Ford Escape / Hybrid :: 2004 - Tranny Fluid Coming Out Of Dipstick Hole?
Jul 30, 2014
Having issues with transmission fluid spewing out the dipstick hole? Truck is an 04 Escape and has worked great until I had a rear manifold leaking. I took the truck to our mechanic and he replaced the rear manifold cat converter. He broke 3 of the 4 bolts so he told me he had to roll the engine forward to gain access to tap out the broken bolts. Im sure he took the throttle body and intake off for more room. I Got the truck back and noticed transmission fluid all over my driveway the next day. I contacted the mechanic and he states it was nothing he did and cannot figure why this is happening. Basically told me to fly a kite!
View 14 Replies
Advertisement
What is the easiseat way to add tranny fluid down the dipstick hole? That anle looks pretty hard to use a funnel.
View 10 Replies
I am checking the tranny fluid level in my daughter's 2007 4 cyl Camry tomorrow.
This tranny has the dipstick and each time we try to check the fluid level with the dip stick we are not sure if we are getting a good reading or not.
What's the trick to it. Should the tranny fluid be at a certain temp before checking? I don't have the manual with me so I'm trying to find the procedure.
View 2 Replies
I have a 2001 Escape with 119,000 miles. I am the second owner, having bought it at 59,000 miles. The engine and tranny operate flawlessly. I replaced the tires that were on it within 10k miles of buying it for I was sick of the pulsing ROWR-ROWR-ROWR-ROWR noise at highway speed.
That noise, couple with the normal Escape noise, drove me nuts. So, I bought a new set of tires, Goodyear RTs. The noise calmed down, but now the noise is back. Alignment has been fine, had it checked, but the tire tech told me "these small SUVS are murder on tires."
I am ready to get rid of it simply because of the road noise at highway speed. My wife complains about it. Compared to her '11 Accord, it sounds like a jalopy. It handles well, no shaking or shimmying.
View 10 Replies
I have a 2002 3.0 Escape. All running great. I have a question about where engine load/vacuum is sensed for determining shift point? I replaced all of the dry rotted hoses in the vacuum recently when replacing intake upper & lower gaskets. since then, I've noticed the shift points aren't quite the same as before. The tubing I used was slightly smaller that the OEM, but otherwise, everything is plumbed up as before.
When accelerating, the engine does rev a bit more than before, before the tranny moves to the next gear. I can ease up on the throttle just slightly, and it'll shift up. If I'm not accelerating hard, it seems to shift fairly normal. Going up slight grades it doesn't want to shift as soon as it should, but on level ground it shifts fairly normal under light load. Going down grade it shifts quickly, as one would expect. This is why I felt it might be somehow related to engine vacuum.
Is there an sensor somewhere, a restrictor in the vacuum tubing, or a vacuum modulator I might look at? I've double checked the vacuum tubing and found no leaks.
View 6 Replies
So I am changing my transmission fluid tomorrow and was wondering a few things.
1. I noticed some people pull off the transmission hose to the inlet and keep draining that until its clear. For a drain and fill do you do it like that or just pull the plug and refill?
2. When youre filling it back up you just measure how much you taken out and then fill the rest by the dipstick? Anything else i should know?
3. Since I havent changed my transmission fluid in 60,000 miles. I wanted to do a drain and fill. I was thinking I needed to drain and fill it 3 time to catch up to maintenance. How often would you do it to get it clear? Drain and fill then drive it for a week then drain and fill? Or do it all in one day?
View 4 Replies
I thought my tranny shift points had gone a little nutty. This afternoon, it suddenly seemed as if it were starting off in 2nd gear...then the OD light started flashing. Now, when you put it in 1st gear manually, or reverse, it's like it's in park. Can't push the truck or anything...put it in drive or 2nd, and it starts off slowly. Once it picks up speed, all seems well. Definitely not starting off in 1st or going into reverse at all. Have y'all seen this problem before?
View 9 Replies
I just did a Sable 3.0 engine swap on my 01 Escape auto 4WD with 112K miles. Prior engine spun several lower end bearings. New motor runs fine. Prior to swap, trans operated fine. Didn't have any of the apparently common 2-3 flare or OD shudder problems. Car was dealer maintained and fluid looked fine - didn't look or smell burned.
Now, after the engine swap, from a stop or at low RPM situations like around a slow corner, the trans seems starved. Have to rev the engine a bit to get the pressure up, car jerks into gear and then trans operates fine. Shifts through all gears fine and goes into and out of OD fine. This happens from a stop when trying to shift into either Fwd or Rev. Feels like the trans is low on fluid, but it's not.
I drained the trans prior to doing the swap and refilled with Mercon, not Mercon V.
No engine codes. Kept my OBDII reader on while driving to see if it threw any temp codes. Still no codes.
I'm sure that the trans was reinstalled correctly. I'm sure the TC didn't cram the pump.
If I recall, there are only four trans sensors and I'm sure I hooked them up correctly.
I'd like to like this car but it's getting pretty hard. Since I bought it a month ago, I've been under it more than I've been in it.
View 14 Replies
Doing trans fluid change on the 2009 -2012? Is it the same as myCD4E drain 4 refill? I know its a different fluid probably buy from Ford.
View 1 Replies
I have a F-150 5.4 automattic 07 model and I need to add some tranny oil,I can't see on dipstick or in book what oil I need,(4) (5)??? I still can't see any markings on dipstick, where would I see a 4 or 5 on dipstick??
View 2 Replies
My 2010 2.5L FWD Escape has oil on the steering boot and has run down on crossmember (?) It is equipped with Electric Power Steering. This appears to be coming from the rack and pinion but does it have fluid in it? How can you add if it does. I have 96,000 miles on the vehicle and except for a drivers door actuator and scratched drivers glass, this is only problem.
