Ford Excursion :: 2000 - Popping Noise Coming From Rear End When Apply The Brakes
Nov 23, 2012
2000 Excursion V10 4x4. I'm getting a popping noise coming from the rear end when I apply the brakes and come to a complete stop and when I release the brakes to take off. It only happens the moment it comes to a complete stop and the moment it takes off. Not when I'm putting it in forward or reverse or accelerating or decelerating. U joints are fine. I was laying under the truck poking around the other day and when I roll it back and forth in park the few inches it'll go, when it comes to the end of it's travel the axle wraps a little and it seems like the transfer case output shaft flange is moving in and out of the transfer case and causing the noise. I'm assuming there is a snap ring holding the output bearing in place. I didn't have time to drop the driveshaft but am planning on it this weekend to see if it still does it when I roll it and to inspect the transfer case. I need to check to make sure the driveshaft splines are not seized up but they seem to have a little free play to them.
View 2 Replies
Advertisement
I have a 2010 Toyota Camry SE with just under 51,000 miles on it. Every time I put the car into reverse and accelerate to apprx. 2-4 MPH then apply the brakes, I hear a loud popping noise, and it sounds like it is coming from the passenger front wheel. Slight noise from the drivers front as well. This doesn't happen in Drive, only in reverse at a low rate of speed. My father and I have taken the front wheels off and tested it, seems to be a motor mount, curious if this seems rational or common in a newer car.
View 11 Replies
I get this loud click noise coming from the front end of my vehicle when I apply the brakes. It seems to happen much more often than not, especially at low speeds. I can only describe it as some sort of loud clicky clanky sound, it's also a single sound, it doesn't go on and on and it only happens when I apply the brakes.
View 2 Replies
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
View 7 Replies
My 01 Excursion Limited 6.8L 2wd is having what I think is a tranny/shifting issue? Mileage is about 160K. She has been doing just fine and no recent work or out of the ordinary maintenance/replacements..
Got in her this morning to go and noticed that the tranny seemed different. First thing I noticed was that the shift form 1 to 2 was long in coming and then sort of hard / thump when it did change. Then is seems to rev higher in the rpm range than normal when going into 3rd maybe 4th.? I pulled over into a parking lot, turned it off and did a brief inspection of the underside, fluid, etc.. and did not find anything strange. Started her back up and went to leave when I heard a popping / thumping noise from the tranny. Threw it in neutral and reved the motor to see what it sounded like and it was good. Back in drive again and the noise was there. Seemed to go away after getting up to say 45/50mph but the shifts were still off. Took her back home and now trying to decide whats first on diagnosing this issue?
View 4 Replies
My car makes a grinding/popping noise when driving that worsens when I go over bumps and that completely stops if I even touch the brakes. When I accelerate, the noise speeds up as well. I took it to a mechanic about three months ago and he said it was a loose bumper and that he secured it. After leaving, the noise got louder and happened more often. Sometimes the noise doesn't happen, while other times it does. My dad changed my front brake pads about a month ago so it can't be those. Is it possible that it is still my bumper making the noise? If so, I don't understand why it would stop when I brake.
View 1 Replies
Rear steel brake line ruptured the other day (was pretty rusty). Despite being an idiot in regards to automotive repair (among many other things), I decided to give it a shot. I was able to get the damaged section off, went to Autozone with the broken piece, they matched it up, were nice enough to cut it and put on one larger fitting (because the two were different sizes) and flare it for me.
I was able to get the one side (at the T fitting) on OK. That was the "new" side, the one they flared at Autozone. Looks good. No leaks.
The stock side, at the passenger side caliper, leaks like crazy. Not out the threads, but out the hole through which the line passes. Know what I mean?
I'm having a hard time figuring out what's happening, because I'm not sure how this thing works. Does the line fit flush to something inside the connection at the caliper? Is it a bad flare?
It did not go in easy, but the new one was just as much trouble as the fitting that came out (stock?), so it must be right.
View 9 Replies
Just purchased a 2010 ls with 20,000 miles on it. Brakes make a popping noise when coming to a stop. Not all the time, seem to get worse as brakes get hot. Have had to dealer twice they have resurfaced rotor, bled system put new pads. Still have noise my service manager opened a trouble in the lexus system and called Atlanta. They said this is characteristic of this car. I drove a couple of other ls cars and did not hear the noise. Not sure where this is going to end up. I saw where the brake actuators where changed on the 07,08 and 09.
View 14 Replies
I have a really weird problem with my car. Every time that I apply the brakes, I get a bit of a shudder. It just started a couple of weeks ago and we checked the brake pads which were fine and the bearings were good as well. What could be causing this problem?
View 2 Replies
so my r32 recently started making a nasty popping noise. the sound seems to either be coming from something in the rear end or drive shaft. not sure why it happened. i went on a 2 hour trip. got there parked it. aired it down (bags) but then when i came back and when to drive it again. it all of a sudden it started making a horrible popping noise. i thought it was the front wheel bearing going out since i knew it need to be replaced but i did that today and its still making the noise.
