Ford Excursion :: 2000 - A/C Only Works For A Little While
Aug 8, 2016
I am having a hard time figuring out what is going on with my A/C. First time you start it for the day, works great, blows cold air, but will only do it for about five minutes, then the compressor kicks off.
I have tried by-passing the high and low pressure switches, compressor still will not kick on. Checked the air-gap, it is fine, and I actually removed the shim, so there is almost no gap at all now, didn't fix the problem.
I tried replacing the A/C clutch relay, no luck there. I can tell you that if I manually push the contact in on the A/C clutch relay, the compressor kicks in and runs.
The only thing I can think of at this point is the A/C control panel in the dash, but wanted to check before I buy that expensive part and replace.
If it matters, this is on a 2000 Excursion, with the 6.8l v-10
View 10 Replies
Advertisement
I have the ESOF in a 2000 Excursion. I went to use 4X4 high and it would not give me 4 wheel drive. light on dash said 4X4 but no 4 wheel drive. I was in snow and only rear wheels spun. When switch is placed in 4X4 low I get 4 wheel drive.
View 1 Replies
My A/C works fine when I am moving, but when i come to a stop it does not come out cold.
View 14 Replies
The Transfer case motor works fine changing from 2H to 4H and back to 2H. Verified the drive shaft is locked in 4wd. Drive shaft is free when switching back to 2H. Hubs work fine and no problems on the vacuum side. Garage is 50+ degrees.
Very occasionally I can get into 4 Lo. (Neutral - complete stop - brake pedal depressed). My main question is could the Transfer case motor be bad if it works in and out of 4H with no problem? I have not seen any answer to this question from my searching. Also, could the dash switch be going? Last summer this started and now seems to be getting worse. This weekend I could only get into 4L one time. Where to start checking (motor on transfer case or dash switch or other)?
I have tried rolling slowly, backing up etc... Problem is I can easily hear the motor work when going to 4H and going to 4Lo (when it is working) most times when it is switched to 4Lo, there is complete silence like there is no power to the motor at all. Tapping the motor does not work. I pulled the electrical connectors off the motor and all pins on both plugs look clean and new.
Thought to first check the dash switch but not sure how to check it. The motor could be also a problem? Is there a way to remove the motor and check it?
I want to get this fixed by the spring since I use 4Lo every weekend when launching the boat. (Never has been deep enough in the water to get close to the Transfer case)..
View 3 Replies
My front heat controls work at start up occasionally. The heat will eventually come on in front after 15-30 minutes of the truck running. Needless to say this sucks for defrosting the front window during warm up. The rear controls work fine. I do have a couple that need replacing but the fan control isn't one. Temp & selectors. I've searched but haven't been able to find anything about same issue. Where to start?
View 14 Replies
I've noticed that when I lock the truck, the rear hatch stays locked most of the time. I have to manually lock it with the key if I want my truck to be secure. When it does work, it doesn't sound weak. When it doesn't, it's silent. Where should I start looking?
View 9 Replies
Cuz then there wouldn't be nothing wrong with my radio. So my factory 6 disc stereo has been giving me guff. Sometimes when I start my X it comes on normally and other times it puts out no sounds. Like the display is working just fine and i can turn the volume up and down and see the bars move across the display like the volume is changing but there's no actual volume from the speakers. Sometimes I never get output from the speakers for my entire 30 minute drive and other times it may just instantly without warning start playing over the speakers.
When it's not working changing stations or changing to cd/dvd doesn't fix it. It's completely random? I've been searching the net for issues like this and I've found a Taurus forum and a poster had the same issue with his factory Taurus stereo. He replace the RCM, which I assume is a radio control module, and it fixed the issue. Does the excursion have an RCM?
View 6 Replies
My backup assist only works when it is raining!! I have read all the posts I could find on the back up system, but have not found one one my issue. I had my wife turn the key on, engine off and put the truck in reverse. I put my ear to each sensor and they are clicking. So I am assuming they are working right. I took the speaker out and cleaned it and put it back in. No beeping at all!!
It was raining really bad one day last week and as I was sitting at the curb in reverse waiting to back into the driveway a car passed me and the system started going off. It startled me and the kids. I backed in and it worked as it should. Later that night we went out to eat and it was still raining and the system worked as I backed into a spot near a light post.
The rain stopped and the truck dried out and now the back up assist is nonoperational again! What is going on? To me it seems the moisture is completing a circuit that is not being completed when dry!
View 2 Replies
I just picked up an 05 6.0 Limited and love it, but I can't figure out the overhead temperature gauge. It shows -40 degrees no matter what, but if I hit the outside temp button on the climate control, it shows the (mostly) correct temp. I verified that the temp sensor in front of the radiator is still there and hooked up, and it seems to me that Ford wouldn't go to the expense of using separate sensors for each readout, so I'm guessing that the problem is in the overhead unit itself. All of the other functions (compass, mileage, range) work just fine. I've seen several threads about the overhead dying completely as chips rattle loose. Is it also common for just specific functions to go out as things start to shake apart?
