Ford Excursion :: 2001 - Front Tire Wear On Both Outer Edges
Oct 26, 2014
I have am 01 6.8 two wheel Limited. about 150K. My question is about both the front tires having more wear on both the inner and outer edges. The inner is a bit more but not by much.
I have been keeping very close track of my air pressure because I know the usual suspect is low air pressure but I am running 75psi and the max sidewall reads 80psi. I have never had it below 72psi. The truck tracks and steers down the road very nice with no drift or pull to either side. wheel balance is good.
Front end align is good. I have no issues with how she drives down the road. Everything seems to be checking out to be in spec..?
View 14 Replies
Advertisement
Having issues with front tires on 2013 Ford F150? I have a 2013 F150 with less than 20,000 miles with significant wear on the outer edges of the front tires. The dealer has alignment it twice rotated the tires 4 or 5 times and the problem isn't solved. I now have 4 tires with outer edge wear. What the root cause might be. The dealer can't figure out what's causing the problem.
View 14 Replies
Any 1 have their tire that have uneven tire wear? Mines is Dunlop and my front right tire has uneven wear on the outer thread. All other tire don't have uneven wear. I'm getting new tire for all 4 rims and check my alignment. My gs is a f sport rwd.
View 3 Replies
I decided to get an alignment (for the first time since I took delivery of the car). I noticed some unusual wear on the inner and outer tire. I will post a before and after pic of the alignment. As you can see they were unable to correct everything.
The shop says that the prius does not have any way to correct camber in the front nor was there any way to correct the toe in the rear.
I cannot think of anything that would have messed up the rear left. The shop was saying these repairs will need either a new control arm or strut.
View 11 Replies
It is an AWD model. My mother just purchased it used from a Lexus dealer last weekend. At freeway speeds, she noticed a shimmy, and she had one of her friends' husbands check the tires out (she's on a road trip and not near me or a Lexus dealer). He found that the tires are starting to delaminate in the front and thread is quite worn on the outer edges.
The vehicle has a warranty (30 days or 1500 miles) and of course Lexus is saying they will only pay for the front tires. (we don't know if that is the whole cause of the shimmy yet I might add). But to deal with the immediate problem, what is Lexus's recommendation regarding replacement of tires on an AWD 350? Do they really say it's ok to replace tires by axle? Because I know that can screw things up on some other cars. . .
I told her to read the owner's manual and see what it says on the matter.
View 6 Replies
My Bridgestone Ecopias(Ep20s) have 26,000 miles on them and are wore on the outer edges. Both sides are worn. I heard this may be to under inflation. I go to Discount Tire and they set all my tires at 37psi. Is this too low. The door says 35 front and 33 rear. Do I need more air for them to wear evenly? Also I have ordered Michelin Energy Savers. Discount will set them at 37, or should I add more air so this type of wear does not happen? I plan on getting an alignment just in case, but really don't think I need one. There is no pull to either side and the wheel is straight.
View 19 Replies
My '02 Ranger has had tire wear for a while now, and its on the inside of both front tires. I was thinking it was either toe or camber, or maybe both. I havent been able to get an alignment recently. If its the camber, should I get the camber kit from Ford?
As for the squeaking, it first happened last summer, and I sprayed WD-40 on the upper control arm bushing and it went away until last week (obvoiusly temporary). Now its back. Also happens while turning the front wheels.
View 10 Replies
2014 FX4 F. Got 6000 miles on the truck, front tires are wearing on the outside edge, and also when turning the wheels to the max in either direction I get a loud creaking sound,??
View 14 Replies
I realize that is vague. I realize it could be anything from a wheel bearing to a ball joint, tie rod, control arm/control arm bushing, etc.
Are there any very common front-end steering or suspension issues on 2012 escapes? When tires are inflated to 32-34psi, the car tracks straight, gets great mileage --but almost sounds/feels like it's got a CV or wheel bearing issue on the front right. Every time I hit the brakes while backing out of the driveway I can hear a slight bump or pop. When the car is parked (flat, tires straight) there is slight play left-to-right in the steering wheel.
I'm a German car guy. Have never touched this car. (Wife's car) Right tire is wearing bad on inside. Looking for some direction so I can assess. Car has 88k miles. This will be a DIY fix. Don't have any manuals or anything so just looking for a heads up where to start. Also is Haynes the best way to go? Is there a Bentley? Anything online/CD/DVD?
Play in steering wheel makes me think tie rod (fine because easy/cheap) but such excessive wear on the inside right front makes me think wheel bearing. Could it be both? This is AWD. Is this (like a Subaru) a CV joint where the front spindle passes through a strut base that everything attaches to --so there's an inner and outer wheel bearing?
Does anything up front require a press or can it all be done without a press?
View 3 Replies
Having issues with excessive front tire wear? I have had the alignment checked by two VW garages and a third party garage and all of them confirm that the alignment is good.
The VW garage also confirmed that as far as they can see there is no suspension issues, but the excessive wear on the front tires indicates that something is wrong.
I have owned the car since new in 2008 so know it has a clean history no accidents.
Both front tires look like this.....
View 18 Replies
I notice that my front passenger tire is getting some inner wear on it. The tire doesn't even have 5k on it. I know I should get an alignment that's a must but is there something that might be wrong with it anyways since its just the front passenger?? Balljoint, tierod end and etc?? I don't really have a local auto shop that I trust 100% so I don't want them to be like, there is 3 balljoints out and etc. I had the inner tierods (both) and a few balljoints fixed last year and then got an alignment done. Any tips??
