When started very high idle after hitting gas pedal sometimes it will lower idle sometimes not,,then holding pressure on gas pedal it has very bad surging ... Any guesses what might be and possible cost fix?? I am no mechanic,will have to take it somewhere...90,000 miles on it..
View 3 RepliesWhen I start my 2003 Escape 3.0, the rpm's shoot up to about 3000rpms. After a few seconds they drop to about 2000 and slowly creep back up to 3000. When I put in gear, I don't even have to step on the gas and my vehicle goes. It maintains between 1500-2000rpms as I'm driving. When I come to a red light or stop sign, it lurches like it wants to go even though I have my foot on the brakes. I've replaced the IAC valve, TPS, had it checked for vacuum leaks, PCV valve replaced. I'm at a loss as to what it could be.
View 3 RepliesSome odd engine noise i noticed on my fiance's 2010 Ford Escape 6 cyl Limited.
I noticed it a week or so ago, the sound almost reminds me of marbles hitting metal. The sound is coming from a pulley on the driver side front of the engine bay (closest to bumper). Rather than trying to explain the sound more, listen to the two youtube clips i put up. Clip 2 from outside the grill you can hear it the most.
What this could be and what I can do to resolve? I prefer to try and fix car issues on my own rather than go to a mechanic, if possible.
Clip 1 : 2010 Ford Escape Limited Engine noise 1 - YouTube
Clip 2 : 2010 Ford Escape Limited Engine noise 2 - YouTube
2004 Escape 2wd 6 cylinder 170k miles. Intermittent clunk/rattle sound when hitting bumps while going straight and especially turning right. I felt a slight bumping in passenger side floor board. Inspected everything. All looks good and tight- no signs of loose hardware, worn ball joints or tie rods. Only thing I noticed was a slight rub mark (missing paint) on the lower control arm under the sway bar on drivers side. And noticed the rear bushings on the control arms are tearing.
Not collapsing but with the tire removed and suspension hanging at full droop you can see tears in that rear bushing on both sides. We painted the arm and sway bar in the rubbing location to see if it makes a mark there again after driving it a few days. Question is do you think that the rear control arm bushings could be allowing enough movement to contact the sway bar or make the noise? The bolts are tight. Has newer Moog struts and newer swaybar end bushings, possibly sway bar hold down bushings too- (they look pretty good).
2002 Ford Escape... My OD light started to come on every once in a while, and would go off once I turned the car off... This being said, as far as I could tell, the tranny was running smooth. Then an engine light popped on and this code and explanation come up... P1744 "Torque Converter Clutch System Stuck in OFF position".
I recently came back from a bit of a trip... and after shutting the car off, it didn't want to restart. Since this time, the car has begun to start, but the engine light remains on with the P1744 coming up...
Research seems to indicate that the problem is with the Torque Converter Solenoid. You Tube videos show that there are two solenoids just under the transmission pan...
I have a 2001 Ford Escape. When started cold, it revs up to abt 3000 rpm. Slowly drops back to about 1000 in abt 10 secs. When the engine is hot, it often wants to idle 2500+ rpms and I have to really step on the brakes to slow the vehicle. When I disconnect the IAC the engine dies. When it is revving high, I can disconnect and reconnect the IAC quickly, and the idle will drop back down for a few minutes, until I step on the accelerator, then start climbing again. It seems to be a lot worse when hot.
I replaced the IAC and TPS about 20k miles ago and thought it was fixed, but the problem has returned. At that time, I could tap on the IAC and it would "get well" for a while. Tapping on this one doesn't seem to change anything. No CEL, engine runs smooth, and I don't notice any air leaks (none that I've found, at least).
We are looking at buying the new style Escape, either new or a few years old, but I'm worried about the life of an Eco Boost motor (a 4cyl. turbo scare me).
We drive around 25-30k miles a year, and would like keep it past the 200+k mile mark. I'm concerned about a turbo charge motor holding up that long and what type of issues would i have to look forward too?
We have a 2008 Mariner AWD with the V6 it has 200+k miles on it and it's been an awesome little SUV. i want the same quality in my next vehicle too.
I have a 05 Ford escape with 107K. When I make a right turn and applying the brakes I feel a clunking in the brake pedal. checked all front brakes and all is ok. So I looked at the drive shaft on the drivers side. I can move or wobble the drive shaft around on the in board CV going in the transmission. Is that normal?
There are no "Clicking" sounds any where while turning which would tell me that is what it is. Also while driving slow not applying brakes there is a lot of clunking and knocking sounds while going over a few little bumps here and there. Is it the inboard CV joint?
i did have the mech recall done a while back. lately, on several occasions, when i've hit the pedal to the floor "fast", i would get a high rev to 3-4k with the car not moving any faster and then after the revs come back to 1-2k the car would take off like it should. the perfect example of this would be when i wanted to change lanes or pass someone on the freeway.
the car accelerates normally when i am depressing the pedal incrementally and i haven't seen the same type of thing during any other situation. i've had the car for a year and hadn't really noticed this prior to recent driving.
