Ford Excursion :: 2000 V10 - Hard / Rough Shift From 2 To 3 At 30 - 40 MPH With High RPMs
Jun 6, 2016
My '00 V10 4x4 w/ 163k miles has had a rough shift from 2-3 (30-40 mph) with high rpms. If I let off the throttle before the shift I can get it to shift smooth, but if I don't let off the throttle it can shift really hard. I only have this issue from 2-3 and it has not gotten worse since I bought the rig almost two years ago. Driving conditions are around town on occasion and for towing a 3k pound pop up. Maybe 2k miles a year so far? The hard shift happens whether towing or not.
I have done just a drain and fill on the trans fluid a year ago. Have not had time to change the filter (even though I have read it's not necessary). I am planning on doing another drain and fill soon along with the filter since I have one and cleaning out the trans pan.
When searching on FTE I read a post about the accumulator springs that can go bad and was wondering if maybe this is the problem? Since I am planning on doing the filter change I was going to do the spring replacement while the pan was open.
View 9 Replies
Advertisement
My 4.65L V8 Explorer has an issue in low gear - RPMS rev high but car doesn't shift up.. eventually "catches" with a jerk but the OD Light started flashing and the Systems Screen reads Check Transmission. Light goes out and message goes away after turning car off and restarting. Had one Tech look at it - he said second gear is toast and need full transmission rebuild. Another Ford Tech looked and could just be solenoid needing replacement and advised to have a transmission service (not a flush) done....
View 2 Replies
Not really sure if the V-10 is supposed to be this way or not. I've had quite a few of the 4.6 and 5.4, both the 2v and 3v variant. Never had them do it.
Basically, my V-10 doesn't idle down easily. I can do a neutral rev and it will hang out from 1,000 to 1,500 rpm for maybe 2-3 seconds, then drop to normal idle revs.
While in gear and slowing to a stop, it feels like the motor is fighting the brakes and I have to press harder to stop. It also comes off the transmission when going 35-40 mph and letting off the gas. Causes a weird lurch if I have to get back on the gas.
Not dangerous or anything of that sort, but very very annoying. And I feel it's costing me some MPG's since I drive 99% city and have lots of stops. Probably 1-2 MPG at max. Back in my 2v Mustang days I remember some of the guys were modifying the 4.6 2v IAC because of similar complaints. I'm trying to dig up that mod, but it's been a few years.
I plan on cleaning the IAC this week when I get the time
View 1 Replies
What causes this? I have to mess with the brake pedal for a while for it to finally register that i have my foot on the brake and let me shift out of park.
View 5 Replies
1999 B3000 with a 3.0. The truck idles at 850rpms. When it starts it idles at around 1000 and runs very rough. When I disconnect the IAC the engine dies. The AC also has problems it blows cold at idle but at highway speeds after 7-8 minutes running the compressor kicks out. One can turn it off and it blows cold again after a few minutes.
View 5 Replies
backed out of the garage fine later in the day went to put it away started hard would not idle and only rev to 2500 .cleaned map sensor,egg valve tested and it works.cleaned the IAC and that works ,fuel pressure is 58psi. starts hard it would idle now it doesn't dies, no code . with 58psi could the pump still be bad? it has 18 pounds of vacuum. where is the vacuum line for the fuel pressure regulator on the motor?
View 14 Replies
I go out of town for work for a week and come back and my 1999 F250 V10 GAS, is acting up. It started when i tried to drive it and it didn't want to shift, it would rev up to 3000+ RPMs and finally shift really hard into gear along with the speed odo not keeping up and bouncing around not wanting to work. I also had my entire gauge cluster lit up with no key and door closed. all the lights were on and it was "dinging" like the door was open and it wasn't. you would hear it when you put your ear up to the door.
So my first thought was to change the VSS (which I did) no luck. So I started wiggling wire loops under the fuse box in the cab and the "dinging" quit.. i took it for a drive and it works like nothing ever happened. Obviously I am guessing there's a short so i brought it to my mechanic and hes saying he couldn't find anything by the fuse box but he thinks its closer or even attached to the gauge cluster itself. could this be true? Why would the gauge cluster loop throw off the shift points?
View 5 Replies
As it turns out, my shift cable wasn't bad. The transmission lever coming out of the transmission doesn't want to move very easily. When in gear, it shifts fine as it should, so I'm thinking something is bad with the lever. Problem is, I don't know what could possibly be causing it.
View 8 Replies
As it's progressively grown colder (which may or may not be related), my truck has grown all but impossible to shift from park into reverse neutral or drive with the engine running when the truck is cold. I often have to shut the engine off, and once I do it immediately is very easy to shift out of park into neutral, and then I can restart the engine. Once the truck has been driven some, it's not hard to get out of park, but if it's shut off for some time (an hour maybe) it will be difficult to shift out of park again. I don't know how to begin troubleshooting this.
View 8 Replies
Purchased my 2013 Elantra GT a few months ago and have been having a problem that had stumped everyone at the dealership. Thought I'd see who else is having it and what the thoughts are. To start, this is a 6SPD Manual Transmission.
Problem: Say you're at a stop and begin accelerating in 1st gear and then shift into neutral because you have to come to a stop again. When operating normally, the RPMs immediately wind down to idle. Well for me, about 15% of the time or more, the RPMs will take up to 10-15 seconds to wind down to idle. During this time, you cannot really shift into 1st gear because the RPM are too high.
The dealership has been working on this issue since last month. They replaced some parts and it is still doing it. They got diagnostic data and told me the throttle was sticking. No one could figure it out. Engineers got involved from regional, and it got pretty heavy as far as time. After several attempts at figuring out the problem and replacing things (which didn't resolve the issue), the engineers drove another new GT and found it was also doing it. So all of a sudden they said "it's normal" and closed the case.
