Ford - Escape :: 2004 - Fuel Pump Repeated Failure
Apr 8, 2016
Got this 04 Escape 3.0 FWD for my son's first car. It was his mom's and she drove it for years and parked it when she got another car.
I charged the battery and it is holding a good charge. Car would crank but not start. Fuel pump was not coming on. I pulled it out and applied 12V to the connector terminal and it started running so I put it back in and it worked fine.
Drove it home and cleaned it up, pulled out the bad window regulator, put it in the driveway till the next weekend.
After it sat for 3 days it would not start again. The fuel pump was not coming on. I assumed that the old pump that I revived had died again so I bought a new one and put it in and it ran fine.
Went for inspection but OBD2 was NOT READY so I drove it about 60 miles until it threw 3 codes. P0136, P2270, P2271 (O2 sensor problem).
I parked it again to wait till my next chance to work on it. 3 days later I was going to replace the O2 sensor but when I tried to start it the new fuel pump was not coming on again. (2nd fuel pump to die while sitting in the driveway).
So I figured the new fuel pump was a dud maybe, so I returned it and got another new one and put it in and it worked fine again. So I replaced the O2 sensor. Didn't have time to drive it 60 miles again to READY the OBD2 system for inspection so I parked it for a couple more days.
2 days later I was going to drive it around to make the OBD2 READY for inspection and again the fuel pump does not come on.
3 dead fuel pumps doesn't make sense to me so I have been considering it could be the Fuel Pump Driver Module but have read that's not an issue on the Escape like it is on the trucks. Plus I have been unable to locate where it is on this vehicle.
View 18 Replies
Advertisement
ok i was just driving my 2004 ford f150 truck and it stopped running. I turned the key and it started back up again and then while on idle it stopped again. I took it too auto zone and it showed a code of p1237 which as far as i can see says fuel pump secondary circuit failure. does that mean i need a new fuel pump and how hard is it to replace.
View 1 Replies
We are in need of a 4th clutch for our 2004 Elantra. This is a despicable record for Hyundai.
View 14 Replies
The dealer has replaced the DMTL pump 4 times on my 2004 BMW325. The last time the dealer checked the gas cap and smoke tested the fuel system - all OK. I do not overfill the tank. The pump has failed again and I am getting tired of taking it to the dealer for a new pump. Fortunately it is under warranty but I am sure that there is something else causing these pump failures.
View 5 Replies
I got a code for Fuel pump secondary circuit failure, how do you fix it? 1990 Aerostar 4.0 2wd with A/T and A/C
View 14 Replies
My car is almost turning on. It goes all the way but then just doesn't start. The fuel pump is working, can hear it. We checked for spark and there is. we sprayed that carburetor or whatever it is in the air intake thing too and it still didn't start. My buddy is saying that it has to be a sensor. Either O2 or crankshaft something sensor.
View 13 Replies
A friend has 2005 escape 3l. He called me yesterday saying that he needed replacing his fuel pump.
Before I got to his place he had already replaced the fuel filter...
We got the pump replaced, and when we went to start the vehicle, it still wouldn't start.
We double checked to make sure everything was connected and plugged in and it was. We checked all fuses, and they were all good.
This morning I am going to try jumping the relay and see if that does anything. What else to check?
View 3 Replies
I am curious as to what are signs that a fuel pump is about to fail?
View 11 Replies
I have a 2004 Ford Escape that seems to have developed an appetite for one of its O2 sensors, about 1 a month for the past 3 months. Specifically Bank 1 Sensor 2. That is this the downstream sensor for cylinders closest to the firewall. I have replaced the sensor twice and the last sensor just popped the code to let me know it's passed on. The code is P0136 is the code that has popped every time. The live data shows a flat 0.0 off of the sensor.
So before I replace another sensor, what would cause the same sensor to die 3 times in a 3 month time period?
View 17 Replies
I have a 2010 f250 6.4 About two months ago the truck just quite on me. I am a farmer in south jersey and have a decent background in diesel motors. First thing that came to mind was fuel. I assumed I was having a fuel issue (clogged filters, failed pump, etc.) truck only had 45,000 miles on it so I took it to my local dealership for what I assumed would be a warranty job. I dealer service all my trucks while under warranty. Long story short I was told it was a fuel contamination issue which scared the walls of the hpfp throwing metal pieces into the injectors, fouling them.
I would need all new injectors, fuel rails etc. as well as new filter housings, fuel tank cleaning, etc. I had receipts for every drop of fuel put in the vehicle and fought all the way to through the dealership to Ford who sent out a rep and who denied the warranty work. Fortunately my insurance company covered the ordeal and all repairs were completed. I got the truck back and 2 weeks later the truck died on me again. I called the dealership back who supposedly warranted the repairs but there first words were there is no way it is their problem, they would look at it but I have to consent that if they find it is contamination again I am responsible for the repairs which we all know just to diagnose they have to remove the cab etc.
I of course lost my mind and told them this is there issue and there is no way in hell I am that unlucky that I received 2 bad tanks of fuel from 2 different high volume highway side fuel stations in the same 2 months. it is obvious they missed something or there is another issue that was not addressed. They claim there is no way they missed something. I am at a standstill.
View 4 Replies
So at 55,200 miles, the fuel pump on my 2003 decides to quit today. I never got a Recall Letter and when I called VWoA in the past about it they said that my car was not one of those affected, even though it was within the years affected. So what do I do now?
View 6 Replies
I have a 2001 ford escape V6 3.0l. Dropped a new motor in it, got everything running fine. Surprisingly the most frustrating part was when we mixed up the order of the front 3 coils but we got it!