2003 Escape Limited V6 Auto 4x4 ... I am having issues with poor fuel milage and starting the SUV...
When i go to start the truck it winds over for abit then starts and revs really high?!?!? I did a complete tuneup, plugs, filter, fuel filter, oil and filter... I changed the fuel pump which has the fuel regulator built into it. I have no codes on the dash. Also if i am at a red light and i put it to the floor I MEAN TO THE FLOOR!!! the truck bogs then drives off NO POWER!!!
Im stumped! I dont know what to do and dont want to keep replacing expensive parts... fuel pump, etc...
The cooling fan runs on high as soon as the a/c is turned on, regardless of the engine temp. I have the sensor(6F9Z-19D594-AA) that mounts on top of the accumulator. If i replace the existing sensor, will the refrigerant leak out?
View 10 RepliesI have the 2.0L 4 cyl. engine (2001 XLS Manual 114k miles). Runs fine when cold but once the engine gets warmed up it starts idling really low. I mean so low that the RPM gauge looks like the engine is turned off, although it hasn't completely stalled (yet). The engine will kind of stumble here and there and occasionally jump up to the normal RPM. Not rough really (in fact it's hard to tell if the engine is on when it's so low) but something is obviously wrong. The check engine light is not on (assume no codes?).
Also when I'm driving I can feel that the RPM's are unstable and erratic. You know, it feels like I'm pushing and releasing the pedal very slightly even though I'm not moving it.
I replaced the spark plugs and fuel filter since they needed to be done anyway. I checked the vacuum lines and they all seem good. I replaced a few deteriorated lines even though they were holding vacuum. None of this changed anything.
So now I'm looking at more expensive stuff like the throttle position sensor, idle air bypass valve, EGR, MAF, etc. Where I should start? Is there anything that I can actually test to see if it's working or do I just need to start replacing parts until I find the problem? I guess cleaning the MAF and IAC might be starting points that don't cost anything (that IAC looks difficult to remove though).
I'm kind of thinking it's the TPS since it feels erratic at speed. However, I have never had a bad TPS cause a slow idle before. I have had it cause rough idle and such but not slow. Can it do that? What about the MAF sensor?
I have a 2001 Escape, V6 engine and I guess it really does not like it when it's cold outside. Usually the car runs just perfect but when the winter arrives and temps drop into the 20s the truck does not want to run idle right when I first start it. I have tried by stating it without touching the gas pedal. And also by pushing it all the way down and then releasing it. I don't know which method is the right one, but it doesn't seem to make a difference. It takes some time and eventually after about 5 miles of driving it will act normal again. What could I do to fix that?
View 9 RepliesI was preparing my sons 2004 escape (3.0L) for a vacation by changing out the spark plugs. When done, I noticed that the engine lacks power during acceleration and has a very high shifting point from normal (3500 rpm). There were no DTC's set so I took it all apart again, this time changing the intake manifold gaskets both upper and lower. I put it all back together and have the same issue. I have double checked (actually quadruple checked) all of the vacuum lines and electronic connections but to no avail. The truck still has very poor power, at idle it bottoms out around 500 rpm. From a start at a stop sign, with the pedal floored it takes a city block to get up to 35 mph. Where I can look next?
View 9 RepliesAfter driving and shut off and restarting like going into gas station etc idles up pretty high for a while no matter if it is hot or cold outside and have to wait 30- 60 secs to come down to normal...
View 2 RepliesI have a 05 escape hybrid with 75k on it. there is a slight problem every once in a while when it starts the idle jumps up and down and when it is put in reverse it has no power to move. you have to put the pedal to the floor....there are no codes and ford has had the car for a total of three weeks, nothing found and of course it did not act up for them..
View 9 RepliesSo we bought a new to us 04 Escape for the kid, he loves it! My question is, what's going on when I accelerate somewhat aggressively, the tach and speedo peg high and battery light comes on. It does not affect performance and gauges return to normal within a couple seconds.
View 11 RepliesMy wife has her 03 escape v6. It has a very rough and low idle. On start up it idles nicely and then the idle drops and pulses if that makes any sense. I've pulled I think its the idle control sensor. It killed the engine as soon as I did. I've cleaned the throttle body.
View 2 RepliesI test drove 2 2005 escape limited v6 2wd today. Both of them were pretty loud in the cabin at idle. The noise and vibration did lessen after the car started to move. Is this normal for escapes or does this indicate a problem somewhere? Like engine or transmission mounts.
View 2 RepliesI've got an 01 Ford Escape 4 cyl 5spd awd, it idled low when its warm, revs between shifts and if you put it in nuetral and let the clutch out when you're moving it revs to 3500rpms and just sits there until you stop or push the clutch back in. I've replaced the iacv and the pcv valve, elbow and hose, and the tps. What to look at next?
View 4 RepliesMy girlfriend has a 2001 Ford Escape 3L, 6cyl. When accelerating there is a loud high pitch whistle/whirling sound. The sound varies with the amount of throttle you give it. More throttle = louder whine. Doesn't seem to do it when idling or coasting. What that could be? I'm about to remove the belt and take a look at the drive belt tensioner and other pulleys.
Just checked pulleys and tensioner and the tensioner seems fine, a/c pulley spins smooth and free no play, alternator spins smooth no play. The belt needs to be replaced. I wouldn't think this would cause such a load whistle under acceleration. I would expect it to do it all the time if it was the belt. I'm looking at the water pump pulley and belt too and they seem ok as well.