98 Ford Escort SE... Was changing out fuel filter and noticed the bottom (filter sets upright) snap holder the broke. Would I be ok with just cutting off some of the metal line and adding flex/rubber and using clamps?
View 5 RepliesI was driving my car today and it started driving like the brakes were on. It started to smell like rubber was burning. Before that I stopped at a traffic light and the car pulled to the left. Is the little car dying. 1999 ford escort zx2...
View 15 RepliesHave a 95 aero E4wd. Have replace driver side cv axle and drove about 8 miles then the outer joint broke. Had mech change cv axle and drove about 2 miles and the inside broke.. Same mech replace it and drove 3 mile and heard like rubber on metal like a flat tire. The cv axle did not break and won't turn when in gear. Back to shop with aero. Lifted on lift and jacked up front and rear. Turned the driver side and the passenger turned with it also it turned easy. Started it up and placed in gear, all were rotation except driver side , it was hung up. What should be fixed on diff?
View 14 RepliesMy 98 CR-V is now making a metal on metal ticking noise. The noise only occurs when the car is in motion. The noise seems to occur about every two revolutions of the wheels when moving slowly; I can't determine if the ratio holds true at higher speeds. The noise seems more prevalent when standing on the car's passenger side, but not significantly. The car has 225K miles.
View 6 RepliesMine appears to be leaking where the rubber pipe meets the metal coupler. What actually secures the rubber to the metal? I will get a new 1 soon but will be a week or so as I'm all spent after a few other unnecessary car related items.
View 5 Replies2002 Dodge Durango 6.9 R/T... I had my bearings replaced 3 weeks ago. And about 1 week later after 40 mins in stop and go traffic I started smelling this hot metal and rubber smell. Then my breaks got really tight when I pressed the paddle. Is this related to having my bearings replaced, what could be causing this to happen every time I am in the car 40 mins or more. It's happened 4 times now and the first time it started smoking. I'm really nervous to drive my truck in stop and go traffic.
View 3 RepliesI have a 1998 Ford Escort ZX2, 2.0L DOHC. I recently had the check engine light come on with code that basically says my VCT solenoid is malfunctioning. It is not very easy to find information about this part, I see that it is expensive, and time consuming to replace. I don't really have the time or money, the car still runs with 120k.What kind of consequences would I run into if I decided not to replace the part. The only thing I can find is that I would not pass emissions.
View 4 RepliesI recently replaced a bad head gasket on this car. After putting the reworked head back on the engine and putting everything back together, I can't get fuel to the engine. I cheated and took the intake manifold out and bolted it to the head and then set it back in the car plugging my injectors back into the manifold once in there. I checked all my electrical connections and they are all good. I am not getting power to the fuel pump, which was replaced a year ago when I first started tinkering with fixing the car. I get power to and from the inertia/fuel cut-off switch, but it doesn't appear to get to the fuel pump. I checked all the injectors to make sure they were seated properly which they were and all the fuses both under the dash and hood that I know about and then some. When I pull the 30amp fuse under the hood, and replace it, I do hear a sound that sounds like something is pressurizing or pumping for a second or to, but the sound is from under the hood and not from the pump/gas tank area.
View 2 RepliesWhat's the best way to changed a EGV valve on a 1996 Ranger? The metal line coming from the exhaust manifold to the EGV valve, is seriously rusted on both ends. It looks like if I don't heat the metal line, the line will just round out, what's the best way to tackle this job.
View 6 RepliesI had a brake line crack on my way home yesterday(that was interesting..) It was the drivers side rear metal line from the splitter to the rubber hose. I went to autozone and was like ok easy enough this line is the same length and appeared to be the same diameter. bend to fit and all was well or not.. the fitting on the end was a different thread pitch and size. 1999 f250 4wd if it matters....
View 4 RepliesI just recently purchased a 1998 ford escort. the gas gauge constantly at half. I haven't driven it yet because my insurance kicks in in a few days.
I asked my friend about it and he said that some cars always gauge the amount of gas no matter if its running or not. Is my escort one of those cars? or is it just broken?
I have a 1998 Ford Escort which I drove about 450 miles in frigid weather over about 8 hours in mid January. After arriving at my neighborhood and getting off the expressway, I couldn't get the idle on the car (manual transmission) to go below 2500rpm's. Further, upon taking off, the car was trying to stall, and I was forced to feather the clutch through town driving and keep the throttle up so it wouldn't stall, even with the clutch in. The weather at the time was about -7 degrees (f). The next day the weather continued, and thee car would start, jump to the same idle for 10 seconds, then drop suddenly to 500rpm, then stall out. I wrote the car off, cleaned it out over the next week, and then I tried to run the radio while doing so last weekend. I got the car to start, and run normally. I think it may be a computer issue, but it may also be the temperatures. The car has 207,000 miles on it.
