2003 Escape 2.0L ... I occasionally hear a single "pop" sound when I turn left. It seems to be coming from the area of the right rear wheel. Any obvious candidates for this issue?
View 2 Replies2002 XLT 3.0L 4X4
Making a grinding sound when traveling straight or turning left. Any turn to the right (even the camber of the passing lane) and there is no grinding sound so I figured it was the drivers side wheel bearing. Replaced it yesterday.... symptoms are still there.
Tight left/right turns don't result in the popping/snapping of a bad CV joint so I don't think that's it.
I don't think it's transmission related since shifting is good and the grinding is not throttle related. Besides, turning shouldn't have an effect on the sound if it was something in the transmission, right?
Back in January I had my right front wheel bearing and u-joint go out, so I replaced them both. At the time I didn't realize my outer stub axle shaft was wore so I just put it back in. After a little driving the right side started to "thump" and "pop" when I would make hard left turns driving around town.
I replaced the outer front stub axle shaft and seal again because the old one was worn down. This eliminated any play in the u-joint. After a bit of driving the thumping and popping noise came back.
I decided to dig into it today so I pulled it all apart. When everything is apart it turns easily, no issue at all. When I assembled the wheel bearing, torqued it to 55 ft/lbs and installed and "locked" the hub I noticed something peculiar. I can barely turn the whole assembly by hand. I have to put a good amount of force to get the whole assembly to turn at all. When I walk to the driver side with all the same parts there i can turn the wheel bearing and locked axle shaft with one finger on the studs.
I have been in this thing 5 times and can not figure out what the heck is wrong. I can't figure out why this stupid axle shaft and wheel bearing are so hard to turn, together or separately, and I can't figure out how to get my front end to stop that thumping and popping.
My mother-in-law has a 2003 Escape with a V-6. For the last week the rear lift gate and window will not open. Tried the door key and the driver's side door unlocked. Turned the key again within three seconds (according to the operator's manual). The two lights flashed, the remaining doors opened except for the rear gate. I pressed my ear to the gate and it sounds like it is trying to release the locking mechanism. Any recommendations?
View 7 Replies2005 Ford Escape XLT (4WD) (non-Hybrid). Our Escape had uneven wear on the front tires. Because the mechanic we've used over the year we've lived here doesn't do alignments, my wife took it to a chain tire place on a Sunday afternoon because they were open. He said the ball joint was bad, so he wouldn't do an alignment and because they were super-busy and short-handed, he asked if we could bring it back during the week for an estimate.
A couple of weeks later I called my guy, who recommended a shop a few blocks over who does alignments, so we took it to him. We told him that the chain store had said about the ball joint. I'm pretty sure that before we took it to him, the car had started occasionally started jerking a bit in a curve, but it's been a couple of months and I only know for certain it was doing it after. (I'm not certain if it was doing it before because my wife was mostly driving that vehicle, then)
The first time it was in his shop, the mechanic said it wasn't the ball joint, but the tie-rod. After fixing that, he sold us a couple of tires and aligned the vehicle. On the way home is when I know I was aware of the car jerking a bit in curves. I'm pretty sure it was jerking in the direction of the curve, but again, it's been a couple of months.
Took it back to him the next day and though we suggested he test drive in one direction which had multiple curves, he said he retightened the tie-rod because one side wasn't right, ran it through alignment again and test drove it in another direction which only had one s-curve.
I want to say it was better for a while, but I can't really swear that to be the case. We've long had an ABS light which our previous mechanic in another part of the country said was the sensor. I had forgotten, but the first mechanic we used here had broken the axle and replaced it at no charge, when he was replacing the alternator.
The alignment mechanic said that we had a bad tone ring and the easiest thing to do would be to replace the axle. A week or so later, I called him and said we were ready to do the brakes, but I have one car and he does many and I wasn't really clear, instead of doing anything with the axle or the tone ring, his shop replaced the brakes.
Somewhere around this time, the vehicle started occasionally jerking to the left. Not in a curve, but in the straightways and the best we can tell, it's mostly when we're accelerating and is most noticeable between 30 & 45 MPH. This may not be entirely true, but it's true enough that we believe it. The "jerk" sort of feels like a car driving through fresh snow "falling" into a rut. It also sort of feels what I imagine a faulty ball joint might feel like.
While it was still more of a minor issue -- it happened more rarely than it's happening now -- we took it to what I'd consider our regular mechanic and got him to replace the axle. I didn't actually say anything to him about the jerking because it was still too occasional and I was hoping it was related to the tone ring. It's now gotten progressively worse and I'm at a loss for diagnosis. You'd think that if it was the ball joint, between the two alignments, the brake job, tire replacement and rotation and getting a new axle, one of the mechanics would have noticed it.
Compounding the issue is the fact that there's two (or three if you count the first guy, four if you count the chain tire place) garages involved. Also, I've done some of the engine work my regular mechanic recommended, so there could be a thing about me getting them to diagnose and then doing the work myself or the one mechanic replacing the axle like the alignment guy had suggested. Who knows. We haven't lived here long, so there's not really a lot of history. All I know is that they all get good Yelp reviews.
Also should probably be factored... the alignment mechanic said he felt vibration around 45 MPH and because didn't think we use the 4WD, he said he disconnected the drive shaft from the CV joint (or something like that) as a means of diagnosis. (If there had been a vibration, we hadn't paid attention to it and he did this at no charge, all on his own) Also, a few years ago, prior to our move, the transmission was rebuilt twice (once under the transmission shop's warranty) and I don't remember what the vehicle was doing, but on a third trip the transmission shop had to do something with the transfer case.
