Ford Escape / Hybrid :: 2011 V6 Won't Start After Spark Plug Change?
Apr 25, 2016
I have a 2011 Escape Limited 3.0l V6 AWD. Did a spark plug change at 115k miles for the first time per dealership recommendation. Got new plugs from dealership.
Was pretty cut and dry to replace. Did not check gap on plugs as was told they are not adjustable per dealership. Put pea sized amount of dialectric grease in the COPs and then fitted the plugs into several times with a little spin to coat evenly. Installed plugs to 11 ft.lbs. and reassembled all components without issue. Installed them one at a time so as to not mix up the coils.
I did break the 90-degree nylon quick disconnect for the fuel line that connects to the fuel supply manifold and had to purchase a new hose assembly. Reinstalled without issue.
Went to start up and engine cranks (hiccup sound) but does not turn over. The sound is weak and not a throaty crank like an engine should give. Check engine light flashes on dash and issues a frequent tone also.
Wondering what the issue is? Are they the wrong plugs? Improperly gapped? Possible the fuel line did not pressurize and there is no fuel getting to the plugs for ignition? Kind of stumped as it was a pretty cut-and-dry replacement (if such a thing is possible).
View 4 Replies
Advertisement
I somehow managed to kill my 04 Santa Fe 3.5 while doing the dreaded spark plug change and looking for pinpointing and rectifying the problem.
A quick rundown of the car... My mom bought her new in late 03, decided to get a BMW X3 a couple of years ago. I bought her with 65k miles. I just recently had the timing belt replaced by a reputable shop at 79k (yes I know I let it go too long.) I just hit 80k and decided it was also time to do the plugs as I had noticed a decrease in performance and gas mileage of late. Other than the recent dip in performance the car has been extremely reliable and has had no previous issues.
I researched as much as I could knowing that the 3.5 isn't the easiest engine to work on. I bought the recommended Champion plugs that came in the car from the factory as well as the oem Hyundai wires. I also replaced the plenum gasket.
I took my time replacing everything but despite my best efforts, I accidentally cracked the plastic on the radiator reaching over to the back bolts on the plenum. Other than that mishap, the only other issues was the #5 plug sticking which finally came loose after some begging and pleading to the car Gods. Unfortunately, my begging and pleading was enough for them to allow the car to start.
After reading a thread on here, I believe the problem is that I removed the TPS sensor to get to the bolts on the EGR valve, I know now that this was a big mistake. I checked and double checked every connector and can not find one that was missed or disconnected. The car would try to start but would not crank over. I was unable to get any OBD2 codes from my code scanner.
I decided to try a TB from a junkyard and swap it on to see if that was the issue. After swapping it on, the car started and ran like crap for about 15 seconds and stalled out. I was however able to pull some codes in this short time.
The codes I received are:
P0102: Mass Airflow Circuit Low Input.
P110 & P1172: ETS Improper Motor Current.
P1192: ETS Limp home - Target Follow Malfunction.
P2127: Throttle Pedal Position Sensor "E" Circuit. Accelerator Position Sensor 2 Voltage Too Low.
I'm not sure if these codes are left over from before I swapped out the TB or not. I reset the codes after I wrote them down and researched them to see if they reappeared but the car will not start again so I can't get the codes to reappear.
View 7 Replies
So I am changing my transmission fluid tomorrow and was wondering a few things.
1. I noticed some people pull off the transmission hose to the inlet and keep draining that until its clear. For a drain and fill do you do it like that or just pull the plug and refill?
2. When youre filling it back up you just measure how much you taken out and then fill the rest by the dipstick? Anything else i should know?
3. Since I havent changed my transmission fluid in 60,000 miles. I wanted to do a drain and fill. I was thinking I needed to drain and fill it 3 time to catch up to maintenance. How often would you do it to get it clear? Drain and fill then drive it for a week then drain and fill? Or do it all in one day?
View 4 Replies
I have a Ford Taurus 2004 and would like to change its Spark Plug. I am looking for instructions for doing so as 3 of the spark plugs at the back of the engine are under the manifold air-intake. I am looking for step by step instructions of how to reach to the spark plugs to the back.
View 9 Replies
I have a 2006 Fx4 with 60,000 miles. I wanted to change the spark plugs myself yet I can't seem to find were they are in the engine, I know how to take them out but I don't know how to get to them.
View 1 Replies
How is the oil change reminder reset? Also how is the computer reset for a new new battery?
View 8 Replies
I just changed the plugs in my 05 stx 4x4 4.6L. Truck was running fine, never a problem but it has 105k so I figured id change them. #4 was the only one that gave me a little problem (besides being so tight). The coil and spring pulled off the boot, and I had to get a pair of pliers and get the boot off the plug.
I simply slid the spring back through the boot and replaced it once I had changed the plug. Other than that they all came out easily. I replaced with motorcraft plugs, and #5 did have what looked like some oil down on the threads when I pulled it out, but not sure if that's a big deal or not
Any way, I am torn between ordering new boots and changing them out, or just biting the bullet and getting 8 new coils with new boots attached. Truck runs fine, but does the usual buck/jerk under a load in overdrive now (never once did it before)...
