Ford Excursion :: 2001 - Fuel Filter Housing Leaking
Apr 28, 2015
I could smell fuel so I popped the hood to look for a leak. On top of the filter housing cover fuel was puddled in the little nooks and crannies of the black cover and some had leaked over the side into the valley between the heads. Is this a common leak? How in the world did fuel get on top of the cover but not on the hood insulator cover?
Also, just bought this not too long ago and the po said he had just done the fuel filter service on it. The gasket seemed pretty flimsy and weak and didn't really fit the gasket surface. Although I'm used to my cummins powered trucks and they use a o-ring to seal the housing cover. 2001 excursion 7.3
View 4 Replies
Advertisement
I have a 2001 f250 7.3l 4x4 and the fuel filter housing is leaking real bad from either the back or under it. I need to get info on parts that i would need as well.
[URL]....
View 5 Replies
I have a very slow fuel drip off the housing for the fuel filter on the engine. Can't see where it's coming from. It started sometime after I changed the filter a couple of months ago.
View 5 Replies
This past week my wife and I took a short trip and returned on a gravel road. I went to start my truck the next morning and there was a puddle of diesel fuel on the driveway. When I looked under it, I noticed that the tip of the fuel filter housing is gone and is leaking slowly from there. I called the dealer and they would not fix it on warranty, the truck has 20k on it. The service man said he would not turn this into ford. I've had the similar problems with this particular dealer. It's obvious that a protective cover is needed for this. I kept the part and am thinking of sending it to ford.
View 13 Replies
My fuel filter housing has cracked and i need to replace it. I have been told by volvo that i need to have it programed is this true or not ???
View 1 Replies
I've got a leak that appears to be coming from the secondary fuel filter housing (the one in the engine compartment)... It's not coming from the filter, but from the side, where there are 4 allen bolts that attach a fitting to the side of the housing...Can I change out the gasket for that piece? I've already tightened the bolts, but the leak persists.
View 14 Replies
A little background info...up until about 6 months ago my 01 Ex V10 was a grocery getter for the wife; only got a few thousand miles a year for the most part. Since we moved from Washington state to Texas it has turned into my daily driver (after a 2500 mile drive towing 8k trailer).
A couple of weeks ago we were running errands and after we got home there was smoke coming from under the hood, but I couldn't pin point it. I let it be because I figure it would let me know when something was really wrong. A few days later it did it again but this time I found the problem; transmission fluid was leaking out of the bell housing onto the y-pipe. I did my research and come to find out it is most likely the front pump seal that got soft from overheating. So my buddy and I drop the transmission and replace the seal. Put it all back together and everything seems great.
Another week goes by and we have driven the Ex fairly extensively around town and even took a couple short day trips and everything is great. Then as we are turning onto an on ramp to get on the highway I give it gas to speed up and all of a sudden the RPMs climb like it dropped into neutral. I had enough momentum that I got over onto the shoulder and started to check thing under the hood. Looked like I was low on trans fluid; ok so I added a quart. Put it in "D" and still nothing. Then I try "1", "2", "R" and they all work fine.
View 4 Replies
Seems my oil was leaking from my oil filter. I recently changed the oil a month ago but it didn't leak until a few days ago. I used a mobile 1 filter. I read that some people have issues with other filters other than motorcraft sometimes leak. I changed it with a motorcraft and it isnt leaking anymore. Could have just been a bad seal on the mobile 1..not sure
View 9 Replies
Do you change when you change your oil, or at what interval? How often to change fuel filter?
View 14 Replies
2002 7.3 liter. I tried to change my fuel filter, but the cap is stuck. I completely striped the socket on top of it. How to remove it? I tried Chanel locks.... It won't budge.
View 6 Replies
I am getting ready to change the fuel filter on my 2000 and I was wondering how to get the filter out of the medieval looking cage that holds it to the frame once the lines are disconnected. I figured I'd seek some knowledge before messing with it and breaking something.
View 8 Replies
I've been using the 'special' plastic ring tool to try and separate the lines from the filter, but with no joy. I can feel the tool compress the spring(?) on both fittings, but no matter how hard I am able to pull the lines won't come off.
View 10 Replies
Have had my Excursion for a few weeks now. Took it to the dealer for some maintenance on the brakes. Had them do oil and fuel filters while it was there. Dealer calls to tell me that the water drain valve had broken off when they tried to drain water and the needed to replace the housing. Picked it up today and this is what they found when they pulled off that assembly...
