Ford Escape / Hybrid :: 2012 - A/C Compressor Not Kicking On
Jun 4, 2017
I am having issues with the wife's escape and the a/c compressor not kicking on(It will turn on for a split second when first fired up if the a/c is set to on but then turns right back off). I am getting a static pressure on the low side of 120 PSI, I have yet been unable to see what pressure shows when the compressor kicks on for a split second. I have confirmed the compressor relay is good and I don't see any blown fuses or anything else out of place.
View 1 Replies
Advertisement
She has a 2010 Escape 4-cyl and the A/C isn't working. It's miserable hot and she has small kids.
The compressor won't start. I put a gage set on the low pressure side and it's sky high, so it should be coming on at least. I also used a Launch scan tool on the OBD port and the HVAC control is commanding the compressor to start, so it's not that - which leaves the $300 compressor or the $9 a/c relay as the next steps. Unfortunately, I only see this car occasionally so I haven't really been able to get under it to check for voltage at the a/c compressor or see if it's a ground issue, etc.
I'd like to go after the relay next but can't find a a diagram I trust as to which one it is. I've heard mention that it's the WOT relay and also that there's an A/C Clutch relay. Any reliable schematic of the underhood fuse block and which position it's in? I took the cover off and they're numbered but there's no map. Also, what p/n is the relay? I'd like to just pop in a new one and see if it takes care of it.
View 1 Replies
The A/C on my 2012 Escape keeps freezing up. Happens mostly on highway and humid days. It's been to the dealership and had literally everything except the hoses/lines replaced.
The final paperwork from Ford said to run it only on the recirculate setting when running the a/c. This works but I really would prefer the fresh air setting.
I feel there is a problem with the system but maybe it's a design flaw instead of an equipment malfunction? Humid and warm weather.
View 10 Replies
My liftgate glass will not open but the liftgate will. Dashboard indicates that the glass is open. Can not open with key fob either. What this problem may be.
View 4 Replies
I just put on new winter tires and rims on my 2012 Escape and after driving about 6 miles, the low tire pressure light came on. Is there is a procedure to learn the vehicle to the new tires?
View 6 Replies
My 12 Escape with the 3.0, shifts fine in warm weather or in cold weather when warmed up. But first thing on a cold morning she's a bit of a screamer getting into the next gear. Is this a signal of something about to go wrong? Is there an easy adjustment? Or this is the way of it and it is fine......
View 14 Replies
I want to not only upgrade to LED lighting, but I want to add to the single bulb fixture found in the center dome light (between the front and rear seats).
I can get the cover off OK, but I'm having trouble figuring out how to remove the fixture itself. There are what appears to be press fit style plugs (similar to what you would expect in a door panel) but there is also half-slots making it look like one side pops out and the other side slides off the mounting plug.
How to remove it without breaking it?
View 12 Replies
The cooling fan runs on high as soon as the a/c is turned on, regardless of the engine temp. I have the sensor(6F9Z-19D594-AA) that mounts on top of the accumulator. If i replace the existing sensor, will the refrigerant leak out?
View 10 Replies
I'm experiencing the tug/jerk/shuddering in my 2012 Escape v6. It happens more around 70mph or 2,000-2,500rpm.
Tug/jerk/lurch/buck happens even more with OD off. Happens around 60mph or 2000rpm with OD off.
Been to the dealer several times even test drove with a mechanic that acknowledges the tug/jerk sensation. No codes or faults. Last visit the dealer showed me a print out of misfire counts and all cylinders were 0 yet on the drive home it was tug/jerk/lurching.
View 5 Replies
Have a 2012 gas powered Escape XLT, 2.5L 4 cylinder.
I need to replace the evap purge valve. Looking at youtube videos and from other posts it seems easy to replace. My problem is where is it located on this Escape?
Is it under the hood or underneath the driver's side? This is just the valve mind you, not the canister in the back.
View 3 Replies
I have noticed that my vehicles engine fan runs at max speed (and is very loud) all the time. Regardless of outside temperature, engine temperature, climate control settings, etc. It runs like that from the second I turn it on until I shut it off.
I have done some research online and found that people with a similar concern have been told that it could possibly be either the Coolant Temperature Sensor and/or Cylinder Head Temperature Sensor. I know that it could be a wide variety of issues, however it seemed as though these were common (and relatively easy) solutions. Does anything think either/both of these could be the problem? If so, need info about the proper part and instructions/video on how to install the new parts.
I would much rather spend ~$50 for two parts than screw around taking it in. If my attempts dont work, at least I know that I have 2 new parts in there. Or is this not really anything that I should worry about?
Additionally, my climate control settings dont all work. And I have found through research that I need to replace the blower resistor. Would this have any impact on the engine fan? I drive a 2012 Ford Escape XLT 3.0L V6
View 5 Replies
I think I forgot to reset the oil life indicator at my last oil change, however I am not 100% positive.
Is the oil change indicator purely based on time/miles driven, or does it have any sort of sensors that actually detect issues with the oil?
I've heard some vehicles do actually do basic checks rather than purely being time/mileage based.
Anyway, I am no where near the miles or time interval from the previous oil change so if there aren't any magical sensors I'll just reset the life.
View 3 Replies
I realize that is vague. I realize it could be anything from a wheel bearing to a ball joint, tie rod, control arm/control arm bushing, etc.
Are there any very common front-end steering or suspension issues on 2012 escapes? When tires are inflated to 32-34psi, the car tracks straight, gets great mileage --but almost sounds/feels like it's got a CV or wheel bearing issue on the front right. Every time I hit the brakes while backing out of the driveway I can hear a slight bump or pop. When the car is parked (flat, tires straight) there is slight play left-to-right in the steering wheel.
