Ford Excursion :: 2000 4x4 V10 - Front Wheel Not Spinning Freely
Mar 27, 2013
Well its been almost 2 weeks since I've had the Ex (has 103K miles). Planning on new V code springs, Bilsteins front and rear , and rear Hellwig bar going in this weekend. Once I see how that that works I may also upgrade the rear springs to B code.
When I had it up yesterday I noticed the front right wheel does not spin freely. I can hear what appears to be the brake pad dragging.
Right not everything wrong with mine seems very common:
- very poor ride, 3/4" clearance between the front bump stop and suspension
- 4 door locks don't work (that's after the suspension fix)
- drivers heated seat not working
View 2 Replies
Advertisement
I was cleaning the underside of my trunk area and noticed the bolts to the back bumper underneath were spinning freely. Not being mechanically inclined, I thought they needed to be tightened. They didn't tighten. Well that got me checking other panels and low and behold I found a few loose ones.
So, is this a DIY project, or one I should take to the dealership? Since it's out of warranty, I'm fine with paying if need be to get everything tight on the outside of the car. But if it's not too difficult, I'd be willing to try.
If it's a DIY, then what are the steps? I looked around the internet but haven't seen anything.
View 5 Replies
I have a 2000 Excursion 2wd. The left front wheel or something up front is making a rubbing sound when I turn to the right. Checked the brakes, they looked fine. Pulled front rotor off and replaced the wheel bearing just incase. Still making that same noise? I can't see any sign of something rubbing either on the frame, brakes lines, or control bars?
View 3 Replies
Started hearing a squeak from drivers front wheel area when turning right, thought maybe pads might need replacing but they were fine as were the pins. So I checked for play with tire off ground and there was def some play pulling from top to bottom, so that lead me to the front hub, I read some posts about pulling the abs sensor and getting some grease in the the hub bearing so I did that but when I replaced the sensor and spun the hub it was scrubbing on the bearing.?
So I shimmed the sensor with a washer but now the abs light comes on but there doesn't seem to be a squeak when turning right anymore. Any example of doing this and had the sensor scrub? And with the play I would assume I need to plan to replace the hub assembly fairly soon...
2000 X 4x4 V10 with 147k
View 14 Replies
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 Replies
Driving at hwy speeds and head a pop noise in front end. Stopped and couldn't find anything, heard it a couple of more times, still nothing found, now I have a grinding noise left front wheel. What the issue may be. 2001 Ford EX 4X4.
View 6 Replies
While driving the other day and making a slow sharp turn, like a u turn, I felt my wheels binding like they were in 4WD. I got under the truck and I could not turn my front axles freely. I jacked each side up independently and I could spin each tire and the axle would turn as well.
I thought being out of 4WD that the axles would turn freely? Mine do not.
I have ESOF and my hubs are turned to AUTO.
Is this normal or do I have an issue with my hubs or transfer case?
View 14 Replies
Noticed that both rear wheel hubs don't spin freely, they rub or grind. 2013 Elantra sedan gets about 10% worse MPG than a 2012 Elantra we traded in for it, two identical cars yet 2012 got much better MPG and now we notice a rubbing noise on the 2013.
2013 Elantra has 19000 miles but has always had reduced MPG, markedly worse than the identical 2012 we traded, but dealer could never find a problem with 2013.
Wonder if this rubbing on the wheel hubs is to blame for the lower MPG? I can't think it works. Not sure if its the emergency brake, the power brakes, the wheel bearing or something else.
Is this rubbing noise normal? Rubbing happens with the hub only or even with the wheel attached to the hub.
View 7 Replies
My car is pulling to one right slightly so I did the alignment. But it didnt eliminate the problem. Ｉ jacked up my car and try to rotate the front wheel. I can hear slight noise of the caliper rubbing the disk and the wheel does not spin freely if I stopped rotating it. However, the noise is subtle so I don't know if it is by design or I have a brake drag.
View 7 Replies
I have a 200 f250 v10 srw 4x4.. I've replaced the auto front lockers with warn premium manuals. I cannot get power to the front wheels. The lockers appear fine. I hear the actuator function when I activate 4x4. Whats the possibility of a bad transfer case or front diff and how do i check? I've searched but there seems to be a lot of non-answers.
View 7 Replies
I've been noticing bad gas mileage over the last few months. I changed the spark plus, that didn't work. then I noticed the prob when I was checking my mail one day, on a slight incline and the car didn't roll back. so I took it home and checked each tire to see if it spun freely, and the two front ones do not, the drivers side being the worst. I don't here any noises coming from either tires, and have actually replaced front right wheel bearing last year.
View 21 Replies
The 4 wheel drive on my Ford Ranger goes out all the time. Today it stopped working in 14" of new snow, and when I was stuck in my driveway in PARK, my rear right wheel was still spinning? What might this mean?
View 3 Replies
I bought a 2000 Excursion XLT, 4x4 with the 7.3 Powerstroke Diesel back in the fall. Here in Indiana the winter is getting bad, not exactly the best time to find out your 4x4 doesn't work! My 4x4 light comes on, but I can tell I'm not in four wheel drive. I've read that on the diesels that the fix could be a simple vacuum line.
View 14 Replies
I have a drag/click coming from my front wheel. I had thecaliper off so it was definitely in the hub assembly. I went ahead and greasedthe hub through the ABS sensor but the drag/click was still there. I amthinking it is either the wheel bearing or the axle bearing. My question is ifI lock the hub and the drag/click goes away does that mean it is the axlebearing? Also, is it possible the auto locking hub could be part of the problem?
By the way, my Ex has 130K on it and the 4x4 auto selectworks fine. There is no play in the hub and no noise that I can hear. The onlyreason I am digging into this is a drop in gas mileage that led me to find outthat both front wheels are very tough to rotate (with the front drive disengaged).
View 4 Replies
I have the ESOF in a 2000 Excursion. I went to use 4X4 high and it would not give me 4 wheel drive. light on dash said 4X4 but no 4 wheel drive. I was in snow and only rear wheels spun. When switch is placed in 4X4 low I get 4 wheel drive.
View 1 Replies
Here's what I am running into. I have factory setup and it doesn't feel adequate. I get vibrations, lots of brake dust on front wheels, and just don't feel I have the stopping power if needed in emergency or towing. Especially with how heavy my 6.0 is already.
View 12 Replies
On my way home from work I was turning a corner and felt a pop / clunk from the front end through the steering wheel, and the steering wheel was no longer centered going in a straight line.
With the truck not moving, when I turn the wheel left and right, I can hear and feel a pop / clunk through the steering wheel. I'm assuming this is a ball joint failure?
View 6 Replies
OK, so the front end of the car is on jack stands. The rear is planted on the ground. The car is in park.
Yet, I'm able to spin the front wheels with my hand.
Wouldn't putting it in park lock the wheels via the transmission?
The car is a FWD 2007 Corolla....
View 12 Replies
This past week I changed out the front wheel bearing hub assemblys on both sides. I'm curious if completely disassembled one of the units? If so what did you use to get the large nut with the 4 notches in it off?
View 2 Replies
I have been having towing with the X. I have been getting a growl lately sounds like the front left wheel bearing. Today I jacked it up and did the wiggle text. I have a very slight wiggle in both wheels. Is a slight wiggle normal? I know the bearing on the left is more than likely gone as the growl goes away when I jerk the steering wheel. But I haven't heard any noise from the right side yet.
View 14 Replies
I have the 2000 Ex. Tan leather seats. Two seats in the front. I need to add a third. I used to have a F150, that had a flip up/down center console. It was a seat when flipped up (the console became the seat back). What are my options with the Ex?
View 10 Replies
