Ford Excursion :: 2000 - Shimmy When Put On Brakes
Dec 11, 2008
My 2000 excursion (94K) front end shimmies when I put on the brakes...could my rotors be warped...or is there something worn in the front end?
View 11 Replies
Dec 11, 2008
Advertisement
Ford Excursion :: 2000 V10 - Brakes Are Not Cutting
I have a 2000 Ex V10 4x4 that I use as a daily driver and also haul with it(4 horse trailer loaded). The brakes are not cutting it, they suck. The rotors have been turned 3x in a year and it is due for pads and I am sure rotors now.
I want to upgrade so that I don't continue to keep having this amount of problems. Sadly the beast gets abused with 3 teen drivers at the moment, so I am pretty sure that is contributing to the eating of brakes.
Ford Excursion :: 2000 - No Brakes - Dash Light On
I have a 2000 7.3 with about 114,000 miles. I just had my water pump, thermostat and belt replaced about a week ago. I've been driving the truck since and everything feels normal. This morning I drove the truck to work and parked it for about 10 hours. Got in it after work and everything started up fine. I noticed the brake light on the dash was lit up which I thought was odd because I never use the E brake. E brake wasn't on and I stepped on the brake pedal and it felt like I had no brakes. I turned the truck off and didn't try driving it, I didn't want to risk anything if I didn't have brakes.
View 2 RepliesFord Brakes/Suspension :: 1994 - Shimmy With ABS On?
Have read through alot of the threads and can't seem to find an answer. Bought a used 94 explorer xlt. It came with brand new Wrangler tires. The day we bought it we were driving home and it started shaking and wobbling at about 95kms and but seemed to improve after 115. So I took it to the tire shop next day and had all 4 tires rebalanced. The shop told me that all were out to lunch. The worst was 2 ounces out. Ok cool. Was certain that was the problem. Took off. Got on the highway and same damn thing. The steering seems very tight. No bangs. No knocks. Just the bloody shaking. Oh and also the abs light comes on just as it starts to shake.
View 1 RepliesFord Excursion :: 2000 - Popping Noise Coming From Rear End When Apply The Brakes
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 RepliesFord Brakes/Suspension :: 2000 Excursion - Rear Brake Line Leak
Rear steel brake line ruptured the other day (was pretty rusty). Despite being an idiot in regards to automotive repair (among many other things), I decided to give it a shot. I was able to get the damaged section off, went to Autozone with the broken piece, they matched it up, were nice enough to cut it and put on one larger fitting (because the two were different sizes) and flare it for me.
I was able to get the one side (at the T fitting) on OK. That was the "new" side, the one they flared at Autozone. Looks good. No leaks.
The stock side, at the passenger side caliper, leaks like crazy. Not out the threads, but out the hole through which the line passes. Know what I mean?
I'm having a hard time figuring out what's happening, because I'm not sure how this thing works. Does the line fit flush to something inside the connection at the caliper? Is it a bad flare?
It did not go in easy, but the new one was just as much trouble as the fitting that came out (stock?), so it must be right.
Ford F-150 (2004-2008) :: 2005 - Brakes Shimmy After New Pads And Rotors
Brakes shimmy on my 05 f150. Been doing this since new new pads and rotors and alignment. what now?
View 5 RepliesFord Brakes/Suspension :: 1989 F350 4WD - Steering Shimmy / Front End Bouncing
Truck is an 89 single cab, single rear wheel F350 4x4 with 7.3 non turbo diesel and a c6 trans. not lifted, stock size tires. If you hit just the right bump, regardless of speed, the front end just goes crazy.. tires and wheel shoot violently side to side and its very frightening/dangerous. you can just barely hold the wheel, front end is bouncing and whole truck shakes from such rapid camber change as the contact patch swaps from inside to outside of the tread.
Tie rod end, draglink, steering stabilizer (add on,) shock absorbers (rancho,) and a wheel bearing are all brand new. With each part replaced the shake felt worse (since more of it was transmitted to the steering wheel rather than lost in the sloppy parts) and i took it off the road immediately.
