Ford Escape / Hybrid :: 2002 V6 - CEL Code P0420 For Low Cat Efficiency Bank 1
Apr 8, 2015
I have been getting a CEL P0420 for low cat efficiency bank 1 on my 2002 Ford Escape V6. The truck runs fine otherwise. I have ran two loads of Cataclean and the light keeps coming back a few days after CEL reset so I am pretty sure one of cats is done. I am going to replace with an aftermarket cat. My question is, with this code, do I need to replace the front exhaust manifold cat or the rear manifold cat?
View 1 Replies
Advertisement
Recently I pulled code P0420, AKA Bank 1: Efficiency Below Threshold.
To start from the beginning...several weeks ago my EPC light came on so, like most educated consumers I decided to buy a vag-com. I pulled the codes and got both the Bank 1 and Bank 2 efficiency below threshold codes (p0420, p0430). I reset the light and literally within 3 minutes the EPC light came back on only this time just Bank 1.
So I drove around again for a week and the check engine light came on this time, back to Bank 1 and Bank 2. Whether trying to replace the spark plugs will possibly fix the misfires, its Cat Converter replacement or possibly just replacement of 02 sensors. I have been reading mixed responses.
FYI I use synthetic oil and chance the oil every 7500-9000 miles, have 89,000 miles and have never changed my spark plugs.
View 16 Replies
P0420 Catalyst System below efficiency -- bank 1
I've had this code for a couple months trying to trouble shoot it. My gas mileage has been affected, as I'm getting about 23/24 MPG city/highway. I replaced the upstream 02 sensor with am aftermarket Bosch variety( I'm not sure why a non-OEM one would make a difference, as long it's working correctly).
My car has 253k miles, the cat doesn't rattle and I don't smell any rotten eggs or anything, but it has to be clogged or the 02 sensor I got was defective. My engine runs fine and I don't have any problems accelerating or decelerating. It may still be the 02 sensor since the gas mileage decrease is so significant, or it could be my converter is really clogged up.
View 19 Replies
I have a 2006 Subaru Forester with 95,000 miles on it. Earlier today the CEL (solid) and cruise (flashing) came on while I was driving. I believe it may have occurred as I was accelerating up hill. I filled up yesterday, so I tightened the gas cap when I stopped. On my way home, I stopped by my mechanic and they read the code; P0420 Catalyst Efficiency Below Threshold Bank was the code that was read. They reset the code for me but told me that the catalytic converter is what needs to be replaced.
My question: Could the light coming on be incidental (i.e., is it possible that it was a "blip" and my catalytic converter is okay?)? My mechanic said he thinks it is, and that my car should last me quite a bit longer. I am asking because I've put in a bit of money into the car of late and I'm wondering if I should just jump ship. I should say that the majority of the repairs are maintenance (e.g., brakes, tires).
View 8 Replies
It has been running very smooth since I changed the lower intake gaskets, and I just went on a 1500 mile round trip roadtrip. It ran perfect the whole way, getting 22mpg to boot. In the last 50 miles, the CEL came one. The code read P0420 which is the cat converter? I dont want to fork up for a new one, are there any tricks to get this fixed or cleared?
View 8 Replies
Wife's 04 Escape threw the PO136 code for bank 1 sensor 2 02 sensor. Replaced it and light is off. Not convinced something else isn't causing it.
View 3 Replies
Book says "catalyst system efficiency below threshold (Bank 1)".. Is it just based on mileage or an actual bad O2 sensor or other bad system component?
View 14 Replies
P0420 code. Catalyst Efficiency Below Normal (Bank 1)
This was the explanation I got from autozone. First question is how serious is this? The car seems to drive fine and normal, but I just purchased this car about a month ago. The light turned off after the guy at autozone plugged in the scanner. I am sure it will come back on again after some driving. Is it ok to drive with it on?
View 1 Replies
05 santa fe/3.5L/ owned since new. Had a misfire problem and solved that by changing coils/plugs/wires...
Still getting a P0430 code (bank 2 cat efficiency low)
Following the Repair manual troubleshooting of that code says
Read H02S - got a scan tool and did that -
Comparing Bank 1 H02S1 and 2 show they are are different voltages and do not follow.
Comparing Bank 2 H02S1 and 2 show nearly identical traces.
I also checked the wiring harness around the sensors and check for air leaks...couldn't hear/see/feel any.
My conclusion based on the info obtained is that the bank 2 cat is bad and needs to be replaced.
View 3 Replies
2001 Jetta 2.0, manual trans
I've been having problems with intermittent P0420 cat below efficiency code. Everything else is fine, no codes, runs great. I tried spacing the post cat sensor back w/ extender bung (after replacing post cat sensor..) and still get the code. I don't hear any rattling or anything to make me think cat is bad physically. I was told by dealer that a code update might resolve for $200 - which got me thinking that that if that was so, it should should be a problem which Feds should be aware.
I searched safercar.gov and found this NHTSA ID Number: 10054864
It's a service bulletin saying that VW made the limits too sensitive and it seems there was a customer satisfaction campaign to update code - pdf on site CSC-10054864-8736
It says:
May 2007
Subject: Emissions Service Action N7
1999-2002 Jetta, Golf and GTI with VR6 Engine
Update Electronic Control Module (ECM) Software for Catalytic Converter Monitoring System Dear Volkswagen Owner: We are writing to inform you of an emissions service action on some 1999-2002 Jetta, Golf and GTI VR6 engine vehicles. Our records show that you are the owner of one of these vehicles.