View 14 Replies
Okay, So my rear washer is not pushing out the nozzle. Pump works, line from res checks okay, nothing frozen at this point. What route the line goes through the body, or what the diag steps are or the process to service it?
View 10 Replies
Fairly new to the ex. I just picked her up from the stealership last night, I'm in love! It's an 05 limited, v10, 71k. Loaded. Still tryin to figure out all the bells and whistles. It has one issue, I think it's minor, the drivers side power seat works intermittently, heat and movement. Being an electrician I believe it's probably a bad connection.
View 14 Replies
we just bought a 2002 Excursion and it has a few issues. First off the door, the ajar light will not go out, however, the dome lights are not on constant, they come on briefly while the key is removed and do work with the roller switch. Also the radio doesn't shut off with the key removed until the timer relay kills all power. I have ohmed the door switches to ground all the way back to the VSM/GEM module. The door lock/unlock switches do nothing for any of the doors, the actuators don't even try to move. The auto headlights also do not function.
View 14 Replies
I have a 2000 Winnebago RV on a Ford F53 chassis. Recently, I turned the vehicle off and found that the speedometer was stuck at 40. After opening the dash in an attempt to investigate the instrument cluster, it dropped back to 0. However, upon moving the truck again, it jumps back to 40. Once I accelerate up to highway speeds, It begins to work properly above 40. Now it sounds just like every other broken cluster post I've seen, but here's where it becomes different:
When I stop somewhere, and its still at 40, I can flip the dash up and it immediately drops to 0 and stays normal until I move again. It then works until about 10, then shoots up to 40 again, and stays there until I hit 40, at which point it resumes working. Once I get below 40 again, it stays at 40 until I stop and flip the dash up.
I assume there must be a wire crossing that I am pulling apart by lifting the dash. However, there is a mess of wiring down there, and I don't have a clue how to find where it is crossing, assuming that's the problem.
Before the problem was discovered, I made three electrical changes, though I can't imagine why they would affect the speedo.
1. I rewired the trailer plug. I wasn't sure why, but I had no power coming to my running light wire in the towing harness. I couldn't figure out why that wire was dead, so I just tapped one of the tail lights and wired the trailer plug.
2. I replaced my backup camera. The old Sony began to flash, so I just ran the new camera wire under the frame and behind the dash. I wired the monitor to the existing cables that the old one was connected to.
3. The chassis battery somehow died while driving. It was slow to start in the morning when we left, and about seven hours later, I shut the vehicle down at a camping world and when I went to leave, nothing. Somehow the battery was down to 6 volts, which I have never seen before. Long story short, new battery and it started up and has been fine besides that speedometer thing.
View 6 Replies
I was driving my f150 with the AC on, it has a 4 position fan switch. Lo, 1 , 2, and Hi. The fan only works on Hi. I don't think its a fuse, so what are the possibilities ?
View 3 Replies
I got a 2000 F250 XLT that the AC fan only works on high. Same thing in heat mode. Is there a relay for the other speeds that I need to check out?
View 2 Replies
2005 Excursion Diesel Ltd
1/ The Heater/AC control, one in awhile is not Turn-On when the engine is started, manually turn it ON did not make any different, but the next time/few times the engine is started it is OK.
What is the possible problem and how can I fixed ?
2/ The overhead console is dead, not sure which fuse it belongs to so I checked/tested all the suspected fuses=OK.
What is the possible problem ?, and can it be fixed ? or take the panel apart for further testing ?
View 5 Replies
Have no heat, the a/c works fine, ran the diag. and got codes 1262,1265,1947, and 5041, I don't even know where to begin.
View 10 Replies
2000 Chevy s10 ... The cold air works great however the heat doesn't seem to work at all. The defrost works but only cold air comes out even if I have the blend door on full heat. What the possibilities are. I couldn't find the blend door on the passenger side, I've checked the hoses and they seem fine, except for the following pic... Could this have to do with the loss of heat?
View 6 Replies
2000 Chevy Monte Carlo... The heater/blower only works sometimes, usually not at all when it's freezing out. when it's a little warmer out, it tends to work more often, but still not all the time. what could this be? my husband tried replacing the blower motor, but that didn't change the situation, so he put the old one back in, and is now puzzled ?
View 3 Replies
In my 2000 V6 Passat...I noticed that my temp gauge sporadically works...more often not. Is there a fuse or something that controls it?
View 4 Replies
I inherited my Mother's 2000 Corolla CE with low mileage. I know that since the car was knew, she had the dealer check on why the horn did not blow every time she pressed it. I do not have those repair papers, so I do not know what they did to the car. Again, after each of 3 visits to the dealer, the horn would work for a few months. Finally, she gave up. Arizona does not test the horn, anyway. So, now, I am having the problem. (Also in my V90 Volvo post). Two cars with no horns.. Short of pulling out the air bag and the wires? Bad ground somewhere?
View 3 Replies
