Ford Escape / Hybrid :: 2005 - Driver Side Brake Light Does Not Come On When Brakes Applied
Jul 12, 2015
The driver side brake light does not come on when you apply the breaks but the light comes on when you turn them on.
View 2 Replies
Jul 12, 2015
Advertisement
Ford Escape / Hybrid :: 2009 - Driver Side Brake Light And Hazards Do Not Work
Drivers side turn signal does not work, and blinks fast when turned on. The brake light on that side and hazards do not work. when I unlock the car with the remote, it lights up fine.
View 5 RepliesFord Escape / Hybrid :: 2005 - Diagram For Driver Side Front Door Panel
I need to find a diagram of the door panel on the drivers front door. Need to see how to remove the switch bezel to check the power window switches.
View 2 RepliesFord Wiring/Electrical :: Driver Side Brake Light Goes Out When Brake Pressure Is Applied
I have a 1962 ford falcon ranchero. The driver side brake light, goes out when brake pressure is applied, but is on when lights are fully on, but even then brake pressure is applied and goes out. Right brake light is fine. And turn signal on right works. But driver side back light goes out when brake pressure is put on and when turn signal is put for left side. Right makes a turn noise left side doesn't. I recently replaced the turn signal switch. So its brand new. But older wires every where else. No cuts anywhere on wires. Fine. And replaced the bulb also.
View 8 RepliesFord Escape / Hybrid :: PTU On Driver Or Passenger Side?
What is the location of ptu on drivers side or passenger side???
View 4 RepliesFord Escape / Hybrid :: 2001 V6 Driver Side Window Goes Down But Not Up
I own a 2001 V6 Ford Escape XLT, although that's already likely far too much information for this weird issue I'm having. It's been going on for a while now, steadily getting worse.
The issue is that the driver's side window will easily roll down, but becomes unresponsive when I click the button to bring the window back up. At first, I could simply press the button a bunch of times and eventually find success. Now, if the window is rolled down, I have to get out of the car and move the door back and forth while furiously pressing the button. Eventually, I'll find a spot in the door's swing where the button will finally make a connection with *something* else inside the door and roll up the window.
What could the issue be? Seems like a clear electrical issue, and something that would occur in the joint of the door, since opening and closing the door is the only way to eventually establish an electrical connection.
Ford Escape / Hybrid :: 2005 - Parking Brake Lever Seized / Will Not Budge
The parking brake lever on my '05 Escape will not budge, is there a simple solution to this problem or do I most likely need the whole cable assembly replaced? Is there any particular spot on the cable that's most susceptible to seizing from rust that I could soak with penetrating oil to free it up? I know the inner cable comes out of the coiled metal, conduit-like outer part and is exposed where it attaches to the rear brakes. Is this most likely the spot that's causing the problem?
View 8 RepliesFord Escape / Hybrid :: 2003 4WD - Front Driver Side Axle Leak
I have a 2003 Escape Limited 4WD with approx 163K on the clock. It developed a tranny leak from the front driver's side axle. The seal is new and in good shape as I just replaced the axle and seal a few weeks ago. (I checked the shaft size and surface finish of the axle and it is in spec.)
I just removed the axle tonight and discovered that the problem seems to be the bushing just inboard of the seal in the tranny. The axle has movement up and down when inserted. (Not good!) This is allowing the fluid to leak from the seal.
Here are my questions. Is this a simple DIY fix using a slide hammer type of puller (or similar), or is it time to take it to a tranny shop. I can not seem to find a replacement part listed anywhere.
Also, with this much mileage, should I have the tranny reworked as a precaution if this repair requires dis-assembly or should I just address the leak and think about dumping it? I would prefer to keep it as my kids are now driving age and this is primarily their vehicle. (It has been a great little truck!)
Ford Escape / Hybrid :: 2005 - Diagram Of Relay Side Of Panel?
Owner of a 2005 Escape and trying to figure out which relay on the interior fuse panel is the Accessory Delay relay. I think this might be causing a battery drain when everything is shut down. A diagram of the relay side of the panel.
View 5 RepliesFord Escape / Hybrid :: 2005 - Clunking In Pedal When Make A Right Turn And Applying Brake
I have a 05 Ford escape with 107K. When I make a right turn and applying the brakes I feel a clunking in the brake pedal. checked all front brakes and all is ok. So I looked at the drive shaft on the drivers side. I can move or wobble the drive shaft around on the in board CV going in the transmission. Is that normal?
There are no "Clicking" sounds any where while turning which would tell me that is what it is. Also while driving slow not applying brakes there is a lot of clunking and knocking sounds while going over a few little bumps here and there. Is it the inboard CV joint?
Ford Escape / Hybrid :: 2010 - Third Brake Light Is Out
My son said the high brake light is out, the one on the roof. Bulb is fine. Before I experiment, where to go?
View 2 RepliesFord Escape / Hybrid :: 2005 - ABS Light Is On And 4X4 Light Flashes About 8 Times Every Few Minutes
My ABS light is on and the 4X4 light flashes about 8 times every few minutes. I thought this would be from a cracked tone ring on teh drive axle, I put the truck up on my floor jack and I did find a cracked tome ring on passenger side. Whoever has the truck used silicone to put the broken tone ring back on. In any event I replaced the drive axle with a new OEM with new tone ring. Drives like a charm but ABS and 4X4 light still on and flashing. It is AWd Is there a tone ring on the drive shaft ?