View 3 Replies98 Ford Escort SE
Been having acceleration issues with the Escort for a while now. The repairs I've made on the vehicle so far are; new fuel pump, coil pack and mass air flow sensor cleaning. Those are in order.
Now onto the issue. From a dead stop and sometimes while driving my vehicle will give acceleration issues though mostly from a dead stop. Checked the tranny fluid and it was a light brown with bubbles(?) so thought I'd do a fluid change but with the work required wanted some input before ripping into it.
1998 Ford Escort SE ... On idle ( at a red light or in park while on) it shakes terribly. When I shift into N it will lessen for 3-10 seconds, but then it will cycle back to the vibrating. The spark plugs were replaced about 4 months ago and got a brand new transmission 5 years ago this coming summer. It came into the family in '00 and I got it when I turned 16. The vibration started about 2 years ago and at first I was told "little car has shaky engine". When it got worse I was told it was the motor mounts, which I replaced a year ago. When they were first put in the car ran smooth as ever.
My mother turned on the AC while I was taking her for a test ride that same day and it started back shaking. They said the motor mounts were perfectly in place, and that it was a broken fan blade. My husband and I just don't see a fan blade causing that much shaking. I can hear the car violently vibrating when I park and take pizza to someone's door. Also a more minor problem, ever since we put new brakes on, my brake light comes on too easy. The weight of the peddle will turn the light on, and I have to keep using my foot to pull it up after each time I touch it, and sometimes when I'm driving.
my mom's car is a 2008 chevy impala police car. This police car has an extra oil cooler unit. the rubber hose is leaking oil right at the point where the rubber is crimped to the metal end connection nut. since this is a police car the rubber hose is very expensive at the dealer (over $300 for the part only). Is there a cheap way to seal this leak with some form of heat resistant tape or glue compound ? or, can I cut the existing rubber hose and remove the leaking end & replace with a 3rd party rubber hose with the correct end and then join the two rubber hoses at the cut portion together with some creative scheme like a metal tube insert with metal tie wrap clamps? Any creative solution that i can deploy to stop this oil leak.
View 6 RepliesThis problem showed up this summer, different times under load: on hot days, going uphill, AC on. Also, always happens when the temp gauge is just above halfway. Even after a stall, I am able to limp home, and it improves the longer the car runs after the problem starts. First I replaced the fuel filter which was pretty dirty, the problem didn't improve, so had the shop run codes -- low ignition voltage. They replaced the coil, and that seemed to work for a while. Now, in109 degree heat, it's starting to hesitate again, but the engine light hasn't come on this time. I had to replace the radiator about 4 months back, when it was cooler, and don't know if it's somehow temp related. Also, haven't replaced the timing belt since I bought it with 90K (its has 119K now).
View 3 RepliesIv got this escort from my sister, i assume it has been hardly maintained considering the... state. I bought it because she was tired of dealing with the problem... driving, it will turn off. She said it got to the point where she just stopped driving it, although it only happened twice. It began when first time it shuttered then died. Took air filter off and it only ran it like that to get it home. Now it doesn't run but for a few seconds even without air filter, so Its the best choice to leave in.
Anyway, I've replaced:
-PCV Valve
-Fuel Filter
-Some dry-rotted hoses
-I didn't replace it, but i cleaned throttle body and MAF sensor in the intake.
I've tested alternator and batter, both are good. I tried fuel treatment. Being honest this is the extent of my.. automotive understanding. But Im fairly certain it is a fuel system problem.
just bought a 06 avalon yesterday. Want to check the oil line recall and don't know where to look or which line to look for. Was told it was replaced with a metal oil line but would like to check for myself. where to look to check this?
View 9 RepliesI just bought a 98 Ford Taurus, I've driven maybe 600 miles on it so far and it's been fine until recently. It first started with this jerking it was doing. I would press on the gas and it would do this jerking thing. And when I would pull up at a stop sign or put it in park it will do that jerking thing too like it's going to stall but never does. Then last week I start smelling this burn rubber smell, and then I saw a little bit of smoke coming from the right side of the Hood and then the check engine light came on.
It doesn't over heat though. Last nite I was driving, I pull into a parking spot and put the car in park and the RPM 's kept going higher, it scared me so I put it in drive and they went back down. I was going home and as I was driving I took my foot off the gas but the car kept going faster anyways. That's hasn't happened again but the burnt rubber smell, the jerking, smoking, and check engine light keeps happening. It's my only car.
I have an 03 Accent. The all metal high pressure power steering line had a leak. So I bought a new one for around 70 dollars from Hyundai. This part has a curved shape and fits around the radiator. The old one was difficult to get off, but the new one is proving impossible to get on. I cant get it into place.
View 2 RepliesMy taurus makes this weird sound when I turn my steering wheel left or right. It sounds like that cartoon "rubber being stretched" sound or maybe a little like plucking an overly tightened string. It doesn't affect driveability but I've been dealing with this for quite some time and I'm trying to sell it now... it's a major buyer turn off.
View 7 Replies