Brand new steering box, put it back on the road, did it again less than a mile away. It rained all day so i haven't jacked the truck up again and really, I am quite sick of this problem.
Ford Excursion :: Squeak / Rattle Behind The Dash - Shimmy And Vibration From 70 To 80 MPH
A little back ground... Drove from NM to MN. Truck ran well averaged 13.5 mpg. hand calc'd (only .1 off of trip computer, I found it was typically a rounding difference). Shimmy and vibration from 70 to 80 mph, I am getting wheels rebalanced today. Rear AC blows very cold, front AC needs attention, coldish air blowing.
I have a squeak behind the bash on the passenger side. After about 300 miles of feeling in, under, over etc we couldn't find the squeak. After a bit we turned off the max AC and the squeak went away. Now it is a squeak with road movement but it only does it when the Max AC fan is running. When we got to Minnesota, we lifted the hood and I can move the whole AC unit and recreate the squeak/rattle. Is this movement usual? Would this be the cause of my front AC not blowing cold?
Ford Excursion :: 2001 - Steering Wheel With Vibrate Or Shimmy When Driving?
got an issue with my 01 excursion. When driving the steering wheel with vibrate or shimmy. As in if the rotor maybe warped or tire has a small bubble in it. Here is the kicker. It does not do it all the time. Some times I can drive it and it drives just as smooth as can be and I can go all the way to town and back. Then sometimes I can drive it to town and either turn a curve or hit a bump and then it will start doing it. Then I will come back home. Then the next time i jump in it and start driving down the road and it is just fine. I just had the brakes and rotors were just changed.
View 6 RepliesSanta FE SM (2001-06) :: 2002 - Shimmy When Applying Brakes
2002 Santa Fe has Shimmy when applying brakes. Had tire balanced and rotated-no change. New brakes with life time pads one year ago. Rotors were turned. Should I replace the rotors and pads or just rotors? Am I on the right track for repairs?
View 2 RepliesLexus RX 2004-09 :: Intermittent Front End Shimmy When Brakes Applied
2005 Lexus RX330. 98K miles. 2 year intermittent problem. When apply brakes the front end shimmies until car completely stopped then go again & all is well until at some future time it happens again. Dealer checked twice & private repair checked also. Nothing found. Tires re-balanced & rotated several times. Newer tires with no issues. This is an INTERMITTENT problem. The rotors have been, new pads & spring installed.
View 10 RepliesMalibu - Chevrolet :: 2007 - Shimmy And Shake When Step On Brakes
My 2007 4 cyl. Malibu does a shimmy and shake when I step on the brakes. It seems to be worse when traveling at a faster rate of speed then when driving around town.
View 7 RepliesSanta Fe (CM - 2007-12) :: Steering Wheel Will Shimmy When Apply Brakes At High Speeds
I have a 2007 Sante Fe Limited that has 93k on it. Within the last year I have noticed the steering wheel will shimmy when you apply the brakes at high speeds, it's slowly came to the point now that anything above 40mph will cause the steering wheel to shake while applying the brakes. I am guessing I have warped or unevenly worn front rotors. The car supposedly had a break job done at 74k and this started happening at about the 90k mark.
I was looking at these : Front Performance Brake Rotors Posi Quiet Ceramic Pads for Santa FE 07 09
Second question, any tool list or required sockets sizes to complete a front rotor and pad replacement? I have a floor jack, jack stands, a set of 3/8 deep metric sockets. I also have a breaker bar. This is my only car so I want to make sure I have everything I need before I start taking stuff apart.
Honda - Accord :: 1997 Shimmy When Driving At Highway Speeds And Hit The Brakes Hard
When I'm driving at highway speeds and hit the brakes hard-ish (e.g., if the car in front of me stops or if I suddenly realize I'm going too fast on an exit ramp), my 1997 Honda Accord feels like it's shimmying from side to side. It only happens for a moment, but in that moment I feel like I'm on the verge of losing control of the car.