View 5 Replies
I've had this problem for a while. The previous owner of my escape replaced two tires and said the ABS and four wheel drive lights started coming on. ABS solid, FWD light flashes eight times every two minutes USUALLY. Sometimes the ABS and FWD light are off if I am on a short drive. Sometimes in these instances I can feel the brake pedal pulse or I can tell the 4WD is trying to activate without a reason (jerking in the steering wheel).
Sometimes the ABS light stays off while the 4WD light flashes constantly. After doing some research on here I'd like to believe it's a tone ring since that seems to be a common problem and a relatively easy fix (and cheaper than new tires). Oh yeah... sometimes (very rarely) the lights stay off and everything works great. The guy I bought it from said that the lights started activating two weeks or so after he changed the two tires.
View 7 Replies
I have the 4r75e transmission. Last week I was driving for about 20-30 mins when my transmission fluid started to boiled and came out the dipstick tube. I let it cool off then took my time and drove it home. I know my transmission is not shot because I am getting full power on the transmission. After I got home I checked the fluid level and it's good, then I disconnect the transmission fluid lines on the transmission to see if I am having flow, but no luck...
I took my air hose and blew the lines out and they were clear. I also blew into the transmission thru the ports where the lines were connected. I started the truck up and the fluid came out with full force about 1-2qarts came out before I shut the truck off. I was all excited and I connected all the lines And started the truck to go for a test drive but my gut told me to disconnect the line to see if I am still having a flow and as suspected no flow...
I took off the lines that connected to the transmission and still no flow. I blew the air into the transmission again and started the truck up and bam I have flow again for about 20 seconds... I shut the truck off and I decided to connected the lines back to the transmission and I disconnected the lines about 12" away from the transmission to put a clear hose that connected both lines to make a loop.
Started the truck and there was no flow, I disconnected the 5/8 nut on the transmission and blew the air into the transmission. Started the truck and only got a few dribbles. I check the fluid level and it's still good. I am stuck and don't know what to do... What part of the transmission send the hot fluid out to the cool. The valve body? The main pump? The solenoid???
View 6 Replies
I went to drive our Escape but when I pressed on the brake to switch it to drive, I heard a clicking sound coming from the center console, the brake pedal went all the way to the floor and there was a high pitched whining sound coming from the engine. I turn the car off and call up ADAC (Germany's road side assistance) and they come and find out part of a hose is missing from the engine and stick something on the end of it and the brakes worked fine. They did recommend I take it in to get it checked out but the mechanic here that speaks English doesn't have access to Ford parts. 2010 Ford Escape XLS 2.5L .....
View 5 Replies
Did my first oil change with Rotella T6. I drained, replaced filter, filled with 13 quarts new. Started engine, let it idle about a minute, turned off, checked level and everything was good. Then I drove about 3 or 4 miles just to make sure everything sounded ok, and when I got back home checked level one more time. After driving, the oil level was still fine, no leaks detected anywhere, but there was smoke coming out of the dipstick hole when I pulled the dipstick. Is this normal?
View 1 Replies
I have an 05 escape xls 4cyl that has started acting up in the past 2 weeks. The vehicle has 52k on the clock and has no other issues but what im posting about.
Heres the problem: Vehicle starts fine every time you turn the key. It does not stall or idle rough when engaging the trans mission so I've concluded it has nothing to do with the torque converter. Once the car is running the vehicle will shut off randomly with the THEFT light coming on. I played with it for about 2 hours and have found that it will do this idling in Park, while in Reverse, and while in drive. The vehicle also will shut off while I am going down the road and every time it does the THEFT light is coming on as the problem starts. It does appear that it only happens when the accelerator is not depressed and will sometimes stay running if you hit the Gas Pedal as soon as it starts to happen.
I have tried using another key figuring maybe a transponder is bad...No dice does the exact same thing. I have also noted that i do hear single quiet (tock) when the vehicle shuts off coming from the drivers side lower engine compartment.
View 10 Replies
So I have been told I need to have the transmission fluid changed in my GX470 by the dealer. They have said that off and on when I take it in for an oil change or some other services since 60K miles. I have never felt a difference in the transmission performance and have had no 'quirks' with it like I have had with other cars when the trans fluid is nearing the end of its useful life.
So I am concerned that since it is a 'sealed' unit that has no dipstick to check the fluid condition, they have a 'safe' way to tell me I need an expensive service when I really do not.
I am not afraid to work on my cars (I used to work on my cars including my built up rotary with a street port) but have just been too busy to do that stuff for the past 15+ years and am starting to get back into maintaining my own cars again.
View 7 Replies
My daughter has a 2001 Ford Escape. The small panel insert around the door handle has the vinyl/leather coming off. How do I remove this without taking the whole door panel, the large one covering the window, off? I do know what I have to do to reattach this fabric, just cant seem to get teh small panel to come off.
View 14 Replies
F150 2011 3.5L Ecoboost. Where is the transmission dipstick?
View 14 Replies
I was driving back home from work and I happen to notice smoke. Oil is coming out of the top of the dipstick hole not the bottom o ring. It seems the crank is building too much pressure . It's a 1990 5sfe so it does not have a pcv valve,ithasa pcv system which is basically a hose from the valve cover to the throttle body.
This does not happen initially when I turn the car on from a cold start. I turn it on leave it at idle for a while and even rev it up and hold it high. It starts to leak after about a 2 mile drive and the car is at running temperature. I removed the hose on the valve cover when the car was at idle and a good amount if air blows out when at idle now when I rev the car up the air blowing out drops some.
View 1 Replies
I cannot find the transmission dipstick to check the trans fluid? I looked in the owners manual also and I can't find it.
View 14 Replies
