I have a 2000 Excursion V10, I keep blowing the #19 10A miniature fuse while I am going down the road. All gauges and speedometer all of sudden die but the vehicle keeps running until I turn it off. When I try to restart she won't fire until I put a new fuse in.
View 14 RepliesMy 2000 ford excursion gauges fuse keeps popping. It started earlier this year and I couldn't pin point when it would pop. Now I'm sure after 30.00 worth of fuses that it happens when I change the gear shifter from park or rev to drive.
View 5 RepliesSo i bought an excursion 3 or 4 days ago and yesterday I went to install a double din dvd receiver. As I was installing something shorted out and I blew the radio fuse. No big deal or so I thought. Got the radio in and replaced the fuse but then the X wouldn't start. Went through everything and found a 5 amp fuse and a 15 amp fuse blown as well. Turns out the 15 amp fuse is for starter motor or something. Well I replaced the fuses and they kept blowing. Unhooked the radio completely and still keep blowing and the X is still obviously not starting. Pulled every relay I could in hopes something would reset and nothing. Any clue what it could be at this point?
View 14 RepliesThe fuse for the speedometer keeps blowing. I changed the fuse and the circit breaker in Dec. 6 weeks later the fuse blew again, I replaced it and it last another 2 weeks and blew again. What is causing and what might be the solution?
View 4 RepliesI recently purchased a 2000 F150 Regular Cab Work Series with the 4.2 V6 4x4 and an automatic transmission. It has what seems to be an electrical issue where the speedometer and gauges come in and out seemingly at random. All of my fuses are good with the exception of Fuse 1 in the fuse box under the steering wheel, which will blow every time I put a new one in. It seems like there is a short in the wiring for the radio? However Fuse 1 is supposed to control only the audio, and I'm not sure why that would be an issue with the gauges.
When they come on, everything seems to work just fine. Also, even when they go out and I have the headlights on, both the gauges and the car stereo will be backlit with the green glow.
When I turn put the key in the run position, the gauges will come on and remain on for a random amount of time after I start the engine, then will go out and come on at random. When the gauges go out so will my check engine light (code P0460).
I have a 1994 f150 5.0 engine and automatic transmission. Problem I am having is speedometer, cruise control is not working. Overdrive light is flashing and number 18 fuse keep blowing. horn is still working...
View 1 RepliesI have a 2000 F350 4x4 with 7.3L diesel and a manual transmission. While driving home yesterday my gauges (fuel, temp, volts, oil pres) stopped working. Within a couple min the speedometer and the tach also stopped working, but the truck was still running fine. Within a couple miles the engine stopped running, just like I had turned the engine off.
After having it towed home I checked all the fuses, none are blown, but there is no power to fuse #16 (15A, instrument cluster, high beam head lamp). Also in the fuse box under the hood, again, no fuses are blown, but fuse #9 (left head lamp low beam) and #11 (right head lamp low beam) have no power to them.
Every time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are the aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, these lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Fuse #27 keeps blowing as soon as I shift into reverse.
Prior to shifting, everything works as it should - I've unplugged the rear sensors, back up lights, trailer plug, and each time, fuse #27 keeps blowing.....
Where I should look? Also - looking for a 2003 excursion wiring diagram that shows what all fuse#27 controls?
My Excursion keeps blowing fuse #45, a/k/a "Ignition switch Run/ Start feed"
Going to have to go in shop. Seems to be a short in the steering column.
Then the dash lights go dim, headlights die, engine sputters and dies. I am guessing alternator most likely.
These two things might be related? Maybe there's not a short in the steering column, I dunno.
Ok I keep blowing fuse #3 in the interior compartment. Let me preface this by saying I have my always-on power for my rear view mirror which is the display for my back up camera, pulled from a wire that is fed by this fuse. The camera is on reverse power only and it pulled from the reverse lights in the rear of the truck, but the always-on power is pulled from this location for the display. Doesn't matter if I have always-on power to camera if the display fuse it has blown and I am guessing the mirror power is the source of my problem.
The fuse controls the OBD and the cigarette lighter and it seems to blow every time I plug anything into that power port that is more serious than say a phone charge. When this fuse goes then my mirror display is down, and back up camera is mainly used for hitching up a trailer solo. My camera is pointed straight down at my hitch ball and it makes hitching up by myself very easy.
