Ford Escape / Hybrid :: 2002 V6 - Check Engine And Low Oil Lights Come On And Power Steering Lost
Sep 26, 2015
Ive got an 02 2wd escape with the v6. Its been an excellent truck until here recently. The wife has had a weird problem twice now, that I have been unable to reproduce. She says the check engine light and low oil light come on and she loses power steering. Shutting it off and restarting fixes the issue.
Took a 400 mile road trip with it last weekend and never had an issue. Only thing I noticed , the readiness meters never went ready. Even after that trip, It still shows a systems not ready code.
Tonight the wife had the issue again. Shutdown and restart fixed it. Battery cables are clean and tight, several grounds were freshly cleaned a couple months ago.
View 1 Replies
Advertisement
Recently it rained pretty hard over here and my sunroof leaked pretty badly. Carpets were soaked, upholstery on roof got soggy, and I think some water dripped into the cluster or something maybe. So this is almost all a water damage issue I believe.
Since then, whenever i start my car there will be a series of 5 beeps that repeat 5 times, coming from the cluster. I did some research and it could be because the airbag warning lamp is out (it's light should flash when i turn the car on but it doesn't).
On top of that, the cluster gauges, lights, and radio lights, flicker for the first minute or 2 of driving and appears they flash on/off faster as i apply gas.
Applying gas also seems to interrupt the airbag beeping as the lights flicker. Car seems to run fine as far as I know other than that.
Did some more research on that and all I come across are alternator problems. From what I've read the alternator is hard to reach on 02 Escapes, and it could be very expensive so I'm REALLY hoping that's not the issue.
View 2 Replies
This 2002 ford escape 3.0 xlt 4x4. on the dash you have your transmission #s laid out . the #1 seems to always be highlighted in a square. but as you move the shifter to whatever gear you want there is another square that highlights the selected gear. Also, before when you would have it in D it would flash back and forth from D to 2 just the lights not the transmission.
View 1 Replies
Our escape recently started loosing its power steering, once the engine is shut off the power steering is ok. Also some times you can feel a pulsing in the steering wheel. I've been doing some googling and it looks like the dealers are replacing the steering columns to fix the problem.
My question : is this the only fix or if something like some contacts being cleaned or maybe replacing a steering sensor of some kind is the fix.
View 5 Replies
So my wife was driving our '10 escape xlt and the engine light came on and it displayed the 'check engine' message on the screen. It has 86500 miles and luckily no problems yet. The only thing that has changed was she accidentally put super premium gas in it the other day. The light came on and after she drove it home (about 10-12 miles) and it sat for a few hours and i drove it about 20 miles it randomly went off while it was idling.
I shut it off and let it sit for 20 minutes and then let it idle for a few and it never came back. It has been running ok. We definitely drive it a lot as she works day shift and i work nights. I'm just trying to make sure there's nothing wrong with it. I got a bulletin a while back about the intake getting moisture in it. I didn't know if maybe this could be the beginning of this or something else. This is a whole new territory for me as i consider my 91 f250 'new'
View 6 Replies
We are a 2 Escape family. We have an '03 and an '05 - both 4WD and 3.0 V6. My college freshman son purchased the '05 this summer to get to and from his summer job. It has a little over 173K on the clock and it has a power steering leak, so I decided to try to tackle this one.
There is a fairly good video on YouTube on replacement of the power steering pump on an '03 - but apparently on the '05 Ford decided to relocate the pump from under the upper right engine mount to a lower location closer to the front bumper so the video is not of much use in this case.
I have searched the web and this site but cannot find any tips or instructions to replace the power steering pump on the '05. The Chilton Manual I have does not acknowledge the difference in the power steering pump location on the '05 and only provides the procedure for those Escapes where the pump is located under the upper engine mount.
I think I may be able to get better access by removing the inner fender plastic and perhaps the front bumper cover, but would really like to know the accepted procedure before I start tearing into this one.
One interesting bit of info regarding power steering fluid on these vehicles. Ford designed them to use automatic transmission fluid (Mercon) instead of power steering fluid. Initially, when I saw the leak, I thought it was a tranny line leak. Then I traced it to the front of the engine which is totally on the opposite side of the vehicle from the tranny lines.
View 14 Replies
My daughter has a 2002 Escape 4WD with 3.0L engine.
Coming home from school a few weeks ago she experienced engine running rough on the highway when trying to accelerate. We ran the diagnostic on it and it revealed that #2 cyl coil was misfiring.
I've replaced all of the rear bank coils (in hopes that I wouldn't have to remove the intake manifold again anytime soon). I also replaced the connectors and weatherproofed them.
Replaced all the plugs while I had easy access too. This all went pretty smooth with exception of breaking 3 of the 5mm coil bolts off inside the valve cover. I've also replaced the upper and lower intake manifold gaskets.
It runs much better now except now on the highway, at 1800 rpm/55 mph if I try a gradual acceleration I get engine sputtering and it won't accelerate. If I push hard on the pedal it will downshift and accelerate normally right past this trouble spot. Other than this it idles and runs great.
I've noticed that the 3/4 in. vac hose on back of manifold is getting pinched closed about 70%. this is the hose that leads down to the top of engine just below lower manifold. I suspect this is the problem but cannot determine the root cause. I assumed it was the intake manifold gaskets but those are now replaced.
View 1 Replies
I need to replace my pressure line on my 02 Escape 3.0L. Looking for a DIY for doing this same job?
View 1 Replies
Have an 03 Escape / 3.0 and the steering catches when turning left. Steering wheel jerks. Replaced the pump about 2 mo. ago and seemed to work, but now it is back. Is there something else I should look at?
View 3 Replies
Check engine light came on and stopped by the local autoparts store to get the error code.
