I have a 1993 f150. Problem is that the steering wheel can wobble back and forth about a half inch or so. I took the wheel off and it looks like there is a lock ring holding everything in place. I just wondered if there was a solution to this to fix it
View 1 RepliesTwo months ago, I replaced the rear drum shoes, wheel cylinders and seemed after that I was ok until today. I checked the rear brakes and they are split in half. i noticed my abs & brake lights lit up this morning. I would think the ABS is getting stuck? How do I check the ABS? This morning I felt like something was holding back the truck. I continued and when I got home I said to myself, let me just check the rear brakes and thais what I found. Both sides had the shoes broke.
View 1 RepliesI have a 1991 F250 Lariat, 4x4, 460 engine, auto trans. I am having trouble with my steering. The power stering turns good to the left but when I turn to the right it is like there is no power and is very tough to turn.
View 1 RepliesI have a 2010 F250 King Ranch FX4. I have an odd problem that I am trying to get to the bottom of. We went on a 2,500 mile road trip last year and I noticed on the way home my steering wheel had worked it's way off center counter-clockwise at a perfect diagonal. I had gotten an alignment right before we left and it was perfect center at that point.
I took it back in when I got home and had a tire rotation and another alignment. Within a week the wheel was off again to the same degree, counter-clockwise at a perfect diagonal.
Two weeks ago... tired and annoyed of driving like this, I crawled under the truck and adjusted the steering wheel to center via the drag link adjustment. I tightened everything down tight and this lasted all of three days.
Wat would cause this? Tires are wearing normally, alignment checks out and it tracks straight. I do see some grease like leakage where the pitman arm meets the top of the drag link and again have some small grease where the drag link connect to the passenger side tire. I lifted the front end and tried to move/wiggle the tires and I have no movement... everything is solid. The truck never wanders when on the road... steering wheel is just off.
Truck only has 90k on it of highway miles and an easy life thus far. I am not hard on the truck.
One my F350 with 175,000 miles on it, at low speeds when turning the steering wheel it seems as if it has two places during use that it rubs or has an oblong spot in it. I have 285 tires on it and have for years.
Kind of like if you were turning a shaft in a seal and it rubbed or was rough. It makes a faint, muffled, barely audible grinding noise or feel. I have a lift and level of about 4" and 285s for years. This just started in the last 5 months or so.
OK, a couple of days ago I hit a good size bump and got the dreaded death wobble. I stopped to check the lug nuts and none were loose... jacked up one side at a time, tried shaking the tires to see if anything was loose and to my surprise on the drivers side I could move the tire back and forth (like turning the steering wheel, not around) so I figured something had broken right as I stopped. Is it supposed to do that?? I know it`s not on older vehicles.
Anyway I figured I was stranded so I thought what the heck, I`m gonna see if it will turn with the steering wheel. Well when I did... with drivers side still off the ground it gets the death wobble, oh it was running when I did it. I jacked it back down and it stopped so then I tried turning the steering wheel to see if it would turn and both tires turned as they should. I was scared to try it but I drove on home about 4 miles slowly.
My brother has an older Saturn and his wife was driving it and from the way he described it, it got the death wobble. Someone told him it was the serpentine belt. He changed it and it didn't happen anymore. Does it sound possible that the belt could be my problem. BTW, the truck is a 99 ranger 4x4 with no lift or anything.
what is this 1" half-tube rubber thingy that fell from steering column or gas pedal?
more importantly, where does it go back to?
I only wash/vacuum my 2007 Camry once a year. Found it while vacuuming the floor mat.
This rubber piece was caught between the carpet and the floor mat near the gas pedal and/or steering column that goes through the firewall.
I replaced the radius arm bushings on my truck about a year and a half ago and about 6 months later I found that the nylon spacer on the driver's side cracked in half and only half remained on the truck so I replaced it (under warranty) and I found the same thing again today. I torqued it to factory specs and the passenger's side is fine. What gives?
View 4 Repliesok, its been 9-10 months now, and i have only 3500 miles on my gx.just looked at the back wheel wells.
The left side of the truck in the back is sitting about 1.5 inchs higher than the right rear? I measured the distance between the rims and the edge of the panel in the back. I am baffled. I raised it, lowered it, and still unequal height. Its going to the dealer on wednesday.
My car has almost 80k on it. It is a 2005 VW Jetta 1.8T GLI. Been a great reliable car but I've been having a lot of trouble with the front end suspension. I get a horrible wobble in the front end. Translates into the steering wheel and feels like the wheels are wobbling very quickly only under braking. It is much heavier under heavy braking, but still exists even under light braking. I've replace my tie rods after finding a little play in them, checked my CV joints and axles and they looked good. Balljoints seem ok. Struts and strut mounts were replaced and the car has brand new tires that were balanced and aligned and rotated. When I replaced the tie rod, it went away temporarily but is back worse than ever. I'm getting really frustrated with this and the car feels dangerous to drive.
View 19 RepliesAfter putting my Ford Ranger in park and pressing down on the E-break to get the news-paper or mail. I've noticed that there is a consistent squeaking coming from the back drum brakes when the brake pedal is applied. But only for a certain period of time; then the squeaking stops.
View 8 RepliesMy truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 RepliesMy wife's having trouble with her '02 Explorer 4x4 V8 XLT.
Today I experienced a violent steering wheel shudder that I would describe as the old "death wobble" you hear about on solid axle trucks, Early Broncos, Jeeps, etc.
At 55mph, in a slight right hand turn, a little bit of a bump in the road triggered it. I held on to it as the steering wheel was rotating left and right a few degrees (maybe ~10deg) and it wouldn't stop until I slowed down to around 35mph.