I have a volt meter but not sure where I need to test, and well what a bad number is when I do test it? The mirror instructions say to pull always on power under the dash and the right wires are attached, and the fuse rating matches, so don't think it's a too much being pulled issue. Maybe a bad connection or maybe a relay issue? I had this fuse blow several times before I had the power mirror but it's certainly gotten worse.
2000 Model, The fuse keeps blowing on this. I thought it was the cruise control fuse because the cruise kept not working and when I replaced fuse it would work. Only for a little though, then I looked at manual and it says the fuse is for the brake position switch. I am presuming this is just like the old days and that is the brake light switch under the dash. They use to have two wires now there is like five. Anyways I do not see any bare wires or anything that would blow a fuse, is it common for these switches to go out or what??
View 13 RepliesI posted earlier about the tranny in my 01 Ex v10 having a transmission problem. The show looked at it and found the O2 sensor had shorted out and in some way sending the truck in to limp home causing the tranny fuse to blow????
Any way they fixed it or so they said and I drove it for a few hours and it did fine. The next morning I drove it and it blew the fuse. (under hood box I belive #19) I took it back to the shop and they beat and banged on it....got it wet etc. and can not get it to do it again. I know whe have an electrical issue but what all runs off of the fuse that controlls the tranny?
Is there any online wiring diagrams of excursions or superduty drive trains? Where all to look for the problem?
My speedometer is off by around 5mph. When I'm going about 65mph it only reads about 60mph.
How is this corrected? Programming or speedometer cable gear?
I have a 2000 6.8L V10 Ex, and I'm currently working through the last thing on my "to fix" list. The truck has 37" tires (Nitto Mud Grapplers), and at freeway speeds the speedometer is off by 10mph. If it reads 60mph, I'm really going about 70mph.
I thought the solution was to order an SCT flash tuner, so I purchased one with tunes from 5startuning:
**1. SCT 7015 - X4 Flash Device with Choice of 5 Star Tuning Custom Tunes - 5 Star Tuning
I choose the correct Revs per mile for my tire (560), but the speedo is STILL 10mph off at 70mph.
No changes that I made to the tire size or axle ratio made any difference. It always read the same amount off. The SCT X4 flash tuner wasnt able to change the speedo on the 2000 Ex's.
[URL] ....
My question is this: If both of those tuners plug into the exact same port, and use the same parameters, why is it my X4 tuner can't change the speedo, yet this other tuner is able to? It doesn't make any sense to me. If the X4 truly cannot change the speedo of certain model years, there should really be a disclaimer about it. Feels like a bit of a rip off since the only reason I purchased it in the first place was to correct my speedo...
My 2000 Passat 1.8T is being evil again. Fuse 15 keeps blowing and I can't seem to find where the short is... however, its stuck at my work. Its a pretty big short, the fuse sparks as soon as I put the fuse near it. BIG SPARKS. Any way to start it without that fuse in?
View 1 RepliesMy wifes truck is having some issues right now. Last week I was driving it down the highway, and the gauges all went off, the door buzzer was sounding, and the door locks where going up and down constant when I had my foot off the gas pedal. Found the fuse and fixed it with a replacement, but its down it three times all together since then?
View 9 RepliesI have a 2003 Accent and I'm having a problem with the brake lights not working. The tail lamps work when the night lights are turned on so it's not a bulb issue. The brake lights keep blowing the fuse. Brake lights will only work with a fresh, new fuse but only works for about a trip, give or take and then its blown.
View 1 RepliesAbout three weeks ago driving. My truck would not shift come to find out it was a fuse that blew. Well I pull over and replace the fuse it starts right up I get about a mile from my house and it blows again so I shut off my x and then replaced the fuse. Will not start...
Now I am getting a Pats code 1:6 and my obd2 reader says no link on my x. It used to read it all the time. I am trying to figure out what I can check to fix this problem are there any relays. Oh also my check engine light does not come on when I turn the key but my truck does crank. does this mean there is no power to my ECU. I did replace my ecu and it did not solve the issue.
My rear A/C and heat are not working on my 2000 X. I don't have an owners manual for my truck, so if there's a rear A/C fuse somewhere either under the dash or under the hood?
View 2 RepliesEvery 3 or 4 days my 2000 Camry 4Cyl Std Tranny keeps blowing out the 30A Buss Fuse in the under hood fuse box. What this fuse runs and what could be the problem. I don't think my Fan Motors are running could this cause the Fuse to pop.
View 11 Replies