I need to pull my throttle body so I can give it a proper clean, but Haynes says that I shouldn't use a wire brush because that will damage the "special coating" on the bore and butterfly plate. It says just to use a rag and solvent.
The crud on mine looks like it will need more than a rag, so I was thinking about a toothbrush rather than a wire brush - do you reckon that'll be OK?
2006 Honda CRV, throttle by wire. How can you get the throttle plate open to clean the throttle body etc.
View 4 RepliesI have a 2004 Ford F150 4x4 with 170,000 miles. its running a little rough so I thought I would clean the throttle body. do you clean it on the truck or remove it?
View 6 RepliesI'm usually over in the EX forum but today was working on my brothers 1998 F150 - V8 4.6L. Had the EGR code P0401 and due to FTE I found the problem took the throttle body off and found it was definitely plugged. One of the bolts was really loose and came off way to easily. Didn't realize until cleaning why... Now I drilled 8 studs out of my aluminum EX heads but this one has me pondering how I'm going to clamp this thing down and center a bit..
1st pic - ports WOW - guessing this was the problem ...
2nd pic - bigger issue ...
3rd pic - the ports cleaned up ...
I have a 2009 Camry which has the well known very bad vibration at idle when in drive at a light. My Ultragauge shows the RPM are very low when it vibrates. Sometimes it drops to around 425-450 rpm when at a stop light in drive (automatic car). Then it sometimes moves up to around 625-675 rpm and that is when the vibration completely disappears and it is nice and smooth. This issue is intermittent but happens everyday.
Most people think it is due to a bad engine mount and spend money doing that and get no results.
I have done a lot of research and feel it is due to a dirty throttle body and IAC valve and want to test my theory. I will post results once I do the job. What is the easiest and most thorough way to clean both?
I brought my Prius, 128,000 miles, into the dealer with the check engine light on. Runs fine, and checked the gas cap. Toyota dealer said they need to replace 4 fuel injectors, replace oxygen sensor, and clean the throttle body. Check engine light needs to be off so I can pass emission test.
View 8 RepliesWell, not an escape, it is a mazda tribute. but it is the same thing as an escape. My sister just called. as she is driving down the road, if she lets off the throttle the engine will randomly die. it did it 2 times sunday, once yesterday, and once today, as she was talking to me. It will not die at traffic lights, just as you let off the throttle sometimes. today it did it at 45 mph. When it dies she just pops it in neutral, restarts it, puts it back in drive, and it is fine. No check engine light after restarting. What I should look at when she brings it over this weekend?
View 3 RepliesI am working to analyze my Granddaughters 2008 Escape FWD Auto 2.3 L issues with the Transmission. Vehicle has 142K miles with engine oil changes but no maintenance on the Transmission.
Engine was replaced about 9 months ago with a used 2.3 L with 52000 miles. Engine runs fine with no issues and NO Codes. BUT when driving the Escape I find it starts out in 1st gear and with a little feathering of the throttle will shift at 2600-3200 rpm directly to 3rd gear. (Based on known ratios and rpm vs MPH) Also no OD/ 4th gear. OTHER than the shifting issue it runs fine.Reverse works normally.
Summary: NO CODES from OBDII, NO OD lite ON or flashing, NO leaks, "wrench" light is ON solid after 1-2 miles driving, "wrench" light is OFF on restart but turns ON after 1-2 miles driving, Changed ATF - old fluid was slightly dark but looked and smelled OK - Drain plug magnet had slight coating of sludge - no dirt, metal or other solids. Transmission Shifting Lever properly selects Park - Reverse - Neutral - Drive with a quick/Normal change.
2005 Escape 3.0 with 160k miles. Slight miss under cruise, goes away under slight throttle. No service history known about vehicle. Best to replace spark plugs and coils with Motorcraft parts? And the intake gaskets too? Suggestions for correct plugs?
View 14 RepliesSo I am changing my transmission fluid tomorrow and was wondering a few things.
