Ford Excursion :: 2001 - Front End Swap Easy?
Nov 7, 2012
What all is needed to swap to the newer style and how easy is it?
View 14 Replies
Nov 7, 2012
Advertisement
Prius (Gen 2) :: Easy To Swap Driver And Passenger Seats?
My driver seat is noticeably more worn out than my passenger seat. I would like to have them swap places, thus allowing me to have virtually a 'brand new' seat. I took a quick peak around the area and it appears to be something I can attempt, but I don't want to get in over my head. Not to mention reinstalling them wrong and having some kind of a safety issue.
View 3 RepliesFord Excursion :: Vibration After Gear Swap Coming From The Front
Brought the truck home the other night after having the 4:88's and locker installed. At about 65mph plus I have a severe vibration that sounds like it's coming from the front. It's bad enough I can feel it in the floorboards.
After some research I'm thinking the drive shafts need to be balanced due to the increased speed they are now running at. The u joints are good and I trust the installer did a good job putting the gears in.
Factory gears were 3:73's. 7" of lift on 37's. Any other parts other than the drive shafts?
Ford Excursion :: 2001 - Gear Selector Swap
I have a 2001 Ford Excursion with the 5.4 and auto trans. I don't know for sure what specific tranny is in it but I do know what I want to do. I really like the pistol grip style shifters that a 2004 ish F-150 has and I wanted to make that conversion in my Excursion. Is it possible? Are the trannys the same to where I can switch out the gear selectors? And also how would I even do it?
View 7 RepliesFord Excursion :: Back End Lower Than Front And Drops Dramatically While Towing - Spring Swap On A Lift
So this may be a really dumb question, but here goes. I have a new to me 2001 v10 gas 4x4 ex. It has obviously been lifted in the past. The springs seem totally shot as the back end is quite a bit lower than the front and drops dramatically while towing. I am adding a helwig and have a wd hitch but have not set it up yet. So my question is can i do the spring swap? It would seem that i would need to address whatever changes are made from the stock ride but im not sure. I like the current lift and would be fine keeping it and adding the lift from the new springs.
View 14 RepliesFord Excursion :: Trans Swap 7.3 To 6.0?
I am in the middle of the 7.3 to 6.0 swap and wanted to confirm the in and out lines of each cooler. All the links to the websites that were writeups seem to be dead.
View 3 RepliesFord Excursion :: Steering Wheel Swap
I am looking to swap the worn steering wheel in my Excursion. I would like a wood and leather like the Navigators have. Any tips on doing the swap?
View 14 RepliesFord Excursion :: 2004 - Seat Swap In 2nd Row
I'm thinking about swapping from captains chairs to bench seats in the 2nd row of my 04 Limited Ex with tan leather. I'd like to mount an amp or 2 under it.
View 10 RepliesFord Excursion :: 2005 - V/B Spring Swap?
I work at a ford dealership in detroit, im looking into doing a v/b code swap, and just had some questions. my current stock excursion springs are completely shot. so i need new ones so might as well do the swap. do i need to order or get anything other than the v code springs, and the b code springs, new u-bolts, and modify the b code springs? i do not need shackles or anything to have the ex sit level when im done..? just making sure before i get involved. have viewed many topics on here about it and just want a definitive answer. 2005 excursion, v10. i actually wanted to go with the X's in front, but i dont know how to make those level in back.
View 14 RepliesFord 6.0L Power Stroke Diesel :: 2005 Coil Front End To 2003 F350 Leaf Spring Front Diff Swap?
Any success story on converting 2003 or 2004 f350 with leaf spring front end to the 2005-2007 f350 coil front end is it possible?
View 8 RepliesFord Excursion :: 2005 - AC Defaults To Defrost When Swap To 4 Hi
I noticed when i swap to 4 hi. The AC defaults to defrost. I have read this is a possible vacuum leak. Well after driving for about a mile the AC goes back to vents " while still in 4 hi" does this mean my hubs are sticking and finally engaging? Or still probably have a vacuum leak?
View 3 RepliesFord Excursion :: Spring Swap Height Differences
I thought I had come across a chart here that showed you the different spring ratings and the expected height change difference from stock, for each engine option.
View 7 RepliesFord Excursion :: 2002 - Just After Ride Spring Swap?
I want some honest opinions on whether a spring swap is worth the money and time to make the ride better and less harsh of ride. I currently have a completely stock 02' 7.3 4x4 Excursion with 204,000 miles. I have been reading a lot on the spring swap and really want to know if it's worth it for the sole purpose of ride and keeping the front off the bumpstops. I don't tow enough to justify it for that reason , and could live without the lift portion because I use it for a daily and family hauler. I experience some sway but not terrible ,but I do believe my shocks are shot as well and I have hit the front bumpstops a few times over railroad tracks.
View 14 RepliesFord Excursion :: 2001 - Front End Vibration?
