Ford Brakes/Suspension :: Front Left Steer Is Making A Lot Of Noise And Wearing On Tire Inside Edge
Feb 25, 2013
I bought a 2002 F250, 2 months ago love the truck drives great for 130000 miles, but the front left steer is making a lot of noise and wearing on the inside edge and like its skipping every couple inches so very noisy thought maybe ball joints but a buddy say tire is out of balance truck does not pull left or right and drives straight...
View 3 Replies
Advertisement
My passenger rear tire is wearing out on the inside edge. Thoughts as to cause and possible fix?
View 14 Replies
I have a 06' Ranger 2WD with General Grabber tires that have about 30,000 miles on them and still show significant tread remaining.
Within the last 2 months, I have experienced excessive tire noise - like I am driving a Humvee or something. Also, when I turned right or left the tires would make even MORE noise - it seemed to be coming from the right front tire mostly. 2 weeks ago I had the tires rotated and the sound seems to have reduced while turning but I still have the howling Humvee noise while driving down the road. There is no vibration coming from the wheel, so I don't think it's a balancing issue. Could it be the bearings?
I also checked the PSI all around and one tire does have a slow leak but I try to keep to topped off.
View 1 Replies
Took my car in for 10k mile service and let them know there has been some clicking noise coming from the front suspension when making a left/right turn...
I dropped off my car on September 21st and they have yet to complete my car... I've called them every single day since but, I don't get a good explanation from the dealer...
View 10 Replies
My 97 f150 had been sitting for a while and after a few miles I could smell brakes and the left front rotor was hot. So I removed the caliper to see if I could free it up. When i push 1 piston in with a C clamp the other one comes out and visa-verse but I cannot push both in with 2 C clamps. When I push the brake pedal they both come out. Its like there is a check valve in the line. How should I go about trouble shooting this?
View 1 Replies
I realize that is vague. I realize it could be anything from a wheel bearing to a ball joint, tie rod, control arm/control arm bushing, etc.
Are there any very common front-end steering or suspension issues on 2012 escapes? When tires are inflated to 32-34psi, the car tracks straight, gets great mileage --but almost sounds/feels like it's got a CV or wheel bearing issue on the front right. Every time I hit the brakes while backing out of the driveway I can hear a slight bump or pop. When the car is parked (flat, tires straight) there is slight play left-to-right in the steering wheel.
I'm a German car guy. Have never touched this car. (Wife's car) Right tire is wearing bad on inside. Looking for some direction so I can assess. Car has 88k miles. This will be a DIY fix. Don't have any manuals or anything so just looking for a heads up where to start. Also is Haynes the best way to go? Is there a Bentley? Anything online/CD/DVD?
Play in steering wheel makes me think tie rod (fine because easy/cheap) but such excessive wear on the inside right front makes me think wheel bearing. Could it be both? This is AWD. Is this (like a Subaru) a CV joint where the front spindle passes through a strut base that everything attaches to --so there's an inner and outer wheel bearing?
Does anything up front require a press or can it all be done without a press?
View 3 Replies
The front and rear driver's side tires are wearing on the outside edge. Searching about, I find that camber problems are indicated with outside edge wear -- but....
View 19 Replies
I have a 2010 f150 supercrew 4x4 with 8.8 3:55 nls rear differential. my driver side tire has a wobble to it it is wearing the inside of the tire. i have replaced the driver axle shaft with new ford oem shaft put in new axle bearings and seals on both sides and have replaced the spyder gears and i still have the wobble I don't know what is going on. the wobble is more pronounced when the tire and rim are bolted to the shaft only without the drum and caliper attached. with caliper and rotor attached i still have the wobble just not as bad however the tire wobbles going down the road more noticeable between 20-45 mph.
View 13 Replies
I have a 99 F-250 extended cab superduty 4 wd with the 7.3. I also plow during the winter. Recently I've noticed wear on the inside of the left front tire. Brought it to a tire shop and had them check the front end and alignment. They told me that the specs were "within" tolerances" for my truck. I'm stumped as to why the abnormal wear if everything is supposedly good with the alignment.
View 5 Replies
Happen 2 times this morning, making left turn. Left (inside) front tire spun out.
Granted there weren't enough grip (sand + LRR overinflated tire) but isn't ESP suppose to take over in situations like this?
View 7 Replies
My 95 F150 2WD. The passenger side wheel is leaning in(top) - toed in? and I am A. concerned that this is unsafe to drive it and B. What is the most likely cause and fix? I was just looking for a starting point.
