Ford Escape / Hybrid :: Exhaust Smell In Interior Upon Startup And Especially If Using Remote Start
Jan 21, 2016
2007 Escape XLT 3.0 AWD. During the winter there can be quite the exhaust smell in the interior upon startup and especially if using the remote start. During driving the smells will clear out and appear again with an extended stop but not as bad as initial cold startups. I realize the hotter the engine and exhaust components the smaller the leaks become. Hopefully not an exhaust manifold leak.
Looking for a way to find where a leak may happen. I saw a video of a garage using "smoke" pushed up the tailpipe to find leaks. Or any other techniques or similar situations.
View 2 Replies
Advertisement
Background: No A/C. Identified Clutch had completely failed. I replaced the clutch.
Status: I turned on the A/C and I saw the clutch come on...it was on for maybe 60s. During that time, the vents started to get cold! After 60s it never came on again.
Troubleshooting: I have refrigeration gauges but not much idea how to read the result. I hooked them up and noted about 350psi for the HP side, and about 100psi for the LP side. I think this tells me I should have enough charge in the system to cycle the compressor.
At this point I don't want to start random troubleshooting as I don't want to touch the refrigerant loop more than necessary. A few questions:
1) The HPCO switch, I was reading that it's mounted on a Shrader valve. Is this the case? I'd like to remove it and test at which point it switches. I have not tried bypassing it.
2) Do our vehicles have a temperature sensor near the evaporator? If so, whereabouts is it located?
View 10 Replies
My ford escape won't let me unlock it my remote start doesn't work but the cars runs fine but today i locked my car before i turned it off which is what i always do. to lock it and when i went to unlock it manually i heard a pop sound and my key won't turn and there's no other way to unlock my car i walked around it 3 times trying to look for a key slot. How to unlock it.???
View 2 Replies
My front interior light/map lights combination does not come on when the doors open. The rear seat and cargo area lights work when the doors open. Do the front interior lights are not designed to work in conjunction with the other lights when the door is opened?
View 6 Replies
My g/f's 2004 Ford Escape (3.0L V6 AWD 112,000mi) is acting up. After a full day of sitting, with the second half of it raining steadily, she was driving her Escape and it was acting funny (miss-firing, she said). The engine light came on and soon began blinking. She got to my house shortly after it started this. We left it and I drove for the day. Later that night, I drove it and it seemed fine. The engine light was on, but not flashing anymore.
The next day I took it my friend that was a Saturn mechanic and now working at a KIA dealership (same owner as the former Saturn and current Buick/GMC and Chevy Dealer). It ran fine for me. So he tries to scan it, his Mac Tools scanner won't read it. The KIA scanner wouldn't read it. I drove it the Ford dealer up the road. They said they couldn't get to it until after lunch, I just want the codes read. They re-iterated, and I told them to pound salt and went to an independent shop where I know a guy. They read it right away for me. "Mis-fire on start-up" & "Cylinder 4 Mis-fire." were the two codes stored. He cleared them.
She got the tune up basics (plugs, wires, air filter, etc) and did the complete tune-up herself yesterday. (I was impressed). She put 94 in the tank and some fuel system cleaner in it as well. She said there's been no change and today I finally saw what it was doing. Sometimes during idling at a stop light, the RPMs will drop to almost zero, the lights dim but so far it has not stalled. It'll do this for several seconds, then correct itself and idle normally.
Currently, the engine light has not come back on. She's thinking coil pack (each cylinder has a coil on these engines) on #4. She wants to switch it out with #1 and see if the problem follows. I think that might uncover the cause, or it could be the battery. It's the original, never been replaced and has a lot of miles on it, but it survived this past winter, without trouble. In my experience, most batteries crap out due to age in the fall when the cold snaps start.
View 11 Replies
Wife is operating a 08 Escape with about 31K miles on her. She loves the vehicle but since we bought it with 24K miles on it it has had a rattle under it. I assumed that it was the heat shield and i would get around to securing it but haven't yet. Here's the question. I noticed recently that about mid way back under the pass side there is a black spot developing on the concrete where she parks every day. The vehicle does not sit and idle there. Its started and is moving in about 20 every time. I have not got under there yet but was looking for possible answers as to what and where to look? Flex pipe? Bad seal on exhaust? If this is the case should a 31K mile vehicle have this issue? The vehicle is louder than a 2.3L should be but from reading that seems normal. If it is the flex is this something that a novice wrench can do?
View 6 Replies
Getting a fuel smell especially when 2004 3.0 escape is idling. Is there a replaceable evap filter or maybe the pcv valve?
View 3 Replies
Started smelling exhaust in the cab while idling, and at startup. After further investigating found out the EGR inlet tube is leaking at the flex joint. So my question is , is there anything that will jump at me while I'm doing this tube replacement.
View 3 Replies
2014 Camry SE i4 20,500 miles ... Is it normal to smell gas coming out from the exhaust during a cold startup? After the car is warmed up the smell disappear ...
View 1 Replies
I am having a problem starting my Escape. It ran fine when i parked it. Now it turns over but wont start.
It turns, almost catches, then turns slower. White smoke comes out of the exhaust, which means it is getting fuel i think. When I crank it all the dash warning lights go off. I tried the spare key. I tried pushing the gas pedal. No codes on the scanner. I switched the fuel relay (r3) with the fan relay (r4). I tilted the column a few times. Coils and wiring do not show any damage or wear. I opened the air filter with no change.
The only change i notice is that when turning the key has some resistance. It does not feel like it used to turn. This year I had to install a new battery and alternator. At 90k miles i gave it a tune up (plugs, boots and coils). It has 116k on it now.