Just picked up an 01 4x4 v10 a few weeks ago. I have a severe vibration that occurs when I hit a bump at highway speeds. The vibration cannot be felt in the steering, and I must come to a complete stop to cure it. There is a rattle, consistent with rotation coming from the passenger front tire. It seems to get louder the longer the I drive it, Going away and starting over after the truck has sat for a few minutes. I have had the truck on a lift and there is no play in ball joints or tie rods. I have recently replaced the sway bar end links. When this started I had the front tires balanced to make sure that's not the issue.
View 14 RepliesFord Excursion :: 2001 V10 - Creaking Noise From Front End?
I have an 01 V10 4x4 with front end noise. I've done steering linkages and sway bar bushings. The clunks are gone but I'm left with some creaks when the body sways.
View 10 RepliesFord Excursion :: 2001 - Front End Chirping With Sound
I have a 2001 Excursion 4x4 with 35" tires and 139,5000 miles on the clock. After driving about 20 miles yesterday while running errands, I heard a "chirping" noise. Since I had just left a stoplight, I first blamed it on the Jeep Grand Cherokee leaving the light with me. It wasn't long before I realized the noise was coming from the Ex. I noticed the sound around 40 to 45 mph and while keeping the truck fairly straight. I caught some video/audio but didn't see where I could upload it.
The ball joints have greasible zerks so I know there are not OEM but, other than that, I don't know when/if the wheel bearings or sealed units have been replaced. Recommendations? Is it a good idea to go ahead and replace bearings, sealed wheel bearing assemblies, and seals to have a reference point and prevent damage or failure?
Ford Excursion :: Leaf Spring Swap - Wheel / Tire Size
My leaf spring swap is almost complete... its been almost 3 weeks with all the conflicts of life but its getting near completion. Just have to do front passenger side now.. Tomorrow and it should all be done.. hopefully... Any ways... my preliminary numbers are 40" front (ground to fender) and 41.5" rear.. Might be 1/2" to 1" off since I haven't finished the job AND the truck is sitting on dirt. Any ways, What size wheel/tires can I fit on there now? And will I need a spacer with that size?
View 1 RepliesFord Excursion :: 2001 - Loud Hum Out Of Front End At Highways Speeds
As the title says I picked up a 2001 7.3 power stroke excursion and I have some questions.
Issues : Loud hum out of front end at highways speeds I believe this to be the hub main bearing I already have the assemblies apart. Oil leak 4 inch spot after 4 days. door lock actuators. Passenger side inner axle seal leaking (very small leak but I'm sure it will only get worse).
Repairs to be made before road trip in 6 weeks to NC
1. Replace hub assemblies
2. Replace all outer axle seals
3. (Maybe) Inner Axle seals
4. U joints since axles are already out
4. Diff fluid front and rear
5. Trans/transfer case fluid and filter
6. Engine oil and filter
7. Flush coolant and replace thermostat and o ring
8. brake fluid
9. Have truck reviewed by competent diesel mechanic. Know of any in CT?
My main questions are about the carrier. How do I remove the carrier without the spreader tool? Since I'm not changing anything do I need to check backlash before and after removal? If putting it in the freezer before reinstallation to shrink it, to be successful? In everything listed above removal and reinstallation of the carrier makes me nervous being a sensitive drivetrain component.
Either way its definitely a cool truck and id like to get it off the jack stands and start driving it.
Ford Excursion :: 2001 - Front End Making Crunching Sound
01 Excursion V10 4x4 230000 miles
When making slow left turns, and sometimes hitting bumps going straight at low speeds 15-35 mph I hear and feel a crunching noise right below the gas pedal floor board area. I;ve had it checked out on a lift plus sitting on the ground and no none can figure out where the crunching (or banging) noise is coming from. Ball joints & tie rods are good, had them checked.
I bought the truck a yr ago and do not know much history of the vehicle. Is does still have the stock wheels, michlin tires and suspension. Ball joints and tie rods were replaced some time ago, not sure when...
Ford Excursion :: 2002 - Swap 2nd Row Bench Seat For One With Full LATCH System
What model year(s) 2nd row bench seats that have a factory LATCH system will fit in a 2002 Ford Excursion to replace the seat that is missing the anchors that are between seat bottom and seat back?
View 14 RepliesFord Excursion :: 2001 - Front Tire Wear On Both Outer Edges
I have am 01 6.8 two wheel Limited. about 150K. My question is about both the front tires having more wear on both the inner and outer edges. The inner is a bit more but not by much.
I have been keeping very close track of my air pressure because I know the usual suspect is low air pressure but I am running 75psi and the max sidewall reads 80psi. I have never had it below 72psi. The truck tracks and steers down the road very nice with no drift or pull to either side. wheel balance is good.
Front end align is good. I have no issues with how she drives down the road. Everything seems to be checking out to be in spec..?