Mostly around 40 MPH -- though it may just be too subtle to notice at higher speeds and we rarely drive this vehicle on the highway, so we're mostly traveling short distances at 35 & 45 MPH -- the SUV lurches a bit toward the left and there's a little jerk in the steering wheel. It really feels like I described, like it's getting caught in a rut. Both the car and the steering wheel jerks to the left side. There hasn't been any noticeable uneven wear over the three months we've been trying to figure this out and the front tires look straight up and down. We also haven't noticed any noise. Not going down the road, not when we turn or when the steering wheel jerks.
Have an 03 Escape / 3.0 and the steering catches when turning left. Steering wheel jerks. Replaced the pump about 2 mo. ago and seemed to work, but now it is back. Is there something else I should look at?
View 3 RepliesOK So I just replaced the Passenger side axle on my 03 wagon with a brand new EMPI assembly. It was really easy but on the test spin around the block I'm hearing a flop flop flop sound on hard left turns.
View 3 RepliesWell my girls car is acting up again. when you make left turns, you can hear this real loud popping, almost cracking noise coming from the passenger side front tire. its a 06 passat with 88k miles on it. What is wrong with it??
View 4 Replies2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
I am experiencing some strange behavior from my 2008 Ford Escape LTD. At low rpm's, usually when I am going uphill, the engine sounds like a diesel at low throttle and low rpm. It sounds fine at idle, but as soon as I apply light throttle I hear the characteristics rattle of a diesel engine. The engine returns to normal once I get above 30-40 mph or so.
My escape is at 99k miles (bought at 89k) and I'm not sure what maintenance was has bee done on it (sparkplugs, timing belt, etc?). (I do have an OBDII reader)
Water leak at the rear hatch. The water is coming in from the door, not the glass. I have wiped the weatherstrip clean, in case some debris was stopping it from achieving a complete seal. It is also happening on both sides.
View 9 RepliesI have a 2001 Escape XLT, when driving thru a parking lot or otherwise at slow speed and hitting bumps, I can hear a clunking sound from the right front tire. Its especially bad if I drive over cobblestone or on a dirt road. Could this be the CV joint? Ball Joint? How can I tell what it is?
View 4 RepliesSo heres the story..........'02 Escape, 179K miles, just had the oil changed 2 weeks ago, ever since then I've smelled oil burning when the car starts up and every now and then after exiting the car. Also have had the check engine light on intermittently for the EGR insufficient flow for the past few months. It comes and goes whenever it wants. Today Wifey called me and said something was wrong with the car, I drove it home (about 26 miles). The car runs fine as shifts through the gears, but as soon as it gets a load put on it, it cant pull hard like it used to and it gets a high pitched/squealy whistle similar to a turbo that's spooled up.
Its hard to say where its coming from but from what I can tell I'd say somewhere under the hood near the glove box. (that's the only way I can think of to describe it). There's a big long hill right outside her work that I wasn't sure I was gonna make it up. Car just didn't have any power and couldn't decide what gear to be in as RPMs were too high in a lower gear but wouldn't pull in the higher gear. Car pulls hard off the bottom but falls flat in the midrange. I was thinking maybe clogged cat but what would the whistling sound be?
ok this has me stumped I get this buzzing/humming/vibration sound from what seems like around Defroster passenger side but it is not all the time only at higher speeds and it it intermittent . I have removed cabin filter and cleaned filter box and checked for a leaf or something even sealed somewhat the plastic shield that covers the cabin filter. I really don't want to rip dash apart but it is so annoying
View 14 RepliesI can't find the fuse from the manual. Is it under another name?
View 8 Replieson how to replace cracked ABS tone ring on the rear wheel of '05 Escape. I've looked everywhere on Youtube but nothing comes up. Many front wheel vids, but no rear wheel vids!
View 1 RepliesThe rear sub frame fell out of her 06 Escape Hybrid. She found the recall for the 01-04's, was the problem fixed in 2004, or are later models subject to the recall and repair also?
View 2 RepliesI have a 2009 Escape that has developed a clunking noise in the right rear. On any bumpy roads it sounds like the shock tower lost it's top bushing but it could also be coming from somewhere lower. It also seems like the truck drifts to the right on bumpy left hand turns, kind of scary.
View 1 Replies2005 xlt 4x4. I was cleaning the threads on the rear constant velocity joint before taking the nut off. Turning the hub was almost impossible without using a steel bar. Is it supposed to be this difficult to roll the rear axles? Yes the selector is in neutral....
View 2 RepliesToday after school I hopped into my car and turned it on, it made a weird clanking kind of sound, but then sounded normal. I turned it off and it did the same thing again. I put the car into drive and it was so slow accelerating. I had my foot to the floor and it was barely catching speed while my rpm was somewhere in the 5000's. I got home and I don't know what to do. ALSO, when my Escape is at a stoplight, it turns off and shows the engine light. What's going on. I had to put my car into park, re-ignite the car and go through, again, acceleration tremendously slow. It is a Ford Escape 2001 XLT with a new engine with 80k miles on it.
View 2 RepliesI went to drive our Escape but when I pressed on the brake to switch it to drive, I heard a clicking sound coming from the center console, the brake pedal went all the way to the floor and there was a high pitched whining sound coming from the engine. I turn the car off and call up ADAC (Germany's road side assistance) and they come and find out part of a hose is missing from the engine and stick something on the end of it and the brakes worked fine. They did recommend I take it in to get it checked out but the mechanic here that speaks English doesn't have access to Ford parts. 2010 Ford Escape XLS 2.5L .....
View 5 Replies