I've only noticed this in the last few months. What this might be? I'm going in for an oil change tomorrow and would like to ask my mechanic to take a look at this, but I'd like to have some theories/guesses in my back pocket before I go in.
Buick - Lesabre :: 2000 Shimmy While Accelerating Between 45 And 50 Mph
I have been to a few different repair shops for my 2000 Buick Le Sabre shimmy problem with no luck. I have a really bad shimmy, while accelerating between 45 and 50 mph, and it seems worse on an upgrade. Past 50 mph, it smooths out. Over the past several months, mechanics have checked the balance of my tires and rotated them, done front end alignment, rear alignment, replaced the right lower control arm, the right sway bar link and the right wheel hub. Still no luck, so it came down to the determination that it must be a bad tire. Now I have 4 new tires (it was soon time to get them anyway), and I still have the shimmy. What else can we look for? My local mechanics seems stumped. I have not taken it to a Buick dealership, however...
View 9 RepliesSubaru - Forester :: 2000 - Front End Shimmy
I have a 2000 Subaru Forester S model with 143k. I have been chasing a front end shimmy since we bought the car used a year ago. I have replaced the front rotors, and pads, cleaned and greased the caliper pins, made sure the calipers weren't stuck, and had an alignment done. There was a bent front passenger wheel that I changed and had the wheels balanced. I have also checked the fuse for the ABS thinking that may have something to do with it. After the alignment provided no change I am stuck.
I just realized that I left out a critical piece of information as I was reading the posts. The shimmy is only under braking and is more pronounced under extra load such as down hill.
Ford Super Duty (1999-2016) :: 2000 - Rear Brakes With More Power Than Front Brakes
I use a bottle hanging like an I.V. drip to flush the Brake Fluid in all my cars. I can pump all the old fluid out, as well as the air. My Superduty 7.3 has a good solid brake pedal after the flush. It seems to me the rear brakes handle 60% of the stopping load. Its been like this for so long I'm not sure if it's ever been different. i then go to a gravel or wet road and test the rear abs, and it seems o work, but definitely has a squirrely feel. I did some strong pavement stops with speed, and it stops, no skidding. Is that the way it should be?
View 14 RepliesFord Excursion :: Brakes Not Working Completely?
Down hill toward intersection with light that turned red. I braked fairly hard and then all of a sudden, brake pedal goes to floor and I go through the light. I pump brake once or twice and still nothing. Luckily I made it through without hitting anyone and eventually stopped with emergency brake. Turns out the line to the rear brakes blew. It was probably weak and maybe the pressure from braking hard blew it. This was sudden. There was no warning whatsoever. Reservoir was empty and practically no brakes in the front. There was enough front brakes to keep the truck from idling forward, but that is it. I thought that I should have had full front brakes with a modern day master cylinder. Looks like Ford blew it with this one. Very dangerous design.
Is there an upgrade available? I never want this to happen again.
Ford Excursion :: Front Brakes Pulsing Slightly
The front brakes are pulsing (slightly, enough to spill my coffee when they line up together) with each rotation. I can't tell if they're warped, or if they have a rough patch on each disc.
View 9 RepliesFord Excursion :: Brakes Unresponsive On Hard Stops
I bought my 2005 Turbo diesel awhile back, and I was having an intermittent problem with the brakes. If I have to suddenly stop, and hit the brakes, it feels like I didnt hit them at all. Sure, I stop, but only after 3-4 seconds of OH CRAP IM GOING TO HIT SOMEONE.
So I just had my truck in the shop, and they replaced my front rotors, turned back back rotors, and replaced all of the pads.
So, I figured that should fix the issue. Not so.
Tonight my daughter was in a car accident, and I was hurrying my way to her, and the light in front of me flipped yellow/red pretty quick. So I hit the brakes, and thought I was going to go right through the intersection..
When I hit the damned brakes, I need to freaking stop. Not keep moving and then slow down gradually. Scared the crap out of me multiple times now. One time I'm not going to be so lucky.