View 12 Replies
I have a 2005 3.0 front wheel drive Escape that the kids normally drive and recently had a crank over/ no start condition in my driveway. I replaced the fuel pump about three months ago. Turned the key and couldn't hear the fuel pump so I proceeded to check the fuses and relays and everything seemed good. I also checked the inertia switch and it seemed ok as well.
I then checked for power at the harness right above the fuel tank and I had 12 volts on two of the four wires so I assume that I have power to my pump. I then took out the pump and had it replaced it under warranty. So I proceeded to install the new pump and I thought that I would hook the harness back up and just turn on the key for a second to be sure that the new pump is working and there was nothing to be heard. Looking for a wiring diagram/colors of the fuel pump?
View 2 Replies
I have a 05 escape hybrid with 75k on it. there is a slight problem every once in a while when it starts the idle jumps up and down and when it is put in reverse it has no power to move. you have to put the pedal to the floor....there are no codes and ford has had the car for a total of three weeks, nothing found and of course it did not act up for them..
View 9 Replies
She has a 2010 Escape 4-cyl and the A/C isn't working. It's miserable hot and she has small kids.
The compressor won't start. I put a gage set on the low pressure side and it's sky high, so it should be coming on at least. I also used a Launch scan tool on the OBD port and the HVAC control is commanding the compressor to start, so it's not that - which leaves the $300 compressor or the $9 a/c relay as the next steps. Unfortunately, I only see this car occasionally so I haven't really been able to get under it to check for voltage at the a/c compressor or see if it's a ground issue, etc.
I'd like to go after the relay next but can't find a a diagram I trust as to which one it is. I've heard mention that it's the WOT relay and also that there's an A/C Clutch relay. Any reliable schematic of the underhood fuse block and which position it's in? I took the cover off and they're numbered but there's no map. Also, what p/n is the relay? I'd like to just pop in a new one and see if it takes care of it.
View 1 Replies
My wife has a 2010 Ford Escape. When we try to start it you have to push the key in REAL hard to get it to crank. It's been doing this for a while and seems to be getting worse. It took her 10 minutes before she could get it to crank earlier today. Our mechanic couldn't find anything wrong the first time we went in.
View 3 Replies
So my wife's 2005 escape currently will not start. It was running rough so we brought it in to the shop to have the codes read. There was a bad MAF sensor code so we brought it home and were gonna replace the part the next day. The next day rolls around and it refuses to start. Swapped out the spark plugs which was much needed, replaced the valve cover gasket, which had also gone bad, and put in a new MAF sensor. It still refuses to start. It will turn over, but never starts. Also, the sound as it turns over doesn't sound right. It's hard to explain what sounds off about it, it almost has a "soft" sound to it. I can try to explain better if needed.
View 6 Replies
I have a 2003 Ford Escape Limited V6 replaced thermostat and fuel pump and 3 coils and 3 spark plugs recently. Now the theft light has come on and will not crank or start. The fuel pump is still not working unless I manually press the fuse under the hood which is also the only way the car will crank still will not start. That's because the previous owner got the key stuck in the ignition so he bypassed it with a dial you can turn. The dial will put the car into ACC and on mode but will not get the car to crank. Also btn1 and btn2 fuses under the hood are draining my battery.
View 3 Replies
After 5 days on raining my escape will not start... It tries but then sounds like the battery goes dead tried jumping it didn't work. Took the battery to be check and it's good...
View 9 Replies
My "Theft" light on my 2005 Ford Escape is flashing and I cannot start the Escape.
1. I tried the key that I had been using successfully for the last 7 years. , car did not start, Theft light blinked. ,
2. Tried wife's dealer key, Car won't start, theft light blinks.
3. Tried various things, such as manual locking & unlocking, turning alarm beeping on/off, disconnecting battery, etc. Nothing works.
Called the dealer, they say they know nothing. Must bring car in, they say. Basically I am screwed and now must spend big bucks to take it the dealer because of Ford's software bug.
View 9 Replies
2003 Escape Limited V6 Auto 4x4 ... I am having issues with poor fuel milage and starting the SUV...
When i go to start the truck it winds over for abit then starts and revs really high?!?!? I did a complete tuneup, plugs, filter, fuel filter, oil and filter... I changed the fuel pump which has the fuel regulator built into it. I have no codes on the dash. Also if i am at a red light and i put it to the floor I MEAN TO THE FLOOR!!! the truck bogs then drives off NO POWER!!!
Im stumped! I dont know what to do and dont want to keep replacing expensive parts... fuel pump, etc...
View 14 Replies
I recently had my PCM flashed due to the deceleration safety recall. My engine now revs to 2200 rpm when I start it even if the engine is hot. It goes down to 750 rpm after about 30 seconds. My engine before the recall, reved from 1200 to 1400 rpm when starting. My dealer and ford tell me 2200 rpm is normal but I think it is too high.
View 7 Replies
My daughter has a 2001 Ford Escape, V6, Automatic, 2WDR, 132,000 miles that is having starting problems. When you turn the key the engine will try to start. You have to push on the gas pedal to keep it running, it will not idle until it gets warmed up. If you try to drive it while cold, it has no power. Reading previous posts I have already replaced the spark plugs, intake gaskets, air filter, EGR, TPS, and fuel filter. Check for crack hoses / vacuum leaks. It is still not starting properly. No engine codes. New problem is oil light is flashing but the engine has oil. All of the gauges, lights, functioning normally. What do I try next?
View 1 Replies
