Ford Escape / Hybrid :: 2009 - Shifter Lever Stuck / Unable To Shift Out Of Park Without Using Manual Override
Oct 9, 2014
My 2009 Ford Escape shift lever is stuck, not allowing me to shift out of park without using the manual override. However, when I slam my foot to the brake (rather than simply stepping on the brake), the brake switch relay, etc. all engage and I am able to shift out of park. Is this a brake switch relay problem, or is it possible that it has to do with the age of my brakes, etc?
View 3 Replies
Advertisement
I have a 2009 Santa Fe and last night, out of the blue, the engine wouldn't start. The shift lever was stuck in park and the brake pedal was very stiff and wouldn't move much. I popped the cap off the shift lock and moved it to neutral at which time the car started without a problem. I could drive but shifting was difficult and the lever didn't really click into a gear. I noticed that when shifting gears. the indicator on the dash would change from N to D and to R in reverse but when I moved up to park, the indicator went blank and the lever locked up again and had be released manually. I also noticed when I got home, since my driveway is a slope, that when the car seemed to be in park is rolled down the driveway, so I had to engage the emergency brake.
View 13 Replies
While traveling I made a fuel stop. Restarted engine fine, stepped on brake, but could not move the shifter out of Park. Towed to Ford dealer, after extensive trouble shooting replaced shifter cable and transmission position sensor. A week later same problem but glad I learned about the interlock override lever on the steering column so can continue to drive. It locks up several time a day. Here's what I know and observe.
. brake light switch appears to be normal
. engine starts normally
. brake lights operate normally
. fuse on interlock function is ok
. when the lockup happens the shift indicator is missing the box over the P
. this may not relate but backup/reverse lights operate very weird - in reverse they only light when the engine in rev'd and go out when the gas pedal is released
There appears to be a gremlin in this Escape that eludes Ford and me. I read some reference to a computer control involved in the interlock function. I'm at a loss.
View 14 Replies
I am having this on and off problem of getting the shifter out of PARK sometimes its easy sometimes its frozen. I am going to take the plastic off to investigate the linkage more and I know there is a brake shift to unlock the transmission out of park. 2002 ford escape 3.0 ....
View 5 Replies
It's a few times in the past 2 weeks, the shift lever won't come out of PARK easily. Sometimes I have to wiggle the shifter for quite awhile before I can get the shifter to shift out of PARK. It also doesn't start when that happens, like everything works but it doesn't start. It's like it's locked. It finally lets go and I can start it and put it in Drive and Reverse and go on my way. But there's not set thing that I can do to make it work.
It's just luckily let me go the few times it's happened. We replaced the shift cable about 1.5-2 years ago and of course the cable is out of warranty. But even if it's the cable, it's definitely going into park because you can hear the click when you stop the truck and turn it off, and throw it into PARK. But when the shift get's stuck it won't crank or make any kind of cranking noise, it's like the battery is dead but it isn't. When it happens you can't even shift it out of PARK to try and start it in D or R.
So I was thinking something could be going on with the NSS. Is there any kind of brake pedal interlock switch on a 98 Ranger? I notice when I start it and press the brake pedal it clicks loud under the dash, which I don't remember hearing always. But maybe it always makes that click when you hit the pedal because I usually always have the radio on. What I can do if the shift gets stuck when I go to leave work? What do I need to look at to determine the problem?
View 3 Replies
I searched for a prior post on this without success. I have a serious problem with my '04 V-8 transmission shift lever being stuck in Park in cooler weather. Ny wife is the primary driver, and on some cooler mornings it is almost impossible for her to move the shift lever out of park. She has to let the car warm up a bit, and then move the lever around a bit with all her might before it will finally move out of park. The dealer can't figure out what is wrong. It only appens when the temperature is below about 50 degrees, and with winter approaching, frequent problems lie ahead.
View 24 Replies
2005 Mazda Trib. will not let me shift out of park . It doesn't happen all the time button seems to be sticking . Is it the button or the electrical switch on the brake pedal ? This belongs to a friend of mine and this is the info I'm getting .