It drove "ok" for a week and a half. Then it started to shudder at 45-55 mph. Got it home that afternoon and started to diagnose why it would shudder. Suspect its not shifting right.We started to diagnose what was wrong, made some adjustments to IAC, MAF and checked a few other things. We then went to test drive, started up fine, drove up the driveway 50' and it died. It didnt sputter and die, it just lost all power and died.
Got it back in the garage and tried to get it started again. Turned Key... nothing. Dash lit up but starter and fuel pump didnt fire. Odometer reads ------. I can jump the starter by pulling the starter relay. Same for the fuel pump. I use a jumper wire between two pins and I can get the starter to crank and the fuel pump runs when I jumper wire the relay too. So I know its not a bad starter nor a bad fuel pump.
Odd part of everything is that It drove just fine that day (other than shuddering). Then started just fine, then died. When it died we were making a sharp left turn in the driveway. We've messed with the steering wheel because it was "accidentally" put upside down when we dropped in the new engine. Could something have grounded out in the steering wheel? Air Bag? Maybe a problem in the clock spring? What would stop it from The fuel, starter and spark all at the same time? Bad PCM? Grounding issues?
View 8 Replies
My 2011 has just over 27K miles on it. On Saturday the Check Engine light came on. The next time I started the car, it cranked over for about 5 seconds before starting, which is unusual. Then multiple times Sunday and this morning, it seemed to take even longer to crank before starting. This morning, it barely would stay running. And there was a lot of hesitation driving down the road.
I scanned it with my OBD II scanner and got P0087 (Fuel Rail/System Pressure Low). I dropped it off at the dealer this morning and jut got a call that they are replacing the High Pressure Fuel Pump. But they had to special order it overnight and probably won't have it replaced for another day after that.
Is the high pressure fuel pump the device sticking out the top of the valve cover on the back, driver side of the valve cover, with the multiple fuel lines going into/out of it?
View 71 Replies
I have installed my 6th resistor and they continue to burn up, leaving #5 only.
View 4 Replies
Several years ago I had to replace the fuel pump - truck had about 100,000 miles. Within the last 4 - 5 months I have replaced the fuel pump twice and just today (about two months since the last replacement), the fuel pump has failed again. That has been the pattern now for the last several months. I have had the work done by one of the reputable car repair shops in town - they have also done work on my 2004 Impala with no issues with the repair. There must be something else going on besides just the fuel pump going bad. What would cause so many fuel pump failures.
View 16 Replies
In 13 months my 1991 Dodge Grand Caravan has managed to kill 4 transmission control modules -- the original plus three factory replacements. The first replacement (by a Dodge garage) failed within weeks, after which they threw up their hands in despair (never recognizing the defective part) and sent me to an electrical specialist. The specialist's first replacement survived until April; their 2nd has just died. I find it hard to accept that all of these TCMs were simply defective.
View 4 Replies
I have a 1993 Dodge Grand Caravan with about 160,000 miles on it. The front end has been deteriorating steadily for some time now. I have no power brakes or power steering, but I do not think that this is related to my REAL problem: My driver side CV joint (or axle or whatever) failed last week. Upon inspection, my mechanic commented on how he was surprised that it held on long enough for me to get to his shop. It was replaced by a mechanic with a new (not re-manufactured) piece.Yesterday I was driving a friend to the airport about 150 miles away, and 20 miles out of town, my van began wobbling in the front, and then shaking violently - consistent with my previous CV failure.
After dropping my friend off at the airport, I proceeded to the nearest mechanic, who again commented on how he was surprised that I was able to make it to his shop. He said something about the last CV joint being too long or something against a tulip joint (or something, I should have written it down).Initially it drove smoothly, as it did after the first fix, but on the way home I noticed a slight wobble that is connected to acceleration (that is, when I take my foot off of the gas, the wobble disappears). I am concerned that the CV is going to fail again. What would be causing this? Are the mechanics at fault, or is there another problem that propagates in the CV?
View 3 Replies
I've got an '03 Accent 1.6 in the family. December 2011 I replaced the crank position sensor and it cured the no start problem. Got it from A/Zone. It lasted 2 years and 8 months. Then, the same thing happened again in August 2014 only this time the car stopped running while on the road and I had it towed to a local garage. They installed a "Standard" & was back on the road again when it stopped running again a week ago. Had it towed to my house this time and read the code. P0336 CPS again! That sensor lasted only 4 months. The garage came & replaced the sensor & it's back on the road...for now. Do these cars only play nice with Hyundai CPS's or should I be looking for an underlying issue?
View 7 Replies
Well I had the dreaded loss of power and EPC/Check Engine light happen on Monday. Was driving down the Interstate and all of sudden we just lost power. It did not go completely dead, but it ran like crap. Called the local VW and they advised to bring it in, still under warranty (27k, 26mths) and it turned out to be the high pressure fuel pump. They replaced the pump and the replacement was bad! Luckily they tested it before they got it out the door back to me. Provided me with a loaner and the dealer had to get a replacement pump overnight. Picked up the car yesterday and everything drives the way it should again.
I had already had the software update, but according to the service advisor that was for the fuel pump in the tank, not the one on the engine. Not sure if that is correct, but that is what the advisor told me..
View 3 Replies
5.4 L, Engine runs if primed at the intake. Fuel pump can be heard running but no fuel gets to the engine. Truck is mint and being sold real cheap due to this issue.
Fuel Pump? Filter? Both? I haven't seen the truck, a friend is considering buying it and rolling the dice it is a quick fix. Fuel is in the tank .....
View 2 Replies
Prius 2009 inverter coolant pump failure 51,300 miles....
View 8 Replies