The noise sound just like a RWD car with a welded diff when it turns. kinda has that locked rear end hop popping noise. i lifted the whole car off the ground and put it in first to let the tires spin in the air but of course theres no weight on them so it doesn't make any noise. i'm really stumped on what it could be. im going to take the driveshaft off and see if it still dose it. then i know its for sure in the rear end. What it could be?
View 4 Replies
So I have a 2015 SE DSG. I'm getting the irritating popping noise, at no particular speed, coming from what sounds to be the middle/rear. It is lowered on H&R coilover, which I have checked over and over again to make sure everything is tight. It started about 500 miles ago, and the Coilovers have been on for about 6000 miles, the car just hit 7000 miles.
View 1 Replies
I have a 2002 Toyota Highlander. The rear right turn signal and break light don't work when I apply the brakes. When I use the turn signal or brakes while driving or parked there is no problem, but once I apply the break the back right side does not work. The light bulbs also burn out faster on that side.
View 4 Replies
We have a 2013 Sonata. For a while now we have been hearing a thump-thump-thump from the back of the car. The thumping starts as soon as the car moves and it appears to come from the driver side.
We get the thumping in our parking lot, on local roads, on the highway - everywhere. The frequency of the thumping speeds up and slows down in lock step with road speed. The thumping doesn't get appreciably louder when we go around turns or when we apply the brakes. We feel no vibration through the brake pedal, or through the steering wheel, or through the seats or any other part of the car.
Six months ago we left the car with the dealer after taking the service advisor for a ride. He heard the noise but when examining the car they could not locate the source of it. They said the wheel bearings looked good, the tires looked good, the brake rotors looked good.
After that we replaced the old tires with new ones and had them installed and had the wheels and tires balanced at a shop that is known for doing this well. (They take care of a lot of SCCA weekend racers.) After all of that the thumping was still there, same as before.
Now the thumping is getting worse. We are planning to take the car back to the dealer to have them go over it again and start replacing parts to see if we can locate the source of the noise that way.
View 7 Replies
My AM radio has terrible reception. There is humming noise that goes away when I apply the brakes. I will bring it to the dealer, but I know what they will say, "cannot duplicate problem" or "radio operation found to be normal".
View 14 Replies
I cant replicate the sound when its in park so i did a very dangerous diagnosis having a friend stomp on the break in gear and rev the engine to exactly 2000rpm as i searched for the sound. The sound is coming from in front of the transmission. I had removed the inspection cover as per another members fix for this sound and its still there. Could it be the torque converter touching something after it flexes at that speed?.
View 14 Replies
Every time I apply brakes I hear a weird humming noise, as well as no stopping power. Checked fluids and pads and everything is where it should be. I heard abs can cause this but not sure on that. I know my master cylinder has a very small leak but it hasn't lost any fluids of that sort. I'm lost. I don't know where else to look.
View 2 Replies
I have a dry metal on metal squawk noise when I reverse, I have taken it to a VW dealer, and they say "there is nothing wrong", or that they "cannot find anything". The noise is not constant, just when I apply the brakes in reverse.
View 2 Replies
It happens quite often, when i start the car, and apply brakes, then there is some sort of knocking sound coming from the rear. It sounds like someone knocking on the door... But the sound will disappear after a while. The car drives fine, could it be the brakes?
View 2 Replies
I had the rear axle seals replaced less than 1000 miles ago. Now the axle is getting whiny. First I thought maybe that the tires made noise but now I'm pretty convinced it comes from the axle.
With a seal replacement, what do they do that might impact the axle - over tighten the bearings?
I also had the rear diff fluid replaced - perhaps they put in the wrong stuff...
Should I replace fluid and see if that stops or should I simply take it to the dealer and let them deal with it?
View 14 Replies
1996 F350 PSD 7.3
Front Dana 60 mono beam
4 x 4
Last week I broke my front right caliper. I replaced the caliper, rotor and pads. Now, when I apply the brakes I pull to the left. I took the truck into my repair shop and let them figure it out. They were unable to repair the truck. They replace the master cylinder, all brake lines, calipers on both sides, brake pads, bearings on both wheels, vehicle alignment, tire balancing and tire rotation. The tires are three months old. Prior to last week i did not have any problems braking or steering. Driving at 60kmh the truck goes straight until i gently brake, it will slightly pull left.
View 2 Replies
Well I went to go to home depot and the key turned and my theft light started blinking and I hear a clicking noise coming from my fuse panel. By the way this is on a 2000 7.3l 4x4 limited. I found what was clicking (see picture) it is the second relay down, the one with the chipped plastic. My question is is this a relay I can replace or is it part of the fuse box? Where I can get a replacement? This is my daily driver so I need to fix this ASAP.
View 7 Replies