View 6 RepliesFord Escape / Hybrid :: 2001 - Red Brake Warning Light On?
I have a 2001 escape. The red brake warning light in the dash is on. I have changed the low brake fluid sensor and disconnected the parking brake switch . It is not on when first started but comes on shortly after starting to drive (within 100 feet). Do these things have a proportioning valve and a sensor in it?
View 2 RepliesFord 6.0L Power Stroke Diesel :: Driver Side Turn Signal Freezes When Brake Applied
2004 F250 6.0L!!
An issue I noticed right off the bat was that whenever I had the driver side turn signal on, and the brake was applied, the turn signal freezes.
I took apart the tail light and found a concoction of wires...I posted a diagram illustrating what it looks like.
There is this pesky Red wire that is spliced into the tail light bulb socket wire (specifically the green wire).
There is a trailer brake installed...if this means anything. I've tried disconnecting that with no luck on fixing the issue.
How to further troubleshoot would be great...electrical work is not my forte!
Ford Escape / Hybrid :: 2005 - Flashing Theft Light On - Won't Start?
My "Theft" light on my 2005 Ford Escape is flashing and I cannot start the Escape.
1. I tried the key that I had been using successfully for the last 7 years. , car did not start, Theft light blinked. ,
2. Tried wife's dealer key, Car won't start, theft light blinks.
3. Tried various things, such as manual locking & unlocking, turning alarm beeping on/off, disconnecting battery, etc. Nothing works.
Called the dealer, they say they know nothing. Must bring car in, they say. Basically I am screwed and now must spend big bucks to take it the dealer because of Ford's software bug.
Sonata I45 (YF - 2011+) :: One Brake Light Goes Out When Brakes Applied?
So I was told I had a brake light out? Went and bought new bulb and replaced. Turn on headlights and the single filament lights. so when brakes are applied the second filament should light up that give the brighter affect.
Well when brakes applied the bulb goes out completely? Take foot off brake and the single filament comes back on. The other tail light operates as it should. Even used bulb from working tail light with same results.
Hyundai - Sonata :: Driver Side Tail / Brake Light Goes Out When Brakes Depressed
I'm driving a 2010 Hyundai Sonata and just recently one of my brake lights has been acting up. Everything works perfectly fine as long as the head lights are off; however with the head lights on, when I depress the brake pedal my driver's side tail/brake light goes out. The center brake light and passenger side brake light work just fine regardless of the head lights being on or off. With the headlights off, all the brake lights operate normally when the pedal is depressed.
View 6 RepliesFord Escape / Hybrid :: 2005 Ford Escape Transmission Fluid Change
So I am changing my transmission fluid tomorrow and was wondering a few things.
1. I noticed some people pull off the transmission hose to the inlet and keep draining that until its clear. For a drain and fill do you do it like that or just pull the plug and refill?
2. When youre filling it back up you just measure how much you taken out and then fill the rest by the dipstick? Anything else i should know?
3. Since I havent changed my transmission fluid in 60,000 miles. I wanted to do a drain and fill. I was thinking I needed to drain and fill it 3 time to catch up to maintenance. How often would you do it to get it clear? Drain and fill then drive it for a week then drain and fill? Or do it all in one day?
Ford Escape / Hybrid :: 2008 - Loose Brakes - ABS Mod Or MC?
OK so this issue first started in July on way back from Florida the brakes started going to the floor. You did have normal braking power, but you had to about stand on them. Took it to mechanic who cleaned and adjusted brakes, after that they seemed to work fine. Fast forward to a month later, I was going over some train tracks with a somewhat heavy load, I braked when going over them, right after that it seemed the brakes went about half way before braking. I took it back to same mechanic who said it's now either the Master Cylinder, or ABS module. I have found so many conflicting posts on this I'm not sure which way to go. I'd really hate to spend $400 on MC, and then it turns out to be ABS. There is also a swooshing noise when you depress brake.
View 11 RepliesFord Escape / Hybrid :: 2004 - Cannot Seem To Get Air Bled From Brakes
I had to replace all brakes because the bleeders were rusted in, wouldn't come out. So I bled and re-bled, but the brake pedal is still squashy and goes down too far if I have to stop from any speed. I even used my vacuum pump for evacuating air conditioning systems, pulled quarts of fluid through all the brakes-definitely no 2004 vintage fluid in there any more! Yes, I made sure to never pull the master cylinder reservoir empty, which would let in air. I always start from right aft and end up at left front, in order of bleed first. No leaks, the fluid level is always where I left it on previous session. I must be missing something...How can there still be air?
View 14 RepliesFord Escape / Hybrid :: 2003 - New Brake Pad But No Brake Pressure At All?
Changed front brake pads yesterday. Took calipers apart, used c clamp and old break pad to release pressure from the cylinder. Installed new pads. Brakes felt spongie. Drove truck forward and backwards hitting the brakes. They tightened up some what but still spongie. Drove truck with no change. Decided to bleed front brakes. Now I have NO brake pressure at all.
*rotor on left side did have small groove but was not replaced... would this possibly be contributing to my issue.