Chances are, if other new ones are doing it, so is yours. I got second opinions from other auto shops who said it is not at all normal and that there may be a defect in the design. I've owned 4 Manual Transmission cars and I have never seen this before. If you're curious and have the 6spd manual version of this car, the easiest and quickest way to see this happen is accelerate in 1st gear to about 4000RPM and shift into neutral. Eventually, it'll get stuck and take a significantly longer time for the RPMs to return to idle. Usually when it finally happens, it'll keep doing it for several subsequent acceleration cycles.
View 36 Replies
So my "farm truck" is idling very rough, to the point that sometimes that it stalls out. At high idle it runs fine but when its at a idle its very rough. Its been running fine until probably a month ago or so and its just getting worse. What it could be? I am thinking it might be that something is dirty but i just dont know where to start with figuring out what the problem is.
View 9 Replies
So my girlfriend has an 04 elantra 2.0... the car will be running fine but then after so long of driving(maybe 15, 20mins) itll start acting strange..
It will hesitate to accelerate and shift hard and at higher rpms. Then at cruising speed it will turn off instantly(no sputter, hesitation, almost as if you just turned the key off). Seconds later the engine will come back but the gauges die and the engine will remain on.
At that point i pulled over and as i was on the brakes the car died when I came to a complete stop. Once the car completely turned off it would not start back up. However jump starting it got it going. The car is not throwing any codes.
View 1 Replies
My parents are having trouble with there 2008 Santa fe 3.3 L. The transmission won't shift and the rpm's climb really high. Does that mean the transmission is going or is it something else.
View 15 Replies
2000 ranger 3.0 auto 4wd hard to shift. Are the cables known to stretch?
View 6 Replies
My 01 excursion with a v10 6.8 liter gas engine was running rough and cutting out at 40 miles an hour climbing hills and similar situations. Had some engine codes for cylinder misfires. Changed all the spark plugs. Now it does not cut out and runs generally smoother. But something is still very wrong. At idle, you can hear it kind of shuddering.
In first and second gear it does pretty well, but when it goes to 3rd the shudder and vibration in the vehicle becomes noticeable, it can become very bad as you slowly climb to 40 miles or 50 miles an hour. If you give it gas and rev the RPMs up and go on up to 60 or 70 miles an hour, it smooths out and you would not think there was anything wrong with it.
The mechanic said we would have to wait until an engine code comes up, but I would like to understand and fix this problem if we could.
View 12 Replies
I have a 4 cylinder 2000 Ford Contour 133k miles
I've only driven the car for about 2 months, Ive never had an issue with it until yesterday other than an occasional hard shift when driving the car hard. Yesterday when I dropped the car in drive it wouldn't pull at all, I sat in my apartments parking lot continually revving the car high in drive but it wont do anything, its like the car is in neutral. Reverse works and I can drive by manually shifting from first to second and then putting the car in drive, but if I put it into drive before reaching 3rd gear it jumps back to neutral.
I checked the linkage, and the lever it connects to on the transmission; when put into drive the position of the lever coincides with the neutral position. I called a few local transmission shops and they diagnosed is as a broken sprag, but from reading online it seems like it could be a clogged transmission filter or a faulty transmission range sensor. Prior to this issue I would sometimes here a whistle coming from under the hood when driving, I didn't know until today that a whistle is indicative of a vacuum leak, but wouldn't it throw on my check engine light? I have checked my transmission fluid, its at the correct level and is a nice cherry red, it doesn't have any bad or burnt odor.
View 7 Replies
My '01 recently seized up and a buddy determined it was the AC pump. Replaced the belt with the bypass version. A month later, I moved across the state to Iowa. A couple weeks into living here I turned the truck on and it was idling really high (about 2500-3000) but would settle down to around 1100 when put in gear. However, shifting into gear is causing a progressively worse "jump" into gear. Hadn't really had the money or the time to take it in so I let it mostly sit unless I absolutely needed the truck.
Today, the idle is still high and does seem to cycle a bit in that it will rev up close to 3000 then settle back down around 2200 or so and then rev back up again and so on. I backed it down the drive into the sun for a little warmth and it darn near jumped a foot when I shifted. I turned the heater on defrost so I could clear the windshield and absolutely nothing came out.
I can't get into a garage for a few days to get it hooked up for diagnostics. So I thought I'd try here. My research leads me to think part of my problem may be a vacuum leak and/or maybe a sensor somewhere.
View 4 Replies
I had to stop quick today. My ice water spilled into the gear shift lever. A mile down the road my rpms went up high and the car barely moving.
2006 Hyundai Sonata...
View 3 Replies
I have a 2000 Excursion w/ V10 and I have an issue with the transmission form time to time. some times it does not want to shift out of first. if I pull over and turn it off for a few minutes it will be fine for a while and it doesn't do this all the time. A few nights ago it did this so I pulled over and turned it off and it still did it but then it started shifting on its own just fine till we got on the high way which is started shifting in and out of over drive going around 60-65 MPH. didn't want to go too fast not knowing what it could or would do. it did this for a few miles then it started working fine. next day it did the same thing not wanting to shift out of first then started working fine. drove it around last night and it all worked perfectly. The CEL is on but I get a no communication text from the scanner so that is another thing I need to look in to. I'm guessing it is an electrical issue being when it works it shifts fine and it does not slip at all.
View 14 Replies
It is a 2000 excursion its got codes # 135 155 443 743 755 1747 And overdrive light is flashing really....
View 14 Replies
Took the wife to work today, she has a big nail in her tire. The X started idling high at red lights, right before I dropped her off, It didn't want to change gears until about 3200 rpms. And change gears hard. About a Mile from home, X started driving normal again...
View 6 Replies