1. I noticed some people pull off the transmission hose to the inlet and keep draining that until its clear. For a drain and fill do you do it like that or just pull the plug and refill?
2. When youre filling it back up you just measure how much you taken out and then fill the rest by the dipstick? Anything else i should know?
3. Since I havent changed my transmission fluid in 60,000 miles. I wanted to do a drain and fill. I was thinking I needed to drain and fill it 3 time to catch up to maintenance. How often would you do it to get it clear? Drain and fill then drive it for a week then drain and fill? Or do it all in one day?
I need to clean my throttle body on my '97 F-150 and it has a label saying not to clean directly. Is it still safe to use TB cleaner and to go ahead and clean it? It needs done but how would I go about it.
View 6 Repliesread a few posts over the years relating to dirty throttle body, but never understood them. At 60000 miles, should this be attempted by the average guy or just leave it alone if it aint broke?
Any pics addressing where is it, what makes it dirty, how to open it, what to clean it with and how often as preventive maintenance?
I've been on a detailing spree lately, I'd love to get a sparkling clean engine bay but I'm worried about getting water into the high voltage bits. The ES300h has high voltage cables, motors and the inverter module on the right hand side.
So far I've used a damp cloth and dishwashing soap to wipe off surface dirt and oil. I'm not sure if using a low pressure hose is a good idea. To the hybrid owners out there, how do you keep your engine bay clean?
The Throttle Body on my 2001, 4.6 L is making a strange whirring noise, when you puy your hand on the intake pipe, you can feel a slight vibration. The Truck idles and runs okay, with no codes. Giving it a little gas and the noise goes away. The last thing I did was clean the IAC with Gum Out Carb cleaner, the second or third time I've done this over many years, with no problems. I'm a little perplexed at the cause.
View 6 RepliesWhile driving home my yellow wrench light came on and I had no power at the pedal, even though the engine was idling smoothly. This happened with no warning and went away when I turned the truck off and restarted it. About 4 miles later it did it again. I immediately went to a nearby dealership only to find out my electronic throttle body needs replaced. Needless to say at this time of year 500+ dollars is not readily available, although I need my vehicle for work.
I do not know a thing about ETB's but did a little research online and found many aftermarket ones at a much better price than Ford's(surprise). My question I guess is what are my alternatives to factory replacement? Can I remove and clean this component or replace it with something of better quality? I'm not into high performance with my truck but if I could get a little better throttle response or gas mileage I'm all ears. My truck is a 2004 Supercrew 4x4 XLT w/ 5.4 Triton. Around 74,000 miles and well taken care of. Miles are nearly all highway.
I have 2011 f150 5.0 with 38,000 miles and the throttle body seized up tight.
View 10 RepliesI have a throttle body noise that sounds like a warble,It is sporadic and I think it should not be their. But I have heard some other f-150s make the same noise. Is it normal or is something not right.
View 3 RepliesMy 1997 ford explorer has this problem that when you start the engine it runs fine then it's makes a choking sound in the throttle body area I have a video of it on YouTube here's the link :
1997 Ford Explorer Engine Trouble !!! - YouTube....
And the truck doesn't give any ob11 codes.....
I busted the cable end by not removing it properly. My question is what is the proper method of remove the cable from the throttle body? Are the cable ends replaceable? If so who has them as a google search didn't find any? I've tried to find written information but haven't any luck. bl2009
View 1 RepliesI accidentally broke the control lever where the cruize control attaches. I've looked all over but I can't find the lever. Where I could buy just the lever? New throttle body is more than I want to spend.
View 1 RepliesI bought a 2009 f150 5.4 with 150000 miles on it. I have a slight hesitation from idle so I want to clean the throttle body. I found several for the older f150"s with the horizontal throttle body but this 2009 has a vertical mounted one. I change the air filter and cleaned the MAF but didn't change anything. My wife's ford 500 had this problem and cleaning the throttle body completely cured it.
View 3 Replies