View 3 Replies
Im noticing my mpg dropping in the past couple of months. I usually get 19 or 20 in town, and up to 23 on the highway. Now im lucking if I get 16 or 17mpg.
I have a 2001 escape XLT. 6cyl 4x4.
I changed the spark plugs, coils and fuel filter about 3 years ago (almost 40k miles ago).
The car starts fine, seems to idle fine, seems to accelerate ok. The only thing that is off is the MPG.
I dont just want to throw money at parts. Which one should I replace?
View 5 Replies
Doing trans fluid change on the 2009 -2012? Is it the same as myCD4E drain 4 refill? I know its a different fluid probably buy from Ford.
View 1 Replies
How to change belt on water pump on my 08 V6 the hayness says there is a tensioner on the v6 well i am stumped cant find it so ....... Belt is tight I see no way to get slack in belt to change it .top pulley and pump pulley is all i see...
View 11 Replies
It has been running very smooth since I changed the lower intake gaskets, and I just went on a 1500 mile round trip roadtrip. It ran perfect the whole way, getting 22mpg to boot. In the last 50 miles, the CEL came one. The code read P0420 which is the cat converter? I dont want to fork up for a new one, are there any tricks to get this fixed or cleared?
View 8 Replies
I want to change spark plug, took connector of spark unit and took bolt M6 out, lifted spark unit but not enough clearance to remove the unit in order to use wrench for unscrewing spark plug. How it works?
View 14 Replies
My wife called me from the dealer and they said they wanted to change the spark plugs at 40,000 mi.??? Is this really necessary?
My M5 recommended interval was 50,000 Miles Seems really low to me Regardless of what the manual says any either way?
View 6 Replies
i have a 98 buick century has around 180000 miles and it ran perfect, then two days ago i changed my spark plugs b/c they were 2+years old i got NGK Vpower and gapped them to .06. i had to roll the engine forward when i got to the back 3 plugs. so anyways after all pugs were changed i took it for a drive it was running fine, then i noticed when i got on the highway when i had to accelerate it missed a few times then on down the road it would go fine until i had to give it a little gas.
It jerks a little bit and it sounds like shit. But it idles alright and light acceleration thru town is fine. i also had it tested at autozone and i got a bunch of stuff about vacuum something and 02 sensor but nothing about misfire or coil pack malfunctioning. all the vacuum tubes on the engine are all sealed that i can see. and like i said it ran perfect before hand so i know its nothing internal. i just cant figure what happened.
View 4 Replies
my wife drives a 2008 toyota camry 4cyl. she has about 86000 miles so i figured i would do a little tune up. change plugs, filters, injector clean, etc. while changing the plugs i seem to have broken 3 of the 4 pressure tabs on the plugs that plug into the coil. for the time being i have the pressure tap electrical taped very tightly onto the plug. What I should do? or is that common to for those to break off. I didn't even really use a lot of pressure either.
View 2 Replies
Just replaced spark plugs in my 2007 Sonata V6 and noticed that my MPG has dropped from about 24 to 19! I used NGK Iridium plugs, and also changed the PCV valve at the same time. Mileage is 136,000. Could the internal computer (that does the MPG calculation) have gotten messed up by all of the disconnecting/unplugging that I had to do to get the surge tank off? (BTW - the engine runs great - just the MPG went way down).
View 10 Replies
I was out driving tonight and our 03 escape started making a thumping sound like you hear when you have a flat. I turned the corner and noticed that the steering wheel is now at a 30 degree angle as I'm going straight and when I hit the brakes the steering wheel straightens out but the car doesn't change direction. It's dark so I can only see so much but the tie rods are good and tight from what I can tell same with ball joints. They just did that subframe recall a month or so ago. My concern is steering box but other than these symptoms it seems to be working fine.
View 4 Replies
Experienced lower mileage after changing the plugs at about 120k miles?
In the 10 months (23.6k miles) since I had the dealer change the plugs, I have averaged 43.3 mpg overall.
View 11 Replies
This is Just an FYI. I replaced the plugs in my 2011 F-150 3.5 Ecoboostwith 50,000 miles. I had a miss under heavy acceleration. Turns out the plugs had a gap over .090" and the side electrode was burned. Replaced them and all is well.
View 8 Replies
How long should I let my engine cool down before changing the spark plugs? I have a 2003 Toyota Tacoma 4cyl 2.4l. My drive home from work is about 10 miles and I would like to change my plugs after work but I am not sure how long I should wait before working on the vehicle.
View 5 Replies
I have a 2007 Prius with ~180000, which runs great. The mechanic shop I used for oil change suggest me to change spark plug because they are dirty. After the change, I found I cannot step on the gas pedal too hard for acceleration. The car will hesitate, choking or die if I try to accelerate too fast. But if I step on the gas pedal gently, and let it reach the desired speed in a slower way, it has no issue. I went back to the shop and they replaced with another set of 4 plugs, and no improvement. I checked air intake tube and it looks no leak, but really old. Other than that, the car runs great.
View 19 Replies