View 2 Replies
I searched for a prior post on this without success. I have a serious problem with my '04 V-8 transmission shift lever being stuck in Park in cooler weather. Ny wife is the primary driver, and on some cooler mornings it is almost impossible for her to move the shift lever out of park. She has to let the car warm up a bit, and then move the lever around a bit with all her might before it will finally move out of park. The dealer can't figure out what is wrong. It only appens when the temperature is below about 50 degrees, and with winter approaching, frequent problems lie ahead.
View 24 Replies
My son who is away at college, has a 04 F150 that has a center console and he can't get the truck to shift out of the 'Park' position. I told him to try and rock the truck back and forth and then try again...no luck.
View 1 Replies
I have spilt some coke into my shifter and it dried. Now when I shift to Drive or back to Park it makes this crackling sound and sometimes gets stuck. How to take the P-R-N-D-S cover off so I can clean?
View 1 Replies
1999 F-350 . My shifter lever is extremely loose, it will not go into park at all. I tightened the two torx bolts, adjusted the needle but its still bad. Im thinking the cable is loose, I saw that there is a small rod attached to the end. Is there a way to tighten it or do I need a new cable assy.?
View 5 Replies
I have 2013 elentra just about a year old, (Took delivery june/2012). Recently some thing happen on the Shift lever, can't shift to "R" for back in parking, Shift to "N" is OK.
Some time it can't shift out from PARK to "R" or "N" or "D" ... Under any of this situation,car engine would not start.
Sound like the SHIFT LOCK did not release properly, or the Brake paddle position switch input did not send to Computer for engine Start.
View 14 Replies
The parking brake lever on my '05 Escape will not budge, is there a simple solution to this problem or do I most likely need the whole cable assembly replaced? Is there any particular spot on the cable that's most susceptible to seizing from rust that I could soak with penetrating oil to free it up? I know the inner cable comes out of the coiled metal, conduit-like outer part and is exposed where it attaches to the rear brakes. Is this most likely the spot that's causing the problem?
View 8 Replies
I just noticed I could manually down shift transmission in D drive by tapping - on shift lever. I thought this was only possible in M manual mode.
View 3 Replies
Fitted new snow tires with the intent of leaving them on year round. Now find that the Escape is pretty well un drivable due to shake at all speeds. Balance has been checked by two tire shops. I think that the problem is that the deep blocks of tread are "squirming"The tires are surprisingly quiet but unfortunately will have to go.
View 2 Replies
A few months ago I couldn't get the shift lever out of park without trying multiple times. Then it was okay for about 5 months now it is back and worse. It is not bound up because of parking on a hill or anything like that and I press very hard on the brake pedal. It take s multiple times to get it out of park trying turning the key on and off and so on. The truck only has 86,000 miles on it and the transmission has always worked perfectly.
View 6 Replies
I have a 1995 Ford Crown Victoria. If I start the car in Park, it will not shift. IF I start the car in neutral, I can shift gears with no problems. In conjunction, the turn signals work well, but I have no brake lights.
View 1 Replies
My transmission is manual, front wheel drive, 4 cylinder motor, plunger has come disconnected from shifting forks, car is stuck in 3rd or 4th gear. Would it be easier to change transmission or is replacing the plunger mechanism a viable option?
View 3 Replies
A couple times recently, I've been unable to shift my truck out of Park & the brake lights don't work.
After checking the related fuses & finding them to be ok, it all works again.
What might be causing this to happen?
View 1 Replies
last night I was on my way to work and had the car in forth traveling about forty-five. A light ahead of me turned red and I held the clutch in until I had stopped. I shifted into what I thought was first. I discovered that regardless of the shifter position, the transmission left it in forth gear. Barely got it moving from a stop and brought it back home.
Looking under the car, I don't know exactly what the linkage mechanism looks like. I'm not sure how to tell if it has been disconnected or misaligned. I don't know if the problem is in the transmission itself either. The shifter moves to other positions freely, but in actuality it stays locked in forth gear.
View 3 Replies
I have a 2006 f150 fx4 4x4. I drove it home from work yesterday and it ran and drove just fine. I got up this morning to go to work and turn the key but the engine won't fire. I turns over just fine. I turn the key to release the trans to put it in neutral to see if it would start like that and the shifter is stuck. I button in the front will not go in. I tried lifting the rear tires off the ground to see if I could free the trans.
View 4 Replies