View 2 Replies
I have a 1997 F250 Light Duty with a 5.4L and 4 wheel drive, 216,000 miles. Last year one of my front tire chains broke and ripped the ABS wire. I have soldered them back together and no longer have the ABS light illuminated in the dash. However, when I apply the brakes at speeds slower than 25 mph, the ABS pulses. Over 25 mph the brakes work as they should until almost stopped and then they pulse.
View 1 Replies
I'm getting a clunk sound from my Passat's front left suspension when making turns. I've found info on how to diagnose control arms and I plan to jack the car up tomorrow and check it out. But how would I diagnose a tie rod end problem?
My Passat has 53,000 miles on it.
View 6 Replies
2008 F-350 wheel will lock for no reason. I think the Hydroboost has a hair line crack it and when the temp and pressure reach a certain number then it sends brake fluid threw the crack to the caliper? I also heard it could be in the ABS because its locking just one wheel?
View 1 Replies
I have an 04 ranger with 31x10.5x15 mud tires on it and the front tires are wearing on the inside real bad if you look at it the tire look tilted in on the tops...
View 1 Replies
Two weeks ago my front left wheel would start shaking like hell when I brake, not at first but after say may eight miles of driving. I have never been in a vehicle shaking so violently and after proceeding from a stop it would continue until it cooled down. I tore out the caliper and made sure everything was clean and lubed and also to make sure I did not put the pads on wrong. Fast forward one commute and the same crap. I could not go faster than 45 mph without feeling like it was going to disintegrate.
When I got home the damn thing was smoking. I managed to get it to the dealership this afternoon and two hours later the guy told me that the guides just needed some cleaning and grease. They did not want to charge me anything (draw your own conclusion) for it. I was told they drove it up/down hills and it was alright. I left kind of suspicious and four miles later the problem revealed itself again. My next thought it maybe axle end play, bad bearings or joints? Intermittent why? 2004 f150 lariat 4x4 ....
View 4 Replies
I installed 2 new axles and replaced the upper motor mounts in my car. Now when I turn to the right the left front tire is running against the coilover and making my car vibrate. I put a 5mm spacer to give it some clearance but it didn't make much of a difference. What could be wrong?
View 2 Replies
i have noticed that my front tires are wearing quicker on the inside. that is to say they don't seem to be wearing evenly. have almost no tread left on the insides of front tires and these tires only have about 13000 mi on them. is this and aligment problem? dealer says no.
View 4 Replies
My wife had the tires rotated on her 2007 Hyundai Santa Fe immediately before we went on a long road trip. After we left, we noticed a high-pitched whining sound at speeds of about 35-70 mph. It did not occur every time we hit that speed, and it generally seemed to go away after we'd been driving for about an hour.
We could make the noise stop every time by braking (as long as the pedal was depressed), or some of the time by turning (but only while the wheel was being turned). Occasionally, going over a particularly big bump could stop or start the noise.
My question is, what color is the car? Wait, no, my question is, is this likely to be the brakes, and if so, could it have been caused by the tire rotation?
View 7 Replies
I'm looking to buy an ISF and now I'm reading about the 2IS chassis suffering from front inner tire wear with many attributing it to the soft LCA bushing (see FIG fix) and the factory alignment. Most of the reports seem to be focused on the 2008-2010 ISFs and I see little about 2011+ owners reporting this issue. It's my understanding that the 2011+ front springs are slightly taller/higher and a different rate. Did this possibility (inadvertently) correct the front inner tire wear issue?
I had a 2003 G35 and front inner tire wear plagued that car too and it was annoying and no real fix available. It had the same exact suspension setup on ALL components. We didn't smoke through the inner rubber tread, but rather it feathered like and if you didn't stay on top of it, your G/Z would sound and feel like a dump truck after about 10-15K miles because of the feathering.
I'm looking at 2012-2014 ISFs and I would check and correct the alignment if necessary. I know FIG makes a replacement bushing, but it's urethane and after about 20 years of modding cars, I've learned that urethane is best left to race cars. After about 5K miles, urethane needs regreasing and almost always leads to squeaking/clunking as the urethane loosens up after a year or two.
View 14 Replies
1996 F350 PSD 7.3
Front Dana 60 mono beam
4 x 4
Last week I broke my front right caliper. I replaced the caliper, rotor and pads. Now, when I apply the brakes I pull to the left. I took the truck into my repair shop and let them figure it out. They were unable to repair the truck. They replace the master cylinder, all brake lines, calipers on both sides, brake pads, bearings on both wheels, vehicle alignment, tire balancing and tire rotation. The tires are three months old. Prior to last week i did not have any problems braking or steering. Driving at 60kmh the truck goes straight until i gently brake, it will slightly pull left.
View 2 Replies