View 11 Replies
Yesterday our 2002 Chevy Venture minivan died in the store's parking lot. It would not stay running when we started it and let off the gas. As long as we were pushing the gas pedal down, the van would run. As soon as you let off the gas, it died.
So my husband walked to the auto store and bought a new fuel filter. He then tried to replace it in the store parking lot. As soon as he took off the 'male hose' from the fuel filter, a lot of gasoline sprayed him in his face and of course he came out from under the van screaming and in pain. (Don't worry with kids we had over 8 bottles of water in the van and I flushed his face and eyes for over 10 min and he is fine now).
Anyway, in the process of flailing under the van when the gas hit his face, he jumbled up these little black and rainbow colored rings and lost a long rusty screw/bolt that screws the main round body of the fuel filter to the underneath of the car and holds it in place.
We searched and could not find the bolt. My husband jumbled up the small rubber rings and did not know what was from the old or new filter. He tried placing them on the new fuel filter but as soon as he turned on the car, not even the engine just turned the key to where you can play the radio... all this gas sprayed out from the new fuel filter. After many tries of re-arranging the little o rings he gave up and called a tow truck.
Today he called auto zone and they looked at a new fuel filter in it's box (same one my husband bought) and told my husband that there was only one small black o ring on the fuel filter. So he put one ring on his new fuel filter (on the male hose I think) but still the filter sprays gas as soon as he turns the key. He then went and bought new 'hose clips' and tried those. The fuel filter still sprayed gas.
So, what I am now trying to find out is what could possibly be causing the fuel filter to spray the gas (leak). My husband (in his words) is a welder, not a modern car mechanic and is getting really stressed over this.
1. Does he need new or different sized little rubber rings?
2. Could the missing bolt that screws the large body of the filter to the car be causing this gas leak?
3. I read he should turn off the gas some where and then replace the filter, could this cause a gad leak issue because he did not do this before replacing the fuel filter?
View 6 Replies
I have a 2000 f250 V10 CC 4x4 long bed. The rubber fuel line that has a quick disconnect to attach to the fuel filter along frame is leaking. This is on the filter side going to engine. Ford tells me fuel line not available. Dorman products tech assist can't tell me which connector of there's will fit my truck.
View 2 Replies
2003 XL 5.3L with a leaking fuel line between the tank and filter. Mechanic says that this line is only available in a kit that includes all fuel lines for the truck. Hard to believe you can't just get the one line.
View 4 Replies
I bought a used 2006 F150 Lariat 4x4 (5.4L) and discovered that the oil filter and filter housing did not match stock. All web searches return the fram filter ph2 but the truck had the equivalent of ph10575. It was the right filter for the housing so it's not a case of someone putting the wrong filter on the truck. The ph10575 filter is for model years 2010 - 2013. Should I start investigating whether the engine had been replaced or is this normal?
View 6 Replies
After my accident this summer with the Ex and TT, I have a fuel leak. It appears to be coming from the hoses between the filler neck and tank.
The part # from Ford for the neck and hoses is YC3Z-9034-AA. This part is no longer available! Even NAPA the go to place and pay thru the nose for shows it as obsolete from their vendor.
I am seeing RED at this since I had zero leaks until the body shop dropped the tank to replace the hitch. The BS and INS co told me prove it was not a dry rotted house and they would pay for it. What to do for the hoses?
View 5 Replies
My 2005 elantra hvt 2.0 has oil leaking into the air filter coming through or near the throttle body, I've been told its an egr valve.
If it is...where is it and how much for a new one and is it an easy fix? If not what could be causing the leak?
View 4 Replies
Im noticing my mpg dropping in the past couple of months. I usually get 19 or 20 in town, and up to 23 on the highway. Now im lucking if I get 16 or 17mpg.
I have a 2001 escape XLT. 6cyl 4x4.
I changed the spark plugs, coils and fuel filter about 3 years ago (almost 40k miles ago).
The car starts fine, seems to idle fine, seems to accelerate ok. The only thing that is off is the MPG.
I dont just want to throw money at parts. Which one should I replace?
View 5 Replies
I went to change the small filter that is mounted just behind the radiator and is inline with the 5r100 . with a socket on the bottom all i was able to do was flex the brackets going to the 3 mounting bolts as this thing is on there real good. Looking for examples on unthreading the bottom cup to access filter?
View 6 Replies