What Is The Problem? The electronic control module (ECM) software for the catalytic converter monitoring system is too sensitive. This can cause the MIL to come on, and some vehicles may exceed Federal and/or California emissions standards. Also, in some cases this leads to unnecessary catalytic converter replacement. What Will Volkswagen Do? Dealers will update the ECM software.
View 5 Replies
I checked out a 2006 Prius yesterday a guy is selling. It had the CEL on (not sure why somebody would try and sell a car with that, but anyway). He said that it's because they get gas at a station that consistently doesn't tighten the gas cap enough but by the time the tank is down to 1-2 bars the light always goes away. Although I don't doubt his story, I absolutely doubted the cause. So I took it to get the code pulled and it was P0420, which is catalytic converter threshold below efficiency.
View 15 Replies
My 2005 Dodge Dokota 4.7L V8 152,000 miles has an intermitent check engine light (CEL) code P0420 ('catalylst efficiency') that turns itself off.
1) 151,000 CEL on, code P0420, checked, cleared at dealer.
2) 151,948 CEL on, code P0420, checked, cleared at dealer (Cat Conv).
3) 152,200 CEL on, code P0420, checked, cleared at local auto parts store.
4) 152,597 CEL on. No checks.
5) 152,815 CEL turned off on its own
6) 152,849 CEL on. No checks.
7) 153,137 CEL turned off on its own.
Twice in this time CEL has came on soon after a fill up from near empty.
Engine runs fine, 18-19 mpg highway.
Have seen numerous on-line reports of other possible causes:
a) base engine problems (coolant or oil) -- coolant temp sensor
b) Air in leakage -- air systems or manifold
c) Lazy front O2 sensor
d) fuel pumps
e) timing or misfire
f) what else? - (gas cap, other...)
What to check first or categories to eliminate?
View 1 Replies
On my 2002 (AVH) 2.0L 4cyl Jetta I have a persistent P0420 error code: "Catalyst System Efficiency Below Threshold"
I changed the oil, cleaned the Mass Airflow Sensor, replaced the coolant, thermostat, and coolant temperature sensor. But it's still showing up.
OBDII says it could still be:
A damaged or failed oxygen sensor (HO2S)
Downstream oxygen sensor (HO2S) wiring damaged or connected improperly
Damaged or leaking exhaust manifold / catalytic converter / muffler / exhaust pipe
Retarded spark timing
The oxygen sensors in front and behind the converter are reporting too similar of readings
Leaking fuel injector or high fuel pressure
Cylinder misfire Oil contamination
View 3 Replies
I'm getting a p0452 fault on my 2002 Escape 3.0 V6 2WD. From what I've read, that seems to indicate low FTP signal below .22v. As I understand it, the FTP sensor has 5 v applied, and the output to the ECU goes down as tank static pressure increases. Conversely, I think the voltage back to the ECU goes up as tank static pressure decreases (for the vacuum leak test measurement).
What the approximate voltage is at atmosphere (engine not running, vent valve open, etc)?
I'm guessing the "less than .22v minimum" signal back to the ECU might look more like either the signal wire shorted to the frame somewhere or the signal wire open (maybe corrosion in the connector)....
Also, where the FTP sensor is located on the Escape and how to access it?
View 3 Replies
I have a 99 Tiburon 2.0 DOHC that I cant seem to get through emissions. The code, p0422 main catalyst efficiency below threshold bank 1 keeps popping up even after replacing the cat converter (twice) and replacing both 02 sensors. What else could be triggering this code and how to fix it?
View 2 Replies
2002 Ford Escape... My OD light started to come on every once in a while, and would go off once I turned the car off... This being said, as far as I could tell, the tranny was running smooth. Then an engine light popped on and this code and explanation come up... P1744 "Torque Converter Clutch System Stuck in OFF position".
I recently came back from a bit of a trip... and after shutting the car off, it didn't want to restart. Since this time, the car has begun to start, but the engine light remains on with the P1744 coming up...
Research seems to indicate that the problem is with the Torque Converter Solenoid. You Tube videos show that there are two solenoids just under the transmission pan...
View 7 Replies
I have a very Big problem with my Ford Escape 2002 I have this problems code: P0305 accuses Cylinder #5 P0306 accuses Cylinder #6.
I already change the gasket i buy the felpro Kit, and i Also replace all the sparks and spark plug boots, I clean the air sensors and i also replace the EGR, i try to switch cables, and all is the same the car start buy when i accelerate it just go off, i don't know what can i do next, somebody told me to change the fuel injector, i take the pressure in both spark holes the number 4 was 150 and the 5 and 6 was 120, No leaks oil. My car is a Ford Escape 2002, XLT 3.0 4x4
View 2 Replies
P0420 bank 1 code popped up while driving. Im thinking this is just an oxygen sensor? Is it ok to drive with this code for a while if i buy an o2 sensor online?
View 5 Replies
I've got a 2004 Prius with about 140,000 miles. Overall, the car has worked great, and I've kept up with regular service.
Several months ago, I started having bad misfiring of the engine. When I got it into the shop, it turned out to be two faulty ignition coils. The shop advised me to replace them all, which I did. Soon afterwards, however, the CEL came on, indicating a P0420 - "Catalyst System Efficiency Below Threshold Bank 1".
View 5 Replies
2004 F150 5.4L V8 ...
P0420 Catalyst below threshold bank ...
O2 Sensors or Catalytic Converter ...
View 14 Replies
2002 3.0L escape 4WD, stalled twice on me when shifting into reverse after a complete stop. No CEL, truck started right up again....
View 4 Replies