I'm a German car guy. Have never touched this car. (Wife's car) Right tire is wearing bad on inside. Looking for some direction so I can assess. Car has 88k miles. This will be a DIY fix. Don't have any manuals or anything so just looking for a heads up where to start. Also is Haynes the best way to go? Is there a Bentley? Anything online/CD/DVD?
Play in steering wheel makes me think tie rod (fine because easy/cheap) but such excessive wear on the inside right front makes me think wheel bearing. Could it be both? This is AWD. Is this (like a Subaru) a CV joint where the front spindle passes through a strut base that everything attaches to --so there's an inner and outer wheel bearing?
Does anything up front require a press or can it all be done without a press?
View 3 Replies
4.6L engine.......Well my A/C isn't working I just found out. The compressor is not kicking on. I checked the charge with my gauges and it is good so I don't think the low limit switch tripped, but I don't have a manual or anything and was wondering which number relay and fuse goes to the A/C compressor.
I also need to know which fuse goes to the power mirrors as well. I downloaded a manual from the ford fleet site, but honestly I haven't gotten around to looking at it. Not home.
View 2 Replies
Bought a 2014 SD 4x4 in December of 2013 and this is the second time the big girl has been to the shop with A/C problems. First time it was the evaporator about three or four months ago. During the last few weeks of the summer I began to smell something strange (like band-aids) when the A/C was on and it lingered until the next re-entry. ALso, began to hear a slight hissing noise when the compressor was kicking in and out. They replaced the evaporator, smell remained as they said it was the refrigerant I was smelling. About two or three weeks ago the smell got slightly "larger", and last weekend she would not cool. This is the fourth time shes been to the shop with other problems such as the My Touch system..............
View 7 Replies
So I am changing my transmission fluid tomorrow and was wondering a few things.
1. I noticed some people pull off the transmission hose to the inlet and keep draining that until its clear. For a drain and fill do you do it like that or just pull the plug and refill?
2. When youre filling it back up you just measure how much you taken out and then fill the rest by the dipstick? Anything else i should know?
3. Since I havent changed my transmission fluid in 60,000 miles. I wanted to do a drain and fill. I was thinking I needed to drain and fill it 3 time to catch up to maintenance. How often would you do it to get it clear? Drain and fill then drive it for a week then drain and fill? Or do it all in one day?
View 4 Replies
I took my car in to get this checked out, but they say they can't hear it.
Sometimes when I turn my car on right after I turn it on, there's a loud humming sound like a compressor or something is kicking on and it's not fully engaging. And it only makes the sound for maybe 3-5 secs. Sometimes it won't happen when I turn the car on, but when I'm driving and I let off the gas and go to touch the brakes, it'll start.
The best I can describe it is a 'hum'...but it's loud, and I can feel it as if it's near the gas pedal right behind the firewall.
Dealer thought maybe it was the ABS switch testing itself..but they could never reproduce....I got in after they replaced my rims and checked it...and it did it 4 times when I started it, then turned it off. He came out to check, and it was almost as if you couldnt hear it outside of the car.
So, what the sound might be...I can't reproduce it anytime I'm there. Figures...... but I hear it almost daily. He put some foam tape on the firewall behind the gas lines saying the 'pulsing' from them might be doing it...but it did it again this morning.
View 14 Replies
Background: No A/C. Identified Clutch had completely failed. I replaced the clutch.
Status: I turned on the A/C and I saw the clutch come on...it was on for maybe 60s. During that time, the vents started to get cold! After 60s it never came on again.
Troubleshooting: I have refrigeration gauges but not much idea how to read the result. I hooked them up and noted about 350psi for the HP side, and about 100psi for the LP side. I think this tells me I should have enough charge in the system to cycle the compressor.
At this point I don't want to start random troubleshooting as I don't want to touch the refrigerant loop more than necessary. A few questions:
1) The HPCO switch, I was reading that it's mounted on a Shrader valve. Is this the case? I'd like to remove it and test at which point it switches. I have not tried bypassing it.
2) Do our vehicles have a temperature sensor near the evaporator? If so, whereabouts is it located?
View 10 Replies
My 2006 Escape Hybrid with <3500 miles on it had the ABS and 4X4 lights light today when I am 60 miles from home. I had this happen a few years ago, and I replaced a cracked tone ring, driving it to the dealer, who was only 5 miles away. My question is, is it safe to drive home and take it to my dealer who is 60 miles away, or should I have it towed?
The vehicle runs, in fact, the ABS and 4x4 light went out - in fact, I think I saw an indicator message that said 4x4 restored, but I am not sure, it appeared and then was replaced by X miles to empty. I would prefer to go home and take it to the dealer I purchased it from, but I don't want to drive in a car where the brakes may not work. I've read differing accounts on the internet and I can't figure if this is a "service soon" meaning I can make the trip home, or if it will strand me or worse if the brakes will fail on the trip home.
View 14 Replies
I just bought a 2010 Escape XLT 4 cyl. The mpg is showing to be 16.7, which is really low compared to what it's supposed to be. I bought it off of a car lot and it had been discounted so I'm guessing it was sitting there for a while before it was sold. Do you think that would cause the mpg to be low? I've driven it on the highway and around town. I've had it for 2 days, but it's freaking me out thinking that there is something wrong with it.
View 4 Replies
Get a set of real gauges if you want to do diagnostics. 110 psi on the low side indicates that the system isn't running at the time and that the underhood temp is around 100 F.
View 1 Replies