Code: P2270
Bank1 Sensor2 fault
Where is this O2 sensor? I've replaced O2's on other cars I've had and just want to make sure I replace the right one.
View 5 Replies
A couple of weeks ago I got a check engine light. Pulling the codes I saw that it was a p0304 and sometimes a p0316. The first time this happened I check the spark plug cables and one was loose (cycylinder 4). Then last week my fuel pump died. since then I have gotten the two codes on a somewhat continous basis. I replaced the plugs (needed to anyway) and the problem did not go away.
The odd thing is that the check engine light does not come on at idle. IT only comes on after the motor is at a higher rev. The replaced plugs looked pretty normal, but the cylinder 4 plug had some carbon deposits. I am currently running injector cleaner in the gas. I may go ahead and replace the plug wires since the current ones are high mileage and it is not an expensive fix.
View 1 Replies
My 02 Ex V10 suddenly lost its power steering. And I mean completely, so it was a bitch to get it home. There are no leaks and the reservoir is full. It makes no noise at all when I try and turn the wheel, so it does not even sound like the pump is working at all. Does this sound like the pump or the gear box? Is there an easy way to tell before I just order the pump and hope that is the problem?
View 2 Replies
My daughter has a 2001 Ford Escape, V6, Automatic, 2WDR, 132,000 miles that is having starting problems. When you turn the key the engine will try to start. You have to push on the gas pedal to keep it running, it will not idle until it gets warmed up. If you try to drive it while cold, it has no power. Reading previous posts I have already replaced the spark plugs, intake gaskets, air filter, EGR, TPS, and fuel filter. Check for crack hoses / vacuum leaks. It is still not starting properly. No engine codes. New problem is oil light is flashing but the engine has oil. All of the gauges, lights, functioning normally. What do I try next?
View 1 Replies
I have a 2002 Dodge Ram 1500 Truck. The other day, I lost all power steering, and traced it to a loose hose connection, which let all of the fluid out. I tightened the connection, refilled the reservoir, and then bled by turning lock to lock several times. when I am sitting still, or low speed parking, it feels like there is no power steering. If I am rolling, even a little bit, it is as normal, and engine speed does not seem to affect the problem, as I have raced the engine at low ground speed, and it is still really stiff. When driving, turns are easy in both directions. The way the effort required does not change with engine speed confuses me.
View 5 Replies
Steering column recall ? The ford sites don't have much info yet. What is involved steering column replacement ? Computer reprogramming to sove the issue of the steering ?
View 1 Replies
I have had various issues with my car over the years but on my way home last night my car just died coming down the interstate. It didn't make any noise, it simply kicked off the cruise, the battery light and oil light came on, and I lost gas and power steering. The security light did not come on and my car's forgotten who I am often enough I know how to do the key relearn by heart. My service engine soon light stays on because I no longer have a catalytic converter. When I turn the key over I smell gas (which I can only assume means there's not an issue with my fuel system), everything turns (alternator, belts, etc.) but it doesn't fire.
I had someone suggest that it could possibly be the EGR valve, but when I went to investigate, turns out there isn't one installed on my engine, where it should be there is a metal plate bolted to the "hole". In the past my ignition control module had to be replaced about every 11 months, so I had two and carried the spare in my car. This stopped happening when we finally replaced the entire coil pack. My car has always idled rough (I'm assuming I can attribute this to the lack of EGR valve).
Over the past two weeks it just seemed to get a little worse, it was making noises when accelerating when the car was cold, almost like a whining and the engine was idling hard. When looking for the non-existent EGR valve I did discover my air filter was ridiculously dirty and the air intake is full of oil. The oil was low but not enough to make the engine seize. I know that's a lot of information but was trying to be as clear as possible about previous issues and what I have ruled out. I did read that it could possibly be the CPR, but didn't know and I need it running again.
View 3 Replies
Looking for info on how to remove the steering wheel on 2006 escape to get to cruise control switches and is there a self test you can do for cruise control functions like holding on button while you turning switch on as in other models ???
View 6 Replies
A couple weeks ago I had to have both lower ball joints replaced on my '01 XLS 4WD with the 6 cylinder engine. The garage's alignment machine was on the blink, so the mechanic told me to it woudl be fine to drive, and to bring it back this week when the machine was fixed.
The Escape seemed to drive fine until today, coming home from work, the Escape veered slightly to the right, and there was a brief sensation in the steering wheel as if it had been disconnected, as if something slipped. Then the steering was back, and although I was tracking straight down the highway, I noticed the steering wheel was turned to the left. It seemed to steer fine, although I had slowed way down.
View 4 Replies
2009 Mazda 3 Since a nasty cold snap in Northeast, instrument panel has gone crazy. The meter showing RPM's works but 0 on the speedometer- dead. Gauges have been all on for a couple weeks. Just noticed now the power steering is gone. All lights seem to work normally and heat/defrost works. Radio works. Haven't noticed if odometer is working or not.
View 3 Replies
Once this happens, simply turning the ignition off and then on again seems solves the problem. We've taken the car to two mechanics, one who said the belt was slipping and one who said the belt was fine!
View 11 Replies
So after hitting a pothole, it would seem like half the engine lost power, after some searching around, i found that i would most likely be the harness inside the valve cover that has lost connection.
Its the right side, so i would need to take of the turbo pipe, and probably something else to get to it.
Since i'm doing this job, what to check out along the way? I want my 7.3 to be as reliable as possible.
I will probably ask some questions along the way, it can be a challenge sometimes to own a car that not many mechanics are familiar with, but as i have read online, this should be a very straight forward fix.
Can the harness be upgraded so it doesn't happen again? Its an 02
View 14 Replies