I crawled underneath and didn't see anything obviously bad (tie rod ends, ball joints, etc).
Then I noticed when turning the steering wheel (with the engine running, but parked) I could feel it shuddering slightly as I turned it.
The PS pump makes quite a bit of noise so I wonder if its on the way out.
Yesterday while driving, i lost all power steering and power brakes (you would automatically think Booster). I pulled over, popped the hood and fluid was spewing from behind the power steering pump somewhere. I limped the truck home about 20 miles. I checked brake fluid and it was full. checked power steering fluid and it appeared to be empty. Yet when i added fluid it took less than a half quart. I started the vehicle to pressurize the pump and find the leak. Yet the pump never pumped any fluid. (one would thing pump was out) I am baffled as to if the pump went out, why fluid loss? If the booster was out, why do i still have brakes just without power assist? Andif a hose is blown, why such small fluid loss? I dont want to just start replacing parts till it get the right one
View 1 RepliesBefore I get started... My truck is a 2006 F-250 Super Duty XLT 6-speed 4x4 with a Limited Slip.
I just got finished with a big job on my truck. New pads all the way around, turned rotors, new emergency brake shoes, hardware, and backing plate as well as replaced the rear wheel bearings both inner and outer as well as the axle o-ring and inner seal. Also, took off the rear pumpkin cover painted it and put fresh fluid in, went with Mobil 1 75W140 LS.
Took it for a drive and the brakes work great. Followed the directions for breaking in the emergency brake which worked fine.
Now the problem is I'm getting rattling from possibly all of the wheels. Definitely from the front driver and at least one of the rear wheels. It was so dark I didn't get a chance to look at it I just pulled it back in driveway.
I'll start looking at things tomorrow but, any common mistakes or things I should check first?
I'm having the same issue that I had on my previous Mkv car. Around 55-80mph the steering wheel will wobble back and forth at about a quarter of an inch very quickly. It's an identical shake to my last Mkv. I had the wheels balanced and checked for bends and the car aligned. Didn't work. Went to various shops spent too much on balancing. One shop showed me that one of my tires was slightly out of round. So I bought 4 new tires and had them road forced shop said everything was great. Hopped on the freeway and the same wobble was still there. Car is at 52k miles and I've been battling this problem for about 5k miles now.
I've had the entire car checked. One tech told me that the axels could have gone bad so it is going in under warranty to get new axels on Tuesday, then going back in for an alignment. My last Mkv had the same issue around the same mileage and I spent so much on trying to figure it out I eventually got sick of it and traded it in on this GTI. My girl friend just bought an 09 Jetta and it seems to be having early signs of the same vibration. I'm starting to think its an issue with the generation. My mk3 with 200k miles drives smoother than this thing. I love the car but me driving on the freeway so often really kills the enjoyment.
Off late my Honda Odyssey steering wheel wobble beyond 60MPH ONLY while going STRAIGHT and foot off of the GAS (which enters eco mode).My mechanic looked at it and said, it is not alignment or any mechanical issue. I looked at the other posts and I could not find any closer to this.
One more thing, I have got the Steering Pump fixed as part of a Recall ( at slow speeds, while turning makes a lot of noise)
I have an '05 Honda Odyssey, that has a wobble in the steering wheel, when I am going more than 60 mph. It has 87K miles on it. Tires seem smooth. Below 40mph it is not there or un-noticable. There is no pulling left or right, it does not seem to get worse if I go from 60 to 80.
View 2 RepliesI had new tyres put on my 2002 Accent 1.5 CDX a few weeks ago, they are 175/70 R 13 and i have Genuine Hyundai Alloy wheels. Over the past few days, Ive noticed a bad wobble that i can feel through the steering wheel, but seems to come from the rear of the car, although it could come from the front, as the car seems to wander around on the road, but going along at 50 mph and taking my hand off the wheel for a second or two it doesn't pull either way, you can just see the steering wheel visible moving from left to right and back again!!!!!
I changed the back wheels to the front and vice versa, and the problem went away, for 24 hours and came back again!!!! This wobble is getting worse, I've had the wheels balanced, rims seem ok, suspension checked, etc and all fine. The only thing I am not sure about is worn track rod ends, and I am not sure what to look for this wobble is at its worse between 30 and 55 mph, but it can be felt on any road (from starting off) and at any speed.
I bought this 2005 Hyundai Elantra with 68 000 kilometers, and it had some nasty steering wheel wobble at about 80km/h and what felt like right rear brake issues. We got 4 awesome tires put on and balanced and that took care of most of the wobble/shaking, and took care of most of the wobble in the right rear wheel. The other day we pulled the rear wheels to do the brakes (pads and rotors), but the rotors we got didn't come with the holes for the retaining screws but one of the guys at auto value said it would be fine, and if not, then take them back.
We put those rotors on and then bolted the wheels back on and i didn't even get down my driveway since the rotor in the right rear wheel felt like it was fumbling around in there. jacked the car up and there was play in both rear rotors but much more so in the right rear one. the rims that came with the car are 15" honda rims with a 4 bolt pattern so could that be the issue that these rims don't bolt up properly over the hubs? i thought that 4 bolt rims for honda, kia, hyundai, and others had the same bolt pattern? am i missing something here? or should i just find new rotors with the retaining holes?
My 2005 Honda Civic just made it through a blizzard (outside the whole time). This morning I started driving it, and whenever I got above 45 mph the steering wheel started vibrating / whobbling very badly. My car seat was also vibrating. I poured hot water over the rims when I got home and that did not seem to work. Should I take it to a car wash? Is my car safe to drive?
View 1 Replies