View 4 Replies
I have a 99 F-250 extended cab superduty 4 wd with the 7.3. I also plow during the winter. Recently I've noticed wear on the inside of the left front tire. Brought it to a tire shop and had them check the front end and alignment. They told me that the specs were "within" tolerances" for my truck. I'm stumped as to why the abnormal wear if everything is supposedly good with the alignment.
View 5 Replies
I think I ran a wheel bearing dry on the front end of my 2001 Ford Excursion. Do I need to replace the outer axle stub when I replace the hub/bearing assembly? Where's the least expensive place to buy one?
I think this has the Dana 50.
View 6 Replies
I just bought a used 2007 Santa Fe Limited. It has 78,000 miles on it. I have gone bumper to bumper looking for problems and am pretty happy about the condition. HOWEVER, I have noticed a shuddering/bobbling, fairly faint, when going over slightly rough roads a low speeds. The tires are shot. But they are all exactly the same ... meaning the same wear more so on the outside. I believe they were rotated properly, but something is wearing the outside prematurely. Is the shuddering/bobbling the culprit? What is the most common issue for the Shuddering/bobbling at low speeds on slightly rough roads?
Next, I want a quiet ride. Handling is not a concern. Should I go with a slightly wider tire or slightly taller tire? Lastly, I need new mats. I want them to be the same as what came with the car. Do I have to go to the dealer or are there some vendors with better deals on factory mats.
View 9 Replies
Right Front Tire has excessive wear on Right INSIDE and car was pulling to the left. I rotated (or is it revolved?) my tires, and now the pulling has stopped......
OPINION: Bad tire that just wore poorly? Slight alignment issue that caused tire wear that then caused car pull? Wheel bearing issue causing tire wear? Or something else?
View 6 Replies
I just thought I'd mention this observed wear of brake pads...I just replaced all 4 up front after about 128k miles...
@ 114k miles it was observed that 1 of the 2 pads of each front wheel had worn significantly more than the other (the inner more than the outer pad IIRC)....my expert mechanic rotated the two and I got another 14k miles out of them...I could have gotten a LOT more had they been rotated @ 50-80k miles.
I don't know if this is extraordinary, or more typical than I'd have thought...or a function of (failing?) calipers, or just how these (MY) calipers work, or just my driving habits (though I've owned the car for only 30k of the 128k miles on the odometer)....but....
In my case the new pads will get a 50k mile inspection and possible rotation if there is uneven wear between outer and inner pads....
I'd recommend that pads be inspected for (uneven) wear at one of the scheduled tire rotations....rotating the pads isn't much of a job, but it might be something for you to consider to get the most miles from the pads (that and better braking too perhaps).
View 14 Replies
2011 Limited. 44867 miles.
Today when I rotated all five Turanza tires (RF > SP, RR > RF, SP > RR, swap L, as per the manual), I noticed the left tires (only) have exaggerated outer edge wear. All three from the right have even wear.
Wifey says it's because I weigh 400 lbs (181kg) and am generally driving alone. When I'm not alone, my passengers are all normal weight. This would be the first time in my life my weight cause uneven wear to tires.
By the way, these tires are LOUD on certain road surfaces.
View 12 Replies
I will be repairing the rust at the bottom edges of my doors. I work at a body shop and we've done 2 X's in the last 2 weeks! one was an 02 and was really bad. the owner wanted 4 new doors and rust repaired at the R/R lower C-pillar. the one today was an 04or 05? and just started to pop. After the first I looked at my doors and my L/R is the worst with just starting to flake paint. The others are just starting to pop.
I'll take some pics of what I'm doing which will be the same we did at the shop. In the years I've been on this site I've never seen mention of this! I know it`s more common in the midwest and east so I'm sure there are more than just a few! In as you don't know what I'm talking about.....look under the rubber weather strip (flap) on the lower part of the doors. the rust starts at the seem where the door frame and skin attach!
View 14 Replies
2001 GLS... Noticed the passenger front door window outer weather strip is loose at one end. Looks like a "tab" on the strip fits into a slot on the door panel. Since the tab is smaller that the slot, is there some kind of clip or something that holds the weatherstrip tab securely in the slot?
View 2 Replies
I have a 1999 Ford Ranger XLT using the Futura GLS 225/70/R15 tires. The vehicle decal in the driver side door listed the recommended tire pressure to be 30 PSI. I have tried to maintain religiously along with proper balance and alignment. However, I've always had the experience of the tires wearing out more along the middle which seemed to indicate over inflation. The sections on either side of the center line seemed to wear out normally. For this reason I've had to turn in the tire prematurely as they become unsafe. These tires were made by Coopers Tire and distributed by Pep Boys. Have i been using poor quality tires all along? Do I need to lower my tire pressure below the 30 PSI recommended? If I do that wouldn't I be risking overheating and/or affecting my gas mileage?
View 13 Replies
I HAVE A 2001 10 CYL EXCURSION with Pirelli Scorpion 265/75R 16 AT tires Istill can't get a good answer on correct tire Pressures-door plate says 38/45 tire wall says 80psi max. I've seen guys post 55/65 for non towing then maybe 60/70 for towing. Currently my steering kinda sloppy-inflations were messed up 55-52 front and 50-47 rear- also manual hubs somehow were in lock pos.Just had ball joints done but mechanic said didn't need alignment.
View 14 Replies
