Of course that was an invitation to smack things with the screw driver. OOPS If there are no heater fuses hiding, besides the ones over the parking brake, I've now also destroyed the unit. Blocks of wood on the vacumm actuators, and wiring the fan direct will work with my unemployment check just fine. BRrrrrr it cold in the car...
View 2 Replies
I have an 04 Limited, 4x4, 6.0 PSD. Over the past couple of years I have had a issue with the AC control head inside the cab. Every so often there will be no power to the head but when you turn off the vehicle and restart it comes right back on. It happens about once every 6 months.
View 2 Replies
1987 F-250 4x4, 460cid... My engine compartment harness smoked. Do the 1987 models have wiring problems and I need any wiring diagrams that are out there.
View 6 Replies
